Golf IV / Jetta IV :: 2004 - Clicky Turn Signal Sound Without Hazard Lights Blinking
Jun 28, 2014
My Jetta has had an off-and-on clicky turn signal sound without turn signals or hazard lights actually blinking. I put up with it for a while, but recently it's been more clicky than not. I'm aware this is a common problem. I had already tried the cleaner spray "trick" which made the problem worse if anything. Today, I removed my signal stalk as described here and gave it a cleaning. After re-assembling, the clicky problem didn't go away, and now the high beams are always on (even with the key out of the ignition, and the car isn't running). I temporarily dealt with this by pulling fuses 18 and 19 for high beams. It's an ok short-term workaround. Low beams still work fine.
I'm considering replacing the hazard signal relay, but a while ago I messed up while trying to use ghetto removal keys to pull my radio.
View 4 Replies
Advertisement
So, I'm driving back from the beach currently (typing this on the side of the road). All appears to be fine with the car. Then all of the sudden, the hazards start blinking and I can't turn them off. I pull over (currently), get out to walk around, see nothing wrong. Not running hot, not anything whatsoever. Sit a couple of minutes, and they go off by themselves.
I've been cruising for the past 3 hours, no problems. No warning lights on the dash.
View 3 Replies
I've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 Replies
The turn signals and hazard lights on my nissan sentra are working some times and all of a sudden they stop working. The problem is occuring almost every day. What could be the problem?.
View 4 Replies
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
View 4 Replies
I have a chevrolet optra 2007 and the hazard lights won't work unless the turn signal (left or right) is switched on at the same time. Turn signals work perfectly fine.
View 7 Replies
The right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
View 4 Replies
I turned the car on this morning and my turn signals don't work, there is no clicking sound when I flip the left or right signal and when I step on the brakes the brake lights don't illuminate. Needless to say the cars behind me don't like it when I slow down to make a turn. Can't be the bulbs and the symptoms make me think it is more than a fuse.
View 3 Replies
My passenger side front signal light works properly, but when I turn my hazard lights on it will not blink normally (the other 3 blink). Inside my truck when looking at my dash I see the small green blinking arrow for the left signal, but not for the right when the hazards are on. When using the signal normally, I see the small blinking green arrow for the right signal though.
1997 F150 Supercab, 4.6L V8
View 3 Replies
I have a 2002 golf MKIV GTI and the hazard lights will flash whenever I pull the emergency break. Sometimes the emergency brake light won't go on when I pull it up but once the light engages the hazards will flash on, also I think it might have something to do with my car not shutting off sometimes. I will remove the key but the engine won't turn completely off unless I press the brake pedal but only if the emergency light is on is when that happens.
View 3 Replies
I've been having an electrical issue for the past few months that I've decided to address now that the weather is getting a little warmer.
What happened is the left turn signal was blinking fast, so I assumed bad bulb, and later that day it stopped blinking fast and now I press the lever down to indicate a left turn and there is a quite loud buzzing sound. Sounds like it's coming from where the relays are, but I've replaced them and the bulbs and still nothing has changed.
I've also replaced the multifunction switch to see if that was an issue, but a new one did the same thing so I returned it.
Running lights work all around, but now there are no left blinkers, and also my left brake light doesn't come on. Pulling a trailer I have the same problem, I had the plug tested and only 3 of the pins have anything to them.
I know nothing about auto electrical systems.
View 12 Replies
I've blown my turn signal fuse for 3 times until the relay burned out. Now I have had cleaned turn signal switch (with CC) from all of the old stuff in there and replaced hazard switch. But it happens again! After 5 minutes driving, both fuses (7,5 AMP for turn signals and 15 AMP hazard) blown out. I'm afraid there are some shorts in wirings.
I'm looking for the wiring diagrams or any other users experience in this matter... Where shall I start from?
There was a water leakage behind and under drivers seat. I removed trims etc. to lift the carpet to take the Comfort Module for checking as there were some weird thing in overall car electric systems (central locking, saloon lightnings, electric windows and dropping gauges on instrument panel. I found a small amount of water in container, where the module is placed, but on the electric parts weren't any water marks... Also it's impossible to connect to the CCM via vag-com.
View 3 Replies
I have a 2010 Prius. I went out to my car, which was parked in a parking lot, and the hazard lights were blinking. I did not turn them on. I drove home for 20 minutes and could not get them to turn off the whole way. My car sits in my garage with the hazards flashing.
View 2 Replies
I have a 1998 Ford F150. The turn signals do not work nor the hazard flashers. When I trun on the hazard flashers(they do not come on) the turn signals will then work. Checked all fuses both under dash and in the engine compartment. With flashers turned on and using the turn signals, the relays located in engine compartment are working. It appears that the only way for the turn signals to work is to recieve power through the hazards.
View 2 Replies
Got into my car this morning turned on the car and the hazard lights started to blink . Thought I might have pressed the hazard lights button , so of course I press the button into the lower position and the lights are still on .. Then I press the button again into the raised position and put the car into drive and now the hazard lights start to blink faster as I accelerate ( now my Prius Became a police cruiser ) it's obvious I have a short some where , or the relay went bad . If it's the relay, where can I find the relay in the car? Looked in both fuse boxes and I couldn't find it . I've since pulled the fuse on the hazard/ signal lights. I'd rather try to fix this my self before I have to pay Toyota to rob me blind .
View 2 Replies
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 Replies
Every once in awhile when I'm on the freeway, the hazard lights will flash and the doors will lock and unlock for about 3 seconds then stop.
The car is running normally other than this, except that the doors have stopped locking with the fob or the key itself. It is a 2001 2.0L L4 SOHC 8V.
View 1 Replies
The turn signals/hazard flasher on my 99 Sebring Jxi stopped working a couple of weeks ago. When I use the signal lever or press the hazard flasher switch, you don't hear any click of the flasher relay, and the lights (front and rear, and on the dash) don't light up at all.
So far, I have:
* Checked the fuse
* Replaced the flasher
* Replaced the turn signal switch
* Replaced the flasher AGAIN (mechanic says that if there was a problem with the turn signal switch, it can burn out the flasher)
* Checked the fuse AGAIN, and even replaced it (even though it's the same fuse for the wiper/washer, and that's still working)
I asked my mechanic about it, and he said that a bad ground can also cause problems. The big question is: where do I begin to look?
View 3 Replies
I have an '02 camry v6. My hazard lights started blinking when the car is off and aren't responding to the on/off button. When I turned the car on they stopped for a few seconds then blinked rapidly several times, then back to normal blinking. I tried disconnecting the battery and restarting the car. The battery is only a few months old. What could be causing it? Where is the fuse for it located?
View 1 Replies
New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
View 9 Replies
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 Replies
