MK4 GTi - My check engine light came on a few days ago and when I checked it, it pulled code P0420.
Just this morning, the check engine light went away.
Is this a common issue? Or should I go get it checked just in case?
I have recently had about $1620 worth of work done on my 2000 4Runner because the check engine light came on and the code was P0420.. My invoice says they replaced the exhaust pipe assembly. Now 2 weeks later the light is back on with the same code...are the 02 sensors part of the "exhaust pipe assembly" or are they now going to tell me I need a bunch (2-4) 02 sensors replaced.
View 3 RepliesI bought an 04 elantra a few weeks ago. The check engine light is now on and I get code P0420 listed twice with my code reader. I have replaced the downstream O2 sensor and reset the codes only for them to return again. It is my understanding that this is going to be a convertor problem. My question is that from the research I have done it looks as though this car has two converters. One at the exhaust manifold and then another in the tailpipe. Which one is going to be the most likely causing my Check engine light to come on. Or do I need to replace both converters.
View 5 RepliesMy 2005 Dodge Dokota 4.7L V8 152,000 miles has an intermittent check engine light (CEL) code P0420 ('catalylst efficiency') that turns itself off.
1) 151,000 CEL on, code P0420, checked, cleared at dealer.
2) 151,948 CEL on, code P0420, checked, cleared at dealer (Cat Conv).
3) 152,200 CEL on, code P0420, checked, cleared at local auto parts store.
4) 152,597 CEL on. No checks.
5) 152,815 CEL turned off on its own
6) 152,849 CEL on. No checks.
7) 153,137 CEL turned off on its own.
Twice in this time CEL has came on soon after a fill up from near empty.
Engine runs fine, 18-19 mpg highway.
Have seen numerous on-line reports of other possible causes:
a) base engine problems (coolant or oil) -- coolant temp sensor
b) Air inleakage -- air systems or manifold
c) Lazy front O2 sensor
d) fuel pumps
e) timing or misfire
f) what else? - (gas cap, other...)
What to check first or categories to eliminate?
I was driving along today and my Check Engine light came on. I stopped at the nearest Advance Auto to have them pull the code and it came up with the P0420, Catalyst Efficiency Below Threshold (Bank 1). I asked what could cause this and they mentioned that the fuel that was put in could be causing it. They didn't mention any other possible causes. Any others? I'm thinking it could be the fuel because the last gas station that I stopped at and filled up at is one that I never go to, and maybe just got a bad batch of fuel.
View 14 RepliesI bought my Jetta almost a year ago, and I've been constantly replacing parts. Unfortunately, my engine misfired twice and the CEL has come on for P0420 which is inefficient catalyst. This is the only code being thrown. I've cleared it like 10 times, but it keeps popping up.
View 9 RepliesSo today my CEL came on. I immediately looked at my mileage and I was EXACTLY at 500m past my oil change the other day. I checked the dip stick and lo and behold, it was about 3/4" past the full marker. I took it back to the oil change place and had them drain it down to a good level.
I had driven from NH to NY this week. I filled up my gas tank on my way home from NY. Gas cap was on nice and tight for sure.
The code is still on (not sure how many miles or drive cycles is required) for something to clear. I figured it was perhaps due to too much oil added. I decided a few hours later to take it to AutoZone and grab the diagnostic code. It's a P0420 code (Cat System efficiency below threshold: Air leak in exhaust before rear HO2S, AF Sensor Error, Fuel System Fault, Faulty Catalytic Converter).
My check engine light has been coming on and off and it seems to show P0420 for catalytic converter. The light stays off for about a week and it'll come on for a day or two and off again.
Wouldn't a failed converter stay failed? Can P0420 be triggered by loose/bad gas caps?
Had the check engine light in the 2005 F150 (90,000 miles) come on. Got the code checked and its P0420. I know that has to do with the cat threshold levels etc. so I believe I am looking to replace the o2 sensor, if I am not mistaken.
How hard of a job is this? Ive done a decent amount of engine work and worked in a shop in high school. Just looking to see if that is the right thing to try first, replacing the sensor, before replacing the cat.
Also I know its the right bank, but if I am not mistaken there is a before and after the cat o2 sensor, which do i replace? Both?
Just installed a short Ram intake on my 2000 Vw Jetta 1.8t. Had the Intake for about 250 miles and now the check engine light came on. Just pulled the code p0411 secondary air injection system incorrect flow detected. Is this just cause there is more air going through the MAF sensor?
View 11 RepliesI have a 2000 jetta 1.8t. Check engine light recently came on and the code is a PO1128. I replaced the maf sensor and that did nothing but make the car run worse. I've check for vacuum leaks and found a busted line at the egr valve, fixed the line, reset the code only to have the check engine light come back on with the same code. I am at a loss now.
View 3 RepliesI've been having an issue with my car and the check engine light is on.
The code reads : P0030
Heated oxygen sensor - bank 1 sensor 1
heater control circuit
2001 VW GTI VR6 ....
I have a 2005 1.8 TJetta GLI owned for about 2 months now. Gas cap warning pops up then goes away when I turn off the car then check engine light comes on. I've change the gas cap to new oem one changed the purge valve [URL] .... After a couple of weeks same issues again brought it to my mechanic he ran a leak detector and told me that there are Evap leaks. I read somewhere that I might need a need charcoal canister and a fuel tank.
