Golf IV / Jetta IV :: Hard Time Starting / Engine Turned Over But Wouldn't Fire
Sep 8, 2015
2003 1.8t gti ... Today when I got in my car...it fired up perfectly normal but when I got in it from leaving school it took 5min to fire up. The engine turned over but wouldn't fire all the time as if the spark plugs were bad. So I bought new NGK spark plugs and had the same issue just a little bit ago.
I know the obvious thing would be to change the ignition coils but they're out of stock everywhere so I have to have them shipped. My question is is the ignition coils the problem? They looked a bit worn but nothing serious.
View 10 Replies
Advertisement
So I've had my car for 3 years now. I've done an emissions delete, replaced maf, diverter valve, coolant temp sensor, thermostat, timing belt kit, fuel filter, air filter, starter and battery (for another issue) have a 3" DP and replaced the O2 when I did that, valve cover gasket, spark plugs, tested another n75 in my car.
The problem: the car sometimes has a really hard time starting when it it way below freezing. When it's around cold, at freezing or under the car will start fine. But the problem starts after I back out of my driveway and take the clutch out and put on the gas. When I try to accelerate the car will not accelerate. You can have your foot pressed to the floor and the car will act as it's stalling out and sputter but it actually won't stall because the call will keep driving and then all of a sudden power will come back and it will take off. The situation can be remedied by either pushing the clutch in. The car will idle no mall or if when the car is sputtering I can tap the gas quickly an it will build up speed and the problem will go away.
View 1 Replies
I have 2002 2.0 Jetta that I totaled. I found a 2000 2.0 Jetta that had no engine or tran. I swapped the entire wiring harness with the engine and trans from 2002 into 2000. I even swapped the doors. The cluster, steering column and all. I am still in the process of getting a few parts to finish it up. At this point, the only thing not hooked up is the headlights and the radiator. I hooked up a battery and tried to get it to turn over today. I turned the key to the on position and the cluster did not do anything. The engine turned over very slowly in the start position.
View 21 Replies
03 Jetta 1.8T AC is giving me fits. When the compressor comes on the AC is nice and cold. Problem is that it isn't on very much. Today was a good example. No AC for about the first 30 min drive to get an oil change (local driving). Next 40 min highway drive, AC only got cold for the last 20 minutes and then started to warm up before I got to work. Drove to auto parts place at lunch, AC cold from start to finish. No AC all the way back to work.
So, this evening I started the car with the hood up and watched. Compressor wouldn't engage. Pushed the AC button a couple of times and clutch engages. Compressor stayed on for 7 minutes and ice cold air. Clutch then disengaged and immediately both fans went to high speed for about 5 minutes with warm air out the vents.
Fans cycled back to low speed and compressor clutch engaged again for about 2 minutes this time. Fans to high speed again for 3 minutes, then compressor engaged for only a minute. Each time the compressor shut down, both fans would go to high revs. The minute they would go to low speed, the compressor clutch would engage and I'd get nice cold air..
Just had the expansion valve replaced and r134a charged by and AC shop last week. I have had the on/off AC problem for months and then could not get the compressor to engage at all for about one month. Of course, just as I was getting to the shop, it started blowing cold air.
Not sure whether I'm looking at an electrical problem or what. Just seems odd that both fans suddenly speed up and slow down and the compressor engages only on low speed.
The only other odd thing I've noticed is that cold or hot, as soon as I turn the ignition on (engine off), one fan continually starts cycling on and off. It does that continuously. I've checked the fuses on top of the battery and they all look fine. No appreciable drop in RPMs when the compressor engages. Fan control module?
View 7 Replies
I have a 1.8T with 152kmiles
Recently, both the coolant reservoir 'Y' connector and the driver side coolant flange cracked and I was shooting G12 all over the engine. I've replaced both of the parts and the coolant temp sensor with a "green top". Reservoir was refilled with the proper ratio of G12 to distilled water, ran for a bit and topped off accordingly.
This morning I started my drive to work and the engine temp was at 0 for a minute or so and started to climb slowly to 190. It stayed at 190 until I took the exit to the highway and the temp slowly started to rise while I was at 60mph. I immediately turned around and went back home with the heat cranked to high. With the heat on, the engine temp would slowly go down but then rise again if I, A. turned the heat off or B. made a hard pull up to ~55+mph.
I popped the hood and the coolant was not boiling and I couldn't see/smell/hear any leak. could this be the thermostat or is this a water pump issue? I plan on taking the thermostat off and checking the pump empellars for any shards. I'm not sure but I do believe the water pump was replaced by my parents while I was on deployment.
View 2 Replies
My high mileage V6 1999 Sierra starts fine and runs great in the morning or when it is cold. As soon a you try to restart hot is spins fast enough, but has a very hard time starting. When it does start, there is smoke from the gas and the engine idles very high for about 10 minutes before settling down. Same thing reoccurs over and over when the engine is hot. May idle up to 2500 rpm, cant kick it off.
View 3 Replies
I only see this issue after I've been driving a while and I've just topped off. I don't always use the same octane, (I'll use higher octane on long drives) so I may be mixing octanes on these occurrences. But I will have a problem getting the car turned over after filling up. I hold the starter on and pump the gas to get it started (maybe 5-10 seconds).
2.slow BEV engine
2004 GL
107K miles
View 2 Replies
My Focus has 102,000 miles. It has thrown a p0171 code and I have been attempting to fix it. So far this is what I have done:Changed MAF, air filter, PCV Valve, plugs, Valve cover gaskets, Bank 1 O2 sensor and fuel filter. All new. I have cleaned the throttle body, fuel rail intake manifold. Cannot hear vacuum leaks and tested for leaks with carb cleaner.
