Golf IV / Jetta IV :: VR6 5 Speed - Clanking Noise When Letting Clutch Out In Gear
Aug 30, 2016
The car runs fine clutch has pressure and everything. I can idle with the clutch pressed down and put into reverse and every gear BUT if I put it in a gear and start to let the clutch out I can hear a clanking or something flying around in there and it doesn't really want to go anywhere and I don't want to really let the clutch all the way out in gear or let it out for too long and screw anything else up worse..
View 2 Replies
Advertisement
Sometimes when I shift from first to second and second to third I hear a clanking noise coming from under the car. It happens when I move the stick and clutch pedal is fully depressed. Doesn't happen all the time and doesn't happen in gears 4-6. Something I should be worried about? Car is stock and has about 1k miles. It's been doing this since I bought it.
Also get a deeper boom noise coming from back sometimes when depressing clutch petal when under boost. Think this is normal tho? My BMW used to do the same thing.
View 11 Replies
MK7 with 15k miles... This morning on my commute into work, I started having some clutch issues. When I would try to go into 2nd gear from 1st at any speed, it would grind when I would let out the clutch pedal. It was like it didn't fully engage and if I pushed the pedal back in and tried to get it in 2nd, it would grind. All other gears were fine. I don't drive the car hard so I don't think I torched the clutch.
Synchros? Shift Alignment if these models have that? Pressure Plate?
View 14 Replies
Normally I'm pretty good about searching and finding info, but there doesn't seem to be a lot out there for these trannys. In any case, when I hopped in my 20th to move it today, I got this grinding noise when letting out the clutch. The car won't go move in reverse or any of the forward gears. Idles fine, sounds fine when in neutral or when the clutch is depressed. It just grinds when you let the clutch out. Seems like I can select each gear OK. Linkage feels normal.
View 2 Replies
I drive a 24v vr6 GTI in 6-speed I was coming home and as I turned and got on the gas a little and all of a sudden there was a pop and my car couldn't go in gear when I release the clutch. Luckily I was close to home and basically cruised in neutral. I jacked it up and found that my axle is twisted. Now I was aware the boots were torn before so I'm assuming the axle got screwed up but my other concern is, why won't my car go in gear? Here's the photo of inner CV. I'm hoping it's just an axle and not the clutch.
View 8 Replies
This morning my cars battery was dead and when I tried to pop the clutch to start it it went into gear but nothing turned on. When jump starting the car it turned on I drove it for a little while and was idling when it shut back off (battery was dead again). I came back to the car in a couple minutes, tried to start it and it started right up. I'm not sure what to think of this.
View 4 Replies
I installed a new clutch, pressure plate, and flywheel at 154,000 and I'm now just over 155,000. I drove it very conservatively for at least 1,000 miles, and had no issues whatsoever.
Now, after sitting for a day, starting off in first gear, I'll get some clutch chatter. Outside of first starting out in 1st, every other gear is solid. And the 1st gear chatter tends to get better as the car is driven longer.
Secondly, it happened today, I'm getting what I thought I experienced before as clutch slippage in 5th gear: I'll lose acceleration as if the clutch is slipping, but the revs won't spike even if I tap the throttle. If I come off for a second and go back on, everything is fine. It doesn't make sense that's it's slipping as it's brand news.
It also seems to happen when it's been rainy or wet, but that could be all in my head.
View 1 Replies
I picked up a 2004 GTI not long ago for pretty cheap because it had a few issues. I am working my way through them. However, having 3rd gear issue.
All other gears are perfectly fine but there is way less play in the shifter in the 3rd gear position and I have to hold the shifter in position until the clutch is engaged (pedal up) to avoid the gear grinding. Once the clutch is engaged it stays in 3rd gear fine. It doesn't matter if I am moving from 2nd to 3rd or 4th to 3rd. Same deal. I have aligned the shifter several times using to proper procedures with no effect.
It never grinds 3rd with the clutch disengaged (so the synchro is fine?) and it will bang shift no problem. Oh and the clutch is less than a year old. It was installed by a shop before I bought the car. It's not really a big deal, but I would like to fix it. If I have to swap the trans that's fine, but need to figure out if it is a trans or linkage issue first.
View 1 Replies
I have a 1.8 Jetta and I realized yesterday that my first gear won't turn on what could be the problem..
View 5 Replies
2004 Jetta 1.8T w/5 speed manual transmission. Bought the car this way, mostly for a parts car, but everything else runs and drives good, so if it wasn't for this issue it would be a decent driver.
Won't/can't select first gear. Seems like there is no "spot" for first, or that the shift mechanism has no where to go., locked out. All the rest of the gear selections work perfectly. Tried the cable adjust ritual, but it was fine-as I suspected. The shift assembly works/moves perfectly from the tranny end and the shift lever end. Not a synchro, it won't go in stopped, moving, running or shut off.
So, what's the probable best guess or best way to come to a diagnosis? Shift tower parts broken somewhere, or something like a shifting fork bent broken? Seems like if it was internal there would be other gear selections that would be affected. Any links to some diagrams?
View 7 Replies
With 8 speed tranny has the clanking/clunking noise when shifting to P? When I park my car and shift from R to P there is a clanking/clunking noise and I feel small vibration on shifter itself when the noise occurs. It happens all the time and the noise loud enough. Is that normal? Up to this moment I thought it is normal (it still very well maybe) until I drove my friends Audi that does not have any noises when playing with the shifter. My Audi did not have that either.
