Golf IV / Jetta IV :: Slave Cylinder Green Rubber Boot Filled With Brake Fluid And Began Leaking A Little
Apr 1, 2015
Was bleeding my brakes and clutch. Using a power bleeder and it seems as though I put a little too much pressure into the system. The Slave cylinder's green rubber boot filled with brake fluid and began leaking a little. Did I blow a seal? Is this normal with pressure like that? I feel like pushing the clutch in would give more pressure than my little hand pump gives...
View 2 Replies
Advertisement
So I took my tranny off to fix a broken dog bone mount bolt problem. I am now in the process of putting it back on. I raised the tranny bolted all the bolts on had everything almost back together and I went to put my slave cylinder in and the clutch fork won't move so that the slave cylinder can slide in. Did I maybe put the clutch fork in wrong? pretty positive I put it back in as it was and slide the clip through the hole and everything.
View 11 Replies
I have an 04 GLI 1.8T 6speed. It is very clear to me that the car has some hydraulic issues. I can't leave the clutch in for more than 10 seconds or it stays on the floor and I have to pull it back up with my foot. So what does this mean? (Besides the fact that I'm a double clutch king now) I couldn't wrap my head around why this was happening and thought at first it may have something to do with a hole in the Slave Cylinder that is allowing air into the lines. Neither confirmed nor denied yet.
My other problem I have is that my car is losing brake fluid at about a quart every 3 weeks. I'm no expert but that is alarmingly fast, and it is getting worse by the month. When driving I get the error message of STOP and my brake light flashes, which is how I know it is low. I can't locate the leak but I do see a drip coming from somewhere behind the drivers side front tire, relatively close to the firewall. I don't know if I have a broken brake fluid line that is dripping down, or if something else could be broken that is causing the leak.
View 6 Replies
I was replacing the oil in the transfer case and came across this under the passenger side. Power steering rack seems to be leaking through the rubber boot, but I have not noticed anything on the garage floor in recent months...
Can the boot itself be replaced? I hate to think the whole system needs to be replaced.
View 14 Replies
My T18 tranny in my 85 F150 will not shift, first instinct was clutch but after tearing the drivetrain out of the truck to check the clutch, there is virtually no wear on it. Slave cylinder is leaking a little bit but the mechanic that took a quick look at it said it was still working. She was shifting fine when i left for school, then when i got off the highway i couldn't shift.
View 1 Replies
My 2003 Toyota 4 Runner with 104K miles recently started showing a brake light off and on. The brake fluid reservoir was at the minimum level and there was some residue leaking from the bottom near a silver disc. Took it to a mechanic and was told it was most likely the master cylinder leaking brake fluid. Is this normal wear and tear or is it unusual in this vintage vehicle? I do not notice any brake slippage at this point. Should I take this to the dealer and ask why this master cylinder is faulty? I thought Toyotas were long life vehicles?
View 2 Replies
First of all this is also my first camry and I noticed that there is only 1 reservoir for the slave and the brakes - which is unique to cars Ive owned in the past. My question is when I remove my slave cylinder from the trans and unhook the hard lines from it would this introduce air into the brake lines since they share the same reservoir? Should I remove the brake fluid from the reservoir before I disconnect the slave? I am wondering because If i just disconnect the lines brake fluid will leak from them between the time I disconnect the old slavecyl and hook the new one up.
Also regarding the trans fluid. my le has 80,000 miles on it and I am not sure whether or not the previous owner ever changed it before. I am having a hard time finding information about how much fluid and exactly which fluid to use. All I know is that gl-4 is the safest choice, butis it ok to use red line mt-90 or amsoil MTF? I dont want to ruin the trans by putting in the wrong fluid and/or wrong quantity.
View 7 Replies
When changing gears my accent grinds as if its not engaging properly? I checked my slave cylinder and the rubber was filled with silver looking fluid could me replacing the S/C fix the issue? I don't think its synchro issue i tried double clutching and still no difference. the grind sounds the exact same as it does when you accidentally release your clutch when changing gears and it hasn't engaged properly. I also changed my manual gear box oil.
View 2 Replies
I got a 99 f250 v10 5 speed manual. my slave cylinder was leaking so me and a buddy replaced it. the pedal felt kinda funny at first but shifted fine. Fast forward 2 months, I moved out west and my truck will grind a little into 3rd 5th and you damn near need to be at a stop to down shift into 2nd.
If I drive like grandpa and shift slow it usually is fine but but might still grind. I am wondering if its a syncro or if we did not correctly "bleed the new clutch slave. Tempted to take it to ford and see what they say.
View 2 Replies
I have power steering fluid leaking out of the bottom of the Brake master cylinder out of a round hole. Every time I pushed brakes it leaks a good amount of power steering fluid out. Why it would do this and is there a screw missing out of the hole or what?
View 6 Replies
I have a 1991 Accord LX wagon that is leaking coolant. I figured it out b/c there is a green fluid pooled on the floor behind the passenger's seat. Why would coolant be leaking there? I bought this car in February and have been nickeled and dimed ever since. I want to sell it and get something else but I want to get the coolant problem fixed first and need to know if this is going to be expensive.
View 5 Replies
I had a small leak in my 94 Explorer which was getting on the compressor pulley and being splattered around the engine compartment. The fluid was green like antifreeze--which didn't make sense; why would antifreeze be leaking from the air con compressor? But as an experiment, I got a non-AC belt and ran the truck without the compressor pulley turning, and the leak has stopped! The level in the coolant overflow tank has dropped an inch or two in the last 500 or so miles. Is it possible that antifreeze is getting into the air con system somehow, like through an internal leak in the heater core?
View 10 Replies
I have a 99 Jetta GLS that is leaking trans fluid in possibly 1 of 2 places. one is coming out of transmission pan seal. If it's the 1st one how would that be replaced. [URL]......................................
View 2 Replies
I have 2012 VW GTI manual with 34k miles and on the freeway I noticed that it's becoming harder and harder to select gears. Few minutes later and by the time I got off the freeway, at the light I couldn't engage 1st gear, nor 2nd, somehow managed the 3rd and brought it home. So if the car is on, I cannot engage gears, if I try the first I can feel some forward motion, like it's trying to engage. If I turn of the car, I can shift through all the gears. I have noticed before this happened that the clutch feel is very soft and spongy and my gear shifter had a lot of loose play. Since I can shift when the car is off, I don't think the problem is worn shifter bearing. Clutch never slipped and I could turn of the car engage 1st or 2nd gear, start it with depressed clutch and go normally so I think the clutch disk is fine.
I am out of 3 year 36k miles, but still have the powertrain warranty. Dealer told me that if it's the pressure plate (most likely) then I would be out of warranty but if it was slave cylinder then I would be covered. I don't want to take a tow truck just for them to tell me that it's definetly the pressure plate, what do you think???
View 8 Replies
I have a leak in my rear wiper fluid line on my GTI. When I use the rear washer, I get a pool of fluid in the driver side taillight and under the rear seats. I'm getting some fluid in the rear driver side headliner as well so the break must be there. First step is to pull the headliner.
View 4 Replies
My car is in the shop and has a leak at the Power Steering Pump. The rubber O-ring on the Power Steering Pump Solenoid Valve (p/n 4417030120) is leaking fluid. The Solenoid Valve is ok, just the Rubber O-ring is bad, but it looks like you have to buy a complete new Solenoid Valve to get the O-ring (a lotta bucks).
I did find a Lexus Power Steering Pump rebuild kit online at, but I can't see if it includes the solenoid valve o-ring or not. Have to replace their solenoid valve o-ring?
View 10 Replies
My auto dimming mirror is leaking fluid internally and is super dark, If i remove the mirror and cut the wires, will a normal mirror mount on the auto dimming base? I always use a Broadway mirror, but the mount sucks and the mirror always tilts down..
So question is will the normal mirror fit on the auto dimming base (ball) or should i just use some electrical tape on the ball the prevent it from falling?
View 1 Replies
I have the regular Prius 2012, The brake pedal is attached to a rod that goes into a flex boot and then into the ABS module in the Engine compartment. The Boot is leaking sticky greasy/oily fluid. It not a constant leak. Its like it leaked on a Hot day and then stopped leaking.
Its not the one from my car, but its what I'm calling the ABS Mod Is this not just the lubricant for the Pedal or is this real brake fluid from the ABS module leaking into the Car? took it to Toyota and they said they had never seen this before and they are recommending to replace the entire ABS Module and Brake Fluid at a cost of $3346 + Tax. (roughly $2700 in parts)
View 19 Replies
Has encountered a strong odor of washer fluid when using it on your windows. I was driving to work this morning through a snow storm and needed to use my washer fluid for the first time. As soon as I turned it on the entire cabin was filled with that smell. Could this be a leak?I thought it was all confined within the engine compartment so not sure why I smell it immediately upon using.
View 14 Replies
I just started to have some idle problems with my 2013 Elantra GLS auto 1.8 that has 10k miles.
I went to the gas station to fill up the tank since the gas was very low (30 mile range). I filled up the tank, started the car and the engine began to stumble and idle poorly like it was about to stall. I put the car in drive and the engine stalled. I restarted the car and it ran normally.
The car will now briefly idle poorly when I'm at a stop light. The car will be at a stop light idling and running normally. Suddenly, the tach will go down to 200 rpm and then up to 1200 rpm, like it is about the stall. Then it will idle steadily and be back to normal. This has happened about three times over the past two weeks.
What may be causing this intermittent idle problem?
View 9 Replies
The brake light came on randomly yesterday, flashing foe about 5 seconds, then shut off. Hasn't come on since, but I looked at the brake fluid resovior and the level is about .5cm (.2inches) below the "min" marker.
Can I just open the resovior, pour in the fluid, recap it and go? I remember hearing from someone that if you open the resovior cap at any time, air rushes in and you must bleed the entire system before you can drive again
View 3 Replies