View 12 RepliesBought a Mk4 1.8T gti last year had only about 75,000 on it and drove it for about 10,000 miles. The check engine light went on about 2 months ago and the code read 3rd gear incorrect ratio. It still rode fine until about a week ago when it started slipping. Brought it to the local transmission guys in my town and got a quote at about $3,000-$3,500 to have the transmission rebuilt. The transmission is a tiptronic automatic 6-speed.
View 1 RepliesI have a 2002 Jetta 1.8t. My check engine light came on and it gave me the code P0135 sensor heater circuit. Bank 1 Sensor 1. We bought a new 02 sensor and replaced it. We definitely bought the right one too. Cleared the codes. After a little driving the CEL came back on with the same code P0135. What is wrong and how I can fix this?
View 6 RepliesI keep getting the error code P0420. Cat below threshold.
I have replace both the front and rear O2 sensors and we reset the check engine light. While driving through the cycles to reset the sensors for them to be ready for DEQ, the check engine light came on again.
I am about ready to buy the Cat Converter, but it is really expensive and if there are any other things that I can try before replacing the Cat I would like to try that first. Any other issues associated with that code, or should I just replace the Cat Converter as my next step.
So I recently bought a GTI and started to fix a couple things. It has a P0420 code so I bought a new downpipe to install. Noticed the stock one was missing 1 of the nuts and the stud had broken off. How get this out? Do I need to remove the turbo? Looks like I do need to remove the turbo to use an extractor set.
View 7 RepliesI just bought a 03 2.0 and ive been trying to fix her back up, she is almost there, just waiting on my first gear getter from diesel geeks and trying to figure out why these codes (p0420 and p0141) keep coming back on. Originally it was just a p0420 code so i took out the upstream sensor and cleaned it, then i took out the backstream and after examining it figured it should be replaced.
I went and bought a new one and replaced it, within the next 2 days the check engine light came back on throwing the original p0420 code along with p0141 this time. So i took out the new down stream 02 sensor and took it back to autozone and they swapped it out with a new one for me free of charge. So i put the newest 02 sensor in and then within 2 days, both codes p0420 & p0141 came back on. Two 02 sensor heating wires being bad i feel is a pretty slim chance. What is possibly the cause for these two codes repeatedly being thrown?
I have a 2003 Toyota Corolla, mileage app. 106,000. Check engine light first came on when driving to destination 40+ miles away (most of my driving is shorter, around-town trips). My mechanic said code is P0420 and so they reset it and said if it comes on again that I need a new cat converter. It did not come on until about 6 weeks later when I was on a longer trip again (had driven about 40-50 miles). Can you tell me if the P0420 code absolutely means that a new cat. conv. is needed or if it could possibly be a sensor or something else hopefully less costly than a new cc?
View 3 RepliesI have a 2001 Honda Odyssey with 90000 miles. Lat last year around Oct/Nov time frame, check engine light came on. I took my vehicle to a local Auto Zone store and they scanned the code and told me it was P0420 - bad catalytic converter.
I replaced the cat converter with an after market model, however after 3/4 months (after driving 2000 to 3000 miles), check engine light came on with the same code. The mechanic changed the cat converter and put a new (after market model). Again after 3/4 months (2000 to 3000 miles) check engine light came on again. And this time the mechanic replaced the cat converter and also oxygen sensor. Now after 4 months or so the check engine light is on the vehicle again.
The mechanic is now saying that the problem is not with the cat converter and he is saying there is a lot of abnormal deposit on the vehicle. When he scanned again he found another issue that read something like "high voltage" and this time the guy thought may be due to short circuit (per code) the fuel injector is sending high volume of fuel and this is causing excessive fuel to go into the cylinder and hence high volume of emission. I replaced the fuse box again and after another 100 miles or, the problem is reappearing.
2001 Jetta 2.0, manual trans
I've been having problems with intermittent P0420 cat below efficiency code. Everything else is fine, no codes, runs great. I tried spacing the post cat sensor back w/ extender bung (after replacing post cat sensor..) and still get the code. I don't hear any rattling or anything to make me think cat is bad physically. I was told by dealer that a code update might resolve for $200 - which got me thinking that that if that was so, it should should be a problem which Feds should be aware.
I searched safercar.gov and found this NHTSA ID Number: 10054864
It's a service bulletin saying that VW made the limits too sensitive and it seems there was a customer satisfaction campaign to update code - pdf on site CSC-10054864-8736
It says:
May 2007
Subject: Emissions Service Action N7
1999-2002 Jetta, Golf and GTI with VR6 Engine
Update Electronic Control Module (ECM) Software for Catalytic Converter Monitoring System Dear Volkswagen Owner: We are writing to inform you of an emissions service action on some 1999-2002 Jetta, Golf and GTI VR6 engine vehicles. Our records show that you are the owner of one of these vehicles.
What Is The Problem? The electronic control module (ECM) software for the catalytic converter monitoring system is too sensitive. This can cause the MIL to come on, and some vehicles may exceed Federal and/or California emissions standards. Also, in some cases this leads to unnecessary catalytic converter replacement. What Will Volkswagen Do? Dealers will update the ECM software.