My, auxilary cooling fan isn't working. However, the bigger (primary) fan is working fine. Fuses, looks ok and i see clutch is engaging fine too. well, the a/c is working but not as it used to before. Its cold but very faintly. I suppose this could be because of the not working auxiliary fan.
View 15 RepliesI recently picked up an 02 Golf with a 2.0/5-speed. It's just a plain-jane model without all the bells and whistles. My fans and A/C aren't working. I can deal with no A/C but the cooling fans are kinda important. I did all of the trouble shooting. Both fans work on low and high when jumped at the radiator temp switch so my fans aren't the problem. I replaced the temp switch with no change. My OBD-II scanner shows that my actual coolant temperature was about 10 degrees off from my temp gauge so I replaced the temp sensor too. The timing belt and water pump were both changed about 5K ago.
I borrowed a "good" FCM from a buddy's car and that didn't work either. I went through the troubleshooting diagnostics for the FCM harness and see that I do not have continuity between T14/14 & T14/5 on the harness side. This indicates that the "F38 Ambient Temp Swicth" is possibly my culprit. Everything else checks out good on the FCM harness. Where is this switch located? I've searched online and found nothing specific to my 02. For the sake of testing can I jump these 2 wires for continuity to simulate a working switch? From what I've read this ambient temp switch disables the fans and A/C when air temps are below a certain temp. My next step is going to be wiring in a variable speed fan controller if I can't figure this out .....but I'd rather not get in to that if I can get the factory setup working.
I am having issues with our 2001 vw jetta wolfsburg edition with a AWW engine the cooling fans not working properly. I had a bad fan and replaced it and since changed the thermo fan switch and the module under the battery and still no luck. With the key off I can jump the fans via the plug for the fan switch only low speed works with the key off. with the key on i can get both speeds of the fan to operate. With the ac on the fans operate.. normal driving the fans will not operate. and the engine will overheat and fans will not go on. Any other relays or sensors that could be faulty?
View 2 RepliesI have a quick question, I got a 2005 mk4 gli, and when the cooling fans go on, only one works, the other one does not, I checked the fuse and its fine.
View 13 RepliesI have a 2007 jetta city with the single DIN radio (stock). I would like to have an aux input or usb input. I would like to know what would be the better option? (I don't want to go aftermarket). I know that there is a lot of option but I don't know witch one will work on my radio. (no pre-wired cd changer, no satellite).
Also, on the bottom right of the radio there is two kind of blank plugs (circle and rectangular). It looks like a usb and aux input would fit right there. I saw a picture in witch someone as the exact same radio but with a usb input (instead of the rectangular thing).
I recently changed my battery and now my auxiliary doesn't work. I have read that it's simply changing a code with program. Vagcom-(VCDS)
View 9 RepliesSome how my aux water pump wires got ripped out and I'm not sure if they shorted out. I pig tailed the wires on the pump and ran the car up to temp and turned car off and pump was not running. If the wires did or can short out what would I look for to replace (ie fuse, relay). Also I'm not sure which wire goes to what pin as the plug got ripped off. Wires are black red, and brown black.
View 2 RepliesI have a 00 Jetta 2.0 AEG engine code and my cooling fans don't seem to be kicking on the low setting. I have changed out my FCM and have also checked the fans to see if they were burnt out and both fans work on both low and high settings. This is also causing my car to overheat but the high speed will kick on when the temp gets too high.
View 9 RepliesI've been troubleshooting my AC for the past couple of months -- 2000 GLX -- and have narrowed it down. I have taken the connector off of the Radiator Fan switch and followed the Bently procedure to start the fans. The high speed will run with the ignition switch ON, but I can't get the low speed to operate. The Bentley manual said if the low speed doesn't run, to use the electrical diagram to find the problem. I need to know where the signal for the low speed fan comes from. I have ruled out fuses, etc.....
View 15 RepliesI've decided the first issue w/ my new-to-me jetta I want to focus on is the cooling fan constantly running. I suspect this is potentially related to the temp gauge not reading anything, which I suspect might be because of the coolant temp sensor.
So basically, when I turn the key to on (I'm pretty sure it's on, not start), one of the cooling can comes on. It's the fan on the right side as if you are sitting in the driver seat. I've been looking at the wiring diagram for this issue as well, and the only other thing I can think of that isn't a computer involving issue would be the thermo switch. But it seems like both fans should be coming on in that case, and it's definitely only the one fan that is coming on.
My 03 Golf ac is not working and i am looking for a wiring diagram/ troubleshooting chart. the cooling fans turn on low and I hear the engine surging like the compressor is trying to cycle but it is not.. When I jump the low pressure switch the fans go to high and no power to the compressor. I get a flash of power to the compressor but just a blip every ten seconds. I am trying to check continuity of the ac clutch but having a difficult time getting in there hot. I just bought the car and fixed light body damage on the right front but it was not even bad enough to hurt the washer bottle. Hard to believe the hit caused damage to the ac? AC seems to be charged with about 100 psi static pressure. Why are diagrams so hard to find?
