Golf IV / Jetta IV :: 2.8l VR6 12v Engine Turns But Doesn't Start
Jul 10, 2014
I have a 120k miles manual 2000 jetta vr6 12v. I was having check engine issues so i put in a reader and showed me problems at catalytic converter. I don't remember the code, and no longer have a reader...
I was told to replace the oxygen sensors in both banks as well which i did.
I opened up catalytic converter to inspect and now the car will get no spark, the engine turns, and the display shows engine stop.
I was also told to put the oxygen sensor further away with an extension cord but not sure if that plays a part.
Does the catalytic converter is causing it to not spark?
Could there be an issue with maybe a sensor at the crankshaft that checks for motion?
What the starting sequence and dependencies are or what failures I could have that prevent the spark?
View 2 Replies
Advertisement
I have a '99' 2.0 Golf. The engine turns over but it wont start. I bought new fuel pump and crank sensor. that still didn't fix the issues. I also am not getting any fault codes so I am really at a lost, when car died on me the engine stalled as if i missed the clutch, ever since i haven't been able to get it on, i also bought a new battery.
View 2 Replies
Okay so my 2003 Jetta GLI normally starts without a problem. But it seems like whenever it gets cold (below about 40) it doesn't even try to start. I turn the key and nothing happens, the engine doesn't crank. All the lights turn on like normal and they're not dim so I don't think it's the battery. It'll still start if I roll-start it, but there isn't any sort of hill for a few miles. Normally once it warms up later in the day it'll start up.
View 3 Replies
My 01 Jetta 2.0 started having issues a few days ago. The engine would crank, but wouldn't start. Wait a few minutes and it would start right up. I go to start it the next day and it would crank, but not start at all. I pulled the P0322 code and replaced the crankshaft sensor along with a new fuel pump, and spark plugs just to be safe.
Next, I checked for fuel and spark, which I have both. The car still won't start and seems to lose a charge on the battery pretty quick. At this point, there are no codes showing up. Could the engine be flooded from trying to start it so much?
View 3 Replies
Just replaced the fuel pump in my 99 Suburban. Replacement is an AC Delco unit. When I tried to start it, nothing. Engine turns over but doesn't start. Checked all connections and getting voltage down to new harness. replaced relay from GM dealership and also fuel filter. I used to hear the old pump prime when turning on the ignition but don't hear anything with the new pump. Could it be a bad pump out of the box?
View 1 Replies
Last year I had an issue with starting my 1.8t Jetta Gli. Every couple of weeks, the car wouldn't start unless I keep trying or come back after a couple of hours. I then thought it was the cranks sensor and had it replaced. Unfortunately, the problem is back! The idle seems a little jumpy, car isn't as smooth as I'd like it to be. It also doesn't seem to have a strong start. I can't figure out what it exactly is, and I don't want to start changing random parts. I was debating on perhaps getting a new fuel pump, coilpacks...
View 1 Replies
I've got a Mk4 Golf 2.0L with 136k on the clock. Hasn't really given me any problems in the past year of ownership till now. I recently picked her up from the shop for a rear axle beam replacement. When I picked her up she drove fine. I headed to class for the day and she sat in a parking lot for 6 hours or so. I hop in and try to fire her up and nothing. Had to have her towed back to my apartments. I've checked fuses, spark plugs were recently replaced but I am getting no spark. When I crank it I do hear the fuel pump and I can smell gas when I crank it. The rpms go up just a bit, 100-200 range. Going to check out the crankshaft sensor later on. maybe it could be the coil pack as well? I don't know a huge amount about these cars, only some info. And I sadly have no access to a scanner to check for codes.
View 2 Replies
Have a 2000 1.8t Jetta that turns over but won't start, What I should be looking into?
