I recently bought a 2000 jetta vr6 MK4 and since i have had it its had a misfire problem. So its saying that its misfiring in "cylinder 1" and sometimes when I clear the code it will stay off for the whole day. I did everything I could think of. I replaced all the spark plugs. I replaces the plug wires. Then i bought I new coilpack. and its still misfiring.
View 10 RepliesI have a 2001 golf with a 2.0 AVH engine. I recently replaced the coil-pack and was very pleased that the engine was running better, the only problem was the mpg was still kinda low in the 24-5 range when it used to be 29.
I tried to do a compression test but I didn't prepare properly, I thought you left the coil pack plugged in and the fuel fuse. Now I have a CEL that *was* flashing saying cylinder one is misfiring though it has stopped flashing. I drove it 13 miles home and it did improve but its still running rough. Very reminiscent of when my bad coil pack was still in there, a real lack of power.
So I have to ask, what can I do from here? Have I damaged my coil pack or cylinders? Will this likely go away on its own? Is there anything I should do?
CEL came on and the report says #2 cylinder misfiring. Changed plugs, wires and coil. Last step was to change the #2 fuel injector. I changed the 2nd injector from the left but I'm still getting the same message. I was wondering if maybe they aren't numbered that way. It's a 2004 Jetta with Car engine: 2.0L L4 SOHC 8V. Did I change the wrong injector?
View 1 RepliesSo a few days ago my engine developed a misfire, flashing MIL light etc...long story short it was cylinder 5's ignition coil. When we scanned it, we picked up a misfire on cylinder 5, and a slight misfire on cylinder 1. Replaced the coil, as well as new spark plugs, cleared the codes, and everything was peachy.
NOW, driving home today.....once again. Misfire, MIL light etc. I'm not a mechanic so I am wondering if it is common for all the coils to go around the same time, or if this is probably just cylinder 1 now going. I'm going to once again get it scanned, but before then...is there anything that could cause ignition coils to just start going bad, other than age.
My friend has 2000 12v vr6 auto and recently he experienced his car bogging under acceleration. He had the plugs and wires recently done to solve the problem and the problem went away for a day and has since returned. I scanned it and here are the codes that its threw. After doing some research i'm thinking its the coil pack, since it was pretty foggy/damp today (when the problem started again).
17626.p1218 - fuel injector for cylinder 6 (N84): short to b+
16690.p0306 - Cylinder 6 Misfire Detected
16684.p0300 - Random/Multiple Cylinder Misfire Detected
I have a 2000 Chevy blazer 4.3L 4 wheel drive. 4 of the 6 cylinders are misfiring and the car has completely lost power. Before this issue occurred it was running fine and the next morning when I went to start it the car was turning over and wouldn't start. My dad and uncle believe it's a distributor or computer issue but I would like other opinions about this issue.....
View 3 RepliesAbout a month ago my wife's 2000 Jetta with the VR6 engine in it started acting up and throwing codes. The codes it threw were for random misfire, misfire in cylinder 2, and misfire in cylinder 5. Starting out, we changed spark plugs, fuel filter, and made sure the injectors were clean.
The problem didn't go away so we water tested the coil and wires, but they passed that test. The wires were quite old and out of spec, while the coil was in-spec across all terminals, according to the vehicle service manual, so we installed some new OEM leads this weekend. While installing the leads we noticed a disconnected vacuum line and reconnected that as well.
The vehicle was driving great for two and a half days, then today while I was sitting at a stop light, it started missing really badly and felt like it was going to kill. It did this for about 5 seconds, then recovered and ran smooth for about 5 seconds, before getting really rough until I started driving when the light changed. It didn't do it when I drove it a few hours later at all. This episode didn't throw any codes either.
What could be causing this issue? Would the MAF cause the intermittent missing, or is it possible that the computer is going bad?
2000 GTI GLS 2.0L ... I understand I need to replace the Ignition Coil Pack on my car. I have looked on ECS Tuning to find the coil pack, but from all the pictures I see of other people coil packs they look nothing like what mine do. So I'm wondering if they are different for my specific car? So the issue that I have is my engine sputters sometimes, but more so when is wet outside. Its only cylinder 2 misfiring currently, and I replaced my Fuel Filter and Fuel Pump already in the past 4 or 5 months. Also a local shop had done some work recently and I know they had replaced the spark plugs. So I'm just wondering what coil packs I need for my car, and how I would go about replacing them. From what I saw online with other 2.0L (They weren't GTIs tho) was that the coild pack was behind the SIA pump or something like that, and they are a small black box. It looks to me that my coil packs are inline above the spark plugs and cylinders?