View 2 RepliesI have a problem with my 2005 gti 1.8t , I had a issue with my cooling flange leaking, I changed it yesterday refiled it with g12 and distilled water took the car for a test drive about 20 min in see the temperature go up, no steam or water leaking any where, turn on the heat notice no hot air from the vents,turn on the ac no cold air, and the fans are not turning on. Everything worked the day before I did the coolant flange, am thinking is this possible because the coolant temperature sensor broke? fans will not turn on at all even if it overheating. If I leave the radiator cap off the coolant is spiting out of the overflow expansion tank don't know where to start looking for some pointers. Would bad thermostat cause the fans not to turn on?I think is impossible that the fans and the thermostat broke at the same time with the fact that everything worked the day before..
View 9 RepliesI have a 2001 jetta 1.8 turbo. when I turn the car off the cooling fans stay on and kill my battery. Ive been told it could either be a relay or temp sending unit but i dont know what one to tackle first, also my coolent temp stays way low almost as if the thermostat is stuck open.
View 2 RepliesAlrighty. I have replaced everything dealing with my coolant. New water pump, mishi radiator, pusher fans, thermal switch, temp sensor, t stat, t stat housing coolant pipes, also new gasket and o rings. All new coolant pentofrost sf. Today I went to bleed the cooling system and waited til it did not suck any more coolant down, and we're no signs of air bubbles. Today when I drove it a to Walmart it began to over eat quickly. I pulled over and looked ubder the hood. Coolant was dripping out of my 19-21 pounds moroso cap. And my coolant hoses were rock hard.
Although my top radiator hose was very hot and my bottom was not, but closer to the motor it was. Like if there was a blockage but there isn't in the hose that goes to the block on the bottom of my radiator. Even with the air flow and my fans manually turned on when I first started the car it was steal overheating. On my vehicle there is not a reservoir it has been deleted. I have just my hoses and my radiator that's it. I don't know what can be causing this to happen. Also I ran an air pressure test and my head gasket is not leaking. Any clue what could be going on????
I have a problem I can't seem to figure out. My car has a misfire at idle. It has stumbled every once in a while at idle before while at Red lights. Now it does it all the time. Check engine light is on and I got 5 codes. P0300, p0301, p0302, p0303, p0340, and p0012. The last two are for cam position sensor. I took it outo and looked at it. Looks fine. I reinstalled it and hand cranked the motor with a meter hooked up and I am reading about 10 volts when it senses the metal ring going around. So I think that is good. I sprayed brake cleaner on all the hoses to see if the motor reved to hopefully find a vacuum leak. Nothing. I also noticed today that my cooling fans or my ac don't work. Now I have another issue to deal with. I checked all my plugs and wiring and coils also.
View 1 RepliesBought a mk4 1.8 gti golf last week and day after I got it I filled it up with petrol at Tesco. Since I did that, the engine management light has been on. It hasn't affected the drive or anything so haven't done anything about it yet.
One of the guys at work plugged in his computer thing to it to find out the fault and the code was coming up as 'cooling system malfunction'. He took the fault off so the light no longer comes on but now it makes the most horrendous noise like a grinder or something when the engine is running. I have not driven it anywhere and won't until it has been looked at but just wondered what others thoughts on it might be? Could the noise be something to do with the turbo? Had new cam belt, water pump etc at about 138000/139000 miles (November 2013) and hasn't done more than 10000 since.
Just picked up a 2004 MK4 Jetta GLS 2.0 for really cheap.
As the title reads I have found some issues with the car after giving it a once over.
Dash/Radio lights - My Dimmer Switch is not getting power. I was wondering what the next step would be. I checked all the fuses and there is no issue.
Cooling Fan - I read about testing the plug and a CFM. Which should be done first?
A/C - I changed Electrical-Switch & Relay: A/C Clutch Switch and it did not fix the issue.
So I picked up this 24v vr6 in florida and it has the folowing codes:
p2181 malfunction in cooling system
p0303 misfire in cylinder 3
p0305 misfire in cylinder 5
p0300 random multiple misfires detected
p1570 engine control module disabled
I am thinking the ecu is fried? otherwise why else would that last code pop up. misfire codes im assuming are related to the ecu because theres new COP on each cylinder, newer starter, newer alternator, new spark plugs. Cooling system malfunction im thinking could be the ECT sensor, apparently the water pump was replaced a little while back.
If the ecu is fried can I buy a new one chipped from like APR or do they need the existing ecu and then they modify it?
I want to start by saying I'm new and don't really fully know how to search vortex, I'm sure there's probably a bunch of things about this. I have an 04.5 gli, my temp gauge reads 190 all of the time but according to vag com I'm running at about 220 some times higher. I've heard my fan kick in once in the year I've owned it. Also I get a decent amount of power loss after driving for about 20 to 30 minutes. Idk if that's related, but just hard wire the fan with a switch? I don't have a lot of money so I'm not really trying to play a guessing game replacing stuff.
View 6 RepliesMy R has the aux input in the glove box. Connecting to my iPod works, but the cable I have is too fat/thick to let me close the door. Any nice, thin/flat audio connector that would work so I can close the glove box and leave the iPod out where I can control it? If I can find one I'd get a portable nav and connect it via its headphone jack for Bluetooth phone use.
View 9 RepliesHeat blows warm at best and A/C isn't all that cold. I want to believe its a blend door issue and dive into it this weekend and fix it but there isn't a single piece of foam coming out of any of the vents. Of all the systems on the car HVAC isn't my cup of tea I don't know anything about it. What else could be the problem?I can live without A/C but the heat things must be fixed.
View 1 Replies