Golf IV / Jetta IV :: Again Cylinder Misfiring - Flashing MIL Light?
Mar 26, 2015
So a few days ago my engine developed a misfire, flashing MIL light etc...long story short it was cylinder 5's ignition coil. When we scanned it, we picked up a misfire on cylinder 5, and a slight misfire on cylinder 1. Replaced the coil, as well as new spark plugs, cleared the codes, and everything was peachy.
NOW, driving home today.....once again. Misfire, MIL light etc. I'm not a mechanic so I am wondering if it is common for all the coils to go around the same time, or if this is probably just cylinder 1 now going. I'm going to once again get it scanned, but before then...is there anything that could cause ignition coils to just start going bad, other than age.
View 9 Replies
Advertisement
I have a 2001 golf with a 2.0 AVH engine. I recently replaced the coil-pack and was very pleased that the engine was running better, the only problem was the mpg was still kinda low in the 24-5 range when it used to be 29.
I tried to do a compression test but I didn't prepare properly, I thought you left the coil pack plugged in and the fuel fuse. Now I have a CEL that *was* flashing saying cylinder one is misfiring though it has stopped flashing. I drove it 13 miles home and it did improve but its still running rough. Very reminiscent of when my bad coil pack was still in there, a real lack of power.
So I have to ask, what can I do from here? Have I damaged my coil pack or cylinders? Will this likely go away on its own? Is there anything I should do?
View 4 Replies
I have a 1996 ford taurus lx v6 3.0 dohm..my check engine light flashing. then it stop flashing..i did replace spark plug,wires,coil pack..when it start to flash i put it gear the car start to shake and sputter.i really don't know why its doing that the car has about 150000 miles on it..i do get a code p0302 Cylinder #2 Misfire..the new plugs and wires and coil pack is about 2 weeks old..
View 11 Replies
I recently bought a 2000 jetta vr6 MK4 and since i have had it its had a misfire problem. So its saying that its misfiring in "cylinder 1" and sometimes when I clear the code it will stay off for the whole day. I did everything I could think of. I replaced all the spark plugs. I replaces the plug wires. Then i bought I new coilpack. and its still misfiring.
View 10 Replies
CEL came on and the report says #2 cylinder misfiring. Changed plugs, wires and coil. Last step was to change the #2 fuel injector. I changed the 2nd injector from the left but I'm still getting the same message. I was wondering if maybe they aren't numbered that way. It's a 2004 Jetta with Car engine: 2.0L L4 SOHC 8V. Did I change the wrong injector?
View 1 Replies
My '04 v6 wagon 100K will misfire in really damp conditions. Last fall after going through a massive puddle and today after sitting for a couple of days of warm damp foggy & rainy New England spring weather. OBDII scanner is reporting cylinder 3 as the one misfiring in the fall, today there were a ton of codes (that I didn't note).
So I made it about 2 miles from the house and had to turn back. No power, check light flashing. I had to put it in manual and keep the revs highish (3-4K). When I got home the exhaust manifold was glowing yellow, assuming one or more cylinders were passing fuel out to the exhaust and it was being burnt off in the manifold.
My question: could I have damaged any gaskets back there? This could be my imagination but I think I'm hearing a new noise that I'd normally attribute to an exhaust leak downstream of the muffler, very subtle - like a gentle light but rapid thud. I only hear this noise with my ear to in the front driver's wheel well. There's no ticking noise I normally attribute to leaks near the manifold. My imagination or is it easy to damage something in the circumstances I describe?
View 11 Replies
Just dug out my 2004 2.0 Jetta after sitting buried for 4 months. You can see a corner of the wheel there lol, its been a LONG winter. It is my car but my brother normally drives it, and while he is away at uni it just sits.
Anyways, dug it out to start it. Started right up, however after a bit the MIL began flashing. It was running a little rough. Took out my code reader and engine misfire cylinder 4 came up. The rpms are varying by 75~100 every few seconds, however nothing rough. It seemed to rev fine.
Before I put it away I got my brother to put some fuel stabilizer in the fuel. He now tells me that he put some in the oil too since it said "oil stabilizer" as well. It was a seafoam type brand... Not impressed with him there.
My question is could this just be the car waking up? Should I let it run for an hour or two to see if things work out?
View 7 Replies
Is it possible that disconnecting battery causes a misaligned throttle body, which in turn causes the EPC light to come on? And does a misaligned throttle body also cause misfiring cylinders (1 & 2 in this case)?
View 3 Replies
Happened a few times on me lately. While pulling towards the top of 5th, I'll start to see the check engine light briefly blink as if the car wasn't sure, then at the top of 5th, she'll start misfiring on cyl 2 and 5. It's only during the long haul pulls that this occurs. My plugs and coils were all changed about 1k miles ago.
View 17 Replies
Here's my question. Recently my muffler fell off the back of my car and was dragging on the ground. The front bracket had snapped off and so had the pipe right where it comes out of the front of the muffler. I want to replace with the stock oem muffler but i can't afford it right now. My question is can i just take the muffler off for the time being so it wont drag on the ground? Will this harm the engine or be completely absurdly loud? Is this even legal....
View 2 Replies
The car already has a cel even though I just bought it. Drove home from work this morning had no problems, went to go shopping no problem, come out start my car and it won't idle right, problem. The Cel flashed at me and once driven a tiny bit stayed constant. Seems like a cylinder is misfiring because of the sound it makes and it is hesitant when you give it some gas. What could it be, coil packs (which is what is was in my 24v) MAF, spark plugs?
