Golf IV / Jetta IV :: For Valve Cover Replacement Spark Plug Should Be Taken Off?
Jun 21, 2014
In order to replace the valve cover do the spark plugs have to be taken off ?
View 12 Replies
Jun 21, 2014
Advertisement
Golf IV / Jetta IV :: Misfiring After Valve Cover Gasket Replacement
I did a valve cover gasket replacement. Changed all spark plugs and coilpacks. The car is still misfiring. I also just did the timing belt and water pump. Why it's still misfiring?? I'm new to this whole forum thing so bear with me lol. I'm wondering if it would be my cat, fuel pump, fuel filter. Or could it be a sensor?
View 2 RepliesGolf V R32 :: Throwing P0174 Code After Valve Cover Replacement
A couple months ago I was hearing a hissing noise under the hood throwing the same code replaced the Valve cover, after there was no issues. Yesterday saw I had CEL and I was throwing P0174 code and there is a similar vacuum leak sound coming from under the hood but the Breather in the valve cover is not sucking in air. The Oil cap comes off but the engine starts to bog, what it could be now?
View 2 RepliesGolf IV / Jetta IV :: Oil From Valve Cover Leak In Pistons
I drive a 2003 24V VR6 GLI
I recently did a valve cover repair to stop the dreaded misfire problem. Well, I'm still waiting on a few things but during the spark plug change obviously some of the oil from where the valve cover leaked previously fell into the pistons because I couldn't really clean it all out efficiently. This seems like it would cause a lot of problems? Do you think I should throw old spark plugs in there and let all the oil burn up before finally replacing them? I really don't want to foul up my brand new NGK's.
Also, I pulled p0300, p0305, p0306, so I am guessing oil in the spark plug/coil pack connection may cause some of the misfires, but do you think two of my coil packs are bad still? My plan was to move them around to see what happens after I get the new parts and am actually running again.
Golf IV / Jetta IV :: 2001 - Valve Cover Gasket Is Leaking Oil
I'm thinking of purchasing a 2001 GLX VR6 Jetta with lots of deferred maintenance (shocks/struts, brakes, exhaust). Most worryingly, the valve cover gasket is leaking oil. The price is pretty low, but is such a beast worthwhile at any price or is it better parted out? And the interior is about as beat up as the mechanical--screeching passenger window motor, broken glove compartment ... Is this thing worth being brought back to life?
View 6 RepliesGolf IV / Jetta IV :: Camshaft Chain Hitting Against The Valve Cover
I know this isn't the usual ticking of the injectors and I believe it's to fast to be a lifter tapping. I believe it's the camshaft chain hitting against the valve cover. I took the valve cover off and the chain is still tensioned tightly so it makes me wonder what this could be..
View 1 RepliesGolf IV / Jetta IV :: Engine Won't Start After Replacing Valve Cover Gasket
My mk4 sat for a while and upon starting up was misfiring. I checked for pvc leaks and didn't see anything but went ahead and cleaned my maf sensor and decided to pull my coils. Cylinder 1 had oil on the tip and around the spark plug which to me spelled out a bad valve cover gasket. I got all the parts to do the inner and outer gaskets and replace the coil and spark plug, however we got a snowstorm and my luck a rabbit got in and ate the wiring on one of my fuel injector connectors.
So went ahead and put on the new gasket, replaced the coil and plug and bought a new Fuel Injector Connector and spliced in onto the Injector "Pigtail'. I double checked everything was reattached properly and let the gasket sealant dry for 24 hours. I went to start it tonight and after trying to turnover it completely cuts out, wont even start up. I'm extremely frustrated at this point and am thinking the rabbit must have gotten to something else unless I did something wrong in the process of repairing.
Golf IV / Jetta IV :: New Valve Cover Gasket - EPC Light On / Stalling At Idle
New valve cover gasket on my 03 VR6 GTI, new plugs, oil filter and cooler seals, new gaskets on the intake manifold and when we started it up . . . .
[URL] .....
It runs rough.
EPC light is on.
Stall at idle.
Runs great at full throttle.
Golf IV / Jetta IV :: 2002 - Code PO343 Came Up After New Temp Sensor And Valve Cover Gasket
I have a a 02 jetta 1.8 turbo the code po343 came up after new temp sensor,valve cover gasket and full tune up. is it an easy fix the car is misfiring an very hard starting.
View 1 RepliesGolf IV / Jetta IV :: 2000 - Blinking CEL / Misfire / Oil On Spark Plug
2000 Jetta AEG ... An intermittent CEL light turned into a blinking CEL after a few months. Checked codes and it threw a P0303 (misfire on Cyl 3).
Pulled the plugs and found this:
There was oil dripping off of the plug from Cyl 3.
I last changed the plugs in July 2014 and only drove around 10k miles this past year.
When I changed them back then though Cly 3 looked like this:
Before I changed them back then I had an oil cooler gasket fail on the freeway and oil shot everywhere under my hood. Obviously oil is in there and it is causing problems.
