Golf IV / Jetta IV :: 2000 - Constant Engine Vibration When Car Is In Gear
Oct 6, 2012
I have a 2000 Jetta with the 2.0 automatic and just like the title states, I have recently developed a engine vibration that is felt at all times. It is much worse when the car is in gear. I only seem to feel it in the gas and brake pedals. It does not seem to depend on speed nor does it only occur at certain rpms. It feels like someone zip tied a vibrating back messager to my pedals. I want to find out what it is because on long commutes my foot begins to feel like its falling asleep. I can visually see the engine vibrating with the car in gear. I am leaning towards motor mounts.
View 1 Replies
Advertisement
I lamented in the past a lot of vibrations when the engine was at 3500RPM (in any gear). I read on the forums and many people blamed the aftermarket "EMPI" axles that I mounted too. In fact, my OEM outer CV joints where seized inside the hub/spindle and one of the inner CV joints was clicking; the boots were all worn. This was the reason I went with aftermarket axles. Anyway, I rebuilt the OEM axles by keeping the shaft only, and getting good quality inner and outer CV joints. I finished today to swap back the OEM axles and, finally, no more vibrations!
View 10 Replies
I have this annoying vibration that starts at 85-90 mph and stays relatively constant above that, but doesn't get super intense or feel like the car is going to fall apart. Its a light vibration that I can feel at 9 and 3 on the steering wheel.
Background: So about 6 months ago I realized my CV boot was torn. I tried to replace CV joint, but they sent wrong joint(Meyle) so we ended up trying to force it onto the CV shaft for like an hour before giving up. I remember one of my BMW Technician buddies literally smashing the joint onto the shaft with a plastic mallet but it just wouldn't go over the circlip.
We ended up just replacing the boot and putting the old CV joint back on, but we didn't have any extra grease to put in it because we had already put it into the new joint that wouldn't fit. Since then I've basically tried everything I can think of, including:
-Balanced and Road Forced
-Laser Alignment
-Replaced all 4 tires
-Fixed bent rims
-Refreshed suspension/steering:
-All new F+R LCA bushings
-New inner/outer tie rods
-New ball joints
-New sway bar bushings
-New strut top mounts
So what the hell is keeping her from being smooth as butter over 90? Did we screw up the shaft by beating on it? Or is it just vibrating from the lack of grease/damage from torn boot? Was I supposed to align the shaft when putting it back on or something?
View 10 Replies
So I replaced the engine and trans engine mounts on my 2004 R32 today. After I got done and drove it there was some serious vibration and gear whine. It also seemed like I wasn't able to transfer all the power to the wheels, it was definitely slower to accelerate. Did something go out of alignment?
View 10 Replies
I am hearing a vibrating sound only between 2000 - 2500 rpm while accelerating from inside/under engine bay. No impact on ride quality and no engine harshness is felt. Only it sounds like some metal sheet is vibrating for a while. After crossing 2500 rpm it simply disappears.
Checked inside the engine compartment by revving the engine while stationery and I don't get that sound. What could it be? Some shield of the exhaust? cat?
View 2 Replies
Recently bought a 1999.5 vr6 jetta and noticed that it will randomly grind going from 1st to 2nd gear (its a manual). It seems really erratic, it will do it at any rpms and at completely random times.
It only does it when shifting up, not downshifting. I can also go 50 times or more shifting into 2nd without it happening or it can happen 5 times in a row. Not sure what do here...
View 5 Replies
I've been having 2000 Jetta GLS VR6. It has an automatic transmission and lately I've noticed that when I put it into Drive, it starts out in 3rd gear. In other words I've lost 1st and 2nd gear when put in Drive. When I manually put it in 1st gear with the shifter, I have 1st gear and all the way up to Drive. The issue just seems to be while in Drive (D)
I've tried the Automatic Transmission Reset :
[URL]...................
Perhaps I'm not doing it right as I can't seem to see any switch under the Gas pedal, just a round piece of plastic that protrudes an inch. I've even removed that and still see no switch.
View 4 Replies
I come today for a apparently transmission problem. I have an automatic VW Jetta 2000 2.0 that i bought a few months ago, the car is great, has 250K miles.
The problem is in the morning when car is still cold, the transmission isn't shifting gear until 3K RPM (For 1-2 is about 2.5K RPM, and 2-3 is about 3K RPM). After 5 minutes of driving all back to normality and transmission shift gear about 2.2K to 2.3K RPM.
The question is: this is normal?, what could be wrong?.
View 7 Replies
So, I recently picked up mt 2000 vr6 has 200k on it runs great well taken care of. I was just driving not getting crazy or any sort of thing. it has ground in 2nd a little from when I got it. I put it in neutral then went to put it in 2nd and it went but nothing there. it will go into 2nd but won't stay and when I hold it in 2nd gear it just revs no noise or anything just sits and rolls. tried doing the reading but all I fold was 1st and 2nd I just have no 2nd.
View 1 Replies
Two control arms and a passenger side cv axle I get a bad engine vibration @3800 rpm. Feels like solid motor mounts. It goes away @4500 rpm.
The old cv axle was making noise from the inner joint and the control arm bushings were broken apart.