View 2 Replies
98 Jetta TDI hydraulic system ... We just received this vehicle from my mother in law, who is not driving any more. It's a cream puff--79,000 miles, beautiful condition. Problem is the clutch engages lower and lower to the floor, and eventually the shifter gets stuck in gear. The brake pedal slowly sinks to the floor when at stops on hills. Our mechanic tells us these two are connected because both the clutch and brake run off the same hydraulic system.
1st time he said the fluid was filthy, and he emptied the system and put in clean fluid. Worked for a little while and then we were back where we started. Second time he replaced a couple parts on the clutch, replaced this fluid, and this time it ran like a dream for a little over a month. Then the problem just returned. Again he says the fluid is filthy, and now we are looking at replacing the master cylinder and again changing the fluid. The theory behind why this is happening is that my mother in law let the car sit for half a year before passing it on to us. She didn't do much driving the 6 months before that either. I've done research, and this doesn't appear to be a common problem by any means on these cars.
View 2 Replies
Recently I switched from Revo software with 440cc injectors to Unitronic with Siemens 630cc injectors. After swapping, the car has developed a hesitation issue. It only happens when driving a consistent speed in one gear, for example going 45 in 5th, the car will feel jumpy and hesitate to accelerate with a seeming loss of power. Replaced spark plugs with new ones and the problem still persists. Problem never happened with old software and injectors.
View 2 Replies
It's a 2003 Ford F-150. When I'm driving slow I hear what sounds like a tin can clanking up against another piece of metal, coming from the rear end. Right, Left, or center I'm not sure. U-joint maybe?
There is also a bit of wobbling when I'm braking at a high rate of speed.
View 5 Replies
My GTI has started to bog out, i guess is the best way to describe... As I am trying to accelerate on the highway my RPMs rev up to 5000 till I get any response to amount of gas I am giving. It will dramatically drop to 3000 without letting off the gas. then gradually will accelerate, untypical to way it use to perform. She respond this way cold or hot.
View 7 Replies
My girlfriend's 2005 Jetta 2.0 overheated and then broke down after making some pretty awful clanking noises. Now it will not start. I'm going to be doing the repairs myself (and learning a lot along the way).
The car will not start. When I try to start it, it makes a 'whining' noise, which I'm assuming is the starter. This is not the first repair I've done on her car. She wants to get rid of it, but now that I've done so much work on it, I've grown a bit attached to it. Plus I think I can save her a bunch of money in the long run If I fix this myself. Here's where I am so far:
I removed the cover over the camshaft pulley and had a look while my SO turned the key to try to start the car. I noticed a couple things:
1. There are no teeth on the timing belt.
2. The camshaft pulley still turns, but not continuously. It turns a little then stops, and then tries again. (Engine not seized?)
I have ordered a code reader which should be here in a couple days. With that I'm hoping to check if there's a compression problem. If so, I'm under the impression that that would indicate a blown head gasket, or bent valves. I checked the oil to see if it looks milky and It still looks like regular oil.
View 3 Replies
I have a 03 golf 2.0 with 82k on it. I am having a really weird issue with car pulling left under load and then going back to the right when letting off the gas. It's more noticeable at higher speeds....over 40mph or so. I did a quick check under the car at ball joints, cv joints and can't really see anything that would make this issue. Would a trans mount or motor mount cause this? Is there something I am missing?
View 2 Replies
Currently driving a GTI mk7 autobahn 6MT, this is my first manual transmission i have owned.. and have a question about a squeak like noise i hear when the clutch engages in gear 2 and 3.
This does not happen all the time, however i noticed that some / most of the time when i slowly let the clutch out in gear 2 and 3, right after the clutch engages and i let it out the rest of the way, it makes a squeak kinda sound.. almost like springs contract / retracting, i can also slightly feel it in the pedal.
Question is ...is this some what normal? i have never owned a MT car, and cant remember if such a thing happened while driving friends / family MT in the past..
View 4 Replies
So far from reading up here is my list:
1) Water pump.
Its not leaking or making noise at this time.
2) Clutch clicking at initial travel.
Noticed this on the first couple miles.
3) Smelly A/C.
This is ongoing
4) Wind noise from doors at highway speed.
Noticed this also
5) Wastegate rattle
Don't hear any rattle, or I am not narrowing down the sound when it happens.
Anything else I should add?
View 4 Replies
I have a 2013 golf r and I usually shift gear at 3 rpm when driving normal but for some reason it doesn't feel right, I can hear the clutch making a weird noise whenever changing gear at a low rpm, it feels so much smoother when shifting above 4 rpm but I dont always wanna punch it so hard especially when there's always traffic from where I live. Any advice on a smoother shift at a low rpm.
View 22 Replies
2000 GTI
260,000 miles (60% highway)
2.0L 4cylinder AEG
All stock.
I have a new issue developing on the clutch of my car. When I fully press the clutch pedal to change gear, I hear cacophony of grinding, hissing and whirring noise, probably coming from gearbox. When I take my foot off of the clutch pedal completely, the noise is gone. half clutch has reduced amount of these noises. I had this symptom briefly one night two weeks ago and when I topped up oil, this was gone. Tonight, it is back.
View 10 Replies
