I just bought a 2004 Jetta and noticed the bottom of the engine does not have a lower belt guard... I can just see the serp belt spinning. I feel like there should be some kinda guard to protect it from Weather and debri? It's a 1.8T.
View 4 RepliesI have coolant leaking from the bottom of this hose on my brothers car. I am not very familiar with the BEW's as I drive an ALH. Just looking for info about part number or name on this hose so I can get a new one. Has a part number MH3364 on it but that is not working anywhere.
View 2 RepliesCome out to the this am and notice a small puddle that was not there last night. Pull the car out and it's start burning something off. Roll the car in first thought is oil (maybe the turbo return line is leaking) no its coolant. On the lower portion of the down pipe and running across the bottom. I'm at a loss as where the leak could be coming from being back there.
View 6 RepliesLooking for a guide to replace the under engine splash guard and spoiler (Part# 17 and 19 on Parts.com front bumper illustration)?
I just purchased a '05 Prius and the last owner curbed the front bumper thus breaking most of the attachment points on the bottom of the bumper and splash guard.
I see the exploded illustration but it is not very detailed.
Have an 04 Jetta GLS 1.8t manual. While accelerating at lower rpm and I'm kind of on the gas to get up and go it starts bogging out. Could almost describe it as a little jerky. Anything over 3000 rpm there's no issue. Doesn't matter what gear I'm in either.
View 15 RepliesSo I was trying to track down this squeak noise and I removed the drivers side seat belt but now the belt will not retract? It's stuck like this, is there a manual release? Buying another one is not a option right now. And I have to drive the car tomorrow morning.
View 1 RepliesI have an appradio 3, with the dash kit, and it has two clips on the top to hold the deck into place, but there aren't any clips on the bottom. So because of that, the bottom of my deck always pushes out.
View 1 RepliesMy 2000 Jetta 2.0 has a coolant leak. I searched and found a lot of mentions of the flange on the driver's side, and I have coolant dripping from the bottom of the car in a location that seems consistent with that, but I felt all around the flange and the hoses that are connected to it and it feels dry.
Where else could it be coming from? (yeah, I could jack it up climb under and look, but I haven't had time yet). I also seem to have an oil leak around the same location, but the dipstick tube was cracked near where it went in to the engine so I'm hoping that was the source of the oil.
My washer fluid leaked out of the bottom of the reservoir and I would like to pull the fuse because it keeps beeping it is low. obviously. I do not have a rear wiper as it is shaved so #27 fuse is out and I was wondering if I pulled # 24 if that would stop the damn sensor or if I can pull something else, maybe just unplug it from the reservoir. I find myself using it never so I wont be fixing it anytime soon.
View 1 RepliesEver since I bought my 2000 mk4 golf I've had this super loud hissing noise coming from the bottom of the car. Almost like someone is spraying compressed air when your foot is on the throttle. Sound gets louder the more you depress the pedal. Had a catalytic converter code so after a few months I bought a new cat, welded it on, and the sound fairly went away. Still present, now months later the sound is now a bit louder but It's gotten on my last nerve, I want to fix it but I can't seem to figure out what that noise is.
Almost sounds like my car is a classic beetle by the way it accelerate at times. The car is sort of sluggish than normal at times, no codes, no lights, sometimes peeling out in 1st gear the car hesitates like I have regular power, then I have this sudden burst of 1 second power then back to normal until I shift then I never feel it again until I'm back in 1st and WOT it. Car does smell like gas a little sometimes, not too prevalent but nonetheless noticeable especially going in reverse. My gas meter seemed to fluctuate at times, I may have a bad pump maybe, not sure if that has anything to do with it.
I've had a Prius since 2006, and bought the 2010 in 2009 when it came out. This is the first winter I'm having a problem with the splash guards under the engine coming loose and hanging down.. I went to the dealer on 1/27 and had them put back in place. I went back again on 2/10. I looked under the car and again one side is hanging down. They dealer explained that it is a plastic clip that holds them in place. I don't drive over big lumps of snow & ice.
View 2 RepliesWhat is the part # for this bottom for an 05' F250 supercab?
I swapped these seats into my OBS truck, but the driver's seat bottom has the typical wear/tear on it and its getting worse.
I have been searching for three days for a replacement bottom cover. I have found them for F150s and the pattern is close but not right. I cannot find them for F250s or F350s as I cannot find the proper part # for the gray DS cover.
This is the tan one: 4c3z-2562900-eaa
How can I pull this up?
It's come to my attention that I have a thumping sound coming from my lower front end. It only happens on low rpm's and I can hear it best when it's in neutral, if I give the brakes a little push I can hear it louder, more profound, and can also feel it on my feet a little, but I don't only hear it while I have the pedal depressed. So..what it could be?
View 1 RepliesSo the car is a 1999 golf gti with a 2.0 AEG with a 5 speed manual. My brothers car. He has been telling me its been hard starting in the mornings for a couple months, sometimes it dies, sometimes it idles at 500 or lower, he has to rev it up to 1500 to get it to warm up then in kinda stays normal till he cold starts the car again, then does it all over. So he was driving down to my house to leave it with me to look at and on the way over he heres a big bang. has the car towed over here.
Cyl #3 has backed itself out and clearly a serious misfire, threads look fine so I put all new plugs in oem ngk three prong, runs ok still too low 400/600 stalling a couple times. this morning i installed new wires (Bosch)and a coil (aftermarket) and it barely wants to run now, stalled instantly. So I put the old coil back in and it stays running but watching the motor, its clearly misfiring. No codes as of yet and i have no access to vagcom. I've checked the firing order and wire placement on coil like 8 times to make sure it is correct.
I recently bought a 97 960. i have had a s90 before in totaled it i loved the car so much i found another. i was driving and broke the timing belt tensioner which in turn lead to the breaking of 5 exhaust valves that i know of. I've taken off the head and noticed that one of the bottom of the valves had melted onto the number 5 piston head.
I called around and search but every motor is at least 1000 and i have been told anywhere from 3500-4500 to rebuild. My question would b is there an easy way to fix or should i junk it. i bought it for a 1000 it has only 140000 on it an its in almost great condition. I attached some pictures of the head and piston so u can see the damage.
Attached File(s)
2012_04_07_19.02.39.jpg ( 1.45MB )
2012_04_10_16.45.26__1_.jpg ( 1.43MB )
So the PO of my Jetta had the alternator replaced...awesome! One less job for me to do. My serpentine belt went out yesterday so I chalked it up to being old. When I got the new belt on it kept slipping off, I pulled the tensioner pulley off and saw that the wheel was all chewed up, I look down and saw that whoever put in the alternator didn't bother to screw in the bolt all the way and it chewed up the belt and everything else.
View 1 RepliesFirst off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies98 Jetta TDI hydraulic system ... We just received this vehicle from my mother in law, who is not driving any more. It's a cream puff--79,000 miles, beautiful condition. Problem is the clutch engages lower and lower to the floor, and eventually the shifter gets stuck in gear. The brake pedal slowly sinks to the floor when at stops on hills. Our mechanic tells us these two are connected because both the clutch and brake run off the same hydraulic system.
1st time he said the fluid was filthy, and he emptied the system and put in clean fluid. Worked for a little while and then we were back where we started. Second time he replaced a couple parts on the clutch, replaced this fluid, and this time it ran like a dream for a little over a month. Then the problem just returned. Again he says the fluid is filthy, and now we are looking at replacing the master cylinder and again changing the fluid. The theory behind why this is happening is that my mother in law let the car sit for half a year before passing it on to us. She didn't do much driving the 6 months before that either. I've done research, and this doesn't appear to be a common problem by any means on these cars.
I have a really small leak coming from the lower end of my power steering hose, it's super small, I was wondering if I could fix this by wiping it down really well and dry, and then layering it with plasti-dip. I think the leak is small/slow enough for me to get in a few good layers. Would this be an okay fix, or would the plasti-dip separate fast?
View 2 RepliesI have a mkiv and before I got to work in the morning, I warm up my car for about 10 min. When I start it up the belt squeals. I do believe that it only does it in the morning. Should I have it checked out? i put belt dressing on it last night but it squealed when i started it up this morning so I don't think that worked......
View 10 RepliesI recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies