I started the car one morning after it snowed. the red "BRAKE" light is constantly on and while the car is moving it beeps which is extremely annoying.. I have tried:
-Topping off brake fluid
- another ebrake sensor (under the center console)
- brake pads have plenty of meat on them
- brake light are working
My brake fluid is fine and fuses 5 & 9 are good. Brake lever is all the way down as well. Have read that for some simply replacing the cap worked. Car is a 2000 w/170K. BTW, A/C does not work, clutch not spinning, fuses ok there as well. I've made sure a/c button is not on nor is recirc button. Some have said probe can be related to this but that also can show up with a bad fuse # 5, but mine is good.
View 5 RepliesHad the 2003 Jetta in for inspection, and he said the rear brake caliper was gone. SO he replaced it.
Now in the morning when I leave for work, as I go up my steep driveway, the brake warning light comes on and beeps at me. Then it stops.
On the way home, as I come up the steep road to my driveway, the warning light comes on and beeps at me!
All other times and all other driving, it's fine.
so it started like a month ago my door light would occasionally come on for no reason now it's to the point where my door light is always on and it constantly dings, i know its the door lock module but is there any way to tell which door? it might be the trunk and also is there a way to temporarily fix it soi don't drive my car into a tree from being so annoyed.
View 4 RepliesI drive a 2000 VW Golf with 148K miles on it. One Saturday this summer my brake indicator light started lighting and beeping intermittently as I was driving. My brakes were operating fine so I did not read my owners manual until I reached my home. It indicated that I needed to have a qualified mechanic check it immediately but as it was almost 4 o'clock in the afternoon I couldn't find a mechanic in any gas station or garage. As I had a 200 mile drive to do the next day, I purchased brake fluid and carefully followed all of the directions for checking and filling my brake fluid.
However, when I took the cap off of the reservoir, the reservoir really looked fine and I was only able to add about a teaspoon max of brake fluid. However, when I tried driving the car, it seemed that the problem was solved as the brake indicator light did not come on again. Approximately 3 months later now the brake indicator light is intermittently going on again: about every other day. It goes on and then shortly after it goes off and then it doesn't come on again for a day or two.
Inasmuch as I added such a small amount of brake fluid last time I'm really not sure that the problem is actually with the fluid. I wondered if perhaps it was more of a vacuum problem or that by opening the reservoir some air escaped or something of that nature. I also wonder if possibly there's a component that's giving a false reading. At any rate, I'm a little white-haired old lady and there's a limit to what I can do on my car myself and I'm also a target whenever I go into a shop to get the most expensive diagnosis and fix. I'd like to go in to a shop with good information so that it doesn't become an expensive fishing expedition. What could be causing this?
Where to begin, I've checked things i thought could be the issue but aren't. I am having a constant e-brake light on which as you know emits the loud and annoying beep sound. What I've checked and done:
I checked the brake fluid, its fully topped off. I also removed the ebrake switch (the thing under it that when depressed pushes the button and turns the light off) and just crossed the wires to complete the circuit (this does the same as the button essentially) before buying a new one to see if that was the issue, which is doesn't seem to be. I had my buddy run vagcom which turned up no codes that SHOULD make this issue occur. I even popped in a new brake light switch which didn't work.
At the same time of this happening my car is making ZERO boost at all. Is it a coincidence? I don't know... it's just weird they would both happen at the same exact time. Again, no codes are showing up. Checked lines and didn't see any potential boost leaks. What to do.
I have a 97 f150 4x4 4.6 the airbag light in the cluster is constantly staying on it does not flash at all. The only threads I can find are for the airbag light flashing which mine does not do. The passenger airbag light is not burnt out so that's not the problem. Where to start looking.
View 2 Replieshave a 2000 golf TDI 5 SPD Manuel. Was driving into work today and I got on the gas a bit and all the sudden the battery light comes on I hear the beep dash noise and my guage cluster shuts off. I pull into work. Car seems to be running fine.. All belts intact. battery brand new. Car starts and operates fine. At idle dash works. But when I tap the accelerator pedal that's when dash shuts off and battery light comes on. Bizarre. I checked a few fuses not exactly sure which one would be bad but. I didn't see any popped ones. I did notice that my top cluster of fuses all the connecting points are browning but fuses are good. So I am not sure if it was already like that....
View 4 RepliesI'm finishing up the install of my sequential shift light and I integrated it into the oem gauge cluster. [IMG][/IMG]
View 3 Replies2001 Jetta 1.8t... Recently made a change in the engine head because in broke the timing belt and had to do valves etc., the car was without power(battery disconnected almost a month), now when it start, a light(symbol orange)comes in the cluster and the engine shuts off, what is causing this problem.