The engine vibration was not there with the old parts.
View 16 Replies
After 11 VWs, I finally have one that I would love to drive over a cliff. My 2015 Golf TSI Sport is a miserable car for me. I have had it back to the dealer four times for the infamous "shimmy" and shift problem with the automatic transmission. It has the standard automatic. The transmission has no idea which gear to use, it shifts like a bowling ball in a barrel.
Clunks upshifting and downshifting. The other problem is the shimmy/wobble. I have it in spades. The car always feels like it is hitting small strips in the road with a constant vibration in the front. The dealer cannot find the problem even though VW is trying to figure it out. (I have a feeling this isn't the first time). It is the worst driving car I have ever owned. Would much rather drive my 04 GTI with 100,000 miles and worn tires.
View 14 Replies
When I'm idling and I rev the engine to exactly 1200 rpm i can feel an extra vibration coming from the engine. If i hold it at this rpm it will continue on. now this is not a violent vibration but more so of a buzz i can feel that travels to my steering wheel as well. what could it be ?
Another question is when i travel up my driveway and i hit the sloped curb at a angle i can hear a specific "clunk" sound coming from around the drivers foot well area what could this be? perhaps my axle going bad? I also heard it when I was reversing out of my parking space while turning.
I am new to this car and trying to make sure I'm doing everything i can to put it into good shape.
View 3 Replies
The following occurs: When car is in PARK there is no strange vibration even with AC on.
When DRIVE is engaged, vibration begins, even worse with AC on. Once the car accelerates vibration is gone.
I went to the authorized dealer service shop and they told me that this symptom is typical of these cars, they even sat me in some other cars to prove that these vibrations are normal.....
View 8 Replies
So I replaced the engine and trans engine mounts on my 2004 R32 today. After I got done and drove it there was some serious vibration and gear whine. It also seemed like I wasn't able to transfer all the power to the wheels, it was definitely slower to accelerate. Did something go out of alignment?
View 2 Replies
I have 1 month left on my AAMCO rebuilt transmission. I took it in a few weeks ago when it went into "limp mode" (Stuck in 1st gear). Eventually, they got an error code of P0730, which I believe is electrical-related. All was pretty good but then today, driving @ high speed on the interstate, I could not get into 4th gear...
View 1 Replies
Lately I've been hearing a constant click from what seems to be my chains side of the motor. Tensioners and chains were said to be done around 123k. After I've been driving it for a few minutes I hear the click. I thought it was the trans/ throw out berrying but when i push the clutch in and have it in gear i can still hear the click. It is not rapid like a tensioner like a tick tick tick, its like tick......tick......tick, could this be my top end of my block not receiving enough oil? I have a cracked oil pan, doesn't leak that often but i feel as if that is the source of the problem. Also I feel as if i lose power once i hit about 4300-4400 RPMs could that be because of low oil pressure?
View 2 Replies
So I recently swapped my 2.8l 12v vr6 for the same engine because mine blew up, everything went good and the car runs great but there is a faint kind of rattling sound coming from the top of my motor, when its idling it will be a constant faint rattle. It gets worse as i accelerate between 3 to 4.5 rpms but then stops making the noise when i really start cooking so Idk if I just can't hear it or what. I've tried looking it up but i can't seem to find a video that has the same problems as my car. My father told me it could be my rockers or valves and others have told me it could be my timing chain or guides. I would love to just take it to vw to get it diagnosed but I don't have the money. I will try and upload a video of the sound ....
View 7 Replies
So I recently lower my car and my 3" exhaust started a constant rattle when I'm in the car. When I get out it stops. Been lowered for a week or so now and today was the first time that happened. I've read up and seen its pretty common when we go lower. Also some ways to possibly fix it.
View 16 Replies
Temp is at 190, runs great, coolant levels are fine, everything seems fine but there's a constant stream of smoke coming from my dipstick tube. Oil isn't milky. 2.0 AZG. Tried searching but only found threads for 1.8t's. Headgasket was done recently.
View 2 Replies
Finally got around to replacing my Thermostat because the DIY here made it look so much easier than removing the alternator and such. Did everything exactly as described and after assembling everything with the new t-stat and O-ring I am getting a constant leak from the housing. I tried removing everything and reassembling...all the bolts are tight. Plastic housing isn't cracked and seems to be in great shape. Everything lines up properly but coolant is just running out of the bottom of the housing. Am I missing some magical trick here?
View 15 Replies
I recently got a 2001 Mk4 GTI from carter Volkswagen in Seattle with 113k on it last friday (it did come with the car fax). I drove it back home to Wenatchee and it ran fine and is still running fine... I think. Today as i was coming home from school the check engine light came on when i was in 3rd gear and the car just wasn't driving as smooth as it was the first day (it felt as if i was driving over really really small bumps or like something was loose and was moving around a lot).
When I would get to a red light and be in first gear the light went off but it came back on as i would shift into 3rd and stayed on when i got into 5th. It recently had its oil changed at 112,000 miles. Also when the car is just idling the tachometer is going up and down a little bit, it is idling at about 600-700 rpms. I got this car because i didn't want to have a car with problems any more (I had an 88 Isuzu Trooper before).
View 14 Replies