I have read online and most of what I have read says that it's likely an issue with the VCG (Valve Cover Gasket) or the PCV (Pressure Control Valve) that is allowing oil to get to that part of the spark plug tube. I've also seen some non VW stuff talking about replacing the spark plug tubes.
Also it does appear that there is a little bit of oil around the threads of the other plugs but nothing getting to the all the way to the tip around the electrode.
I have pulled the plugs, wires and the ignition coil as well ... I'm ready for whatever. I am by no means a mechanic but I am capable of following instructions and doing what is needed. My problem is generally finding out what is needed to be fixed.
Golf IV / Jetta IV :: Heater Control Valve Replacement
Replacing a heater control valve for a 2004 Jetta? My car's vents only blow hot, and I checked the cables and saw that the control arm was disconnected. I tried to put the cylinder piece back in and had some luck, but I can't get it to sit tightly in there and it keeps falling out. Also, it still wont change the temperature coming out of the vents. I assume that something broke on the inside piece that the cylinder connected to.
[URL] ......
Here is an example of what mine kind of looks like, but mine is way more loose.
Camry :: Valve Cover Gasket Replacement On 2006 V6
So I'll be taking on a project to replace the valve cover gasket on my 2002 Camry V6. There's a bit of leakage through the gasket. And while I'm at it, I'll replace the spark plugs as well. I'm looking for a write up on this project. did a lot of searching but couldn't find anything.
View 14 RepliesSanta FE SM (2001-06) :: Valve Cover Gasket Replacement
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 RepliesInfiniti - G35 :: 2006 - Valve Cover And Gaskets Replacement
I have a 2006 Infiniti G35 base sedan. The dealer noticed oil on the engine and said that I needed to replace both valve covers and gaskets -- My question: Why is it necessary to replace the valve covers and not just the gaskets?
View 6 RepliesAvalon 2005-12 :: Valve Cover Gasket Replacement
A few days ago I noticed some oil leaking from the left (front) valve cover area and I suspect it's the gasket. Fortunately, I didn't see any leaks from the back cover. It seemed like an easy job to replace the gasket, but as I started to disconnect the wiring, e.g., cam sensor, spark plugs, etc., I can't seem to find a way to remove the black plastic wiring harness 'housing' out of the way.
View 1 RepliesLexus SC430 :: 2002 - Valve Cover Gasket Replacement?
How to replace valve cover gaskets on 2002 430sc???
View 14 RepliesAccent LC (2000-05) :: 2002 - Valve Cover Gasket Replacement
Replaced this gasket that seems to be leaking oil. Looks simple enough, is there anything i should do or know before taking on this job? It's a 2002 Accent GS 1.5L ....
View 8 RepliesMercury - Sable :: 2008 - Cutting Off After Valve Cover Replacement
I have an 2008 Mercury Sable Premiere with a 148 miles on it. Just got the Valve Cover gasket replaced and new water pump put on. The car is running very smooth as it always done,but now when coming to a stop,it either acts like it wants to cut off or sometimes it just shuts off. When it cuts off I immediately crank it back up and it starts, but why or what could be the problem? It also starts up a little slower than before and I know its not the battery because that's brand new.
View 6 RepliesPassat (B5) :: Oil Loss After Cam Tensioner And Valve Cover Gasket Replacement
I noticed the oil smell that can be associated with a leaking Cam Tensioner Adjustor Seal from my 2003 1.8T Passat a few months ago. The dealer confirmed that it was leaking and that it was covered by my extended warranty since my car was 5 years old and at 70K miles. I had the work done and after I picked up the car I noticed that the oil level was at the top of the hashes not at the top bend like it was when I took it in.
I don't know what caused it to drop to the hashes but I do know that the level has dropped to 3 visible hashes in the little over 1K that has been put on the car since then. I am concerned because in it's first 70K miles the car did not visibly lose a drop of oil.
Any logical cause for this annoying trend, the only thing that changed was that the Cam Tensioner and Valve Cover Gaskets were replaced. Is it possible something else was messed up during the repair?
Ford F-150 (2004-2008) :: PCV Replacement Without Taking Off The Valve Cover?
5.4L 3v engine: The PCV is located in the drivers side valve cover. Tried to pull it out with no success and came to the conclusion that maybe it's threaded and a nut locks it in from the underside of the valve cover. Can this thing be replaced without taking off the valve cover?
View 4 RepliesFord Excursion :: Spark Plug Replacement?
OK, this technically isn't for the Ex (since it's a diesel), but I do need to replace the spark plugs in a Ford V8 soon. Problem is I've been running diesels for a long time and haven't really kept up with spark plugs.
Seems like there's lots to choose from now. Regular old fashioned, double tip, triple tip, platinum, kryptonite, thermo-nuclear tip, etc. Is one spark plug really any better than another, or is it all just marketing gimmicks? Is it worth spending extra for some fancy sounding spark plug?