Golf IV / Jetta IV :: Brake / ABS Light Came On Blinking With 3 Beeps
Jun 28, 2016
So my brake light on my dash is on. The other morning when I started my car the like came on blinking with only 3 beeps. No more beeping after that just blinking. Now it has been doing this every time I start my car since (3 beeps and blinking). My abs light is also on but it has been on for years. I checked the brake fluid and it is full. I also never use my ebrake because it doesn't work so this shouldn't be the problem.
View 3 Replies
Advertisement
When I look back into the rear view the top brake light isn't a solid light, it keeps blinking but sometimes it won't blink and just have a solid light. Also, my friend pointed out to me that both of my reverse lights arenot even coming on. I suspect a loose wire somewhere. Where should I look? Or something else?
View 5 Replies
After about an hour of driving, the coolant temperature light on my 2010 GTI started blinking. The gauge never showed a temperature higher than the usual 190, including traffic and idling. Having reached my destination, I shut the car off and then back on, happy to see no warning lights at all. One dinner and some three hours later, I started back for home. 20 minutes into the drive, the car sounded three tones and the blinking light came on again.
Like before, the car drove without incident for the rest of the drive, and the light was no longer present once the car had been shut off and then on again. The owner's manual said that the coolant level might be too low, or the temperature too high, but neither of these seem to be the case. The car is equipped with GIAC stage I software and an Audi S3 intercooler.
View 5 Replies
So I just got new pads and rotors for the front on my 2000 Mk IV, drove smoothly...
Then about 1 week in today, my ABS lights came on.
I turned it off, left it for about 2 hours then turned on the car again, Got a red exclamation mark that made 2 intermittent beeps together (twice), then the ABS light went off??
Still drives smoothly? faulty assembly?
View 4 Replies
I would like to know if its ok for me to top up the brake fluid on my r32.
Ok, my brake warning light is blinking, I've researched and found that either I need to top up the brake fluid or fluid level is low due to brake pad wear.
My car has 56k miles and by just looking at the pad I think it has plenty of life, maybe half worn.
So, should I just top up the fluid or do I need to just change the pad? Someone told me if I top up the fluid and change pad later fluid will over flow..
View 2 Replies
I have an 02 GTI w/ 1.8t and 5spd. I was in the drive through and all of the sudden the ABS, ASR, and seatbelt lights came on and the battery light is randomly blinking. I got home turned the car off and went to restart it and when I turn the key nothing happens. I should also mention I recently have 2 cels for p0701 lean condition and bank 1&3 misfires that developed after I replaced a bad injector. Where do I even start?
View 1 Replies
2004 VW jetta 2.0 ... So my vehicle stalled on me i replaced the battery, the alt, and then when i started it after installing the new alternator it didn't sound right so i checked it out and saw a spark plug wire was in very bad condition and was causing a spark where the spark plug and the spark plug wire connect so i bought a new set of spark plug wires and swapped the old ones for the new ones. Now when i start my vehicle the check engine light is blinking and the car definitely does not sound right. i am positive i did everything correct when swapping the spark plug wires but i am lost as to what could be the issue.
View 1 Replies
So my oil light was blinking on 03 jetta 1.8t for a week or so because of the cold temps where i am once my car reaches temp if you turn off the car and turn it back on my light stays off. i had a oil change recently hubby did that plus i had all my fluids checked and had to have my dipstick tube replaced because it broke.
I had a mechanic who lives in my complex take a look at the car and he said everything is running fine. So today I started my car then my oil light went on again it has been a lot colder than the past few days could that be the reason? My cars not overheating at all but once it gets to temp if you shut and turn the car back on the light goes away. My car only has 88 thousand miles on it and we used the proper oil for the oil change..
View 4 Replies
I just bought a 2000 GTI with the 1.8 turbo. It was very affordable, but it had a few problems. On hard rides, the check engine light was blinking AND I think there was too much oil in the crankcase (I say "think" because the dipstick funnel is gone and I'm not sure how far down the dipstick should go -- new one is on order).
I got rid of the extra oil, and now if I keep the oil in the hatched area of the dipstick (with the dipstick pushed down as far as it goes), the check engine light will never blink even under hard driving. But with the oil that low, the oil light will flash and beep on hard turns. I was experimenting, adding a little oil at a time, and hoping to find the magical sweet spot where neither the check engine light nor the oil light would go off. Instead, tonight I found the opposite -- the sour spot where BOTH of them go off.
So now I'm thinking maybe I need to change to a thicker oil. This car has 124,000 miles on it and was recently refilled with 0w-40. On my last car (a 1994 Golf with the 2.0 liter and 140,000 miles), the oil light would beep on hot days. I solved that permanently by changing from 0w-40 to Mobil 1 15w-50.
Finally, I checked the codes and it said there was a misfire in #2 cylinder as well as general misfiring So I checked the plugs and discovered that the previous idiot had gapped the #2 plug at 1/8 inch! So I (the present idiot) regapped them all and the engine seems to run better, but maybe going for months with such a huge gap has already fried the #2 coil. Should I just replace it? (or all of them?)
View 14 Replies
On my way to work, my check engine light started blinking and car was sputtering (real bad on idle). I ran the code and it came back with misfires codes. I changed the coils/plugs, fuel filter and fuel pump last year. Can the coils be bad already? When I clear the codes the car will run fine for a little while. But after a couple miles CEL will blink and the car will run roughly again.
