I get some bucking under load between 1500 and 3000 rpm. This issue is more noticeable when the engine is warm. When it does this it makes a sound that to me sounds like a misfire from the exhaust, but I've never gotten a misfire code.
Sometimes i get codes p0411 and p0420 (secondary air injection and cat efficiency) but VCDS tests say my cat and o2 sensors are all good.
So recently I took my engine apart to do a valve cover gasket and Ecs tuning 2.0 coil conversion. I noticed a good amount of oil in the plug tubes so I got out my trusty soap dispenser and started pumping out oil. Pulled plugs and cleaned them (wanted to make sure oil was all out b4 getting new) also while I had it apart I wanted to take intake off, ( just to polish it and clean out any carbon inside).. Well I never ended up doing that. I removed the injector connections and realized it was to much work for such little satisfaction. So I plugged the injectors back in.
I got my car all back together and now I'm throwing 6 cel codes!! P0102 (maf) which I'm assuming b.c I took it off for so long, p0201, p0202 ( injector 1 and 2 miss), then some misfire codes p0300 (random) p0301 (cylinder 1) and p0304 (cylinder 4). The car starts runs very rough then cel comes on and blinks. I was thinking maybe the oil getting down to the combustion chamber couldn't be the best for it but it would just burn off. Only other thing I did was take off the thottle body and cleaned it.
I was driving home today and when I got on to the freeway, the car lost power and the check engine light started to flash like it was misfiring, also the EPC light came on. When I got off the freeway and let it idle, it idled rough until I turned the car off and put my APR flash back to stock. After that the car was idling fine and the check engine and EPC lights were gone. Everything seemed to be working fine until I hit about 75 mph. The car started sputtering again only as long as i tried to accelerate. Under light to moderate acceleration the car works fine up to about 70 mph. After that or under heavy acceleration the car sputters and the CE light flashes and then turns off.
View 7 RepliesI bought a 2001 golf gls 1.8T (AWW) about a month ago and it was running pretty bad, was throwing some codes, cylinder 1 misfire and some o2 sensor codes, I replaced the coil packs and spark plugs and then cleaned the MAF. It was still running bad ,rough idle and power loss. I figured it had to be some kind of vacuum leak, I replaced the PCV valve, cleaned the intercooler and put on a silicon TIP. Still had some rough idle and power loss, checked for vacuum leaks, using the good ole starter fluid method and found my intake manifold was leaking so I replaced that gasket. STILL rough idle and power loss, now I'm pulling codes for o2 sensor and a misfire in cylinder 3. My question is, should I replace my pre-cat o2 sensor or replace my MAF sensor? Or are there other things that should also be checked/replace.
View 5 RepliesSo my girlfriends's 2001 2.0 Golf (engine code AVH, 153k miles) began throwing codes for misfire on cylinder 4 and for the o2 sensor (post-cat) recently. I went ahead and replaced the spark plugs, wireset, and the coil pack. They were way overdue. The CEL went away for like 30 miles, and then came back. Now it's reading misfire on cylinder 3 and the same thing for the o2 sensor. What else it could be? Search is coming up blank, most people replaced the coil pack and the CEL went away.
View 2 RepliesMy daughter's 2000 Jetta with a 2L has an engine light and codes that state Misfire on 1 and 4. It is intermittent as it only misfires once in a while.. She is in Rolla MO, and I am in Detroit MI. A couple of years ago the car died when she was home and I found a swollen/cracked coil pack. I replaced it with an aftermarket. The plugs and wires were replaced about 30k ago with OEM parts. I am tempted to have the son in-law replace the coil pack with a Bosch unit.
View 3 RepliesSo my daughter's 2000 Golf Mk4 with 160,000 miles on it was running rough and had 3 codes stored - cylinders 2 & 3 misfire and a 411 secondary air injection problem.
Having had the misfire code before I swapped injectors around and the error code moved cylinders with the injectors so I attempted cleaning them and also cleaned the throttle body and intake manifold. At this point car still running rough but also started smoking badly.
Replaced the following items:
- Spark plugs
- Spark plug wires
- PCV valve
- PCV hose
- Fuel injectors w/ remanufactured
Hose reconnected between secondary air injection pump and air intake - previous owner had duct-taped it in when he couldn't get it to seal I guess. I've never heard it run.
Car running better, idles more smoothly, doesn't stumble or stall like it did before, no error codes coming up BUT car smokes a lot and the fumes make me feel sick just driving it a mile.
The car had never smoked like this before, hasn't had a whole lot of love the last year or two but no real problems either so why the sudden smoke?
At first I assumed it was cleaner being burned off but that should have been gone in under a minute and this is on-going. It's bad enough to not only be embarrassing but apparently dangerous as the fumes are bad.
Okay, so a few weeks ago, my tire blew out on the freeway. Of course my spare wasn't in there and when I got one I couldn't get the lugs loosened. My 4way was too big on all sides. It was late, I am a single mother of two young kids so I had no choice but to drive slowly to get it off the freeway. The next morning I came back fully prepared, got my car in to get a new tire. I have been driving with ONE code for my CEL, but at the shop (where I use to work) I used the scanner and it threw 5 codes.
P0300 Random misfire
P0442 Small EVAP leak detected (this one was already there)
P0420 Catalyst system below threshold bank 1
P0301 Misfire cyl 1
P0303 Misfire cyl 3
My beautiful love is an 02 Jetta 2.0 4 Cyl. Now, since 4 of these codes popped up AFTER my first blowout (I turn 30 next month, knock on wood)
Did driving my car at 5 mph about a mile and a half (everywhere up until the gas station was NO PARKING) do something to my car? All of a sudden, any in town driving ESP IDLING makes my check engine light blink and my car has no power I just have to pull over wherever I am. I checked the car out myself on the side of the road and my cat was glowing. After this I do not drive my car.
