Golf IV / Jetta IV :: Squeaky Front Right Wheel
Oct 20, 2013
My car is a 99.5 Jetta 2.0 5 speed. Recently it had developed a squeak coming from the front right wheel. It speeds up/slows down based on vehicle speed. I jacked up the car to examine and once the wheel was off I checked everything and it appeared fine. Wheel bearing, tierod, and ball joint all replaced a few months ago, and brake pads and rotors replaced a week ago.
With the wheel off I spun rotor and it did still make the noise. That being said it rules out the possibility of anything to do with the wheel or any bushings. Obvious answer would be the brakes but they are brand new and appear fine. Anything missing?
View 4 Replies
Advertisement
2005 Jetta. My passenger side door emits the most high pitched, eye-gougingly disturbing noise when opening. I don't have any wd40 handy, would it be okay to just spread dome Mag1 wheel bearing grease over the hinge? Might be a stupid question, but that won't damage anything right?
View 3 Replies
I have 2002 BMW 325xi (all wheel drive). For about 2-3 months now there is a squeaky noise coming from passenger side front wheel. It sounds like a really bad and rusty coil spring but the weird part is that that noise only appears in warm weather. It has nothing to do with how much distance I drive. If it is 70 odd degrees or warmer outside, the noise starts. In warm weather, the car does not have to be running/moving to hear the noise. I can just push down the passenger side front and hear the noise. I took to a mechanic and he wants me to replace tie rods, control arm and struts. basically the whole suspension system on the front for this noise (in other words, he does not know what exactly is making the noise, so replace everything)
View 5 Replies
2001 Chevy Silverado, 1500 4wd. 135k miles. Front passenger wheel squeaks when rolled forward or back. Checked brakes and they are fine. While I had it apart, I could hear the squeak which sounded inside. I don't know the terminology, but there is a bar between two rubber boots. The squeak sounded as if it was coming from the boot near the center of the truck where there are four bolts.
View 1 Replies
I drive a 2006 Toyota Corolla, and I've noticed e a squeaky noise coming from my passenger side front wheel. The noise only occurs when I am accelerating the car and driving between 20-40 mph. As I accelerate, the squeaks increase in frequency. They disappear when I brake.
A mechanic replaced the front brake pads two years ago (15,000 miles ago) and also shaved the rotors. About a year later, the squeaks began. I brought the car into a different mechanic at that time (because I moved) and asked them to take a look. They checked the brakes and said they looked good. They attributed the noise to metallic brakes as opposed to ceramic and said the noise would go away in time. The noise has persisted, however, and is becoming more intense.
What is going wrong? Could this be a CV joint or wheel bearing issue? A rotor issue?
View 1 Replies
My front right wheel began clicking a few weeks ago. It clicks under these circumstances...
- Usually when the car first starts rolling from a long stop. Usually stops after driving for a bit but does come back sometimes
- from 5-50mph (stops at high speeds)
- cornering does not seem to change the clicking. If anything it stops it rather than makes it worse
- clicking is in rhythm with wheel speed
- noise stops when brakes are applied
I'm thinking it's either a cv joint or I just replaced my brakes maybe it's the brake clip came out and is hitting the inside of the rotor?
View 14 Replies
For the past few weeks, I thought I was hearing something squeak but I always passed it off as just the radio, but this morning I had the radio off and heard it again (and more intensely) The closest thing I could think it sounded like was when you drag your hand over a latex balloon.
Is it possible that this was a puck that didn't get removed? I'm at about 4500 miles and I got the car at 300 and would dread to think that I've been driving around with it all that time.
View 15 Replies
Feel this is a bit stupid, but whatever. I was jacking up the front wheel of the car today on the pinch welds (one part of it got super bent) and while the jack was almost maxed out, my front wheel didn't go anywhere. I must've had almost a foot gap between the wheel and the fender..
Took some pictures of where I jacked, and the suspension/wheel of the car. What it could've been or how I'm supposed to properly lift it so the wheel comes up?
can see the pics here: [URL].....
View 8 Replies
So I just jacked up my car to check out how bad the bushings are on the control arms and the tire rod. They're bad. So I'm going to get the suspension stage 1 refresh kit from ECS.
Well I went to spin the passenger side wheel and I noticed that I can tilt it back and forth slightly, I checked the other side and couldn't do the same thing. I just got both wheel bearings replaced by a shop and I'm hoping its not the hub. This is just a CV joint or bushings or if it's actually the hub???