View 2 Replies2000 Jetta 2.0 cylinder 2 misfire. Replaced plugs and wires. No check engine light but code is pending and there's still a misfire. Need to smog
Replace coil pack?
Swap fuel injectors and recheck?
Happened a few times on me lately. While pulling towards the top of 5th, I'll start to see the check engine light briefly blink as if the car wasn't sure, then at the top of 5th, she'll start misfiring on cyl 2 and 5. It's only during the long haul pulls that this occurs. My plugs and coils were all changed about 1k miles ago.
View 17 RepliesThe car already has a cel even though I just bought it. Drove home from work this morning had no problems, went to go shopping no problem, come out start my car and it won't idle right, problem. The Cel flashed at me and once driven a tiny bit stayed constant. Seems like a cylinder is misfiring because of the sound it makes and it is hesitant when you give it some gas. What could it be, coil packs (which is what is was in my 24v) MAF, spark plugs?
View 22 RepliesSo I installed a Forge Wintake yesterday and my car responded well to it yesterday. Everything was working great and then on my way to work this morning a CEL turned on and it is misfiring on at least one cylinder. I checked all of the connections to my coils, the MAF and my First O2 sensor. Everything looks fine. My Car is a 2012 GTI. I also have a APR stage 2 flash and a Raceland Catless down pipe.
View 14 RepliesI am having a recurring problem, My engine keeps misfiring. I have replaced the spark plugs, ignition coils and pcv valve with all new parts and and fixed it for a little bit but now my car is misfiring again, and Im hoping its not the head so need to narrow down what the problem is...
View 1 RepliesSo leading up to today ive had some bucking under load which felt like misfiring to me. I borrowed my friends VCDS cable, checked MAF, checked o2 sensors, checked cat. They are all good. This problem is constant but i did get a misfire code once (random, cyl 1, 2, and 3). I cleared the code and they never came back.
Today as im driving home from work, the bucking problem was much worse. Then the CEL came on. I just checked the code, and it was system too lean. I cleared the code and now the car will not start. It cranks, shows rpm on VCDS and sputters but doesnt even come close to starting.
1995.5 Jetta VR6
Misfire cylinder 1 and random misfiring
P300 P301 Vagged it and can't figure it out
Changed the plugs, wires, and coil pack Used and old timing light and getting spark in all wires so can't be the coil pack
Fuel injector, O2 sensor, any other things?
Is it possible that disconnecting battery causes a misaligned throttle body, which in turn causes the EPC light to come on? And does a misaligned throttle body also cause misfiring cylinders (1 & 2 in this case)?
View 3 RepliesI'm getting misfiring after the engine is hot, but it only shows up under certain load. For example, if I'm in 3rd gear at about 2500 rpm and I give it some amount of throttle, it wont misfire at all but if I give it just a hair more (maybe past 50% or so), it will start misfiring badly and the blinking CEL comes on. The codes it's triggering are misfire on cyl 1 and multiple misfire.
I replaced the coilpack about 6 months ago, that's why I'm hoping for some feedback before I drop a few hundred dollars on another one. I had the plugs out very recently and they look fine. The shape of the wires are difficult to get multimeter probes on so I haven't checked them.
So I have a 2004 jetta GLI (1.8T) with forge splitter valve and short ram intake. I went and got my codes pulled and all 4 cylinders misfiring and random misfires. I replaced both coil packs and spark plugs. check engine light popped up again after about 20 miles and same thing. I just bought the car so I'm not sure how long it has been running with these misfires. I just got the timing belt replaced. I know it could be off a tooth. (Wouldn't a code pop up though for it?) How could I check that. And I also took my MAF sensor off as well and no change. Heard it could be clogged cat, any way to check? I've also cleaned the throttle body. It runs fine when I'm driving, just a rough idle.
View 15 Replies2002 Jetta 1.8t, auto tranny, 90K miles. Recently took it in and had all coilpacks replaced under VW's recall.
Sometimes when it's been sitting out in cool air for a long time (in Texas summers, this is nights-only), about 3 miles in it suddenly starts misfiring- BAD. Check Engine light comes on. Lasts about 30 sec, then goes away and doesn't come back for the rest of the drive. WTF?? I can't make it happen on queue.
