Golf IV R32 :: Buzzing Relay With High Beams
May 19, 2014
With the euro headlight switch off and I pull the high beams on a relay buzzes, the high beams come on and the interior lights come on and off
With the euro headlight switch on or in the middle and I pull the high beams there is no buzz and all the light work properly
- I've checked every fuse on the fuse box inside the car and they're all ok
- I've unplugged the headlight switch but the issue still persists
- I've unplugged the headlights one at a time, then both but the issue persists
- I pulled the relay that was buzzing and the issue went away so I figured it was a bad relay, I ordered a bosch one from ecs and replaced it but again the issue persists
View 4 Replies
Advertisement
My high beams went out a few months ago on my 2008 prius. They told me it was the relay. I just replaced it today with a relay from advanced auto parts. My highs work now. But as of 2 hours ago I noticed my lows are no longer coming on. A few days ago I picked up the car after having aftermarket hids put in. The lows were working then highs still no. A few weeks ago I had some other relays replaced and they told me the cap was off and water got in it.
So could it be that my low relays have gone bad now too. It seems weird right when I fix my highs my lows stop working. If its possible I want to try a new relay to see if that fixes it. But I need the part number and location in the relay box. I can post a picture of the inside of my relay box, can't point to which one it is. I am sure it even has the part number on it.
View 6 Replies
Just the other day, I'm driving along and flashed my lights at another car so they can make a left turn into a parking lot. No big deal. However, when doing that, I noticed a buzzing noise when I pulled back the lever to engage the lights.
After I got home, I tested things out and found:
With my Euroswitch, I don't have any lights on during the day (no DRLs, etc). This is when this buzzing noise occurs. As it was getting dark out, I also noticed that when I pull the lever back to engage the high beams (i.e., to flash them) the dashboard would light up (like if I turned on the lights normally).
Now, if I have the park lights or headlights on already (which includes the dashboard), and flash the high beams, the buzzing noise does NOT happen.
It also doesn't happen when I push the lever forward to enable the high beams fully. The buzzing sound seems to come from the lower left, around my left knee area or near the steering column.
Why this is happening, and what the cause might be? What is the possible part that needs to be replaced?
I have a 2004 Jetta GLI 1.8T 6-speed. Seems like the old signature is gone.
View 2 Replies
After spending weeks ordering parts and doing research on this issue all my attempts have not solved the issue. To reiterate the issue, the high beams work, and the low beams do not. Thus far I have attempted the following without the desired result-
1. Changed the headlights out just in case both bulbs burnt at once.
2. Changed the blinker stalk in hopes of a faulty switch.
3. Changed the headlight switch to a brand new OEM Euro style switch.
4. Checked all fuses (did this first actually).
View 6 Replies
My wife drives a 2002 Golf 2.0L with about 214k on it at the moment. It runs really well and I'd like to keep it that way. Last week she told me that the car wouldn't start sometimes and that she would hear a buzzing noise when she turned the key. If she turned the key off and then on again the car would start. The problem was occurring more consistently as time went by and sometimes she would have to try to start the car four or five times.
I took a look at the car and her description was correct. The 53 relay under the dash was buzzing once the clutch was depressed and the key was turned, but the car wouldn't start. I took out the relay and put it back in and the car started fine. I swapped it with the other 53 relay in the panel (dual horns), and started the car a bunch of time with no problem. Then I gave the car back to her to drive to work. Everything was fine for a while.But now the problem is starting to return.
View 17 Replies
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 Replies
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
View 5 Replies
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 Replies
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
View 2 Replies
The other night on my way home, I flipped on the high beams and the low beams didn't shut off. Flash to pass still works, and pushing in on the end of the stem turns the low beams off as well.
Having the column switch apart, is it possible this could be fixed without having to pull the steering wheel? Or, am I better off just spending the hundred dollars of so and putting in a new part?
View 13 Replies
It ford related but I just bought a used car that has hid low beams and when you turn on high beams there is no light at all. The blue light on dash comes on and head lights go off. I just got this car 2 days ago and haven't really looked into it.
View 5 Replies
Didn't find anything on this, but I've noticed that on my GTI the Fog Lights stay on when the High Beams are turned on. Which I find unusual since no other car I've ever owned did this (Including my '12 TDI), and as far as I understood, in the US (At least here in NY), it was actually illegal to have them both on at the same time. ?
View 12 Replies
I did some VAG COM work today. (Comfort Blinker, fogs as DRL, Needle Sweep, Auto Lock/Unlock, Remote Windows, Fogs as Corner lights, Fogs don't go off when high beams on). I am using a Hex- Can cable that is approx. 1 year old. These are the malfunctions I am getting with the VAG Com
01-Engine -- Status: Malfunction 0010
02-Auto Trans -- Status: OK 0000
03-ABS Brakes -- Status: OK 0000
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: OK 0000
[Code] ....
View 3 Replies
My headlights don't turn on but everything else does DRL turning signals. I tested the resistance to ALL the fuses. I have two new ignitors and two new 10k light bulbs. The only way my high beams work is if i hold the lever in to bypass the resistors but like I said they don't turn on when I turn the HL switch. I just bought a new HL switch two .. the issue remains, what it could be?
View 3 Replies
So I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
View 1 Replies
Ok today I was driving my 2004 Gli n noticed when I flash my high beams (pull them back for temporary lights) my interior lights come on. When I release the high beams the lights go back off. I know this isn't normal n wanna fix it.
View 8 Replies
I bought an hid kit for my 2013 elantra a month ago... When I installed them with the relay, I have flickering issues and the relay makes a buzzing noise... How can i fix this???
View 4 Replies
I have a 2000 F350 7.3. I started out with my batteries dying after a few days of sitting. I found the interior lights were coming on dimly, and the relay buzzing. great, got it. I pulled the fuse and ordered the dimmer/light switch. I came back next week and the batteries are dead again. Charged them, drove the truck, and then the radio starts coming on without the key on. Pulled the radio.
Next day the truck starts fine, but now the seatbelt noid is going off all the time and the tranny overdrive is blinking "off" but still shifts fine, and goes into overdrive. The speedometer also works erratically... I read a post about the marker lights leaking, I looked and that's a definite possibility. My question is are all these related back to the GEM or BCM? or more problems?
View 11 Replies
2001 F-350, 7.3L,
Has done this off & on for a few years and am tired of it! Noise is kind of a buzzing that seems to come from the flasher/turn signal relay. It stops buzzing when you turn on a turn signal, activate the flashers, or lift up on the shifter arm(?). Had to drive home yesterday with the flashers on! So I see from researching that it may actually be the multi-funtion switch on the steering column. So I removed that, cleaned up all the contacts, and put it back on and the buzzing did not go away.
View 14 Replies
2004 F250 SuperDuty 6.0L Diesel. The turn signal (left or right), it would make a buzzing noise, so I located the relay under the steering wheel (by putting my hand on it and seeing which one was buzzing) and replaced it, I bought a replacement at Schucks, then the buzzing noise went away, and the clicking noise is back.
But.... I don't see the turn signal lights in the dashboard and the turn lights are not working, I checked, what could be the problem ? I read the owners manual, in the fuse box under the steering wheel, fuze #18 is used for turn lights, but it is not blown.
View 14 Replies
I just had my car coded for aftermarket HIDs and i have no high beams and a bulb out indicator on. did i miss a step in the VAG coding or will the high beams work when i put the HIDs in?
View 6 Replies
