I got a 2000 vr6 Jetta with a 5 speed manual transmission. When shifting up or down through the gears it doesn't seem to like going into first and second. All the other gears seem fine. I've tried adjusting the shift cables and changing the gear lube, but nothing seems to work. I've heard of the cable bushings going bad and possibly shot motor mounts ( I'm at 135,000 miles).
View 5 RepliesI've got an '02 Jetta GLX with a 09a tiptronic. Last year I had to replace one of the shift solenoids. (Car wouldn't shift out of 1st gear. Now I've got an issue with the car slamming between gears, mostly up shifting. I've ordered the n93 solenoid but I've been reading the post with the symptoms. The job is labor intensive and I really don't want to miss anything. Is there another solenoid I should be replacing.
View 3 RepliesSo I have a 2001 VW Jetta Wolfsburg Edition, love the car. So here's my problem, whenever I am driving for more then 20-30 minutes my shifting between gears begins to become more and more rough, like whenever I shift from 2nd to 3rd, it directs me to first gear instead of 3rd and I have to kinda force it into 3rd. This only happens when I am driving for a long period of time, why this is happening? and sometimes when I put it in reverse I get a loud crunch noise but I get it into gear...
View 1 RepliesGot a 02 Jetta 1.8T 5spd auto tiptronic with 100k miles. Having issues with shifting. Trying to determine if its electronic or mechanical. Had a short in solenoid 10 N283 which melted the TCM. Put in a used N283 to see if the trans is still ok mechanically. Plan is if its ok to put new fluids and solenoid pack. What do the experts think does is need a full rebuild or will new electronics do the job?
After putting the used N283 solenoid the trans works but not correct. The problem is in the shifting only. Feels like its out of time. When you start moving from a stopped position from 1st to 2nd the car takes off good but when changing gears it reves and feels like its slipping then it hits hard into 2nd. Then 2nd-3rd is a fast shift and not hard. 3rd-4th slips and revs a little then changes gears 4th-5th is fine. all down shifts are fine. Does not mater if the car is hot or cold its the same.
If I disconnect the MAF 1st to 2nd shifts fine with no problems. 2nd-3rd little rough but not bad. Problem with disconnected MAF when going in Drive at 30-40mph all of a sudden it jumped into 1st gear and felt like I was slamming on the brakes.
With the MAF connected and I shift manually in tiptronic mode each gear runs real good with no slipping at all. But same problem happens when switching gears. I can drive it smooth if i accelerate to 3000 rpm and then left off the gas a little and it shifts fine.. Same with the other gears.
I got a used TCM to rule that out and the problem is close to the same. It tries to shift at lower rpm but still does about the same problem. I did recently had a MAF go out. Put in a new bosch and no change. Did my VCDS scan and only codes I get is "17840 secondary air". I can get operational data on some solenoids but not sure what parameters to look for.
I have a 2005 2.5 vw jetta.
It has 150,000 miles....the cars been working just fine untill DEC of last year. I had the dealer check the transmission fluid and they said it was low....so they flushed and refilled the transmission oil...they didnt see any metal but that didnt fix the problem.....
Now i have the car not shifting correctly ....theres a delay when shifting in all gears but it is intermittent, sometimes it shifts hard and sometimes you can just baby the throttle and it wont shift as hard.....once on the freeway the car runs fine......but when coming to a stop you can feel the downshifting.....
I figured it has something to do with the valve body....my concern is the dealerships have quoted me 2000$ to replace the valve-body....the cars paid for and was wondering if i should just move onto a different jetta or fix this one?
If i fix the valve body will this jetta have the same issue later? Also i do have the vacuum pump leaking engine oil....not much can this be fixed while doing the valve body job???
Stage 2 clutch with a diesel geek short shifter. I have started noticing shifting from 2nd to 3rd is difficult. Sometimes it will go into 5th when shifting up from 2nd. Not a lot of resistance but it is more than noticeable. How do I resolve this issue? Am I hurting my clutch if I keep driving like this? Nothing is grinding at all in between shifts.
View 2 RepliesWhen shifting gears, mainly in 1st, 2nd, and 3rd while the air conditioner is on I'm experiencing jerking / clunking. When I shift it's not a smooth movement and produces a thump. The only way to really avoid this is by letting the clutch out very very slowly. It only happens when the A/C is turned on. Shifting is perfect when the A/C is off.
View 6 RepliesSo I took delivery of my ordered PP GTI about three weeks ago, When driving under light throttle, when upshifting or downshifting amongst the first four gears, the car makes a whining/ humming noise from about 1700 to 2300RPM. I lifted the front end of the car to check things out and noticed that the left axle makes some weird sounds. I'm hoping it's a bad CV, issue with transmission (not clutch related)?
View 2 RepliesLately when shifting gears, there's this clunking noise as I let off the clutch. It happens more often than not when I'm in traffic and I upshift without giving any gas on the clutch release. Currently got 13k km on my car.
View 1 RepliesOkay, my shifter rod got spun, and now it doesn't want to go into any gears. Just freely kinda swirls, and you can't push down. The guy working on the car wants to pull the shift box down and see what is going on. He thinks the shift cable or selector cable is broke.
View 5 RepliesMKIV jetta GLI, first two gears just won't engages as if it's still in neutral. Have to start her moving from 3rd. What could be the issue?