View 2 Replies
So, the very first time it happened was the weekend after I installed my new motor mounts I am not sure if it is a coincidence or if there was something that I touched while installing that is causing the car to act this way. So I notice that it's more common on the wet days even though I have started to doubt this recently as well. The instrument cluster illuminates CEL and EPC for a brief second and the car feels like it looses all power and sometimes even stalls when at idle but then after that goes away it runs like a champ. Also ever since this started happening the car is really hard to start after it sits off for few minutes when at normal running temperature. Right, when it happened I tried to scan it and I thought it was the scanner that was not able to communicate with it but that wasn't it since I have tried over 10 different kinds now( that includes the ones that have scanned my car with no problem before). I did have the CEL to stay on once but I still couldn't scan it and it went away by itself or I have reset it by disconnecting the battery. Its really driving me crazy and I am stuck but not giving up on this car, I love it too much and it's been very faithful to me so far! I mean there was literally two days recently when the weather was dry when I drove the thing without the random occurrence of EPC and CEL but it still didn't want to start when warm. In fact, one time after work after it has been sunny all day it didn't want to start when the engine was still cold as well.
The things I have replaced or tried so far that have not repaired it are:
*New Camshaft Sensor
*New Crankshaft Position Sensor
*New Purge Valve
*New Coil Pack
*Took off and cleaned my Throttle Body
*Checked with and OHM meter as many grounds as i could find between battery and they all checked good(the main engine ground looks good)
*Cleaned MAF sensor
*New Coolant Temperature Sensor
*Checked that all fuses were good and seated
*Verified that the k-line is good.
*Able to scan the ABS module and radio through vag com so i know its something with the ECU communication
That's all that I can remember as of now. the car went through many stages but here is how it looks as of now.
[URL]
View 24 Replies
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies
I bought this car and I've changed out the Clutch Position Sensor, the black one on the clutch mount. Started to work and start but now it's doing the same symptoms as before. So here is what is going on.
1. Randomly doesn't start, full power comes on, and fuel system turns on, immobilizer works just fine as far as I can tell (key light turns off)
2. Cruise control doesn't work (which lead me to the CPS)
3. High revs between shift, once I push the clutch to shift it revs up high, I noticed that if I stay under 3k it doesn't do it as much, but if I go HAM on it it revs up about 1k rpm more than at shift point. But if I shift nice it revs about 2-400 rpm.
It's been tuned by C2 Motorsports, done by a certified mechanic, that's the only mod on the car, besides suspension. I bought the car and dropped 1100 to fix it to drive right, newish throttle body, and a major vacuum hose, and the tune within a month of getting the car and the tune was to mainly flash the ecu so it wouldn't pull two codes for a leak that wasn't there anymore.
View 5 Replies
2001 Golf with A/T. 130,000 miles. Daughter went to turn key, heard a "snap" sound, car wouldn't start...no "click" from any electrical contact, starter apparently not getting any "juice". key now turns in switch too easily...can't feel the usually resistance when turning key. Key fob works, steering wheel turnable, can move trans lever out of "Park" into all positions with foot on brake. Broken key cylinder, or some link to ignition switch? Car at repair shop, waiting it's turn.
View 3 Replies
My '07 H3 will turn over, but not start, but it only happens about once a week (4 times total as of now). When this happens, if I let it sit and try again in about 15 minutes it will start. I've spoken to 2 mechanics who state that they need to experience it happening to diagnose it. This means I would have to leave my H3 with them for potentially a full week which I can't do. How to handle this? I'd hate to be stranded somewhere in 115 degree heat with my 6-year old.
View 6 Replies
My Dad's 2011 Raptor has been having starting issues for about a month now. He turns the key, it turns over, but doesn't actually start; the same thing happens if he tries to start using remote start. It will start once in awhile on a 2nd or 3rd try, after throwing the shifter back and forth from Drive through Reverse several times and trying again, but not most of the time.
It doesn't happen all the time, but every once in awhile, and always at random times.
The first time was accelerating at an intersection a month ago. A second or so after hitting the gas, the engine died in the middle of the intersection. He took the key out, threw the shifter back and forth, tried again, and it started right up without issues.
Later that night, he tried starting it after sitting for over an hour (and had started it several times before without problems), and it failed to start, even after 7 or 8 tries. He had it towed to the dealer the next morning. He even tried starting it that morning in the dealer parking lot, without success. Several technicians apparently started it several times later that day without any issues! They didn't fix or replace anything, because they didn't find any problems. When he got it back, it worked perfectly.
