Golf IV / Jetta IV :: Timing Belt Squeak Only Seems To Occur When In Motion And Let Off The Accelerator?
Jul 27, 2014
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
View 9 Replies
Advertisement
So I was trying to track down this squeak noise and I removed the drivers side seat belt but now the belt will not retract? It's stuck like this, is there a manual release? Buying another one is not a option right now. And I have to drive the car tomorrow morning.
View 1 Replies
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies
I plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 Replies
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies
I recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 Replies
2.0L 8v ....So what's my chances the valves stayed clear of the pistons?
Driving 70mph 5the gear and cruise control set. Motor just died and I pulled off.
Cars back home in the garage. Iv ordered the ecs tuning timing belt kit.
This was a belt I installed 50k miles ago, shouldn't have gotten a auto parts store belt, or maybe it was my install, but I deff didn't think the belt was going to fail that early. Is there much of a difference between different brand belts and OEM?
View 22 Replies
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 Replies
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
View 9 Replies
In a few weeks I will be bringing my new to me Ranger back to the great state of Texas. The truck however, has a squeak when running, which I think has been concluded as the idler pulley for the timing belt. Well, I'm nowhere near the truck still and in order for it to get here it will need to be driven half a day to reach me, at which point I could do all the work it needs done.
My question is: Should I take the risk and have it driven here before the belt change (I did look at it while I was out there and it's already cracking pretty good), or should I go ahead and have someone get the belt done at a shop? It's less the belt that concerns me I think, and more the pulley, even though it's just started squeaking in the last 1000 mile.
View 10 Replies
I drive a car I am extremely reliant on. I don't have money to buy a new one and I may be a bit over protective of this car. It is in excellent shape, I bought it with 96K and whoever owned it took good care of it. I changed the battery pretty much right away, and the auto parts store guy said it looked like it was the original battery. So I suspect the timing belt is original too, (along with the clutch, which works great BTW). I don't know anything about cars short of what I have heard on CT, but it seems there is a trend towards having to change the timing belt at 80-90K And I know that a worn out timing belt can have no symptoms and essentially ruin your car if it breaks.
I took my car for the blue plate special, and it has been to the dealer a couple of times for some repairs where they also do the general service and see if they can find something to charge me for and in all cases, my car had nothing they would identify and repair. Fluids are good air filters are good etc. When I took it to the little shop on the corner I got the same report, and when I picked it up I asked, well how does the timing belt look? And he said. I can't tell you, you would have to take it apart to find out. So my questions are, as I do not know if the timing belt has been changed by previous owners. should I just go for it and have someone change the timing belt as part of my regular maintenance plan now, or is there some nifty way to find out if it needs changing without having to spend an arm and a leg?
View 9 Replies
I have a 2000 Jetta VR6 12v. I'm having an issue with backfiring. Also, I am having a severe issue with bucking. Sometimes it will not happen at all, and when it does happen it can occur from 2300-5500 RPMs. No matter how hard or soft I am on the throttle, it will hit this point, different everytime, and the throttle will cut out, then pick up, then cut out, then pick up.
Now, I know my MAF is throwing a few codes. But it was throwing codes for a month before this started, maybe longer,and the only symptoms were backfiring and a little lag at startup. However, the same night my issue began, I also developed a coolant leak. Upon inspection, the coolant leak path was traveling directly over my CKP sensor where it connects to the engine block, which also began throwing a code. The car starts fine, idles fine, and never stalls or dies. So my options here are replace the MAF if that seems likely to be the issue, or to attempt using liquid electrical tape to prevent the leak from hitting my CKP sensor.
View 17 Replies
Does VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.
View 22 Replies
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies
Looking for info if the R32 has a timing belt or is it a chain and at how many kilometers shows it be changed.
View 5 Replies
So my mk6 developed what initially sounded initially like a bad serpentine belt tensioner. Only under anything more than load, and sounded like a bird chattering under the hood. Got outside today, fired car up, watched tensioner and it sat there steady as a rail. The noise is coming from the opposite side of the engine. Not really mechanical/metallic at all and tracks under load with the RPMs. Why i initially thought what i did. Not I'm sort of baffled.
View 3 Replies
So I was getting my car flashed to stage 1 at a dealership here in the Chicago suburbs and there was CSG R in there with the timing belt shredded. Turns out water pump came apart, shreded the timing belt, and apparently the pistons smashed the valves. I got a call from my friend whos a mechanic and said another one is getting towed there today with the same issue. Both have between 2k and 3k miles on them.
View 24 Replies
Serpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 Replies
I recently had a good amount of work done to my Mk4 R32. Last night on my drive home from the stealership I ended up with a passenger headlight out and a very loud clicking/ticking noise which seems to be coming from the Serpentine belt area. After closer inspection it looks like the tensioner lines are't lined up which means my belt and tensioner need to be replaced? I'm not sure, but I have a video and this picture.
View 7 Replies
I've got my sister's 1995 Dodge Neon with the 2.0L SOHC. While driving it recently I heard a horrible squeaking noise then a ZZZZZZzzzzzz sound. I immediately pulled over. The check engine light came on, and I shut the car off. Coolant was all over the place leading me to believe the water pump failed. I had it towed to my house, and now I will have it towed to the shop to get fixed. I would like to have them repair the timing belt and water pump. However, I am afraid that the valves were beaten to a pulp and now I will need a new engine. I was only going 35 mph when it happened. What are the odds that my valves were smashed up, and is there anything I can do to check them before I pay for a timing belt/water pump repair?
View 19 Replies
