Golf IV / Jetta IV :: 2001 - Engine Would Not Idle Correctly / EPC Light Started Coming On
Jun 5, 2014
I purchased a 2001 Jetta and it ran alright for a few days then all these problems started arising. The engine would not idle correctly and then a week later my EPC light started coming on. After all of that I have replaced the Throttle body ( Bosch) the MAF ( after market) and gas pedal ( after market). It ran fine for a day and then same issues. I had a mechanic relearn the throttle which had the Engine light go away for about a day. Now all the issues have came back. Here are the main problems.
1. Randomly lose throttle ( up hill, down hill, highway does not matter)
2. I randomly get stuck in park and cannot shift at all.
This is extremely troublesome since every time I lose throttle i have to put the car in park, shut her off and turn her back on to be able to drive. I keep getting the Throttle and MAF codes. I also checked on the recalled parts and they have already been replaced. I have read many reasons as to what would cause this but even the mechanic doesn't even know and I cant pay for him to check the electric. Also when driving if it is raining my car will not start or when it does it chugs. I was running through a puddle and after the water splashed the car basically would no longer run.
View 7 Replies
Advertisement
While I am driving the car it will start to die and skip. Happens randomly. Today I was driving up a small hill and it went quits on me started lurching with check engine light coming on and off. The car will turn over and start, but only for a few seconds before dying again.
Seems to happen when the car is running for a while. Also the ABS light flashes on then off randomly while driving sometimes although It hasn't been an issue. Will be checking tomorrow to see if it starts.
View 1 Replies
I got my 2.0 turbo project up and running. no CEL but i did have a bad o2 code but it was erased and didn't come back.
Not only is it rough idle and smoking out the exhaust but i am also getting smoke out of my catch can vent.
The smoke looks black coming out of the tailpipe but little blue after it gets out a ways from the car. Where to look??
I did just replace a piston and install a head gasket spacer. I don't know if that could be causing it some and it will go away with some driving or what?
I have not taken it out on the road as I have some brake work to finish. so mostly it idled.
Here is a link to a video on what the car is doing : [URL] .....
Its a 01 engine code....
View 3 Replies
I have a 2003 Prius, I had an accident and after it was fixed the check engine light started coming on. It would go off after a couple of days. The first time I took it to Autozone and the codes were P3150 & P3130, but the next day the check engine light went off. A couple of days later the light came back on....went back off....next week it stalled on the highway, but it started back up, now the codes it's reading are P1636 and P3002. It still starts up and will drive, but I'm afraid to drive it.
View 2 Replies
I've had this car for awhile now and it's always had this weird whining sound coming from the engine.I had the transmission serviced thinking maybe that was the sound and it wasn't. I've taken off the serpentine belt and spun all the pulleys. I can't figure it out, I'm thinking maybe timing chain but I'm not sure.
View 12 Replies
I own a 2001 Jetta 1.8t with Gti front end. So I was driving downtown the other day and I bottomed out really hard and cracked my oil pan. I didn't realize it was cracked and leaking so I drove it home, drove fine with no issues at all. When I got home I parked it and went inside and in the morning I came out and tuned it on for maybe ten seconds. It made a really loud ticking sound that was constant and oil pressure was almost all the way down. So I shut it off and looked and saw the oil pan. I fixed the oil pan yesterday and started it up and it sounded really good and drives fine. But I've been hearing a pretty decently loud ticking sound when everything's up to temp and warmed up. The ticking is only at an idle and it drives like it use to just sounds bad at an idle. Some people think it's my oil pump and tensioner, some people thing I ruined the turbo and possibly internals.
View 4 Replies
On my way to work, my check engine light started blinking and car was sputtering (real bad on idle). I ran the code and it came back with misfires codes. I changed the coils/plugs, fuel filter and fuel pump last year. Can the coils be bad already? When I clear the codes the car will run fine for a little while. But after a couple miles CEL will blink and the car will run roughly again.
Car : 2004 Golf 2.0
Codes:
16684: random multiple misfires
16648: fuel injector #2 short to ground
View 5 Replies
So my gf's check engine light on her 01 Golf flashes once in a while, and it misfires. But the thing is, it doesn't stay on, and it's once in a while (like once or twice a week). She has new spark plugs, and new wires. I have a feeling it's the coil pack, but I really don't know if it needs to be replaced until the check engine light actually stays on.
View 14 Replies
Just a few days ago I was driving and I noticed as I went over 35 mph my car would stutter and the check engine light would start flashing. And when I slowed back down the car drove fine. I'm wondering what the problem could be? Feels like the car is losing power. Car is currently at 119k miles.
View 1 Replies
So last Thursday I started my car up in the blistering cold and it ran fine for about a minute and started to misfire so I shut it off. It hasn't ran since. When that happened the check engine light was blinking because of the misfire. I didn't have a code reader at the time to read it. now that I got a code reader the damn thing isn't throwing any codes. it spits and sputters sometimes. I've had no previous problems with the car. Thinking It might be a weak fuel pump or bad coils and in not sure how to test them.
View 1 Replies
I have an 04 gti 1.8t and last night it started over heating. I pulled over and checked the coolant and the oil but everything looked good. I let it cool down and drove it home. When I popped the hood there was a little steam coming from the coolant overflow tank but I saw no leaking. I decided to vent the pressure off the system and then I got a little drip on the passenger side close to where the inter cooler is. I can't pinpoint the leak though.
View 4 Replies
So my girlfriend got a 2002 Jetta Wagon 2.0 automatic (PRND321, no tiptronic). She noted when she was driving fast on the driveway highway one day her speedo stopped climbing and would wiggle around 60mph and not go any further even if she was going 80+.
I would have thought first that the speed sensor would be messed up. Went to the junkyard and pulled 2 speed sensors for cheaper then 1/4 of new. Put the newer cleaner part on and the same exact issues. Locks up and wont climb past ~65mph and the needle wiggles. I am guessing its not the sensor. Question is what could cause it? Could it be the actual internal gear in that meshes with the transmission? Ill try replacing, i have extra i think. But could this be a cluster or a computer issue? And the odometer is also off. When it gets stuck at the slow speed, the mileage won't count at the full speed. She drove to a friends at a known 80 miles away and it only said its was low 70-something on the gauge when she got there. So there is a discrepancy of mileage count too.
I am going to head to the junkyard soon and thinking of pulling a cheap cluster to try it out, but I also heard you might need a VCDS for the immobilizer in the cluster. And the mileage is stored on the cluster or not? What should I pursue next?
View 1 Replies
So im trying to diagnose my girlfriends issue with her car. When she starts it, the car will make a very loud rattling sound, not really grinding, but like metal on metal contact. Sometimes the sound goes away, but when the car is cold it is a guarantee. The battery light is also on, which was not the case when the rattle first started. I first thought (and hoped) it was perhaps the serpentine belt tensioner as I researched that when it fails it can make a loud rattle sound.
Once replaced, the same issues occurred. So I went ahead and put the old one back on since it was not the issue. Note that the old one and new one both shared the same tension applied to the belt and the pulley was still smooth without issues.
Using a stethoscope to try to determine the location of the rattle a bit more precisely I found the noise to be coming more from the alternator. Weird because I recently replaced it within the last year. I went ahead and removed the tension from the belt and played with the alternator for a bit. The clutch felt good when i used a screw driver to hold the fan and tried to move the pulley. One direction moved with ease while the other direction refused to budge, perfectly normal as I researched. The thing that I noticed that I thought was unusual was the fact that the shaft of the alternator had some play (Video below).
The belt has plenty of tension on it so i do not believe that it is slipping on the alternator. I push the belt with the tensioner engaged and the tensioner does not budge.
I decided to measure the voltage coming off the alternator with the car running and it was at 10.95 which im pretty sure is very low for these cars.
View 2 Replies
The other day i started my car after school and about two minutes after the car started the battery light came on. A little bit later, the gauges went to zero but the car was still running, On my way home from school, it did it again twice then the battery light came on and stayed on. I got home and tried bringing the car to autozone and all the lights on the dash went dim and the car slowly died.
View 13 Replies
I have a 2004 volkswagen jetta, and it has started overheating. At first my problem was the thermostat. After that was changed out the fans stopped working correctly. It kept blowing fuses in s180 slot.
I read somewhere in another post that this is due to the fact the resistor in the low speed fan go bad, and for your car's radiator fan to go from zero to high speed, causes the fuse to blow. Also I read that when the fans start up it draws the most current, and then after it's running the current is considerably less.
This is my solution, I went to napa, and got a circuit breaker for a car, and Yes, to my surprise they make them. I picked up several a 10amp, 15 amp, 20 amp, and a 30 amp. First, I tried the 30 amp circuit breaker and it didn't trip the circuit, but when I put a regular fuse in the slot, it did trip the circuit, when I did the fan test at the thermostat switch. Next, I put the 25 amp in there and neither did it trip the circuit. When I put the 10 amp in the s180 slot, it tripped the circuit, just as the regular 30 amp fuses do. So that confirmed that the amps that were being drawn from the fans were not enough to trip a 30 amp circuit breaker.
What I did next, is I took a 20 amp circuit breaker and put that in the s180 slot. Then I hooked up vag com on my laptop to check and see how it performed with the 20 amp circuit, and these are the results.
Car Temperature in celsius
at 111 degrees the gauge was moving past the halfway point
at 115 degrees the gauge was one notch past halfway going towards the red zone
at 120 degrees the gauge was two notches past halfway going towards the red zone
at 122 degrees the fans kicked on high speed for about 30 seconds, and knocked the
temperature down to 105 degrees.
In conclusion, if the high speed on the fans work, you don't have to take those out and go and buy an expensive new fan set. Just stick a 20 amp circuit breaker in the slot, and keep using the fans that you have.
Part no: 782-3154................ Name: Circuit Breaker, 20 Amp; Blade
Note: I take NO responsibility for any damage you do to your vehicle from any information you obtained from this post. Do this at your own risk! I am not a mechanical expert but this is my solution to the overheating problems.
View 1 Replies
I know its a shot in the dark but my engine light came on the other night. Its a 07 v8 with 25k mileage. i started it up idled fine for 30 secs, then the idle started to get erratic up and own for 15 secs leveled off and the car ran fine. I drove for 10 minutes turned the car off for a couple of hours came ack started her up and engine light came on no rough idle or anything.
View 8 Replies
I swapped transmissions in an 01 vr6 glx automatic car. The car will start and run perfectly until it reaches operating temperature. Once it hits 190 f it shuts down and will only start again if u wait a few minutes. It has me stumped. I have unpluged the coolant temp sensor, and Have checked for vacuum leaks and loose connections but no luck.
View 1 Replies
What would cause and how to fix my Jetta. It will idle at almost 10 rpm sitting still? It also sputters as if trying to die. It has an after market air intake with a ktm air filter
View 4 Replies
I have a 01 1.8T and I'm looking for a little more rumble and idle noise currently my set up is a 3 inch downpipe cat less and a resanator delete into a stock muffler with modified tips, I had the downturn cut out and ran it straight out the back. Anyways my question is what muffler would you recommend that gives a nice idle and aggressive acceleration with my current set up ( the 3 inch downpipe and res delete).
View 3 Replies
Just bought a 2.0l 2001 golf four door. the previous owner had the car for only a short time. They claimed the CEL came on and the code was for the MAF. He cleaned it and when I test drove the car there was no light or sign of any issues with how the car ran. Today while figuring out why the alarm kept going off(battery died in key fob and i replaced them), it began idling rough. It had just started to rain as well. From what i could find from older thread is it could still be the MAF, TCV/ISV, or O2 sensor. Is there any good way to diagnose without a vag-com cable. Mine wont update its firmware and i'm screwed at the moment in terms of gathering info on the problem.
View 9 Replies
I have a 01 vw bora 1.8t and recently I let it sit for one day and now it has trouble starting when it's cold and when it does start it has a very rough idle and often stalls out of you try and press the gas. Once it has warmed up she runs fine. My check engine light is on but I have no way to take her down to a shop to get the codes read. What is wrong with my car? One of my friends told me it could be a cool pack or a sensor.
View 1 Replies
