out of nowhere the right side of my cluster stopped working. The speedometer is completely dead and when ever i go around a cornor my gas guage drops to 0 and beeps. I haven't changed anything with the car and the only thing i e messed with recently was the valve cover.
Is there any wires close to the valve cover that could cause the cluster to short only on the right side?
This morning I started my car and all was well, all gauges working. Drove 2 miles and stopped to get gas. Put some gas in my car and started it back up. My gas gauge never went up. Stayed slammed down to the E. All my other gauges were working normally except the gas. My gas light was not on saying I was on E, and I don't have a CEL.
View 5 RepliesSo I have been having issues with a cluster in a car I recently bought. Sometimes it works fine, sometimes no gauges or MFA, sometimes just no gauges. All of the dummy lights work, and the odometer has power, although it does not seem to record miles when the cluster is not working.
I checked for power, good. Looked in the Bentley for grounds, there are 3. Terminal 9&24 and a sender ground, terminal 7. 9&24 both show continuity, but I get zilch on the sender ground. Tried looking in the wiring diagrams and google but I cant figure out what a sender ground is or if it should have continuity?
Next step is to try another cluster, but I don't want to go through the trouble of switching it to a new cluster if the ground is bad.
I recently purchased a 01 1.8t GTi with a blown timing belt. I got the car rebuilt, did all maintenance work like brakes , hub/bearings, bushings, oil and all the good stuff that goes into getting the car back up and running. I've finally started driving it and I'm having a weird issue.
Yesterday , I stopped at a red light and the car randomly died on me. Pushed it off the road and checked things out but I couldn't see if there was anything wrong but about 10 minutes later , I was able to restart the car and drive home. Now today , on my way home from work the car starts back firing and I lost all power and rolled to the side of the road where he car would just continue to crank. I was able to get it restarted but it cut out again a couple seconds after. I don't have my code scanner but I know I do have one lean code for something. Maybe cause I have a leak between turbo and dp. I don't have access to vagcom unfortunately..
Yesterday (3/28/12) my Radio Data System (RDS) feed suddenly stopped working on one of the radio stations I listen to on my car radio. Until it stopped, it identified the title and artist of the song I was listening to as well as the station. It still worked on other radio stations, and it worked on other radio stations this morning (3/29/12). Then the RDS feed suddenly stopped working on every station, and now no RDS information appears on my car radio screen at all. What could have possibly happened?
View 7 RepliesSo I just got a new car tonight (01 Jetta 1.8t) traded my tdi for it. They failed to tell me about the lighting problem. The dash light (blue ones that light up whole dash) only work sometimes. Don't work when headlight switch is on (have euro switch) but they will work sometimes if you put the left blinker or hazard lights on. Illumination for window / lock controls are glowing red, same as all the buttons by the vents up top of the radio, ac / climate control lights not working. They did end up telling me that they swapped the other car they had (2L golf mk4) and they swapped in that dash and it worked no issues. Do I need a whole new cluster?? Or is there something I can try to fix it?
View 1 RepliesOur 2015 Prius 4 with 8,900 miles just suddenly stopped chirping and turning the lights off upon locking. The courtesy lights also no longer work (the lights worked last night as I approached the car but not tonight. The locking chirp/beep worked 3 hours ago but not now. Also headlights no longer go out after double clicking lock on either of the 2 fob.)
View 13 RepliesA couple months ago my Key Fob stopped working. I tried using the button and then tried to use the key to unlock the door. I'm trying to figure out if there is a possibility that the immobilizer in my fob is junk or maybe its something as easy as changing the battery (which is another issue in itself because I cant open the fob for the life of me) Once again just curious if there is something I can do to fix this issue without contacting and dealing with the dealership. Would like to be able to lock my car again at some point.
View 3 RepliesA few months ago I'm key fobs stopes working the I switched out the batteries and still no progress. What it could be?
View 3 RepliesThe reverse light has stopped working on my MKIV TDi. Done all the usual things I can like bulbs/fuses.
View 2 RepliesThe issue I am now experiencing is my passenger headlight would only turn on once in a while . The driver side headlight would work just fine both high beam light also . Today I opened my hood I verified the cable had a poor ground to the headlight I noticed a burnt smell after checking the cables . I turned on my high beams both sides turn on . Then out of no where my turn signals both (Left - right - back and front stopped working. Including the Hazard lights both front and back). The cluster would not show neither turn signals turning on ( left-right ) I noticed that my headlight turn signal on the passenger side would turn on but not blink it would stay dim only when . I pushed the hazard light button . My cluster would show the right turn signal ( no clicking no flashing arrow ). The driver side would not work either. What can I do to fix the problem? I know that I will not be able to drive the car due to the issue.
View 5 RepliesSo I just got a 2002 1.8t, everything was fine until the fans and ac stopped working. After poking around the forums a bit I changed the following:
1. Fan Control Module. Result: nothing
2. Radiator Cooling Fan Switch Temperature Sensor. Result: nothing.
all fan components have the correct voltage going to them. Fuse 16 for the AC clutch is not blown and has power going to it. The AC compressor has power going to it. The fuses on the battery box have power going to them specifically S180.
My question is what am I missing? is it possible that the fans themselves could be bad? car is not overheating, the after run coolant pump kicks on. But the AC clutch is not spinning nor are the fans. btw AC clutch is not seized up.
The rear wiper on my wife's 20th stopped working the other day. I checked the fuse and it was fine. I pulled off the rear panel and got to the wiring. I don't have a Bentley so I'm not sure what wire does what. I tested the wires and the far left is a switch 12V and the far right is the ground. The center two didn't show any voltage with or without the wiper on. When should these wire see power? What else should I check?
View 16 RepliesMy blower motor in my Jetta recently stopped working. When I turn on the blower it works for 10 seconds or so then slows down and dies. Is this a blower motor or resistor problem?
View 1 RepliesA few days ago I was driving around. I get back in my car and when i turn it on no air blows and the radiator fans aren't working at all. My car hasn't overheated but have stopped driving until I can figure the issue out. I have since replaced the fuse box on top of the battery to no avail. I was thinking that it could possibly be the fan control module but in all the posts I am reading not one says that theirs don't work, they just keep running. So is there something else i should be looking at?
View 1 RepliesLast weekend my headlights, wipers, turn signals, AC, and horn stopped working. Through searching and another post I narrowed the issue down to my ignition switch. After taking apart my steering column and getting the switch out, I found this...
The house which is connected to the switch, with the one of the red wires obvious fried....
So I'm hoping this problem and I'm wondering who else has had this happen. When I took apart the ignition switch itself, nothing appeared to be damaged. No burns no broken pieces, etc. the metal post on the outside corresponding to the fried wire on the housing was corroded, but that was it.
I think I need to replace the housing since all that plastic melted and I chipped it away to get to the connector. I can't seem to get the connectors on the wire off of the metal connectors that are supposed to be in the housing.
I have a 2000 VW Golf 2.slow. I have done some research from other threads but I'm wondering if mine is a simpler fix then testing all the wiring. After taking the car to Auto-Zone and having my battery and alternator tested they said the alternator was the problem. I had to wait a day to get paid to buy the alternator so I had them charge the battery. After I put the battery back in and started her up I got a flashing e-brake light, ABS light and no A/C. My A/C clutch compressor isn't kicking in either. I checked my brake fluid and it's fine as well.
View 15 RepliesWhen driving in the rain, I've had the scary experience of the windshield wipers suddenly stop working. Maybe 30 seconds later, they start working again. I'm just glad the cars in front of me have had their lights on. It even seems that the wipers go the same speed no matter how fast I want them to. Also, the blades do rub against the windshield. Is it the linkage or should I simply replace the blades?
View 2 RepliesAll of a sudden my cluster light don't work. Like my all my warning lights work fine. Just when I switch my headlights on my cluster doesn't want to light up green anymore or the green lights for my climate controls. It's a 2002 F350 with a 5.4 in it. Where to start looking?
View 3 RepliesThis is for my gf's 2010 sonata. The instrument cluster stopped working but then after a couple days it started again. Once again it stopped working. This time I checked the fuse and it was fine, there was power going to it. I was able to get it to start working again by disconnecting the battery. I hate electrical shorts. I have done some research but haven't come up with anything other than re-seat the cluster or replace it. I plan on doing that the next time it stops working. I'm thinking it might have something to do with the ignition, but i really don't know.
Engine codes are P0011/P0014/P0462
The P0011/P0014 are, i think, the oil control valve. I ordered that.
The P0462 code has to do with low voltage to the fuel level sensor, but the gas gauge has worked fine, well other than when none of the gauges work. Still I don't think it relates to cluster problem.
So the window switches and hatch release switch have decided they want to stop working. Along with actually locking my car from the inside or keyfob. I have checked all the fuses and the wiring looks to be intact. The hatch release switch doesn't work but the fuel door switch Does work. The passenger side window switch also isn't working and of course both Windows are down.
View 6 Replies