View 2 Replies
I just purchased a 2004 Golf 2.0 for my daughter. The car seems to be in good shape but it does have a few problems being used and 153k miles on it.
1 - a/c switch doesn't light up and the blower does not come on. No airflow thru the vents at all. I Googled this and it sounds like blower motor and/or resistor?
2 - when using key remote to lock doors the right side marker light sometimes stays on. I have to hit the lock/unlock 4-5 times for it to go out. Is this short?
3- Front left wheel bearing was replaced but the previous owner just did that one side. The front is making noise so I plan to do the right ASAP.
Anything else I should be watching for?
I had an 85 Golf - one of my favorite cars, bought this in the hopes this one would be as good to my daughter.
View 8 Replies
Lowered my car yesterday. 23" FTG. I'm now hearing a clicking noise from my drivers side front wheel.. I mostly hear it when my foot is off the gas and I'm just coasting (usually at slower speed). Also, it gets louder (worse) and is accompanied by what sounds like a rubbing when I take turns.. Is it axle bind? Or should I be concerned?
View 1 Replies
I'm not sure if my car is an R32 but it is a mkIV GTI V6. There is a small radiator in front of the front passenger wheel and air is ducted from the front air scoops into the radiator. What is it cooling? I searched for a transmission radiator but nothing came up. I can only speculate that it is to cool engine oil or transmission oil. Is that correct and if so what is it called?
View 2 Replies
I have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 Replies
VWVortex, so I've had some issues with my MK4 recently (go figure). It started with steering wheel getting intermittent and random jerks to the right after driving for about 20 minutes on the highway at any speed any gear but only at around 1/6 throttle. I needed to do front end maintenance anyway, so I replaced both complete LCA's with ECS Tuning's ply ones, went stage 2 BFI engine mounts, stage 2 BFI dogbone mount, both ball joints, both tie rods ends, both axles, and an alignment.
Now I'm getting a shimmy in the steering wheel starting at ~80mph. I know my wheels are slightly bent and are being replaced in the summer when the weather is warmer, but it wasn't doing this same shimmy prior to all this. Just the jerking. Could it be they messed up on the alignment? Its really getting on my nerves considering I've dumped a lot of money trying to fix this problem just to have something else pop up.
View 4 Replies
Just started the other day. Ecuador codes at p030p035p0411. The noise only happens while accelerating past 10% throttle in any gear.
[URL] ....
View 1 Replies
I bought these wheels last summer from ECS Tuning - Alzor wheels for my Jetta. I haven't driven too much on them since I was deployed to Afghanistan for 9 months. I've been home 4 months. I think I have about 10k miles on them. The issue is that now one of them leaks. I took it in to be checked, thinking it was the tire. There is no rock rash, I haven't hit anything. The wheel leaks from the area that the spoke connects to the wheel base. There is no visible sign of a crack at all so I don't know what the heck is up. The paint looks fine from the spot it leaks from.
View 4 Replies
I have a bad wheel bearing but on the highway my steering wheel shakes. It is only on the highway not down residential streets. I'm pretty sure it is the driver's side wheel bearing. I already balanced my wheels and everything.
View 5 Replies
My 2008 GS 460 with 53k steering wheel makes a squeaky noise when I turn the car on and it moves to it's memory position, but only during the heat.
View 4 Replies
Funny my Audi did it when I got it. Had to replace steering column. My old Treg V6 did it. Lube job. And now the current Treg is doing it. All on the onset of warmer weather.
View 4 Replies
I have had some play in the steering wheel of my '04 F150 screw 4x4 for a long time. Today, I replaced the outer tie rod ends in order to get rid of a squeak. While I was down there, I tried to move the inner tie rods in and out and didn't detected any movement so I figured they were still good.
Now that the new outer tie rods are in place, my squeak is much better but I am still noticing play in the steering wheel. Assuming that I checked the inner tie rods correctly and that they are indeed ok, and assuming my new outer tie rod ends are good, why would I have any play at all in the steering wheel?
View 1 Replies
I have a '07 RX350. My steering wheel recently started having a squeaking noise when you turn it right, or left. This has nothing to do with the motor to extend or retract. You can hear the noise when you turn it ever so slightly back and forth (whether car is running, or not). I have seen other threads that talk about a grommet needing greese between the steering wheel and column, but not enough detail for me to determine what they mean. Also, if that's the case, I am not sure how you get to tha area?
View 4 Replies