I heard about the all-too-common grounding problem on the engine harness. I did find a significant resistance between the ring terminal on the head and the battery (-). I tied the 3 ground posts under the battery together with 12ga wire and crimped terminals, and ran another 12 ga wire up to the engine block ground right under the ring terminal that grounds the coils, which should have shorted past any weak spot on the harness. PROBLEM STILL OCCURS!
Scans showed:
17766 Cylinder 2 Ignition Circuit: Open Circuit
16682 Cylinder 2 Misfire Detected
16684 Random/Multiple Cylinder Misfire Detected
17658 Low Fuel light (only ~3 miles after lighting the Low Fuel warning, I don't think the fuel pump's running dry just yet here)
Seems to focus on Coil 2. But last time I did this I got these errors for Coil 3 and swapped it for a new replacement I had in the trunk in case one went out unexpected. Well now it just says Cylinder 2. Just did it again tonight after clearing codes and got these same Cylinder 2 errors again.
Actually I started to wonder... I've been running the tank close to the "low fuel" light to check my actual mpg usage (no display for it in my MK IV), but fill back up a few miles after it lights. I can think of a couple of spots on the late-night drive back that I see this, one's after a hill which might cause a fuel pump to run dry temporarily, but another's a light downhill then up a light offramp. I don't think the tank's been low every time this happened but I'm not sure. Well, a couple of times it's been mostly level in the parking lot anyhow and misfired a bit right off the bat when starting, so probably not.
Wouldn't there be some sort of "low fuel pressure" code if fuel starvation was actually the issue going on? Hmm, I went looking and I'm not sure there is one for a MkIV, there's errors for fuel trim but I don't think you get those in short-term. This is kinda scary how it just goes out while driving, and I can't do much to reproduce it or test out fixes.
So looking further, other people report what may be intermittent fuel pump issues when the tank goes low. But could that result in "Cylinder 2 Ignition Circuit: Open Circuit"? I mean the coils will still electrically read as firing. Of course if the system gets all glitch-y, the software may be making a mistake somewhere and report this wrongly.
I'm having a misfire issue on my 1.8t. When I go into high boost I'm getting bogged down and misfiring.
I plugged in my obd2 adapter and it gave me a misfire on cylinder 3. I since cleared the code to try and see if it was a coil pack by switching it to another cylinder, but now the cel won't come back on although the problem persists.
I have recently changed the plugs and the car was fine. I then added a fuel injector treatment and the misfire started shortly afterwards. (coincidence perhaps). It's frustrating as I can't rule out coil packs as my cel won't come back on and my code reader is not displaying any faults.
I did previously have a cel with something about fuel trim bank 3? I am also sure I have a boost leak as the car whistles pretty loud under boost.
Also worth mentioning I have a bit of white smoke sometimes but I'm not using oil or coolant and they are not mixing either. I'm at the end of my tether with this car and just want to try get it back to normal.
Firstly, my car is a 2001 with a 1.8T, 5 speed manual. It has APR's 93 with the mode-switching software, a FMIC, a short ram air intake, the SAI delete and the original DV (used to be a Forge 007). I bought the car in 2008 and it didn't have this problem until the following winter, sold it in 2012 and recently bought it back from the guy I sold it to.
My car will start and idle great, and accelerate through first gear without problem. In second and third gear, when it hits around 3000 RPM, it just suddenly starts to sputter and run like crap and not get any kind of boost. Fourth and fifth gear, I can run it until it peaks and it'll never miss a beat. It only does this when it gets cold outside (sub-30 degrees) and is perfectly fine the other nine months out of the year. I usually don't drive it in the winter if it's avoidable, but I have to travel a lot this year and would like to drive it instead of my truck.
In the past few years/15K miles, I've replaced:
- All four coilpacks
- All new spark plugs
- New coilpack harnesses
- Catalytic Converter
- Throttle body (twice)
- Diverter valve (back to stock, other owner did it)
- SAI delete (other owner did it)
- Fuel Filter
- O2 sensor
- ECU (the factory one got shorted and had to be replaced back in '08)
I've also gone through and checked every vacuum line and can't find any leaks (including spray testing). My CEL is on due to the SAI delete. I've tried it in both the stock and APR mode and it doesn't make a difference.