Golf IV / Jetta IV :: 2003 TDI Will Not Start After Timing Belt Replacement
Dec 29, 2014
I recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 Replies
Advertisement
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 Replies
I just finished replacing my timing belt, water pump and all belts. I made sure to double check the timing marks lined up via this pic:
Timing belt diagram
I put everything back together and no go. I am not sure what to do now. Should the crank sprocket pulley be in a special starting position? I see is has a "1" engraved on it.
View 22 Replies
Does VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.
View 22 Replies
The timing belt broke in my gf's '08 accent recently and I decided to have a crack at replacing the belt after getting a quote for $900 from the nearest mechanic (with no guarantee it would fix the problem).
When re-aligning the cam and crank to TDC, I wasn't sure if it mattered which revolution the crank was on (ie. 1st or 2nd revolution) when putting everything back together. I tested rotating the engine with the new belt on slowly to make sure there was no contact and everything seemed ok.
So basically now everything is back together, tried starting it up and it won't start and now i'm wondering if it would make a difference or not if the crank was rotated 1 additional revolution. Otherwise there is more significant damage.
View 17 Replies
2.5 Litre ... Okay, I've done this on other cars, both Fords without a problem but now I'm stuck on the no start situation. I have spark and my fuel pressure is 60 psi. About to do a compression test. Only issue with replacing the belt is that no matter how many times I try removing and installing it I'm always 1/2 tooth off after rotating the engine a couple of times but that shouldn't be enough for a complete no start. Tried starting fluid. Replaced cam sensor. new plugs. checked firing order. I have spark at #1 according to my test lamp which plugs inline.
View 6 Replies
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies
I plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 Replies
2.0L 8v ....So what's my chances the valves stayed clear of the pistons?
Driving 70mph 5the gear and cruise control set. Motor just died and I pulled off.
Cars back home in the garage. Iv ordered the ecs tuning timing belt kit.
This was a belt I installed 50k miles ago, shouldn't have gotten a auto parts store belt, or maybe it was my install, but I deff didn't think the belt was going to fail that early. Is there much of a difference between different brand belts and OEM?
View 22 Replies
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
View 9 Replies
I am looking for a link or instructions on replacing the timing belt on a 2.8 30V. I attempted to search and mostly came up w/ the info relating to the turbo.
View 2 Replies
2001 Jetta GLX, 12v 2.8 VR6 Automatic, 157k miles.
Relevant Info: P0411 code, unknown if associated with my slightly rough idle and recently reduced mileage (down by 3-4 MPG). I see 2 N80 valves, one by the power steering reservoir and one behind the throttle body attached to the fire wall. I removed them both, got a tiny bit of what may have been charcoal out of the lower valve and tested both with a 9 volt battery. Both were closed with no power and open when I attached the battery. I cleared the code and it returns within 30 minutes.
Possibly irrelevant info:
Changed the timing chains 3 weeks ago and the code popped up just afterward. Prior to changing the chains, all I saw was a Cam Position Sensor code that is now clear. The slightly rough idle was present to a greater degree before chains were changed but has improved.
SAI solenoids look good but their little rubber hoses don't look fantastic. Could this contribute to the rough idle or is it not part of the vacuum system?
Ignition coil is new and all plug wires tested to about 6k ohms.
I've looked up other's experience with P0411's and have seen the list of possible causes. Wondering if I'm missing a possible cause, if I can test the system further without having to buy parts etc, if the reduced mpg's and rough idle are related...
View 3 Replies
My 2004 Passat 1.8T GLS (station wagon) has 72,000 miles. I checked the manual which says that timing belt is to be replaced at 105,000 miles.
However, car is 8 years old - does the age matter or I should be fine until I get to 105,000 miles to replace the timing belt, tensioner, water pump etc.
View 8 Replies
I got 123000 km on my car. Manual says 144000 km is the right mileage to replace the belt, but I have heard opinions that it should be done earlier.
View 7 Replies
I was told that I must replace the timing belt every sixty thousand miles. Is this true?
View 24 Replies
Looking for the proper instructions in replacing timing belt and oil seal I have done this on a Honda accord before but I need to know how to properly align everything so I can do it right the first time.
View 2 Replies
How to change the timing belt and water pump on a 2006 2.0t passat?
View 3 Replies
2007 Santa Fe GLS 2.7 V6. T belt replaced by dealer at 62K. Noticed engine vibration when picked up vehicle. RPM is steady, engine runs smooth, no error codes, no strange noises. Mechanic who did the work confirmed vibration problem and recommended bringing it back - had no answer on the cause but mentioned lose motor mounts which I doubt - the car ran perfect until the dealer did the work.
View 3 Replies
My 2001Honda Civic EX (manual) has only about 46,000 miles on the clock and runs very well. My mechanic says I should consider replacing the timing belt (the manual suggests after seven years). I plan on keeping the car for many more years -- should I replace the belt now? How devastating is it if the belt breaks while driving?
View 5 Replies
