Golf IV / Jetta IV :: Right Turn Signal Won't Turn Off After Locking With Alarm
Jan 21, 2016
I would like to start off by saying I am new to this forum. I bought a 2005 Jetta GLI a couple of months ago and from the first day I noticed that occasionally when I would lock it with the alarm, the right turn signal would stay on. It was not much of a problem as I would just press the lock on the remote again a couple of times to turn it off. Lately it has become more frequent and annoying. I have to wait up to an hour so I can finally turn it off through the remote. I was thinking the relay probably.
View 15 Replies
Advertisement
I just bought a 2002 Jetta 1.8t today and have a few questions for some of you with vast knowledge on these cars.
1) When I lock the car the interior lights don't turn off, and about 5 seconds later the dash lights turn on. I sat outside in a lawn chair and waited 10 minutes to see if they would go off and they didn't. Would that be a faulty door switch or the CCM acting up?
2) Doing a 3" catless downpipe with 3" straight pipe?
3) Are there any major issues I should look out for? The car seems to be in pretty good mechanical condition, minus a loose exhaust hanger that rattles at idle. Not bad for 119,00 miles.
View 2 Replies
Had an issue arise today where out of the blue my turn signal decided to turn on and stay on... and i do not mean it was blinking as if i was going to turn i mean solid on, no clue what caused the issue, the stalk is still in the middle position, and when i turn the other side on (passenger/right) it blinks normally, now if I turn the hazards on they both come on and stay on solid, this problem does not even stop when i pull the key out of the ignition, I have to remove the negative battery strap for it to turn off completely.
View 3 Replies
I seem to have a problem with my jetta. It's the 1.8t. When I turn the turn signal on, I can see the dash and headlights dim. Also when I tried putting both windows up at the same time, the car seemed to short out and almost shut off. It reset the time and trip mileage when it did so.
View 1 Replies
So my turn signal stalk doesn't go back to neutral after a turn.. also, I don't hear the usually " clicking when turning the wheel that you hear when it goes far enough to re-set itself. What controls this action? Its not the clock spring thing commonly referenced to the airbag airbag is it?
View 2 Replies
Im switching out the bulbs on the front turn signal light today, I reach my fat little fingers in there and can barely pull off the wire harness that goes into the back of it. When I did this the wire coverings on all three wires just disintegrated I would guess from the heat inside the headlight. Wel there's a short from where they are touching and my signals don't work at all. my question is I can hardly even reach my fingers down in there too remove that wiring harness ( which is the shortest wire ive ever seen) is it necessary for me to remove the grill the front bumper and each headlight in order to access the wires better?
View 5 Replies
Driving home the other day my right turn signal stopped working. Checked all lights when I got home and the front signal had a constant but low illumination and all the other lights were mostly out as well, very little was working actually.
Pulled the bumper and head lamp tonight. The plastic connector on the low beam was melted and the wires were burnt. The problem was the two brown wires that are sort of routed together. Third wire (grey or another shade of brown depending on headlight manufacturer) was OK.
Headlights are aftermarket, Volx Tuning, < 1 yr old. The rest of the harness inside the assembly looks good- certainly don't see any opportunities for a short.
I replaced the connector and bad section of wire and plugged it back in for a test. All lights were then 100% operational. I removed the assembly to find that the same lamp was smoking again. (I sort of expected this, but had to try.)
Clearly I've got a short somewhere but where do I start? The part of the vehicle's wiring harness that is visible behind the assembly is in good condition. The lamp itself (H7 I believe?) appears OK as well, I don't guess I get so so lucky as to hear those can develop an internal short in the base or something?
View 1 Replies
My Jetta has had an off-and-on clicky turn signal sound without turn signals or hazard lights actually blinking. I put up with it for a while, but recently it's been more clicky than not. I'm aware this is a common problem. I had already tried the cleaner spray "trick" which made the problem worse if anything. Today, I removed my signal stalk as described here and gave it a cleaning. After re-assembling, the clicky problem didn't go away, and now the high beams are always on (even with the key out of the ignition, and the car isn't running). I temporarily dealt with this by pulling fuses 18 and 19 for high beams. It's an ok short-term workaround. Low beams still work fine.
I'm considering replacing the hazard signal relay, but a while ago I messed up while trying to use ghetto removal keys to pull my radio.
