Golf IV / Jetta IV :: Timing Belt Tensioner Came Out?
Oct 20, 2014
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies
Advertisement
I recently had a good amount of work done to my Mk4 R32. Last night on my drive home from the stealership I ended up with a passenger headlight out and a very loud clicking/ticking noise which seems to be coming from the Serpentine belt area. After closer inspection it looks like the tensioner lines are't lined up which means my belt and tensioner need to be replaced? I'm not sure, but I have a video and this picture.
View 7 Replies
Alright so MK4 vr6 AFP engine. I did the timing chans when I bought the car around 175-180K. Car now has 224K miles on it. A few days ago I started hearing the chains slapping around. Because I didn't want to call it a broken guide just yet for tor the hell of it I took the upper chain tensioner bold out dunked it in oil and pumped it up till it was hard again. Put it back in and drove the car about 130 miles straight. I didn't hear them making any kind if noise. The next day I drove it about 30 miles still no noise. Later in the evening I whent to get gas when I pull in the drive way I noticed they were rattling around again. So the next day I drive it back home (130 miles) and noticed they were even louder especially around 1500-200 rpm.
So I took the tensioner back out and dunked and pumped it up again. It didn't do anything this time chains are still loud. But I noticed when I was pumping the tensioner in thr oil both times the air bubbles weren't coming out of the bleeder hole they were coming from the end around the piston. When I did the chains the first time I got everything from Germanautoparts.com. and I notice that the tensioner they sell isn't genuine vw part the only place I found the actual vw pary is ecs tuning and the stealership. Is it possible I just have a defective tensioner? I really want to get to the bottom of this before I go and pull the motor and find that nothing is broken. Should I just buy the oem tensioner and see if it fixes it first?
View 14 Replies
I am deep into replacing the timing belt on my 08 Elantra 2.0, and am nervous about taking the tensioner off since it is not obvious how to set it. I could use a fool proof explanation on how to set the tensioner.
The Haynes manual talks about 1/4 deflection but that seems too imprecise.
I can not see the marks in the video : DIY 2008 Elantra timing belt video 2 of 2 - YouTube
And this post 2008 Elantra Timing Belt does not quite seem to explain. I am contemplating putting it all back together, just changing the accessory belts and handing it to a shop. I could use a fool proof explanation on how to set the tensioner.
View 7 Replies
I recently bought a 97 960. i have had a s90 before in totaled it i loved the car so much i found another. i was driving and broke the timing belt tensioner which in turn lead to the breaking of 5 exhaust valves that i know of. I've taken off the head and noticed that one of the bottom of the valves had melted onto the number 5 piston head.
I called around and search but every motor is at least 1000 and i have been told anywhere from 3500-4500 to rebuild. My question would b is there an easy way to fix or should i junk it. i bought it for a 1000 it has only 140000 on it an its in almost great condition. I attached some pictures of the head and piston so u can see the damage.
Attached File(s)
2012_04_07_19.02.39.jpg ( 1.45MB )
2012_04_10_16.45.26__1_.jpg ( 1.43MB )
View 1 Replies
Six months ago my 2005 Honda Pilot got a new timing belt that was incorrectly calibrated. When the Honda Dealer test drove the car, they damaged the values. They fixed the valve damage and gave me a discount on the timing belt. I considered selling the car, but decided to keep it.
Now it's six months later. When driving I hear a "clicking noise". The dealer says that the timing belt tensioner needs to be replaced and that it would be dangerous to drive it at high speed as it is now. The clicking is caused by a worn ??? tensioner.
They claim that the incorrectly calibrated timing belt could not have caused this problem with the tensioner.
View 5 Replies
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies
I plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 Replies
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies
I recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 Replies
2.0L 8v ....So what's my chances the valves stayed clear of the pistons?
Driving 70mph 5the gear and cruise control set. Motor just died and I pulled off.
Cars back home in the garage. Iv ordered the ecs tuning timing belt kit.
This was a belt I installed 50k miles ago, shouldn't have gotten a auto parts store belt, or maybe it was my install, but I deff didn't think the belt was going to fail that early. Is there much of a difference between different brand belts and OEM?
View 22 Replies
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
View 9 Replies
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 Replies
What to do if your timing chain tensioner fails and wipes out the valvetrain. Go to www.vwusa.com and click the contact us page. Find the link for "online chat" and open a dialog with a vw rep. Have the vin, milage, purchase date info handy and tell them what happend.
Maybe I just got lucky, but I thought my (second owner) 2012 GTI with 46000 mi was toast, the rep (Bill H) told me not to worry and set me up with a case number and the location of a dearship that will confirm the damage and replace my engine.
My experience is in direct opposition of what I have read on forums when people take their GTI's to the dealership first, then after hagling with the stealership managers for weeks on end finally end up emailing vw corporate (which takes weeks to respond) and finally having the issue resolved.
Of couse, this is only if your car has not had the warranty run out. I thought that being the second owner voided the powertrain warranty...again that was false.
View 2 Replies
I hear it's a problem on the Mk VI. Is there anything you can do or upgrade to eliminate the problem ... especially considering that it goes out of warranty after 5 years.
View 12 Replies
So my mk6 developed what initially sounded initially like a bad serpentine belt tensioner. Only under anything more than load, and sounded like a bird chattering under the hood. Got outside today, fired car up, watched tensioner and it sat there steady as a rail. The noise is coming from the opposite side of the engine. Not really mechanical/metallic at all and tracks under load with the RPMs. Why i initially thought what i did. Not I'm sort of baffled.
View 3 Replies
My ball bearing on the tensioner seized and broke the belt. Does that happen all the time?? My car is a CP and right now it's only 36k miles..
View 24 Replies
I drive a car I am extremely reliant on. I don't have money to buy a new one and I may be a bit over protective of this car. It is in excellent shape, I bought it with 96K and whoever owned it took good care of it. I changed the battery pretty much right away, and the auto parts store guy said it looked like it was the original battery. So I suspect the timing belt is original too, (along with the clutch, which works great BTW). I don't know anything about cars short of what I have heard on CT, but it seems there is a trend towards having to change the timing belt at 80-90K And I know that a worn out timing belt can have no symptoms and essentially ruin your car if it breaks.
I took my car for the blue plate special, and it has been to the dealer a couple of times for some repairs where they also do the general service and see if they can find something to charge me for and in all cases, my car had nothing they would identify and repair. Fluids are good air filters are good etc. When I took it to the little shop on the corner I got the same report, and when I picked it up I asked, well how does the timing belt look? And he said. I can't tell you, you would have to take it apart to find out. So my questions are, as I do not know if the timing belt has been changed by previous owners. should I just go for it and have someone change the timing belt as part of my regular maintenance plan now, or is there some nifty way to find out if it needs changing without having to spend an arm and a leg?
View 9 Replies
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
View 4 Replies
Does VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.
View 22 Replies
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies
