Golf IV / Jetta IV :: 2004 - All 4 Cylinders Misfiring Randomly
Dec 10, 2014
So I have a 2004 jetta GLI (1.8T) with forge splitter valve and short ram intake. I went and got my codes pulled and all 4 cylinders misfiring and random misfires. I replaced both coil packs and spark plugs. check engine light popped up again after about 20 miles and same thing. I just bought the car so I'm not sure how long it has been running with these misfires. I just got the timing belt replaced. I know it could be off a tooth. (Wouldn't a code pop up though for it?) How could I check that. And I also took my MAF sensor off as well and no change. Heard it could be clogged cat, any way to check? I've also cleaned the throttle body. It runs fine when I'm driving, just a rough idle.
View 15 Replies
Advertisement
2004 gli , 1.8t , 136k , 6 speed
The car started misfiring after exiting the freeway, at the light it felt like it was gonna cut off. The brake pedal is stiff like the car is off. When it's idling is when it's most noticeable. It smoothed out after 2nd gear at like 35mph but still not right. The pedal thing has never happened before but I knew the sputtering was the coils, so I had it scanned and sure enough. 5 codes.random misfire.. random misfire all four cylinders.. so I bought 4 and replaced the old ones.. Changed the Sparks as well. No change.. The cel came back on..still idling rough.. What it could be.
View 5 Replies
Is it possible that disconnecting battery causes a misaligned throttle body, which in turn causes the EPC light to come on? And does a misaligned throttle body also cause misfiring cylinders (1 & 2 in this case)?
View 3 Replies
My friend has 2000 12v vr6 auto and recently he experienced his car bogging under acceleration. He had the plugs and wires recently done to solve the problem and the problem went away for a day and has since returned. I scanned it and here are the codes that its threw. After doing some research i'm thinking its the coil pack, since it was pretty foggy/damp today (when the problem started again).
17626.p1218 - fuel injector for cylinder 6 (N84): short to b+
16690.p0306 - Cylinder 6 Misfire Detected
16684.p0300 - Random/Multiple Cylinder Misfire Detected
View 1 Replies
So last night i was driving and i made a turn onto the highway and speed up to pass this slow ass car :thumb down: and as i did i lost acceleration and my car started to rumble like when you use a high gear when u make a turn while moving that slow acceleration. And as that happened my engine light turned on and my EPC so i drove it well barely made it home. i had a friend with his VAGCOM come to see whats wrong it said cylinder 1&3 are miss firing so he took his ignition coils out of his car swapped them in my car and we drove it around and it drove fine and no fault codes. so now my issue since i have GIAC, CAI and APR full exhaust if my warranty will cover to have them put new ignition coils since i did get an extended warranty. I'm just afraid they won't.
View 7 Replies
CEL came on and the report says #2 cylinder misfiring. Changed plugs, wires and coil. Last step was to change the #2 fuel injector. I changed the 2nd injector from the left but I'm still getting the same message. I was wondering if maybe they aren't numbered that way. It's a 2004 Jetta with Car engine: 2.0L L4 SOHC 8V. Did I change the wrong injector?
View 1 Replies
I have a 2004 Jetta 1.8t 6speed, I recently bought it from a person(my first VW ever) so just trying to fix some things on it, One thing that I'm stuck at is My CEL, it keeps flashing the code P0501 and some random misfire on my cylinders, I have reset it and they keep coming back.
when I put about 10-15% throttle it revs up fine, no misfire or hesitation until the fuel gets cut off around 5500, which is 1k below factory red line, does not hit a thing like the rev limiter where it pegs off the top multiple times just fuel cuts off.
If i put anything above the said pressure the car then begins to misfire and lots of hesitation and that's what causes those codes to go off.
I've been reading many things pointing towards the engine speed sensor or the wiring. Occasionally my fuel/temp gauge quit working but I believe that is a separate issue all together.
So really trying to narrow down what is actually causing my engine to hesitate at low rpm.
Also i might note when I'm in neutral I can go wide open throttle and the car revs fine until the cutoff and only does the bog down when it's under full load. It sorta feels like the possible misfire is due to bad air/fuel but really do not know.
View 7 Replies
I'm getting used to just expecting a problem with this car every 3 months or so. Anyway, I have a 2004 1.8T GLI which lately has been idling and then stutters and dies. The first time it happened it turned right back over and started driving. So I drove it home and cleaned up the battery terminals and it didn't seem to have a problem since. Now about a month later I was just parked and turned it over.
It was on for about 1 second and then it stuttered and died. I can hear the starter engaging and turning the engine, but it won't turn over. I also checked the battery levels and its showing 12v so I don't think it's electrical? From scanning forums here it seems like the two prime suspects are spark plugs or the fuel pump?
Also checked the fuses and none are burnt. I could see it being the fuel pump because that would explain it randomly stuttering and dying. Also the car is at 149k miles and that is the original pump. Wondering if maybe it being at 1/4 tank isn't working either? Going out to buy a vagcom and see what codes it throws!
View 2 Replies
04 jetta 1.8t
apr tune 1.6v
neuspeed 4bar fuel pressure regulator
3" turbo back
APR TIP
This is the second time this happened to me. First time was about two weeks ago where i was just driving and the car stalled. Tried to start but it sounded like it just wasn't getting fuel. Brand new battery, terminals are clean) Got it started and it was revving high like a cold start, normal but why after driving for 30 mins? EPC light came on also which was strange along with the CEL, a buddy checked the code and it was for the secondary air injection pump. (I have not had that go off in a while. Code po4011 secondary air injection. Had this issue a while ago with that code when i did a short ram intake. Tuner cleared it so i can pass emissions. ) Now today it died about 2 miles from my house. Same thing but no CEL. EPC light came on and car was revving high, luckily 3 cars behind my buddy was there and he give me a push into the gas station. Once again it wanted to start but i felt like no fuel. waited a few minutes and it started right up again until it almost died in my drive way. Cluster comes on when it dies. ignition is good.
My big question is the stalling part and the EPC light coming on, then the car revving like it is a cold start but not stopping? and i need this car to be working.
View 11 Replies
My 9-2 is misfiring on cylinders 2 and 4. At first we suspected a timing issue but that doesn't appear to be the case. My mechanic is looking at it but can't seem to locate the problem... so far:
- replaced old spark plugs
- checked the coils (moved them to see if the misfiring followed the coils--it did not)
- checked the timing belt (all good)
- compression is good
- fuel coming in is rich
He's dropping the exhaust today to check things from that end... A faulty mass airflow sensor wouldn't effect specific cylinders would it? and we'd see a degradation in the fuel richness right?
View 5 Replies
According to the OBDII, I have a misfire on #3 & #4 cylinders. Im getting codes PO300, PO303, PO304 and PO171.
View 2 Replies
I have a 2005 Toyota Avalon Limited with 106k miles. Check engine light detected Cylinder misfire in cylinders 3 and 4 at 99K even though I didn't feel the car driving any differently. At the time I was planning to drive the vehicle across the country and so maybe I freaked out, but a friend and I replaced all the spark plugs and coils at the same time (I knew the back 3 were a real pain).
Then at around 104K miles (after letting car sit for 8 weeks) I noticed my car was jumping a bit while idling at lights and the RPMs would dip about 50-100. It felt like I was running out of gas even though the tank was full. For the last 2k miles the idle problem has gotten slightly worse and I think I can even detect a misfire while driving in hilly terrain (although this could just be the oft complained about jerking transmission issues that plague the Avalon). There is NO check engine light illuminated and no codes.
what may be causing my car's idle to dip? It can't be the new plugs and coils already can it? How can I tell if there is a leak somewhere or if the fuel injectors are dirty?
View 4 Replies
A couple of months ago I replaced my coils because of misfires. Just yesterday I satarted getting the running in 3 cylinders feeling. So I was woundering why they went out so fast? (Coils were from my brothers 20th gti)
View 5 Replies
2000 Excursion V10.
Recently cylinders 1,2,3,4 wend dead on my wife's Excursion. I searched here for a pin out diagram so I can check all the wires from the coils to the PCM. I changed the coils on those 4 cylinders with no change and then swapped them with the coils on the left side of the engine. the problem stays on those 4 cylinders. Any link to pin out the wire harness for the coils to the PCM
View 9 Replies
2001 VR6 GTI....
Already done:
Replaced the coil pack and plugs
Measured resistance of plug wires (all at about 6K Ohm)
Replaced front O2 sensor
Replaced purge solenoid valve
Replaced coolant temp sensor
Replaced fuel filter
Replaced fuel pressure regulator
Replaced MAF sensor
Cleaned the throttle body
Cleaned the throttle position sensor
Ran a tank of seafoam treatment (injectors were new 6 mos ago.)
Checked running voltage of battery
It was smoking and stinking bad with a rich mixture. It improved with the MAF change but still runs like a farm tractor. Now it idles on 3 or 4 cylinders, runs rough through 3000 RPM then runs cleaner at above 3000 RPM, but only at light throttle. CEL is either on or flashing when driving.
Don't know what to do next - nice car not fun to drive like this. What this could be and how to test it?
View 7 Replies
I am having a recurring problem, My engine keeps misfiring. I have replaced the spark plugs, ignition coils and pcv valve with all new parts and and fixed it for a little bit but now my car is misfiring again, and Im hoping its not the head so need to narrow down what the problem is...
View 1 Replies
So leading up to today ive had some bucking under load which felt like misfiring to me. I borrowed my friends VCDS cable, checked MAF, checked o2 sensors, checked cat. They are all good. This problem is constant but i did get a misfire code once (random, cyl 1, 2, and 3). I cleared the code and they never came back.
Today as im driving home from work, the bucking problem was much worse. Then the CEL came on. I just checked the code, and it was system too lean. I cleared the code and now the car will not start. It cranks, shows rpm on VCDS and sputters but doesnt even come close to starting.
View 10 Replies
1995.5 Jetta VR6
Misfire cylinder 1 and random misfiring
P300 P301 Vagged it and can't figure it out
Changed the plugs, wires, and coil pack Used and old timing light and getting spark in all wires so can't be the coil pack
Fuel injector, O2 sensor, any other things?
View 4 Replies
So as I was heading out the other day, the car had low acceleration and engine shaking. The check engine light started flashing.
Checked the codes at the parts store: P0300, P0301, P0303.
I just dropped it off at the auto repair shop.
Could it be a I'm just wondering if I shouldn't have taken it to the dealer as the printout says it could be a CPU issue?
View 5 Replies
So my 2008 accent is my daily driver. I'm nearing the 300,000 mile mark but the last 100,000 miles have been plagued with random multiple misfires. I have changed the cables, crankshaft sensor, plugs, and I've been through numerous costly coils (I keep 4 with me). All listed parts were most recently changed at the same time. Why do I misfire on nearly every commute and get stuck operating on 3 cylinders?
View 11 Replies
97 F150 4x4 XLT 5.4L... I had two cylinders misfiring, removed COP, injectors and plugs. Reinstalled all parts and reconnected all sensors. Now I am not getting fuel to the injectors. Double checked for disconnected wires and hoses, checked all fuses and relays, also the inertia switch. Fuel pump does not hum when key turned on. Tried hitting bottom of gas tank. My question is, before I pull the tank again, is there something under the hood I may be missing. It does get quite crowded at the rear of the motor.
View 6 Replies
