Golf IV / Jetta IV :: Steering Wheel Shifting 20 Degree To The Right
Dec 23, 2015
My 20th in the past 15k has received all of the following parts: driver axle, both ball joints, driver full tie rod the pass isn't OEM and feels fine, poly control arm bushings, poly sway bar bushings, fk coilovers with new mounts and bearings, and both wheel bearings, and I believe that's it.
The problem is: when you're going down the road, whether you're turning or going straight, if you give it any gas the steering wheel will shift a good 20 to the right and it'll shift the car over to the right but continue going straight. Then when any type of braking occurs, the wheel goes back to center shifting the car back to the left and continue going straight again until I apply the gas again. The steering will also shift if I hit a bump. But it's only to the right. I'm stumped as to what the problem is and its quite dangerous. Power steering is fine, no leaks.
View 4 Replies
Advertisement
The alignment machine says passenger rear toe is out 1.1 degree.... Tire is worn to a slant, axle bushings are fresh.
View 8 Replies
I just picked up a 2005 SC LB 4x4 5.4 v8 6mt F-350 yesterday and drove it about 250 miles home. It is my first Super Duty, and I love it so far but... the steering has some issues. There seems to be decent amount of play in the steering wheel when I'm driving straight. Also, the truck drives straight when the steering wheel is turned about 30 degrees to the left, and I would like to fix that and bring it to center. When I was cruising on the highway (65-70 mph), there was also two 20 minute periods of time spaced an hour apart where the steering would get light and the truck would dart to the left (i do not think road conditions were a factor as it did not happen on the worst stretches of highway. The truck has 133,000 miles on it, and has had pretty routines maintenance done on it, as it was owned by a drilling business as a work truck to haul tools. The guy I bought it from said that it needed the steering shock/damper replaced, so I will do that, but what else to you think I need to do to the truck?
View 2 Replies
I have a bad wheel bearing but on the highway my steering wheel shakes. It is only on the highway not down residential streets. I'm pretty sure it is the driver's side wheel bearing. I already balanced my wheels and everything.
View 5 Replies
My mkiv gti leans a lot to the right whenever I let off the steering wheel. I brought it to a shop and they put it up on a lift and told me that I needed a tie rod flip kit because it's lowered. Long story short, they charged me $70 to look at it for 10 minutes. Do you really need a flip kit for a car lowered on coilovers? I have several friends with lowered cars and none off them have had to do this. I'm thinking it's something else such as a bad shock but I'm no expert.
View 14 Replies
I'm almost at a lose here. I have a 01 1.8t golf and at 60 the steering wheel shakes and at 80+ i feel it in the whole car. I've already replaced both axles, wheel bearings, tie rods, ball joints, new coilovers, new wheels and tires, and passenger side control arm. There's not much more I can replace besides hubs and driver control arm or do u think it could be defective parts like one of the new axles.
View 9 Replies
I just had an alignment done and the steering wheel is turned counter clockwise a little. I know very little about alignment. I know the terminology and what it means and i heard the the rear camber and toe isn't adjustable on mk4s. I did lower my car,only about one inch though.
Here is the sheet that came with the alignment:
View 14 Replies
I have a issue with my golf 1.9tdi when i start the engine it shakes really bad and feels very rough when sitting in the cab steering wheel vibrates really Bad and engine looks like its going to fly out of the car but when i apply throttle the vibrations go only happens when idling.
What it could be i have done a Diesel Purge, changed the fuel filter, cleaner the EGR Valve, changed the coolant temp sensor, checked the injector loom for continuity and resistance everything was fine, checked resistance on injectors readings was all the same, flywheel seems fine when running (no movement) and no change when i dip the clutch, engine mounts i changed the right hand side one all the rest are fine and not penetrated.
View 7 Replies
its possible to repair? or only a new one it's the solution? cause my gti 1.8t it's making a sound like tssshhh when i turn the steering wheel. I change the power steering rack.
View 2 Replies
So, I decided I'd swap out my 4 spoke MFSW for the nicer looking 3 spoke. From what I read, it should've been a direct fit, which it was for the most part, besides the horn not working after putting it back together. I tried looking up solutions, but to my dismay, found loads of things that didn't solve my problem. I already made sure the fuse, and the relay was fine, which they were. The horn worked fine before changing the steering wheel... For whatever reason, I'm only getting around 1-2 volts at the pin connector for the horn pin, and from what I read online, I should be getting 12 volts.
So from what I know so far, for whatever reason, the 12v from the relay, is not reaching the steering wheel fully, which doesn't allow the horn to work. I even tried putting the old steering wheel back on to see if it made a difference, which it didn't. It didn't even work with the old one on it either. I am currently unable to drive the GTI until this gets fixed,
View 21 Replies
Whenever I brake hard the steering wheel jerks to the right and the car follows. And it'll stay to the right until I got about third gear or if I shake the wheel back and forth. Not sure what it is. What could cause this? 01 jetta wolfsburg.....
View 8 Replies
Went to start my car today but couldn't move my steering wheel at all??
Ignition still works and i can turn my keys but not the wheel?
View 4 Replies
Ok a week ago i noticed a popping noise when i would turn my steering wheel while the car was parked. It sounded and felt like it was coming from the drivers side.
Now a week later i have a weird constant whirring/growling noise coming from the drivers side wheel area. Which only stops when I stop completely or take a right hand turn.
So I think its a wheel bearing due to the fact it stops when I turn right, but thats why im here im not totally sure.
View 1 Replies
I have a 2000 MK4 Jetta GLS that's had a clicking noise in one spot whenever I rock the steering wheel left-to-right or right-to-left. It's noticeable while stopped or at low-speed and seems to be in one particular "sweet spot." I've had the tie rod ends changed, with no improvement. It seems obvious that it's some kind of linkage or joint that's worn out, but I'm just not familiar enough with the steering system on these cars to know where to look. I thought maybe a bad CV joint, but they usually click when the wheels are turning, not when the steering wheel is being rotated, and they don't usually go on clicking for a year without wearing out.
View 3 Replies
As the title says. Last night my MKIV started this jump in the steering. No load or decelerating, the wheel does a pulse or jump, fairly violent. I drove ten miles with no problem, then a couple jumps, then fine. Pulled tires and inspected, checked bearings, tie rods, ball joints. nothing obvious. Could it be something in the power steering?
View 4 Replies
I have a 03 1.8t jetta if i turn the steering wheel all the way to either side a epc light comes on and cuts power a lot what could this be....
View 2 Replies
So I just got my first alignment done on my gli since I lowered it. Before I got the alignment it had a shake in the steering wheel in acceleration mainly but more often at higher speeds. I was hoping that it would ride like butter but it's still shaking. The alignment was pretty bad before I took it to the shop today but what could the shake be coming from now? BTW I installed Ecs tuning rear wheel centering plates last night and I'm about to install their adjustable sway bar end links because I noticed last week that the sway bar had been rubbing the axle some.
View 14 Replies
I've always had a small creaking or groan when i turn the wheel after I lowered my GLI a year ago, but i feel like it's getting louder...
What could be causing it? cause im doing my year end "maintenance" (if its worn/almost broke, perfect excuse to buy upgrades) ...
My control arms are brand new with r32 bushings as are my 034strut mounts/bearings. I checked my steering fluid level and its good.
Pic for reference of current height, might raise it .5 or so, my new job has quite the driveway entrance.
View 3 Replies
During the tedious removal of the airbag from my mk4 multifunction steering wheel, I managed to rip the cruise control buttons wires out of their harness. I am honestly bewildered by the descriptions I've found online, and just want a photo of which colored wires should go in which holes XD.
View 2 Replies
Car: 2003 Jetta GLS 1.8T
The car is starting to produce a heavy shake in the steering wheel when above 45mph up through highway speeds. The kicker is that the shake only occurs on-center, because turning the wheel just a few degrees off creates a relatively smooth result.
Checked the wheels for balance, tire wear [which is good, no cupping], lower control arm (LCA) bushings, and complete a lock-to-lock steering test on the ground to confirm steering rack mounting bolts are tight. What's the next pieces of hardware I'm needing to verify?
View 2 Replies
I have a mk4 TDI. Running 18" 225/40 and coil overs. My car began to have a loose steering wheel and was unstable at high speed so i did alignment and it was bad. when they fixed it next day it broke again. My front wheels end up being too open. If front left is straight than the front right is too much open, like i am turning right. i did alignment again in the shop, they made them straight and it broke again next day. What can cause that my allignment breaks every day? Shop doesn't know.
View 1 Replies
