I'm upgrading my head lights and added a euro switch. I need to splice into some wires. I want it to look clean and waterproof. I'm looking into t taps or a quick splicing terminals that go directly over the wire when closed it splices into wire leaving male end to hook the new wire up too.
View 4 RepliesSo I have a 12v vr6 jetta and I really want a better exhaust with a nice clean and loud growl. My friend has a mk5 with a full Apr exhaust that sounds absolutely amazing and I want it to sound like that and I am willing to change my rear valance to the later mk4 jetta style if needed.
View 3 RepliesAfter a bit of a crunch to the underside, i've noticed some circular metal covering broke back and some wires are torn and exposed just behind the front passenger wheel on the bottom.
View 5 RepliesSome how my aux water pump wires got ripped out and I'm not sure if they shorted out. I pig tailed the wires on the pump and ran the car up to temp and turned car off and pump was not running. If the wires did or can short out what would I look for to replace (ie fuse, relay). Also I'm not sure which wire goes to what pin as the plug got ripped off. Wires are black red, and brown black.
View 2 Replies2001 MK4 GTI VR6 put brand new coil pack, wires and plugs in the car because it was misfiring. Was fine for about a week than I got a clogged cat code and could feel the affects. I now have no cat, no resonator, and no muffler. The car is finally driving good and then the check engine light came back. It says only a misfire in Cylinder #3 and when accelerate hard to speed up my check engine light starts to blink until I stop accelerating hard. So my guess is the clogged cat caused that cylinder to misfire but I do not know the actual solution to this. My EVAP hose is semi-pinched and when u squeeze it you can almost kill the engine. The weirdest thing of all is this: driving normal I shift in between 2000 and 3000 RPM and once i get into 4th gear about 2000 RPM......my car starts shaking badly and i feel like my engine is going to fall out. I have searched and the only thing i can think of is a bad injector...
View 3 RepliesI have a 2001 jetta mk4 and I was thinking about getting some halo lights for it. But then I thought it would be useless because the headlights are always on regardless. So is it normal for the headlights to be on all the time? And if it is, is there a way to bypass the headlights so if I did,get halo lights, only the halos would light up?
View 5 Replies My car is a 2.0 AEG manual for reference.
So, my alternator died last night and when I changed it this morning, I fired her up and now when I turn my light switch one click I can see my high beam light illuminated on the dash. If I have the switch on any setting, it's illuminated but no lights are on out front except the dtr lights. Turn signals work fine and so do the brake/tail lights. I checked the fuses for both low/high beams but they were fine. I saw someone mention an ignition switch while I was searching but I'd rather get other opinions whether it is that or not.
Edit: My original test drive the car ran fine minus the headlight issue. But upon driving it through the city when I was coming to a stop at a redlight the battery light came back on and it died. It fired right back up and barely made it across the street to a parking lot before it died again. It'll fire up but won't stay on. On my way to an parts store for charging system check.
05' TDI Jetta. The headlights will not turn on. The DRL's will work. I changed the dimmer switch, and put in a Euro switch to try and fix it. But the only thing I get when I turn on the headlights are the running lights. All the running lights and interior (dash) lights work fine. I checked the fuses and pulled the 173 relay (to kill the DRL's).
View 7 RepliesSo I was driving today when suddenly my headlights went out so I put my highbeams on and note...they were obviously working...but when I pulled parked the car they went off also and now nothing works; neither high beams or headlights. Also, the rear running lights and both turn signals work on the front and back. I checked the fuses and none were blow.
View 3 RepliesThe warning buzzer to indicate the lights are on when the car is off is not working. I assume there is a switch in the key ignition. Is that the likely part to fail?
View 4 RepliesI seem to have a problem with my jetta. It's the 1.8t. When I turn the turn signal on, I can see the dash and headlights dim. Also when I tried putting both windows up at the same time, the car seemed to short out and almost shut off. It reset the time and trip mileage when it did so.
View 1 RepliesI recently have been running into some problems with my 03 jetta 2.0. Last night as I was driving home my radio start to turn off followed by ABS, airbag and battery lights coming on and then lights on the dashboard were dimming followed by headlights going out for a few secs then returning on but dim. I stopped in my drive way to open door and when I tried to press the accelerator, my car completely died.
Over the past 2 weeks or so I have had to change the fuel pump and the alternator because i thought that was the problem. I noticed when i first had problems the fuel pump wasn't charging so i changed that. then days later my car started to completely die when I tried to start it(not turning over, no lights no nothing). i tried a new battery it would still die. So I installed a new alternator. My car worked fine for about a week-week and a half before last night.
I'm reaching out to see if any other MQB platform owners who had DCC/Magride are experiencing suspension errors after upgrading to coilovers while employing a delete kit. Some of us S3 owners have been running into this issue after such an upgrade and using this kit by KW. I can throw a suspension error on demand in my S3 by taking a turn/curve at 40mph+ (highway on/off ramps work perfectly for this). A bumpy road or hard braking can also cause an error to be thrown.
Aside from the error being annoying sounding and looking it also re-enabled traction control. You cannot turn traction control back off until you've power cycled the car. This is a pretty annoying side effect that could also be pretty dangerous under the right circumstances. KW seems to think their kit is operating correctly and that the height sensors are out of range due to lowering the car. Currently there's no way to adjust where the height sensors sit so in my personal opinion this seems like a massive oversight on KWs part and their product is not working correctly.
Due to a leaking shock.. I looking to upgrade the suspension. I am in between wanting to bag it or go coilovers. If I go coilovers I think ill go with the KW v3 if I bag it I am not sure whether to go with bagyard or the air ride from the ecs site.
View 2 RepliesI read posts here about the shimmy/wobble some owners are experiencing with their GTIs and TSIs. I never had it for 10,000 miles on my Golf Sport TSI with standard triptronic. The dealer said they were upgrading my transmission software when I had my free oil change. Now it does wobble and it is very irritating. Does this affect both DSG and Triptronic vehicles? If so, I am prone to believe that the problem lies elsewhere. What do you think?
View 8 RepliesI'm trying to adjust the headlights on my Jetta wagon. I know the basic way to go about doing that theoretically, but how to actually adjust the headlights? Are there screws or something somewhere? I also thought I read somewhere that the car automatically adjusts the headlights slightly as your driving? How do I account for that?
View 4 RepliesSo recently my water pump failed so i did the pump, timing belt, and thermostat. While putting the alternator back in a may have broken a few fins on the alt. case. Anyways I was ripping it a bit today only a day after stuff done and the battery light came on. The car is warmed up and the idle drop a few hundred rpm and then back up. The headlights dim as well. and come back up with rpm. Even when I hod the pedal steady at 2k rpm itll still dip and come back up...thinking its an alt but is that really a symptom of a bad alt? I was also thinking I didn't tighten the alt bolt down alt the way or fuses or something so checking that but I am almost positive it's all tight down.
View 9 RepliesI'm looking for pictures of the front xenon headlights with white direction indicators and the way how to do this modification .
As the picture below......
Also...doom lighting does not turn on with driver door open...all other doors, yes. Lastly, cannot reset trip meter.
View 1 RepliesSo I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
2000 Jetta GLS, 2.0, Standard Trans............ Need to solve either of these issues??? I am newer to the VW family and unfamiliar with their designs/technology.
View 5 Replies