So, what should I do. I did a tune up. Should I replace the 02 sensors then the cat?
My 2.0L Jetta had an intermittent misfire, only at idle. I took it in to the shop, and they fixed a vacuum leak and replaced the plugs. The car drove home fine, but the next morning it was misfiring at all speeds. When it got back to the shop, they said that the coil pack was bad. I wonder if they might have done something to cause the pack to fail, since it seemed to be working fine before I took it in. Their explanation was that the coil had become accustomed to sparking at an adjusted (more powerful) setting to account for the vacuum leak, and when it tried to go back to the factory setting, it quit working. Also, all of the stress from running at a higher output wore it out.
View 4 Repliesweird thing happens in my 2.0 manual jetta. every 1500ish miles, when coming to a stop, it feels like my car is about to stall but its not in gear.The trip milage will reset, radio will turn off, dash will dim, but no CEL. Since then key fob doesnt work (replaced fob batteries), and my DRL are off. still cold starts no problem (figure its not the battery), trying to figure out if i can get closer to what needs a fix before tearing into something unrelated.
View 3 RepliesI recently bought a 92 Celica gt (5s-fe). The engine feels like its misfiring and wont idle on its own.
I've done all the normal maintenance to it and the spark plugs all show normal signs of wear. I haven't verified fuel and spark yet. Check out the video below. The piece of cardboard is to keep the throttle partially open. Also, the exhaust is broken off at the flex pipe so excuse the awesome sound ...
[URL] ....
Have an 04 Jetta GLS 1.8t manual. While accelerating at lower rpm and I'm kind of on the gas to get up and go it starts bogging out. Could almost describe it as a little jerky. Anything over 3000 rpm there's no issue. Doesn't matter what gear I'm in either.
View 15 RepliesWhat could be the issue at hand here. I just recently bought a 337 edition gti and I absolutely love it. But the guy I bought it from says that it was chipped but he doesn't know what brand tune it is. But the problem, like the title suggests, is that in first gear the car pulls incredibly hard but as soon as I shift into second I lose all my momentum and it just feels sluggish.everyone that I've seen on these threads have said that I should be getting the most power I'm second and third gear. Is this tune just not a good one? Could there be something more?
View 4 RepliesI changed my oem clutch in my mk4 golf 2.0l with a stage 1 ecs tuning clutch kit. Lightweight flywheel, clutch disk, pressure plate and throw out bearing. But since I have my clutch pedal has been less stiff then usual. I like my clutch pedal as stiff as possible but it just isn't I bled off the slave cylinder. When I was done no air was coming out but it is still way to soft for me. What should I do next??
View 6 RepliesI am having a recurring problem, My engine keeps misfiring. I have replaced the spark plugs, ignition coils and pcv valve with all new parts and and fixed it for a little bit but now my car is misfiring again, and Im hoping its not the head so need to narrow down what the problem is...
View 1 RepliesSo leading up to today ive had some bucking under load which felt like misfiring to me. I borrowed my friends VCDS cable, checked MAF, checked o2 sensors, checked cat. They are all good. This problem is constant but i did get a misfire code once (random, cyl 1, 2, and 3). I cleared the code and they never came back.
Today as im driving home from work, the bucking problem was much worse. Then the CEL came on. I just checked the code, and it was system too lean. I cleared the code and now the car will not start. It cranks, shows rpm on VCDS and sputters but doesnt even come close to starting.
1995.5 Jetta VR6
Misfire cylinder 1 and random misfiring
P300 P301 Vagged it and can't figure it out
Changed the plugs, wires, and coil pack Used and old timing light and getting spark in all wires so can't be the coil pack
Fuel injector, O2 sensor, any other things?
I have a 2001 golf with a 2.0 AVH engine. I recently replaced the coil-pack and was very pleased that the engine was running better, the only problem was the mpg was still kinda low in the 24-5 range when it used to be 29.
I tried to do a compression test but I didn't prepare properly, I thought you left the coil pack plugged in and the fuel fuse. Now I have a CEL that *was* flashing saying cylinder one is misfiring though it has stopped flashing. I drove it 13 miles home and it did improve but its still running rough. Very reminiscent of when my bad coil pack was still in there, a real lack of power.
So I have to ask, what can I do from here? Have I damaged my coil pack or cylinders? Will this likely go away on its own? Is there anything I should do?
Is it possible that disconnecting battery causes a misaligned throttle body, which in turn causes the EPC light to come on? And does a misaligned throttle body also cause misfiring cylinders (1 & 2 in this case)?
View 3 RepliesI recently bought a 2000 jetta vr6 MK4 and since i have had it its had a misfire problem. So its saying that its misfiring in "cylinder 1" and sometimes when I clear the code it will stay off for the whole day. I did everything I could think of. I replaced all the spark plugs. I replaces the plug wires. Then i bought I new coilpack. and its still misfiring.
View 10 RepliesCEL came on and the report says #2 cylinder misfiring. Changed plugs, wires and coil. Last step was to change the #2 fuel injector. I changed the 2nd injector from the left but I'm still getting the same message. I was wondering if maybe they aren't numbered that way. It's a 2004 Jetta with Car engine: 2.0L L4 SOHC 8V. Did I change the wrong injector?
View 1 Replies