Golf IV / Jetta IV :: 2003 - Lots Of Squeaking
Jun 16, 2015
Lately, my vehicle has been squeaking like crazy. Any grease points that might need to be looked at?
View 1 RepliesLately, my vehicle has been squeaking like crazy. Any grease points that might need to be looked at?
View 1 Replies2003 Jetta 1.8T (Manual Transmission)
It does this while driving. Seems like when the car is under load or lots of gas driving there is no sound, but when less gas pedal like coasting it makes this sound.
Car has leaking turbo seal. And bad catalytic converter.
Installed a set of ultimos about 2 weeks ago. Replaced everything. Control arms, ball joints, mounts, bushings, pinch bolts. And I'm hearing a squeaking noise in the rear. Just started noticing it Saturday after we had a very hard rain.. Could it be from them being wet?
View 4 Replies2 days ago I changed my driver side wheel bearing and put in a new cv shaft
The axle nut may have been somewhat over torqued but nothing crazy over the spec.
Everything else is as per spec.
My problem is that every time I turn left slow fast sharp not sharp it's making this good awful noise.
It is not a constant squealing. It's every rotation. On off on off on off. No bearing humming or anything when driving straight or turning right. Just left. I'm pretty good at solving pretty well anything with my gti but this one has me stumped
2000 GTI GLX VR6
I get weird squeaking noises coming from the front of the car. It happens when the front dips during braking at a stop. Happens when I turn. Happens when I go over bumps. What it could be? Car has 150,000 miles and suspension is stock.
View 2 RepliesThis is kind of an odd ball problem since I have not encountered this before, but every time I turn my wheels full left or full right and start moving a really high pitched squeaking sound comes from the front of the car. Is it bad alignment or wear sensors on the brake pads rubbing? the brakes have a lot of pad left so i find that hard to believe.
View 5 RepliesIn the early AM I am driving with the heat on full blast, you can feel it is blowing HOT air and engine is fully warm.
However it feels that through the glove box, shifter, and other spots on the passenger side I am getting lots of cold air entering the cabin.
Thus taking longer for cabin air to overcome the hot heat blowing out. (this is not a thermal test I swear!)
Where the air could be coming in? Is AC somehow on to cool glovebox?
I couldn't avoid seemingly a huge pothole when drove at night, and the sound was really awful. After that, I could feel vibration through the steering. The ride isn't the same anymore. What causing the problem? Try to get the car to the tires shop tomorrow. don't wanna bring it to the dealer. Bad experience when I tried to get an alignment after installed vwr lowering springs.
View 11 RepliesAir conditioner was acting weird. (It doesn't blow cold air when the car stops at the lights or in the parking lots. But it works great while driving). Then I went to dealer. And they scan my computer. And they said we need to change Aux Fan control unit and also one of the fan .I ordered OEM Aux Fan Control Unit . And I installed it. I connected Vagcom and cleared the Fault code but It still acts same. I checked the fans. They both works fine to me. They run 10 seconds and stops. So I didn't get this part. How the heck this AC works fine while I am driving but it doesn't work when I stop ?
View 7 RepliesHave a pretty good running (I think), 2000 7.3 with 151K that has always been pretty noisy. Lots of clatter. I amjust wondering if there's an easy way to tell if I may have injector issues starting to come up.
View 8 RepliesAlright. 99 Ford F-250 4x4 Ext Cab 287,000 miles. I know she is getting a little long in the tooth but this issue is new within the last month. It does seem to be better when it has been plugged in. On start up I smoke out the neighborhood. Blueish/White smoke, also sounds like it's missing on a couple injectors. Doesn't matter if you cycle the glowplugs a good long time. No luck. Glow plugs are 1 1/2 years old along with injector o rings. Only thing new is I changed from Rotella T-6 to Delo 5W40 Syn, but it was doing it before the switch as well. I tested my glowplugs relay and that is working fine. Could I have lost a UVCH? Fuel filter six months ago or so.
View 14 RepliesMy DD just developed a head gasket leak. I've been noticing a coolant smell for a few days and today saw lots of white smoke from the tail pipe. I figured this is where my coolant was going and sure enough there is coolant coming from the driver's side head. I've ordered the gaskets and new bolts, but need the install.
I think mostly what I will need is the intake and head bolt torque and sequence. I will need to take a few days off work to get it done. Truck is a 2002 F150 with a 5.4L engine.
Well, today i had my first bout with tranny issues of any kind either before or after my BTS installation. After sitting all day at work, heading home, the shift i guess from 2-3 at about 40-50 mph shifted really hard, BANG. Heard a whirring/whining sound, lots of slipping with the TC. After a lil ways it was like it was in neutral.
Coasted to stop. Went thru the gears from park, rev, and drive about 3 times, got movement each time. Got out, looked for obvious, no fluids or linkages apparent. Drove thru town about 25-30 mph. Felt like it was "hunting" and shifted like a manual grinding gears. Got on highway and no overdrive and im thinking no high gear either.
Push button on shifter light changes, but no change in operation. Running 60 and rpms are turning 2700ish. Still "hunting". But while hunting it isn't wide rpm swings, just a small amount, not wide enough for a gear shift. I am thinking that its torque converter constantly engaging and disengaging.
While letting out of gas it coasts down with TC still locked up all the way down to about 1100 rpm before unlocking. Then I start seeing the OD light flashing. Ok, classic wire chafe in steering column. But it doesn't always flash, only sometimes. And fuses are good. Temps never got above 150 during this 50 mile drive.
So i get home (and its frigging dark already, i hate that this time of year) and I log on and start reading up on this again to refresh my memory. I had called Brian over at BTS when it happened as i was going down the road, he was busy at time. He called me after i got home and i explained and he talked me thru some things. Wanted me to pull the codes and get back with him tomorrow. I did that and the screen shot is below. I will talk more with Brian tomorrow.
But during some of my reading i think i came across some others that had similar trans codes and the issue ended up being the alternator. Alternator ? For trans issues? Is that right? I guess stranger things have happened. I have a high output alt waiting to be installed but haven't yet. I guess we shall see. Brian thinks it something telling the TC and trans to act that way. Doesn't think anything mechanical, yet, leaning towards electrical.
I've got a GTI with a lot of engine vibrations, and I'm not sure if it's something to worry about or even if it's somewhat normal. I have 23,000 miles, Stage II for most of that. My motor ticks obviously but they all do. The idle is smooth (mostly, the needle never fluctuates it's idling at a specific RPM perfectly) but I feel little hiccups and inconsistencies in my steering wheel at a stop light.
Could this be bad motor mounts? Could this be a valvetrain issue? Is there any way to debug this?
I first noticed the issue (it might have been happening beforehand, but never noticed it) after getting my 20k dealer service. Until then I was changing my oil and filter every 6k with motul specific 5W-40. Could they have used a different weight of oil that might simply be changing the way the motor feels?
It seems the idling vibration characteristics of my motor have changed, and I'd like to fix the issue if one exists to prevent future damage to the motor.
Steering wise, it seems very likely that I'm due for a steering box. Lots of slop when I turned the wheels back and forth. Also, as per the seller, it seems like the the wheel bearings and ball joints are in good shape.
The sway bar end link bushings are smoked, so those need replacing. As for oil leaks. I'm thinking it would be best to pull the motor. It looks like this engine has had the pan off, but I do believe I have a front pain leak. The crank case breather is going into the intake which is annoying. And I believe the intercooler is full of oil, explaining the mystery oil leak by the passenger side intercooler boot.
Couldn't see any oil in the valley of the motor but I see oil coming down the down pipe of the exhaust, out the bell housing of the motor and dripping from a weep hole maybe 8 inches down the transmission as well? Seeing as to how I'm not sure what clutch I have, it make sense to pull the trans. And If I have the dreaded oil pan leak and a intercooler full of oil, why not just pull the motor? I'd also like to trim out the front panel for 05+ head lights and clean up the wiring on this thing. Found a cheesy electric compressor for a small horn. Sounds like a clown horn, no kidding.
1999 7.3 misses when starting it cold (first start of the day even when outside temps were around 20 deg C ). It has a noticeable miss and lots of white smoke. After warming up it runs perfect. I changed the GPR and tested all glow plugs, 3 bad and one weak one all replaced. Now that it is cold out it still misses when first started, even if left plugged in.
It will start and run for approx 3 seconds perfectly smooth then it starts to miss and idle speed slows down. on one occasion I went to start it after sitting 10 plus hours plugged in and it started then missed and slowly died. Would not re start, It was firing and smoking but not enough to get going again. Went back the next day and it started and ran fine for a few weeks. Did the same thing to me yesterday, started and then petered out and died and this time it will not re start after 2 days of trying on a couple occasions. I changed out the CPS with no luck.
7.3 auto, starts and idles OKAY, drives fine if you have a light foot but trying to go faster than 50mph or more than 2000 rpm and the whole thing has an anxiety attack. Starts sputtering and popping, lots of grey smoke when it runs rough rough, let off the throttle and it MIGHT behave nicely again.
New lift pump, cleaned the pickup tube, fuel bowl fills nice and fast, just had my edge attitude juice tuner removed since it was causing similar issues that went away for the last 2 months, changed my IPR and CPS (had a mechanic test everything when the tuner was taken out, all injectors buzzed good, sensors good)
When this first happened after the initial problem with the tuner was resolved, it did throw the CEL, but I have since been able to get it to come back on, and my buddies OBD2 scanner wasn't even registering my truck when I hooked up... Dare I say PCM is to blame?
I have a 2007 Volkswagen Jetta with 78K miles. The brakes are squeaking, so I am assuming that the front brake pads need to be replaced. The front brake pads were replaced in 2010 (I don't remember the mileage).
View 2 RepliesSo i just recently purchased this car and about two weeks in I CEL turns on and the car just doesn't seem to drive like it did when i first brought it home. I don't know much about forced induction cars but the from watching the boost gauge, it seems to flutter when accelerating and just doesn't pick up like it should i feel. First thing I could think of is a boost leak but like I said, don't know anything about these cars.
View 3 RepliesI recently bought my first VW 1.9TDI and noticed that the car shakes between 75-85km/h, both when I drive at those speeds, accelerate and or even brake during that region. I know the car needs an alignment which I have booked in when I change to my winter tires tomorrow, but could this issue be something else like a bent rim? Or what else could this issue be coming from during those speeds.
View 6 RepliesI have an '03 gti vr6 with a miss fire problem. Once it's warmed up is when I notice the problem. Just changed all the spark plugs and now I'm lost.
View 21 Replies