Golf IV / Jetta IV :: Passenger Side Thud Sound When Going Over Bumps And Left Hand Turns
Sep 22, 2014
My passenger side has been making thud noises on a number of occasions on my 01 Jetta 1.8t:
1. When I go over bumps, the front passenger side will make a loud thud noise.
2. When I take my foot off the brake, there will be a loud thud from the front passenger side as well.
3. When making left hand turns and I begin to turn the wheel back to return it to its original position, there is a thud coming from the front passenger side as well.
It does not continuously click like a bad CV joint would. All these symptoms came at the same time period.
View 3 Replies
Advertisement
I have the most terrible clunking/rubbing sound on my right passenger side, especially when I'm turning left. When I drive straight it sounds like the wheel is hopping even when going over minuscule imperfections in the road. I also get a terrible rub when going over speed bumps or into grooves and dips in the road.
I've searched and searched but cannot come up with a answer towards rectifying the issue. My car hasn't been lowered; I'm running the stop 337 suspension. I've replaced the following within the past two years:
-control arm bushings
-ball joints
-tie rod ends
-upper strut bushings and bearings
-passenger side axle
-dog bone mount
-engine mount
-tranny mount
Most recently:
-front struts
-sway bar end-links
-driver's side axle
It seems to like everything should be solid considering I've done all of this crap. I don't understand why I'm having this issue and why it sounds like it is getting worse and worse.
View 18 Replies
06 sonata v6 standard 16in tires. I do all my maintenance, but i am stumped. A sound that is best described as a rattle crossed with a metal object (bolt/nut) rolling down a rail. Strange i know. Checked for rubbing, nothing. Made sure all bolts and nuts were correctly tight. Does it whether braking or not during any speed. May be dropped object, but neither I or a mechanic could repeat during Right hand turn. I have changed my front pads and dbl checked that is not the cause ( was doing it before change anyway) my fear is I'm missing something and am fearful of a mechanical failure.
View 9 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
View 8 Replies
I did my pads and rotors this weekend. On the fronts I had some difficulty with the passengers side retaining clip. It was stuck in on the bottom. I wound up bending it out of place trying to get it off, and eventually just removed the caliper without it.
I took it out for it's first regular drive today and there is a rattling noise when the passenger's side goes over bumps (could be front or back, hard to say). I have theorized that the clip is deformed enough that when it gets jostled, it bumps out onto the rim which makes it go twang (which would be consistent, it's a relatively high pitched rattle. I'm going to look at it tomorrow, but I'm not sure what I should actually do. Can I just clip it off? What purpose does it serve? I might be able to get it out with WD40 and bend it in to shape.
View 5 Replies
I am having a problem with my 2007 R32 manual,over the last few weeks its developed a whining noise in what seems to sound from the rear left side,more so when driving around a left hand corner (weight is off the noisy side),or when i let my foot off the gas and let the car run,ive jacked it up and when I grab the back left drive shaft and shake it, I found there's a bit of play on the side going into the diff, there's 70000 miles on it and no problems to date, looking for some info on what problem could be?
View 6 Replies
FYI This is on the passenger side. Should I just replace the whole metal shaft? Can I just replace the rubber thing that is severed? If this is the wheel bearing do i need to get it repacked?
I am replacing the whole suspension because I started hearing a "pfft" sound going over bumps and sometimes a clunk on the passenger side when cornering to the right. is this severed leaking rubber thing the main cause of the clunk perhaps?
View 13 Replies
What is the cause for a clicking sound coming from Left hand side wheelwell area when I make semi tight Left hand turns from a parked/stationary position?
View 4 Replies
I got a brand new 2011 Mazda 3 i Sport 4 door sedan in May and it's been great so far. Lately though, I have started to hear a sound coming from the back left hand side of the car. It really closely resembles the sound of tapping one's finger on a counter top. When I'm stopped, there's no noise but when I go I can hear it. As I go faster it goes faster as well and when I slow down it slows down. What is going on?
View 2 Replies
I have a 2002 Accent that has this clicking sound coming from what sounds to be the left hand side under the hood. The click sounds like two marbles colliding. The car runs ok otherwise, but I would like to know about that sound.
I took a video, but its kind of hard to hear it. But if you listen close enough, you can hear it.
2002 Hyundai Accent click noise in engine - YouTube ...
View 4 Replies
Just installed raxle on my driver side. All clicking sounds are fixed but I noticed if I take right turns sometimes you can hear a constant clunking sound coming from the driver side wheel. It doesn't happen all the time, you kinda have to turn and hit a certain angle of the steering wheel. Also, only happens when driving low, if I raise the car just a little bit its gone. Never had issues with my oem axle binding so Im not sure how exactly does the binding sound?
View 24 Replies
I have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 Replies
I have been getting this weird bumpy feeling when making left hand turns and even sometimes when going strait on the road. It does not seem to effect the breaking for acceleration of the car. This does not happen all the time and will start and stop without any change in driving.
View 22 Replies
There is a knocking sound in the rear passenger side area. Cannot diagnose the cause, what it could be. I checked the bushings for the anti sway Bar but that was not it.
View 1 Replies
The car is a 2.8L w/ a manual tranny. The car was making a rhythmic clunking and clicking noise around right hand turns on the left wheel. So when the weight of the vehicle is applied to the left, that's when the noise occurs. The car has been in the shop for 6 days and the technicians have replaced both axle shafts (it was time to do so anyway) but the noise is still there!!! What could possibly be making that noise other than bad CV's? The rhythm of the noise coincides with the rotation of the wheel/shaft which is where they have focused. Could it possibly be bad strut mounts? This is driving me crazy!!! They tell me its perfectly safe to drive (how do they know this when thy don't know whats wrong?) but I can't imagine this can carry on much longer without something breaking.
View 2 Replies
I have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 Replies
I just got a 2001 Jetta 1.8t 100k miles, and had some repairs done - timing belt - K03S Turbo - Forge Tip - 2.5 Turboback Exhaust. I bought the car without a working turbo, yesterday I got the car back from the shop and it was a night and day difference..... but to my point, today I had some CEL's pop - Charge Pressure control positive deviation, Pressure drop between turbo and throttle valve, and secondary Air injection system incorrect flow detected. Now I have never owned a turbocharged car before, but when my windows are rolled up and im accelerating, I can hear what I am guessing is the turbo starting to spin over by my passenger side(2k ish rpms+) except it doesn't have clean spin sounds, kinda sounds like bearings are goofed or something. This noise only happens when I am accelerating or cruising? I also have felt really no change is boost or power!!
View 2 Replies
My wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
View 2 Replies
I've just bought a 1996 celica GT. It has very low mileage and is in great general shape for it's age. There is one thing that annoys me and it's a clicking sound coming from the rear passenger side wheel when going over bumps (I hear it a low speeds as tire noise take over after I guess). I was wondering if I should be looking for different signs when I jack it up? Worn bushings? And is there a way to reproduce the sound. I've read about the rear bushing being a problem on these cars... is it true?
View 5 Replies
So I'm also noticing my car occasionally makes a huge thud sound from time to time when I put it into two certain gears. From park to reverse it's not loud but there's a little noise, but from any gear into Drive it's sometimes a loud boom and the car shakes. My pops mentioned to me this is dangerous because of how the engine is moving underneath the hood when it happens. I just recently changed the dog bone mount, could it be the others? I'm ware that it's wise to change all 3 if you change one but I was on a budget & it was a lot worse before. Someone mentioned it might be my torque converter but I did some research & the two symptoms don't add up. And I'll add once more that this happens occasionally & not every time I switch to a different gear. What it may be?
View 11 Replies