A couple weeks later, it had the same problem at the gas station, after getting a full tank. My Mom told him that her truck (a nearly identical '11 Raptor) had the exact same issues several times in the past, and her trick was to let all the lights in the truck turn off, then try starting. He did that, and it worked!
Tonight, the same issue emerged. He did everything that had 'worked' in the past, and it still failed to start after about 10 tries. It's headed to the dealer on Monday, but what it might be?!? I also want to add that when it starts, it starts flawlessly, without hesitation; as if there wasn't a problem.
View 8 Replies
Mazda B2300 2.3L 1995 model... About a week ago I ran my B2300 out of gas (or so I was convinced I was out of gas) because the engine quit running. After adding gas was unable to start it back up. It turns over but doesn't start.
Here's what we did to try and fix it:
1.) Replaced Fuel Filter
2.) Check the fuel pressure, and it was at 35 psi when the key was on
3.) Replaced all 8 spark plugs (4 cylinder truck btw)
4.) Checked spark of all 8 coil pack slots and 1st and 3rd slots (exhaust side) were not sparking. After replacing coil pack we received spark but truck still didn't start.
We're speculating on the possibility of it being the PCM (ECC).
View 2 Replies
So I just finished redoing my head gasket. Everything is hooked back up the way it was prior to the tear down. I'm getting spark, fuel, compression, timing was set correctly according to Haynes, turns over but just doesn't want to fully start up.
View 3 Replies
So a truck that was running fine Sat for 2 weeks. Battery died so i sent some coworkers to jump it. They tried using a welder which they didn't get turned down enough. Now the wiper motor stays on even without the key. Radio doesn't work but the dash light still comes on. With a new battery installed it turns over but doesn't start. I know something had to get fried but where to start. Thinking about replacing all fuses and relays...
View 7 Replies
So i just recently purchased this car and about two weeks in I CEL turns on and the car just doesn't seem to drive like it did when i first brought it home. I don't know much about forced induction cars but the from watching the boost gauge, it seems to flutter when accelerating and just doesn't pick up like it should i feel. First thing I could think of is a boost leak but like I said, don't know anything about these cars.
View 3 Replies
My car has been sitting for three days and I went to start it and it turns over but doesn't even try to fire. If i press the gas while it's turning over, it doesn't change at all. Do any of you know what could be causing that?
yes I searched and it turned back nothing, so if there is already a thread, could you point me in that direction?
Also, the car previously had a tick on start up for about 30 seconds and then it would disappear, that doesn't seem related to the no cranking thing to me though. The only other strange thing that happened was a week ago when the car dumped an unusual amount of smoke as if it blew a head gasket... but it didn't, and nothing has happened since then until now.
The car used to do frequent trips of 15 or 20 miles at a time every day but now it does 5 or 6 miles every few days and then 300 miles at 80mph each way once a month, so I don't know if the constant 3800 rpms on the long trips could be having some sort of affecting this
View 2 Replies
I've been watching my mother's 1976 Fiat convertible this summer. It had been taken to the shop about 6 weeks ago and it's been running fine without any problems. I had to leave for about three weeks and now the car will not start.
When I turn the key in the ignition with the clutch engaged, the engine turns, but pressing down on the gas pedal has no effect. The engine doesn't rev nor does it catch. There is gas in the tank and clean oil. I checked all the connections I didn't find anything loose.
View 6 Replies
Mmkay.. 2000 GTI VR6.. Will start initially, when engine is cold (sat overnight, or through the work day) but once the engine is at normal running temp, if you shut it off, it wont start. Acts like its out of gas.. have to "prime" and keep hitting the gas pedal while cranking, to (sometimes) get it to start when warm, and then it runs like crap until I get a few miles down the road.
Brand new plugs and wires, and just this evening, pulled a plug, and its obviously fouled, and covered with unburnt gas. Coil Pack maybe?
View 19 Replies