View 14 RepliesI just changed the clutch on my jetta and my car is in gear I don't know how to adjust the gears
View 24 RepliesI own a 2000 Jetta auto with 200k on it. I have the same problem. It wouldn't change gears till 4000 rpm i scanned it. And got the cods g38 and g68. So I changed both. It was working fine then again same thing it works then stop works. So scanned it again and got same codes changed them again worked fine then stopped working so I took it to vw and they told me same thing same sensors and the wire harness so I changed them again got the parts from VW this time. It was working then stopped. And when I turn on the car and drive my gear box display goes all black for at least 10 min driving then goes back to normal. But sill doesn't change gears. Now not even after 4000 rpm. Ps. When I do it manual 1st gear 2 and changes fine once I put it on drive doesn't not change gears.
View 7 RepliesMy 03 Gli 24v manual transmission has been acting up lately. First it started to get a little difficult to shift into gears about a week ago. Then tonight i was driving through a parking lot in 2nd, and after i came to a stop i tried to put it back in to first and it would not go into gear. As i was trying to get it into 1st i could tell it was grabbing a little bit and the car was inching forward.
I got it to a parking spot and starting reading about other peoples issues, one i read said they were able to get it to move after pumping the clutch some. After trying that i was able to get it into gear and drive it to my parents. Looked at my brake fluid and its full. Took it for a test drive around the neighborhood and it was shifting fine at first then started getting a little difficult to shift again. I tried taking off in 6th and it stalled. I tried going from 1st around 3k-4k rmps to 6th and it was still driving with very little lugging. My clutch feels and is still stiff, not loose at all. I do have to go all the way to the floor with the clutch before im able to shift
Finally to my questions. Could my clutch be going bad? Could my cables need adjusting? Something I read about a pressure plate maybe?
1.9 tdi tiptronic
Diving along at 40mph, rpm's jump up so i let off the gas, get back in it and grabs for just a few seconds then acts like its in neutral. i put it in neutral and then back in drive. nothing, so i coast to the side of the road. get a tow back to my work. runs fine cel is on and all of the gears are lit up, as opposed to normally just the one your in lights up on the dash, reverse works normally and pulls well. Whats up with it.
Auto tiptronic, has no forward gears(acts like its in neutral). reverse works fine and pulls ok ...
So I have a 2.0 automatic golf GLS. Its the last of the MK4's but a 2005 model. So this is what's going on. When I drive the car for awhile the transmission (I'm assuming gets hot )& Im at a stop & start from 0 the car struggles to change gears. The rpms go way up into 5k sometimes 6 just to go to second gear, And then so forth. This only happens when I drive around for awhile. My dad just flushed the transmission fluid after my car refused to change gears. It was stuck in a high gear from my assumption & it was always a lot of work for the car to build up speed. What's going on with my tranny? Is it the solenoids? Valve body? TCM? Car is at 104k miles btw
View 8 RepliesI have a 2004 jetta gls wagon with a 1.8t. the car ran just fine and had a tune running 16psi strong. I changed the battery in it and now the car wont boost, bogs out and SLAMS hard from gear to gear ( auto 5 speed ). I don't have vag com. I just need to get the car to drive with out it. Even if i get back to factory tune im ok with it.
View 8 Replies I have a golf mk4 1.8T AGU, about one week after i had my k04-023 turbo on and all the Stuff that comes along it started "stall" (don't know if its the right word??) in the High gears, most 5th gear but it first start doing it when i hit boost (3000rpm)
I runs on Stock n75 valve.. I though i could be a boost problem, maybe the Stock system cant handle it? I did install a boost gauge to see if it was the was the problem, and it dont Seem like it. In first it runs from 1.4 bar and drops to 1.2. Same in second and third. But in 4 and 5th it goes to 1.7 bar and drops to 1.4.. I did wonder it maybe the n75 valve cant handle 1.7 bar??
I bought a 2004 2.0 Golf a few months ago and I've been noticing a strange squealing sound.
1. It happens when sitting in neutral or with clutch in for a while (red lights, etc) and when letting the clutch out and giving it some gas in first gear or reverse
2. Lasts only about a second, between 1000-1400 rpm maybe?
3. Never happens between any other shifts, and doesn't seem to happen if I really hit the gas/let clutch out very fast or shift quickly
4. Electrical load, engine hot or cold, A/C on or off, turning wheel all seem to be independent of the noise. Sometimes it happens, sometimes it doesn't regardless of these.
5. I've put a few thousand miles on it since I bought it, doesn't seem to be getting any better or worse.
6. Sounds kind of like a pulley/belt squeal, but I'm afraid it could be a throw out bearing or pilot bearing?
I found a lot of references to the clutch pulley on the alternator seizing on mkivs so on a whim I bought a new belt and clutch pulley, but when I went to change them I noticed that my alternator doesn't have a clutch pulley on it. It's the OEM 90A Bosch alternator.
The car has about 135k miles on it but unfortunately I just bought it so I don't have much of a history.
1. Any thoughts on the noise?
2. Should my alternator even have a clutch pulley?
3. I put on a new Goodyear serpentine belt because I thought maybe the old belt was slipping or something (it was in rough shape) but the noise doesn't seem to have changed.
Just as a troubleshooting method, I'm thinking of taking the serpentine belt off completely and trying to replicate the noise in a parking lot, just for a few minutes when the engine is cold.
I have a 2001 vr6 Jetta automatic transmission. When I shift my car from park into to reverse or drive the whole car jerks as if it's banging into gears. But while driving it drives normal. When I stop and accelerate I feel the same jerking you would say.
View 5 RepliesSo I changed transmission fluid on my 1.8t GLS because I was having difficulty shifting out of gears on cold starts. It seemed to work fine for a few days and now I'm back to square one, it still doesn't want to shift correctly!
View 14 Replies