Car : 2004 Golf 2.0
Codes:
16684: random multiple misfires
16648: fuel injector #2 short to ground
View 5 Replies
Ok...so I drove my car last night about 120 miles and all was well. Got up this morning to go run some errands and the car started acting weird, sputtering. The check engine light was blinking on and off, then it came on solid and stayed on. I haven't checked the code yet.
2004 Jetta GLI1.8 T Manual Transmission
View 7 Replies
Well last night on my way home after work (2:30 AM) I was on the turnpike and puff my car shut down and anti theft immobilizer light started blinking and the car won't start got it tow....
View 3 Replies
So last Thursday I started my car up in the blistering cold and it ran fine for about a minute and started to misfire so I shut it off. It hasn't ran since. When that happened the check engine light was blinking because of the misfire. I didn't have a code reader at the time to read it. now that I got a code reader the damn thing isn't throwing any codes. it spits and sputters sometimes. I've had no previous problems with the car. Thinking It might be a weak fuel pump or bad coils and in not sure how to test them.
View 1 Replies
I have a volkswagen jetta glx vr6.Today my key wont turn (unable to crank engine) and the car won't detect my key (no remote entry/lock function).I've detached the battery.
Plugging the batter back and keeping the key in:
1. Off position causes the "Electronic Immobilzer" light to blink.
2. When in on position. no "electronic immoblizer light comes on.
3. In anycase I can't get the ignition to work.
My engine check/airbag lights are also on and my radio/ac doesn't work. Also the electronic controls for rear view mirrors don't work. Half of the tail (exaust) pipe rusted and has fallen off.On the funny sideI asked the guy at VW to appraise my jetta for a trade and he said it would be $500 for the car !! ONLY After the company official tested the car this won't start...the sales person left, since it was 6PM on Friday. I was left alone and had no option other than to leave my car at Pugi VW showroom and ask a friend for a ride...Long story.
View 4 Replies
Why my Golf beeps 3 times whenever I take off from a complete stop?? No dash lights, other than ABS... The tach isn't currently working either.
View 4 Replies
So while driving my mom's 99 passat, after a few miles it gives six loud beeps, the BRAKE light comes on, the oil pressure warning light starts flashing, the ABS light flashes, and the tach sits at zero.
Brakes still work, havent tested ABS. there's no noticeable change in performance. I'm assuming this is the CCM and ABS modules on their last breaths.
View 2 Replies
I removed the rear shelf to do some reupholstering. Obviously, the third brake light is enclosed in this assy. Now every thing is back together and my 3rd brake light isn't working anymore. Probably got banged around when it was out. On troubleshooting it, it actually works but comes on so low that you can't even see it behind the glass. I even disassembled the whole thing and directly wired it to the car battery same results. All LEDs illuminate but at a fraction of what they should. I'd say maybe 1/10 of what they should. I checked continuity of the whole circuit board and every thing checks with no broken solder except for 1 diode. It's the black one on the far right that has no continuity. Why such a low illumination?
View 2 Replies
My brake fluid is fine and fuses 5 & 9 are good. Brake lever is all the way down as well. Have read that for some simply replacing the cap worked. Car is a 2000 w/170K. BTW, A/C does not work, clutch not spinning, fuses ok there as well. I've made sure a/c button is not on nor is recirc button. Some have said probe can be related to this but that also can show up with a bad fuse # 5, but mine is good.
View 5 Replies
So yesterday on my way to work the EPC light came on. Everything seemed fine. No loss of power or check engine light. Just an EPC light on the dash. So after searching around and checking the forums I decided to step outside and check the codes. I have a bluetooth OBD2 deal that talks to my phone and I have software on my phone to read and clear codes and other things. I checked but no codes. So I decided to do the clear codes function and it made the EPC light go off. On my way to grab some lunch the EPC light came back on and I noticed my cruise control would not work. Did some more research and figured it must be the brake light switch.
Went and bought one for 15 bucks and installed it. Cleared the light again with my phone and headed home. On my way home the EPC light comes back on. Once I get home I check and find my brake lights dont work at all. I checked the switch and it is functioning properly. I could even unplug the brake light switch and jump the red/brown power wire to the red/black wire and they still wouldn't light up. No power getting back to the lights. This morning I get up and head to work. No more EPC light and my brake lights are working fine. I'm thinking maybe a short in that red/black wire but I just don't know. Does that wire go straight from the brake light switch to the brake lights or does it go through any modules or connectors or anything? I would love to get a schematic of the Brake light wiring. 2002 GTI VR6.
View 14 Replies
So my brake pads worn light came on recently on my 03 jetta...low and behold all 4 brake pads needed changing...funny though because upon buying pads with the sensor when I went to put new pads on the old ones didnt even have a sensor it was already cut at the harness and spliced together to keep the light off....so upon inspection one of the wires was black and the other copper....idk if one was supposed to be black or if its because its fried? Anyways i went as far up the wires as I could till they are harnessed in with the abs sensor wires...still one wire black....spliced together crimped and still the light comes and goes....I dont have access to the vcds or vagcom so can't turn it off that way..
View 2 Replies
My car developed a new light on the dash. Whenever I start to drive my e brake light comes on and stays on the entire drive. It randomly started doing this? It's a 05 1.8t tri with the o2j ...
View 4 Replies
