Golf IV / Jetta IV :: 2002 GTI Does Not Go To Full Boost Until Re-accelerate
Jun 13, 2016
I have a stage 2 2002 GTI with 135k & I'm having an issue once in a while where if I go WOT the car will only boost up to about 5 (around there, don't remember) psi but if I let go and accelerate again, it'll boost normally again.
No lights or CEL comes on when it happens though. I tried searching for any info but not sure what direction to look at. I have a stock K03S, Forge DV, 3" Turboback, Short Ram Intake, FMIC. Bad N75 or DV?
View 1 Replies
Advertisement
The car is an 02 gti. I am having problems at full boost(17 psi) where the car starts to stutter, backfire, and eventually drops to 5 psi. Throttle up to 15 psi is always smooth and there is no hesitation or misfires. It's chipped but I am unaware of which software as it was already on the car when purchased.
What I've done:
Checked for any leaks - none
Cleaned maf
Replaced plugs(0.028) and coils which was needed anyways
Coil harnesses look good
Fuel filter changed
I've read about the n75 but I am not experiencing any surge issues that many have described. I do believe the car is running a little rich because I can smell some fumes but it is very light. Car fires up just fine and idles smoothly.
View 4 Replies
I just replaced my my k03s with another one with only 20k on it. After I did this, I noticed a loud screech sound when in WOT. The screech lasts a little bit after i left off the gas when revving in neutral. I've been doing research on here, and I've read that it could be a boost leak somewhere or even the turbo dying. The shaft play is minimal though.
View 17 Replies
Ever since I got my car about 5/6 months ago I noticed it's not getting full boost. when I first got it the stock boost was getting about 5-7 I don't know if that's normal I've read they normally get more. eventually I got my car tuned and it's supposed to peak at 22 psi but it only got to about 13-14 psi. slowly it's been getting worse and my car is getting 2 psi. I've had lots of people tell me it's a vacuum leak. also the bov makes a flutter noise if that has anything to do with it. my intake doesn't make a sucking in noise like most do. The car has been randomly backfiring usually between gears. I just ordered a turbo inlet pipe a breather hose kit and a boost hose kit.
View 4 Replies
Okay I have a 2001 Vw Jetta 1.8t Wolfsberg.
I have done a few mods:
- Oil catch can
- Boost gauge
- New turbo (5000 miles old)
- Brake booster mod
- PCV system fixed and some hose deletes (that make the intake manifold have one line off of it rather than two)
- Timing belt/ pulleys
- Accessory belt / pulley
- A few other things but nothing to cause this
The car will do this randomly. And I mean once every two weeks of that. I will go to accelerate and the boost gauge says the "boost" is at zero and no matter how much I give it gas, it won't go past zero and stutters. But it stops almost as fast as it starts. I don't get it...
My catch can has 3/4" line to about 1/2" or so, that meets the oil catch can. (Ebay with the blue hose.) I have new plugs, all new (dealership recommended) lubes, all kinds of new small odds and ends. But it's never done this before. (3rd time now in a month..)
View 9 Replies
Sometimes while driving if i accelerate the car fully the rpms will accelerate way to fast (at least 2x faster than usual) without picking up much speed at all. I can tell that the car is not going to full boost. The problem is the worst in 5th and 6th gear (when the car is relying more on boost im guessing?) and will happen one day and be perfectly fine the next. I just had the car checked for a boost leak about 3 weeks ago so i dont think its that. The car is chipped with uni stage 1+ (20psi) and has a full 3 inch turboback.
View 15 Replies
I have a 02 gti with 1.8t and tiptronic trans. Anyways my gf said she was driving and traction light/battery light came on car started slowing down when she tried to accelerate. Said brakes were stuff to and car shut off..what would cause this. I had a maf code over the weekend i cleared.