View 10 RepliesSo when I put truck in reverse my back up sensors constantly beep. Not a beep beep beep like they are supposed to. More like a annoying Beeeeeeeeeeeeeeep . Doesn't do this all of the time but most of the time.
View 7 Replies05 GTI 1.8t
Neuspeed chipped (yeah, bring the insults, car came with it, peaks 24psi so neener-neener!)
Other than that it's mechanically stock.
Last time I had the oil changed, I drove roughly 30 miles to work the following day. When I went to leave work the car beeped a few times, no lights went off. I pulled over and checked oil, it was a half quart low. Topped it off and didn't have a problem after.
Yesterday I had the oil changed, drove to work today and as I left I got that same beep. This time it looks like it's not low on oil. No lights went off, I pondered for a few minutes and took the streets home. No following light or signs of trouble.
What could be happening? My oil pressure sensor is relatively new, replaced it last year and I checked the connection today. I searched around but keep coming across common oil pressure threads. I'm planning to get an oil pressure gauge, guess I'll get one sooner than later for peace of mind.
I recently snapped the emergency brake line on my Bonneville by using it for the first time. Now my brake light is on and beeping. It isn't siezed up. I don't plan on fixing the line if I don't have to. Is there any way to stop the beeping.
View 2 RepliesI've a 2008 Toyota Corolla ever since I bought it back in 2007. I don't have any problem with the seat belt warning before but recently for the past months the seat belt warning keeps beeping constantly, even when I'm wearing my seat belt. I fastened every belts in the car to make it stop but it just keep going. How to get it working properly?
View 1 RepliesMy girlfriend just bought a 98 XLT AWD 4.0. does have a few problems.
First, the brake light is on (on the dash). all the lines are good, but the front pads need to be changed. if i take off hard, the brake light goes out for a bit.
Second, had a CEL. P0743, torque converter clutch circuit blah blah. also, the o/d light flashes constantly.
The trans shifts fine, even under WOT. also goes into o/d with no problems, and the button works.
My brake light goes off and on constantly. It happens when I am on an incline, start from a dead stop or go over a bump/into a dip. The fluid is fine, the pedal does not get soft or hard to press. Could it just be that the float is shot and needs to be changed?
View 5 RepliesMy wife's 1998 Passat's ABS and Brake lights both comes on along with that beeping buzzer. Everything is norm from start up, but after driving about 10 miles or so the ABS/brake light& buzzer show starts up.
It seems the ABS is working because my wife found a patch of sand in a parking lot and jammed on the brakes while the ABS/brake light& buzzer show was going on. She said she could feel the brakes pumping.
We took it in to the dealer and they check the brake pads and sensors. They said that the sensors and pads were ok. They thought it might have been dirty sensor, so they clean them.
Two days later the ABS/brake light& buzzer show came back. But this time my brakes squeal a little if you press on the brake lightly. (cleaning solution got on the brakes?) Also how big a deal is it installing a new ABS black box ? (where is it?)
1999 Passatt ... My ABS system is shot and the "ABS BRAKE!" lights flash constantly, as long as car is on. I have been told to not replace the ABS system as it's incredibly pricey. I was told by another owner that he had heard there was a way to have this blinking stop pretty easily.
View 1 RepliesMy 2012 F-150 has the back up camera, and the warning system that beeps with increasing frequency when you're backing into something.
It's worked flawlessly, however the last few times I've started and put it in reverse, it starts beeping constantly although there is absolutely nothing back there. Having been on this forum for probably 3 years, I don't recall this system ever being discussed.
So, where is the sensor located? I looked all around the obvious places, like under the rear bumper, and don't see anything. Is it part of the camera
system?
Secondly, what could make it beep when there is nothing there? Yes, the tailgate is up, and there is nothing in the hitch that might trick it. I'm thinking
dirt on a senor.
So my girlfriends passat is starting to have some problems. It looks like a light show on the dash. When driving it, every now and then (a lot more now) the tach goes dead, and the oil and brake light flash, and it starts beeping. The car also has a ABS light on but that has been on for a long time.
So far I've checked both the oil and brake fluid levels, and checked all the fuses. Everything is good there. It just seems funny that they all go at once. I figure maybe one of the plugs to the cluster is loose giving everything a zero reading? I need to buy a vag cable and software some time that's for sure.
I've decided the first issue w/ my new-to-me jetta I want to focus on is the cooling fan constantly running. I suspect this is potentially related to the temp gauge not reading anything, which I suspect might be because of the coolant temp sensor.
So basically, when I turn the key to on (I'm pretty sure it's on, not start), one of the cooling can comes on. It's the fan on the right side as if you are sitting in the driver seat. I've been looking at the wiring diagram for this issue as well, and the only other thing I can think of that isn't a computer involving issue would be the thermo switch. But it seems like both fans should be coming on in that case, and it's definitely only the one fan that is coming on.