Golf IV / Jetta IV :: Engine Whine At Above 4000 RPMs
Jul 17, 2014
I've had a weird problem pop up within the past few weeks. My engine seems to have a noticeable whine above 4000 RPMs. It sounds almost like a supercharger whine, but my engine is completely stock. Possible problems I found online include exhaust leak, vacuum leak or tensioner issue for the belts.
Another issue I have had is that whenever shifting into second gear, I have some difficulty getting it into second gear. It makes a scraping sound as though the clutch is not disengaged all the way. On occasion, I have also had the shifter kind of pop second gear out when continuing onto third or even feel like it is rejecting second gear sometimes. A friend of mine told me that the scraping sound is normal and, "that's just how manuals are." Doesn't seem normal to me especially since it is every time I shift to second gear.
View 7 Replies
Advertisement
My VR6 is making a ticking sound when i accelerate, between 2800-3100, then it dies down a little and then gets loudest at about 3600-4000. The noise stops at exactly 4000rpms every time. Here is a sound clip of what the noise sounds like... you can hear it best in the last 15 seconds or so in the video. Maybe its the timing chains...
[URL] .....
View 19 Replies
So I drive a 2008 R32/U.S. spec and I was in neutral when I pressed the throttle and it would not rev over 4000 rpms and was wondering why??
View 24 Replies
My hybrid has been a great car, owned 3 years. Now have problem: runs great but if going higher speed 65 and pulls hill needing to kick in to 4000rpms it dies right away says high temp engine but does not smell hot or need water. Let it sit for 15 minutes (even though will start right away but might keep dying unless sits). Will run fine unless hits higher rpms then dies again. 2005 Ford Escape Hybrid...
View 5 Replies
I have an 05 jetta 2.0 and I had a loud whine on passenger side of engine. I removed serpentine belt and ran engine briefly and noise was still there. Figured it was water pump or tensioner. and when I was changing timing belt, tension, and water pump I found it was the timing belt itself that was whining. It was OEM original belt with 140,000 miles on it. The belt was in very good shape no tears just used looking. Now engine is very quiet.
View 1 Replies
So I replaced the engine and trans engine mounts on my 2004 R32 today. After I got done and drove it there was some serious vibration and gear whine. It also seemed like I wasn't able to transfer all the power to the wheels, it was definitely slower to accelerate. Did something go out of alignment?
View 10 Replies
I have a 2002 vw golf and its epc light keeps coming on and every time I reach 4000 rpm it goes into limp mode, what is the problem.
View 2 Replies
Sound shown in video. This is when vehicle is idle, as rpm's change the sound becomes more frequent. Check engine came on about a week or two ago, not sure if its related (haven't gotten the chance to get it read yet).
[URL] .....
View 1 Replies
So ever since i put stiffer motors mounts in my car, the trans has whined. It was perfectly fine before the new motor mounts.
Its not nearly as loud as what straight cut gears sound like....but after taking my car on a road trip to Atlantic City this weekend, it does get annoying after a while. Happens every gear but at low RPMS... 1900-3000 RPMS.
4th gear seems to be the worse. This is not my daily driver so i can live with it, but if it was my daily i would be annoyed and probably but the stock mounts back in. While on the road course i do not hear it because i am at high RPMS and the noise isn't really there (well it might get muffled by the sound of the engine but i hear no whine)
I actually hear everything going on in the trans to be honest, i can hear the clutch engaging/disengaging and every move i make with the trans. (i am glad i still have the dual mass because im sure the chatter would be 10 times louder with stiffer mounts)
I run OEM trans fluid... i have heard of some guys running different fluid to quiet it down some...
View 24 Replies
2006 Kia Sorento Auto Transmission, Appx. 106k miles. My wife's car so I don't drive this very often. However, on the last trip, I noticed that it would stay in a particular gear longer than (I think) it should. The RPM's will go up to maybe 4000 or so and stay there for a while even if I let my foot off the gas before finally kicking into overdrive or the next gear and back to a comfortable cruise. I notice this mostly happened when I was going highway speeds and either passing someone or going up a hill. I can't think of the last time the transmission fluid was changed, so I'm thinking that may not be a bad place to start...
View 3 Replies
I have a '96 Saturn SL with a 1.9 SOHC. I recently removed the engine and transmission to change the clutch. I also changed the timing chain guides, the valve cover gasket, the timing chain gasket, oil pan gasket, front and rear crank seals and motor mounts. After I put it back in, it revs to 3500-4000 rpms and is very rich (so rich it smokes). I replaced the throttle position sensor since it had a crack at the plug and to see if that was the problem. I have looked at everything again and nothing is jumping out at me.
View 10 Replies
I have a 2006 chevy malibu 2.2 ecotec 4 cyl with ~130,000 miles and i am experiencing the following symptoms:
Car will not rev past 4000 RPMs or go over 70mph. I do have a check engine light with the following two codes: P0068(throttle position) and P0420(cat efficiency)
My question is instead of just replacing the cat where can i take my car (i live in tulsa, ok) to have the cat and the sensors checked before they are written off as bad?
View 19 Replies
I just installed a boost gauge and drove the car a little and this is the readings I get. It starts off with 20 inHg and to normal street driving it goes up to 0 and down. However when I pushed it a little, the maximum reading I got was 11-13PSI (High RMP-almost redline). I am a noob in this boost department so Is this readings really accurate or is there something wrong? Recently i had some transmission work done. And since then the gas pedal feels heavier. I was convinced that it is from the new bushings but I feel like this is boost related. Because at 4000 RPM sometimes It suddenly looses the boost (Kick).
View 5 Replies
I am hearing a rumbling noise when I hit 4000 rpms on all gears worst in 2nd and 3rd.... I just recently replaced the timing belt, TBA Done, valve cover gasket, and passenger side axle (through raxles). Anyways I started hearing noise after those repairs, my mechanic has gone through all the work recently done and cant find the problem..... We replaced the tranny mount thinking it was that, but no luck.... I have not lost boost, and noise starts 4000k and goes away at 4700k No codes are flashing.
View 5 Replies
Is this normal for the Camry? When you're flooring the car besides the typical roar I hear like a small high pitch noise, it's gone once I let go of the gas. I tested it & start to hear it at about 4000RPMs I believe. Recorded it on video but you can't hear it at all on video.
View 14 Replies
I have a 1990 Lincoln Mark VII, black on black, basically one owner, excellent condition... except one problem. While driving the car my speed dropped to 40mph, while my RPMs rose to 4000. Upon checking I found the plastic clip, which holds the linkage from the transmission to the accelerator had snapped. I replaced the part and still have the same problem...is my transmission smoked or is there an adjustment?
View 4 Replies
I've got a misfire problem with my Focus. It started about a month ago and did not trip a code until last week. It stumbles on acceleration between 2,000 and 4,000 rpms. It is only a slight stumble and although noticeable, it does not impede driveability much. Last week I was able to get it to finally trip an OBD code. P302 - Cylinder 2 misfire. I changed the plugs and wires with no effect. I thought I had it narrowed down to the coil or injector until my wife noticed a new wrinkle.
Under normal driving conditions the misfire is annoying, but my wife found that if she turns on the A/C, it is undriveable and will not accelerate past 30 mph without some patience and a neck brace for the bucking. My first thought was the A/C compressor was freezing up. I turned off the A/C and left the blower on and it would not stop missing. I turn off the blower and it smooths right out to the annoyance I described first.
Right now I drive the car without A/C and blower whenever I accelerate. If I'm going a steady speed, all is well and I can run the blower and A/C.
View 7 Replies
Two days ago, I was driving on a North GA steep, windy, mountain road in my 2002 v6 4.0 Ranger. All of a sudden, i started revving real high (about 4000rpms) and getting no power (20mph). I pulled over immediately and transmission fluid was pouring, by the quart, out of my truck. I didnt get to look exactly where it was coming from, since i backed away once i saw a small flame coming from the leak. i then called a tow truck (assuming it was a seal or a hose break) and had it towed to my house.
I started investigating the possible problems and didn't really see anything noticeable under the truck (not that I was expecting to). So what I did was put three quarts of transmission fluid in the dipstick hole and put in gear to see if I could spot a leak. nothing. then I drove it around the block to get it warmed up and put a little pressure on the transmission by driving up a semi-steep hill to see if that would spark the leak again. still no sign of the a leak.
And finally, when I went to go check the dipstick after my test drive, it read to be above the cross hatched area, hence being overfull. What my next step should be?
View 6 Replies
When I push down the clutch there is an annoying whining noise. I can be at a stop or driving and either way it does it. It goes away when I let the clutch up. 04 GLi 1.8T 6 Speed. Has the Valeo Single Mass clutch conversion.
View 4 Replies
Just recently replaced timing chains and clutch on a 2000 VR6, now I have a bit of drive-case whine but in 3rd & 4th gear only? Replaced throw out bearing with new and sachs clutch, Are my transmission bolts too tight or something?
View 2 Replies
I had a rebuilt alternator installed on Thursday and for the past two days when I start up the car there is a high pitch whine coming from what I believe is the alternator. Do some rebuilt alternators make noise when charging the batter after start-up? The alternator has a 3-year warranty and I'm going back to the shop tomorrow.
View 4 Replies