View 17 Replies
2002 Jetta 2.0.... car was jerking when accelerating and check engine light was flashing, severe loss of power and when stopped at lights it would shake and the rpms would drop and go back up... took it in and was told to get the coil pack replaced. One week later new coil pack - check engine light is back on and yesterday same problem (car was idling rough, and severe jerking/flashing check engine light happened again). Took it to autozone to read the code it is giving P0420.... The shop said i might need new plugs and wires, which were replaced with bosch parts one year ago. Any chances these went bad so quickly?
View 3 Replies
I purchased a 2002 gti in Febuary with 161k miles. I believe it was a couple weeks after I bought it - it started making this creaking sound. At first it was more rare to hear it but it occurred going on uneven surfaces like up a steep hill or around an uneven turn or even stopping and going. It basically happened when the front end pitched up/down. It sounds almost like a rubber creaking or even plastic. (Some sort of bushing maybe? I'm no expert) Now it is rare for it not to make the creaking when taking off or slowing to a stop. It only occurs at lower speeds like right when taking off or at the very end of the stop right before the actual stop.
It will even slightly make the noise when accelerating in second gear right after shifting. (This is occasional) When I come to a complete stop and turn the wheel side to side ot will make the sound for a couple of turns and then go away. I have tried rocking the car and pushing down on it to replicate the sound. No luck. I lubricated various bushings and parts with silicon. It seemed to fix it but it only lasted for a few hours. (This could've been coincidental) It doesn't make the sound 100% of the time though. Probably at least 90% though when coming to a stop and going. It seems as the environmental factors (Temp and humidity) have a small effect on the creaking. I have a neuspeed 25mm front swaybar with endlinks.
View 2 Replies
Recently purchased a brand new 2013 R. With ZERO mods on it and 5,000 miles, I flashed the car to UM Stage 1. Immediately after flash I get a noise that sounds like a metal clattering in first and second gear from about 2K to full boost. Happens most audibly when the car is cold but is subtly ever present when heated up.
When the noise occurs I feel as if I'm getting half boost or a very inconsistent boost curve. The boost then kicks in after the 3,500k(ish) threshold. On rare occasions, the car will warm up and run exactly as I would expect it too. 1st, 2nd, 3rd all boost very evenly and strong from 0k and beyond with no noise and the car is amazing to drive.
To try and diagnose the issue, I flashed it back to stock and the noise disappears though I can still feel it not boosting consistently. I took it to the dealer (stock) and they said the didn't notice or couldn't hear anything which was what I expected. I'm guessing it is something the with wastegate but I don't know enough to say with any confidence.
View 15 Replies
I installed a VF intake a few weeks back and noticed my car is peaking at around 14-15 PSI max according to my boost gauge, when it used to hit 17 peak. I'm not sure if I may have a leak nor have I checked it via vag-com.
It does feel a bit off, but for as far as I know the gauge could be messed up now.
Just wondering if there would be any immediate signs (sounds etc...) of whether there would be a leak, or what other problems may cause this.
View 2 Replies
Ok here is my question. I've noticed the power on my car has felt inconsistant for the last little while. I finally got around to logging the car and my boost peaks at mid 20's just over 3000 RPM and then drops fast to between 13-15 psi before I even get to 5000 RPM.
Under full boost I hear a low fluttering sound like the diverter valve opening and closing when this is happening. I also don't get the typical diverter valve sound when shifting when the car is doing this.
I took my diverter valve out and inspected it. I can pushing the piston up very easily with almost no resistance, is that normal? I would think that it should be hard to push the piston up if not wouldn't boost pressure be able to overcome the piston and leak past?
My mods are. HPA tune, HPA catted down pipe, and VWR intake.
View 24 Replies
my car into VAG COM and since then it hasn't boosted past 4 lbs. it has Revo stg 2, K04, aftermarket side mount, full exhaust and a couple other bolt ons. Before the car was spiking at around 23/24 lbs. after pressure testing the system I found that the turbo inlet pipe was lose, so I tightened it. Still no change. I tried holding the battery terminals together for 10 minutes to reset the ecu and I also tried clearing the codes through a handheld code reader. No codes even come up anyways for this. The car is a 1.8T.
View 4 Replies
So my 2001 1.8t Golf is having some issues holding boost. I have a Gonzo stage 2 tune, CTS FMIC, Forge 008 Diverter, Silicone inlet and MagnaFlow Exhaust. I've also done the whole Evap, SAI delete and installed a catch can.
Starting in 2nd or 3rd at WOT the car spikes up to 18psi and then progressively loses boost throughout the rev range. Close to redline the boost drops to 5 psi or so. It seems to be dependent on the revs. In fifth gear the car holds 18 psi much longer as the revs don't increase as fast.
There are no CELs. I've done multiple leak tests starting at the air box and plugging the pcv/catch can system as well as at the compressor side of the turbo. None of the tests revealed a leak anywhere in the intake system. However, when I stuck my ear very close to the valve cover I could hear what sounded like a very small air leak coming from inside the valve cover. I took a look at the wastegate actuator and it seemed fine, no play in the rod, no loose bolts and to move it just requires enough force to compress the spring and it returned to its original position.
My thoughts are that it could be a fueling issue or turbo in the process of dying maybe.
View 9 Replies
Just noticed today that I have a slight drop in boost. Normal boost is 1.5 bar but today it is running slightly lower boost and does not have the same pull through all the gears.
2001 mk4 1.9 tdi golf
View 4 Replies
I just recently notice a whistling noise when I hit boost. I'm not sure but it sounds like it is coming from my gauge. I'm not losing boost pressure. I do have a glow shift gauge. The most recent install was the TIP which I clamped on to the turbo but I'm wondering if it isn't on tight enough.
View 2 Replies
I was riding along today everything running fine then I came to a stop sign and when I pulled off my car wouldn't run 10 psi of boost it was only running 5 psi so I when to a buddys checked everything over and all my piping looked fine so I went up the road and everything was fine so when I started going home it did the same thing pulled of shut the car off pulled off and it was fine again.
View 5 Replies
I think my stock DV is going bad, my car makes a weird noise under boost?
1. Only happens when first starting the car after it has been sitting for an hour or a few. (not overnight)
2. Does NOT happen when first start in morning.
3. Goes away after like 5 minutes every time and the normal WHIIISHH sound comes back like it should when I step on the gas.
4. It does not make the sound at idle.
This recording I made was of my car being revved up after it sat for one hour.
[URL] ...
View 12 Replies
Replaced my coil packs/sparks, and just got around to changing my N75 valve today. The rough idle issue is gone but now when I go WOT it boosts but goes from 15psi-12-13-12-14-12...etc. I've checked and there are no boost leaks. I do have a CEL saying I need a new bank 1 sensor 1 Oxygen sensor. If it is that, why did this problem arise as soon as I changed the N75 valve and wasn't present earlier?
View 1 Replies
I was having an issue with my car not going into boost so I plugged my code reader in and it had 2 codes 1 was p1200 n249 malfunction and the other was diverter valve malfunction so I did the quick easy one and got a new factory diverter valve but it still doesn't go into boost and still reads p1200 n249 what do I need to replace or should I do the n249 bypass it's a bone stock jetta 5 speed.
View 5 Replies
I just got done with a complete engine rebuild on my 02 1.8t jetta, had everything hooked back up and went to start it for the first time and it wouldn't. I went back looking for loose connections, nothing. Worked and banged my head for a day or two, I had fuel and spark but couldn't get it to fire. Finally I "choked" the intake to see if it was getting too much air and it fired right up. I unplugged my map sensor giggles and it starts up perfectly. I then hooked everything back up and what do you know it starts up and runs fine, but if I plug the sensor back in it kills the motor after about 10 seconds of running and won't start until I unplug the map again.
Car runs and drives but wont boost over wg pressure but that's probably because sensor itself is unplugged. I just wanna know what could cause it besides the sensor itself being bad. I ordered a new one waiting for it to get here (hoping it fixes the problem).. And I'm talking map (manifold absolute pressure) not maf (mass air flow), just in case people are confused.
View 4 Replies