View 4 Replies
I'm having a weird issue with my passenger side turn signal light. It's more of an annoyance than an actual problem. When I turn on my headlights both yellow turn signal lights also usually turn on but the passenger side one is not turning on anymore. The odd thing is that it still blinks as normal when I engage the turn signal. I replaced the bulb but it did not resolve the issue. I'm thinking it's an electrical short somewhere. It's not the wiring in the headlight housing because I tried an old housing I kept when I replaced my headlights last year and I still had the same issue. What I should check first?
View 1 Replies
So I have an 05 MK4 GLI, my alarm has not worked since the day I got it. Hold the alarm button on the fob, no luck. when I lock or unlock the car, the lights don't flash and the horn doesn't beep. My ex had an 03 GLS 2.0, alarm/lock/unlock worked without a problem, so why mine doesn't work.
View 7 Replies
I have a 2004.5 Jetta GLi and I want to get rid of the Amber turn signal inside the headlight. Do they sell a clear or smoked lens for that, or do I have to buy new headlights all together?
View 3 Replies
I was on the way home tonight and I noticed the driver side HID headlight turn off after putting my turn signal on.
I have LED DRL fog lights installed and they're wired with no relay and plugged into the Engine Compartment fuse box. The installer connected them on the left side (where the wires come in, from the two black components by the air filter).
Could this wiring setup be interfering with the HID's?
View 9 Replies
Jumped in the truck this evening to go to the store and when I stared it up the left turn signal was blinking. Lifted the arm as usual to cancel and it does not cancel. Cannot get the left signal off unless I hold the turn signal up for the right signal. The right signal does not activate, but the left does go out as long as I hold the arm up. Let go and the left starts blinking again. Tried driving around to see if it would cancel and no luck. The bulbs are all good. I checked the relays in the fuse panel and they are good. Dang thing just won't shut off. It is a 2011 F150 SCREW Platinum w/5.0.
View 4 Replies
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 Replies
Just wondering if its possible to have 2015 Sonata SE Headlights to turn Off when turn signal on and turn On when turn signal is Off...
View 6 Replies
Was wondering how to remove the turn signal bulbs in the OEM LED taillights.. Ordered Some new bulbs and decided to see how hard it was to change out. Removed taillight and located socket the contained the bulb. Looks like it should twist to unlock but only turns a little. looks like it wants to turn counter clockwise.
View 2 Replies
So I was doing the DRL - Dimming on indication mod with the VAGCOM. I used the following steps:
Go to [09] Central Electronics
Go to Security Access and enter 31347
Go to adaptation channels and set the following (they're quite far down the list):
"Leuchte2SL VLB10-Lichtfunktion G 2" to Blinken links active (besides Phasen)
"Leuchte2SL VLB10-Dimmwert GH 2" to 35
"Leuchte2SL VLB10-Dimming Direction GH 2" to minimize
"Leuchte3SL VRB21-Lichtfunktion G 3" to Blinken rechts aktiv (beide Phasen)
"Leuchte3SL VRB21-Dimmwert GH 3" to 35
"Leuchte3SL VRB21-Dimming Direction GH 3" to minimize
Now my right front turn signal is inop. Checked voltage and swapped bulbs left to right. the bulb is good. No sure what I did. Could I have disabled the blinker somehow? Where is the channel for the right front blinker?
View 1 Replies
Just now toward the end of my drive to work the turn signal clicker was possessed and randomly clicks. Still clicks as normal when I turn on the signals.
View 21 Replies
The other day this started and hasnt quit. I was driving to work and after i used my turn signal and everything worked correctly and as it shoud except for the noise. The turn signal noise keeps ticking, sometimes at a fast pase, after i make a turn and the signal turns off. And will continue to do so even though i havent even used my turn signals.
View 7 Replies
A couple of months ago my turn signal ticker decided to keep ticking after I stopped using the signal. It would happen in either direction, full signal use with automatic return, and if only using the signal stalk to move over a lane (not fully pressing the stalk down). Problem went away but is now back. At first I thought a light bulb was out since the noise was kind of fast. All my bulbs light up and all functions are normal. It is only the noise that is the issue. My signal does not stay on when I get this extra noise. what can I do to fix it?
View 7 Replies
I only have access to an old VAS scan. I can only edit the long code directly.
I'm looking for the value (hex or binary) I need to put on Central Electronics (09), Byte 15, Bit 3 in order to turn the drl off when turn signal is on.
I have a canadian 2012 GTI with bixenon and rear led.
[URL] ....
View 1 Replies