Symptoms: engine cranks but has a hard time starting, usually on second try. When tank is about half full I get Rough acceleration, higher RPMs (doesn't change gear) and engine stalls on hard left turns. Idle gets rough at times but usually stabilizes at around 700 rpms.
At the beginning, #1 spark plug chamber had a lot of oil in it. It's been a few months and no oil after Valve cover gasket and PCV change. Tested coils and the plugs get a spark. Before I start messing with the fuel pump, am I missing something else that I can do?
View 19 Replies
I have Golf MK4 variant 1.6 77kw BCB 2005y
When i crank engine i hear it fire immediately for a fraction of a second, then it carries cranking empty few turns and then fires again.
Happens only on a first start after standing still few hours.
[URL] ....
View 5 Replies
On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
View 3 Replies
2001 VW Jetta 1.8t automatic.
Transmission has a hard time going into 1st and reverse. Also some times hits hard going into third. I have a CEL for a vehicle speed sensor? Was wondering if it's not the VSS but maybe one of the other tranny sensors?
Separate question. Same car has a rough idle issue. Occasionally stalls but intermittently runs normal always has a low idle around 600 rpm. I have a code for an injector on cylinder three.
VSS code : P0725 - engine speed sensor circuit malfunction
Injector code : P0203 - injector circuit open cyl 3
View 4 Replies
After running to operating temp, if the car is turned off then restarted (like you would at a gas station, which is where I notice this) the engine will turn and turn and turn but not fire. I have noticed that stomping on the acceleration will cough it into life during this procedure. This doesn't happen every time and I have recently run high octane gas during a long distance trip.
106K miles...
Recent p0441 fault codes and gas cap warning light...
No other problems or codes...
View 4 Replies
Was having some issues with my 2000 Passat not starting after only being turned off for a short period of time (long periods of time no problem). My check engine light came was on along with the Emissions Workshop message in the display. I took it in and had it serviced at my local repair shop. They said it was something with a temperature gauge or something to that effect that was causing it to lose a temp reading. Anyways, after the repair the car starts fine, runs great, the check engine light went off and so did the Emissions Workshop display. Then a few days later it came back on...still not having any issues with it starting but what's going on??
View 7 Replies
I need to put a starter in my v6. Is it fairly simple or will i have to jack up the motor the problem is it starts fine when cold but after you drive it for a short distance and shut it off it has a hard time starting.
View 4 Replies
I'm having a issue with my Chevy Lumina Z34 (1991). When it's cold outside the car has a hard time starting up! I have to crank it multiple times while giving it gas. When it starts and is warm she runs great. I've been recommended to get a fuel injector flush. I also read synthetic oil could work also. It doesn't happen all the time.
View 1 Replies
In the morning, my Treg won't start on the first attempt. If I just click the key to the right (to start the automatic ignition process) it just grinds and grinds then dies. The second time it will start. This has only happened the last couple of days. Also I should mention that it has gotten quite cold around here. Although the car is in a garage and my wife's Jetta fires right up.
I've also been having Insufficient Coolant problems. After one week of owning it I took it to the dealer and they topped off the coolant. A week later the Insufficient Coolant message came on again and I topped it off with about 1 quart (litre) of distilled water. It's been ok for the last day or so. I haven't seen any external leaks. I love my Touareg, but I really hope this isn't the beginning of a bunch of problems.
View 3 Replies
Vehicle- 98 honda crv lx problem- it always starts when its cold (hasn't run for several hrs). Once its been running for a short while and is shut off, it either has a very hard time starting again or just won't start.
specifics- always starts the first time once engine is warm the problem starts engine turns but doesn't fire. Wears downs the battery. When I get it jumped the car will start sometimes the car will act sluggish during a left turn or from a dead stop when trying to accelerate quickly.
question- does this sound fuel pump related or battery related or both?
statement- car problems blow!
View 4 Replies
I have about 26,000 Miles on it, this afternoon I tried to start it. The starter engaged and turned over and over and over, but the engine wouldn't start. Then I took the key out, waited 5 seconds, and tried again, it started. It was about 60 degrees out, so it wasn't cold. Half a tank of gas.
This may seem a little petty, but its a 2012 with only 26,000 Miles on it.
View 1 Replies
Hard time getting your manual MK6 to shift smoothly when the engine is cool after sitting overnight?? Got about 4k miles on it and I don't recall it happening when I first got it. Started maybe at 2k miles and happens every morning. It seems to only happen to me until the car warms up and then its fine, it jerks like if I was learning how to drive a manual.
View 16 Replies
Our 1997 Lumina with a 3.1 liter engine and about 190,000KMS is having difficulty starting in the morning.
I have changed the spark plugs, plug wires, checked the connections to the battery and put dielectric grease on them. None of that seemed to make much of a difference. The key has to be held for about 5-7 seconds and it coughs to life and then runs rough for about another 5 seconds and the interior lights are dim during this too. After that it comes to life and runs great.
Is it possible for starters to start to weaken? I have never had a starter do that, they have either worked or not. Besides that, I don't know what else could be the problem.
I have heard that these engines can have condensation issues when the temperature straddles the freezing mark, which it has been the last few weeks. Maybe it just needs to get below zero and stay there?
View 14 Replies
My 2005 Santa Fe needs a purge valve.
View 3 Replies