View 22 Replies
I was driving around and I got a low oil light flashing and it turned off straight away.
So I checked my oil. When I first removed the dipstick it shows full, wiped it clean and put it back and it showed empty.
I put have a bottle (small one can't remember size) of oil in. I drove around parked waited a bit, and it does this same thing.
View 18 Replies
Yesterday out of no where my rio started to misfire so i immediately took it into autozone to have it checked. when doing so the check engine light was on, but solid.
The tests came back with P0300, P0301, and P0302 or 3. I cant find the papers, but its 3 cyns that are misfiring. The guy at autozone suggested i try changing out the plugs first since its cheaper and has been known to fix this issue.
The second I bought the plugs I went home and changed them out. once finished i started up the car and not only was the car still misfiring, but the check engine light is now flashing... I did notice one thing when changing the plugs.
If facing the engine the second coil from the left had a bit of what looked to be rust. i was able to wipe it off with ease. What my next move should be?
View 9 Replies
I was driving home today and when I got on to the freeway, the car lost power and the check engine light started to flash like it was misfiring, also the EPC light came on. When I got off the freeway and let it idle, it idled rough until I turned the car off and put my APR flash back to stock. After that the car was idling fine and the check engine and EPC lights were gone. Everything seemed to be working fine until I hit about 75 mph. The car started sputtering again only as long as i tried to accelerate. Under light to moderate acceleration the car works fine up to about 70 mph. After that or under heavy acceleration the car sputters and the CE light flashes and then turns off.
View 7 Replies
This morning i went to start my car and threw a flashing engine light. common sense says its a misfire. i know it's probably smart to check my spark plugs first but here's my dilemma. if it isn't the plugs and turns out to be my ignition coil, where the hell is that even located? I have an 04 Jetta 2.slow engine
View 2 Replies
I have a 2003 vw golf, 5 speed. check engine light flashes after a big rain. The mechanic has replaced the fuse box and spark plugs, but the problem continues.
View 16 Replies
So my gf's check engine light on her 01 Golf flashes once in a while, and it misfires. But the thing is, it doesn't stay on, and it's once in a while (like once or twice a week). She has new spark plugs, and new wires. I have a feeling it's the coil pack, but I really don't know if it needs to be replaced until the check engine light actually stays on.
View 14 Replies
Just a few days ago I was driving and I noticed as I went over 35 mph my car would stutter and the check engine light would start flashing. And when I slowed back down the car drove fine. I'm wondering what the problem could be? Feels like the car is losing power. Car is currently at 119k miles.
View 1 Replies
I got a 99 1.8t. Here's the deal, misfiring at idle, flashes battery light. alt and battery was checked and there great. it has a maf code, so I unplug the maf and still get the same misfiring. maf was fine be4 i tried cleaning it, now it throws the code. it had misfiring be4 i clean it also. next problem is it stutters and misses if i go wot in 4 or 5 gear and the batt light flashes it doesn't throw a misfire code. Also if I am idling and i floor it, it stutters and misses at lower rpm rage and then is fine at higher rpm range. i replaced plugs and gapped em right, i did a power balance test and the coils all are firing so is the injectors. I don't got vag but i do got a good obd2 scanner i was looking at the data wen car was off and i seen that if i floor it the tps only reads 77.7% . Also my timing says its 12 degrees and idle fuel pressure is fine i checked with a gauge. Pretty much misfiring with no codes thrown and flashing battery light.
View 17 Replies
I own a 2000 accent. Broke down, called racq, they said it was electrical problem with fuel pump and my car would kick over after someone cranks it and another person bangs the underside of the fuel tank a few times(exterior). then broke down again and car wouldn't start at all, had no spark would only crank not kick over, I took it to a mechanic and he found out it was the fuel relay switch so he replaced that and the car was running again, however it was only running on 3 cylinders and the fuel light would flash/turn on for seconds/ flick on and off even with a full tank.
Took it back to the mechanic and he said the fuel lines were blocked and needed new fuel filter so after he fitted all that was still running terrible, would misfire, fuel light still flashed and driving it around drank the fuel. Found out that it was the first cylinder that was the problem. I changed the sparkplugs and no difference
So I went to a car wreckers and replaced the 1st fuel injector (got it for 5 dollars off an accent that was wrote off from the back end) once i fitted the injector it started to run better. It is now running at about 75%. doesnt go as hard as it use to, still misfires, still drinking the fuel and the fuel light is always off and on when I am driving. It has low revs in idle mode so it rattles/shakes heavily as well and smell of fuel in the back seats every now and then.
oh and a side note - drove it a few nights ago and the clutch pedal is 'loose'... as in the grab is near enough clutch in 7/8ths of the way(near the floor) and when the clutch is fully out there is alot of 'play' which is when you press the clutch in a quarter of the way its nothing, no tension or anything just floppy, but im not 100% sure if the clutch cable needs tightening or something worse( i only replaced clutch about 2 months ago so it couldn't be burnt out?)
View 3 Replies
i have a 2008 santa fe with a 2.7 61,000 miles 2nd owner ,out of warranty. It started missing and the check engine light came on. I took it to a local parts store who put an analyzer on it an it showed the #3 spark plug was misfiring. I am hoping its the plug. I do my own work but havn`t been able to find a correct sequence to replace the plugs.
View 3 Replies
