Golf IV / Jetta IV :: Timing Belt Busted When Cruising Down The Highway
Sep 5, 2014
2.0L 8v ....So what's my chances the valves stayed clear of the pistons?
Driving 70mph 5the gear and cruise control set. Motor just died and I pulled off.
Cars back home in the garage. Iv ordered the ecs tuning timing belt kit.
This was a belt I installed 50k miles ago, shouldn't have gotten a auto parts store belt, or maybe it was my install, but I deff didn't think the belt was going to fail that early. Is there much of a difference between different brand belts and OEM?
View 22 Replies
Advertisement
I currently have a MKIV Golf. The other day i was out and about and i was going through an intersection. It had some deep gutters, or divets, whatever you want to call them to allow water to flow through the intersection. I didn't notice how deep they were until i hit them, being it was night and I didn't think going the speed limit i would even need to worry about that at a busy intersection. Anyways, i hit it, heard it, felt it. Didn't think of it much since it didn't seem that hard of a scrape. Got some food and ended up driving for another ten min.
My oil light came on and i ended up driving a block or 2 to the gas station. I stalled out on the highway right before i got to the gas station and had to try popping my clutch to make it into the parking lot as it was a busy highway. It restarted and i got into the parking lot fine. immediately turned off the engine. After half an hour and multiple dry dipstick checks and 3 quarts of oil on the floor i ended up finding out that there was a bullet size hole in my oil pan.
The only thing is that the fact the engine sounded horrible, but didn't seize up, and i don't know how long the engine was completely dry, should i take it to a shop so that there isn't a possibility that damage has been done to the engine? or should me replacing the oil pan, adding the proper oil and amount be sufficient for the engine to run fine. I don't want to take the chance as I've already been through engine problems with an s13 i had that seized up on me because of other oil issues.
View 20 Replies
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies
I plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 Replies
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies
I recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 Replies
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
View 9 Replies
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 Replies
I have a 99 vw jetta the coolant outlet flange nipple became brittle and broke...its the smaller 1/2 size hose not the two larger ones. Not sure how much coolant actually flows thru there and want to know if i can drive it a couple miles to a shop without it hurting the engine. I believe it's bone dry but don't know and i didnt want to add water since it's 32 degrees COLD. Don't want the water to freeze. The part comes in this weekend ...how far can i drive , with water no coolant....(vw coolant is expensive).
View 2 Replies
I drive a car I am extremely reliant on. I don't have money to buy a new one and I may be a bit over protective of this car. It is in excellent shape, I bought it with 96K and whoever owned it took good care of it. I changed the battery pretty much right away, and the auto parts store guy said it looked like it was the original battery. So I suspect the timing belt is original too, (along with the clutch, which works great BTW). I don't know anything about cars short of what I have heard on CT, but it seems there is a trend towards having to change the timing belt at 80-90K And I know that a worn out timing belt can have no symptoms and essentially ruin your car if it breaks.
I took my car for the blue plate special, and it has been to the dealer a couple of times for some repairs where they also do the general service and see if they can find something to charge me for and in all cases, my car had nothing they would identify and repair. Fluids are good air filters are good etc. When I took it to the little shop on the corner I got the same report, and when I picked it up I asked, well how does the timing belt look? And he said. I can't tell you, you would have to take it apart to find out. So my questions are, as I do not know if the timing belt has been changed by previous owners. should I just go for it and have someone change the timing belt as part of my regular maintenance plan now, or is there some nifty way to find out if it needs changing without having to spend an arm and a leg?
View 9 Replies
Experience a lurch during slowish highway cruising? If I am just putting along with my foot barely on the gas sometimes the car will give a jerk or a lurch like it's trying to decide whether or not to go fast or stall. Just a really quick bit of feeback that makes me think...what was that? Here are some common elements:
-Only happens when cruising at relatively gentle speeds (100km/hr or 55mph)
-Seems to happen more often if it's windy? Has happened a few times when passing by semi trailers
-Seems to happen more frequently when there is snow on the road or blowing snow?
Could it be some sort of sensor or air filter problem? No codes have been thrown.
View 11 Replies
I have a 2013 Golf R Apr stage 2+ with about 74k on the odo. I have been stage 2 for about 5k and was stage 1 for about 20k before going stage 2. Changed my plugs and coils at stage 2 as well. So was driving on the highway at about 60 just cruising when all of a sudden there was a minor hiccup in the car and then pushed the gas pedal and nothing, RPMs started falling and then car shut off, put the clutch in and coasted to the side of the road. Tried to restart and it would not.
I have power and car tries to start but won't catch and turn over. Towed it back to a buddies shop and let it sit overnight, still won't start. started poking around. Checked Hpfp and everything seems fine, cam follower and cam are good. Noticed that when I open my drivers door now I don't hear the other fuel pump prime like it usually does and after putting hpfp back on and opening drivers door a couple times we checked the Schrader valve on the hpfp and no fuel came out like it usually would. Have it narrowed down to most likely culprits; Faulty in tank fuel pump, faulty fuel pump control module, faulty fuel pump relay.
Btw just thought of this, no check engine light ever came on, also don't have a way to pull codes.
View 17 Replies
Does VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.
View 22 Replies
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies
Looking for info if the R32 has a timing belt or is it a chain and at how many kilometers shows it be changed.
View 5 Replies
So I was getting my car flashed to stage 1 at a dealership here in the Chicago suburbs and there was CSG R in there with the timing belt shredded. Turns out water pump came apart, shreded the timing belt, and apparently the pistons smashed the valves. I got a call from my friend whos a mechanic and said another one is getting towed there today with the same issue. Both have between 2k and 3k miles on them.
View 24 Replies
So I was trying to track down this squeak noise and I removed the drivers side seat belt but now the belt will not retract? It's stuck like this, is there a manual release? Buying another one is not a option right now. And I have to drive the car tomorrow morning.
View 1 Replies
I've got a 2003 Jetta TDI Wagon 250k mi. Makes the wroh wroh wroh wheel bearing sound, but wheel bearings are new and rock solid. I have been able to feel it through the floorboard and steering wheel for months now. But yesterday, while cruising at about 80MPH on I64, it got worse. Every now and then, I get a clunk clunk clunk mixed in with the wroh wroh wroh and it sounds really bad. When I turn hard left, the sound goes away. When I turn right, It sounds like satan is trying to escape my engine bay. The faster I go, the more violent it gets. No clicking when I turn, so I've ruled out outer CV joint, but was thinking that maybe it was the inner Cv joint?
View 6 Replies
Serpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 Replies
I recently had a good amount of work done to my Mk4 R32. Last night on my drive home from the stealership I ended up with a passenger headlight out and a very loud clicking/ticking noise which seems to be coming from the Serpentine belt area. After closer inspection it looks like the tensioner lines are't lined up which means my belt and tensioner need to be replaced? I'm not sure, but I have a video and this picture.
View 7 Replies
