I've only had the car about a month, and love everything about it. . . . but with the onset of cold mornings, I'm not very excited about the luke-warm air coming out of my heater.
It's reminding me of my old B5.5 Passat VR6 wagon and the annual heater-core flush that it required. Of course, the Passat was 13 years old and had 200k on it.
I have a 94 ford Taurus all of a sudden my ac doesn't blow cold and my heat doesn't blow hot. Also every now and again I hear a sound like an alarm clock coming from passenger side??
View 3 Replies2000 f150 heater only got warm.
Flushed system, new thermostat, new coolant. Then NO warm air. A/C blows cold. Checked heater blend door and actuator both intact and working. Heater core not leaking, system holds pressure and doesn't leak.
Is there another automatic valve that could be shutting off flow to heater core?????
I am having a problem with the heater on my 98 2.7 Intrepid. Will not blow hot air when idling (just warm). After several minutes of driving with heat on air temp goes from hot to warm. It might just be me, but it seems like the air flow is cooler coming out of the defrost vents than from the dash/floor vents. Thermostat has been replaced (proper operation verified before installing). Had to replace gooseneck and heater coil supply tubing due to a leaking bleed valve. There appears to be NO air in the system.
Heater core was backflushed, there appears to be no restriction. Hose temp on exit line is approx. 15 deg. cooler than supply line when fan is running. Blend door actuator was replaced last spring (motor shorted). When temp control is moved from hot to cold temp changes drastically and door can be heard moving. On-board ATC diagnostics indicate all is good. Engine is running at normal operating temperature, not overheating or running cold. Is there a cabin filter or inlet supply for the air that could possibly be obstructed? Air flow seems adequate, not restricted. AC works fine.
I have a 2000 suburban with a 1500 motor and 300000 miles. Last year I replace the water pump and the thermostat. The heater would blow warm but not hot . But only when I start to drive. Yesterday I decide to change thermostat again thinking the new one from last year was faulty. Now the heater only blows cold air .
View 3 RepliesMy heater quit blowing hot or warm air all of the sudden. I took my mechanic and they said it showed no codes and were afraid to mess with it so I took it to a dealership. They worked on it most of a day. Said nothing showed a code as bad, they got into it and found the air going into the heater core was hot, but it was cool coming out. They spent some time flushing the coolant and said they found some sediment in the coolant fluid. They were hoping to flush out anything clogging the heater core.
View 8 Replies2005 Elantra here with 120k miles
Problem: Not heat will come out unless
1) I don't turn on the Fan Motor at all. Very Nice heat will "bleed" out of the vents as long as there is no Fan on - on any setting.
2) Lukewarm heat will come out if I am giving the car gas or revving it. As soon as it goes back to idle or I am no longer giving gas it goes back to no heat at all.
Things I have tried:
Topped up the radiator and tank (radiator has been replaced)
Water pump replaced
No leaks
Thermostat is opening ( Upper hose gets hot, Lower hose stays cold for a while and then gets hot)
Flushed heater core with a garden hose.
Inlet hose to heater core is hotter than outlet hose but outlet hose is not cold to the touch.
Radiator cap has been replaced
Car does not run hot at all
I just replaced the radiator in my 2001 Elantra and now the heater will not blow warm air. Also the temp gauge on the dash stays at cold.
I have replaced all radiator hoses ...
New thermostat
New thermostat sensor
I have a 97 E-150 with factory air (vin L) the heat/cool quit working just before summer it quit blowing cold. The old man took it to some mechanic (i hate when he does that) and he fixed it so there was air only saying he had a choice of cold or hot (being summer in the desert he chose cold). Now that it is cold and we are traveling where defrost is needed, I need heat!!! I went to the Ford dealer and picked up a new potentiometer and that did not fix the problem. whenever the unit is on the a/c compressor kicks on........ Is this electrical or vacuum and where might i find the problem?
View 8 RepliesI have a 2004 gmc sierra and it is having heater issues. For a while now when starting it up cold it would not blow any warm air until the vehicle is moving. The other day while driving it would go back and forth between hot and cold.
View 3 RepliesI have a 2013 Prius 4. I'm not sure if there is a problem or not but the heater just seems to blow the same temperature of air no matter how high I set the temperature. The air feels lukewarm. I was driving 60 miles yesterday with the temperature set at 76. I had on a long sleeve shirt and polar fleece jacket and it never got to where I was really warm. Outside temp was about 50.
View 10 RepliesI have owned my 2008 Rx 400 h for just over two months now and at the risk of sounding dense, am I right in assuming that when you are coasting along without the engine running, the heater will start to blow cold air? Everything works fine until you lift your foot off the pedal. This is my first Lexus/Toyota and hybrid so I'm not totally au fait with how it should be working.
View 2 RepliesMy heater will blow hot when the fan speed is set to the lower two speeds but when I put the fan on the higher speeds the heat starts to turn cold almost right away, but when I put it back to low it gets hot again. It doesn't matter whether the button for the recirculate mode is on or off, defrost or whatever. WWhat is the cause of this?This is on a 2005 Chevrolet Silverado 2500 HD truck.
View 1 RepliesI'm 1/2 way through a flush and water pump replacement. Its going to get cold and I don't want to blow any heater lines. I have the pump off and the block drained (I also managed to get some coolant into the block - but not the rear heat).
I don't see an easy place at the front to disconnect the lines. I'd like to blow them out just to be safe. What is the best place to disco in the front or if I even need to - can I just disco 1 in the rear and then blow in both direction?
I fear that there may be some vent door closed that will prevent flow. I can't start the truck - I can turn the key on.
I have a 2007 PI and recently lost heat and ac. All the controls do what they are supposed to do but both heat and ac blow room temp only. Fuses and relays are all good. Is this a blend door actuator problem? This is my guess and I'm basing the next question on a yes answer. Is it possible to access the actuator by making an eightXfour hole in the top of the dash above the radio. I would prefer not to have to pull the dash out of the way since everything else works good.
View 1 RepliesMy 99 grand cherokee's heater is broken - fan blows but only cold air. I've had two mechanics tell me its probably the blend doors and will be quite expensive to repair because it requires removal of dashboard. Looking for after market repair kit which allows for a DIY fix going through the glove box? Is this a good bet to try?
View 5 RepliesCannot figure out how to get the heated air to flow through the back via the rear vents. All I get is outside air. I cannot find anything about it in the manual. The dealer has no clue but is trying to find something on it. New 2009 Santa Fe Limited.
View 11 RepliesI have a 09 santa fe and it just started doing this. when we start it and let it warm up it will get the normal temp and will blow hot air but when we start to drive the thermostat goes back down to cold and it will blow cold air. I have had a problem similar to this before and taken it back to the dealership and they replace the same thing over and over. but this time its not fixing itself and it is staying like this. usually it will fix itself.
View 5 RepliesTo kick off the coldest week (so far) of the winter season, I noticed a problem with the heater controls in my 06 Explorer with manual temp. controls. No matter which fan settings I select (defrost, panel+floor, etc), air does not blow through some of the vents. I can hear the fan working and air flows through the defrost vents and through the floor vents, but the there is no airflow through the vents below radio and round vents on the far left and far right sides of the dashboard.
Perhaps related to this problem, a couple months ago I replaced the blower motor resistor because fan speeds 1 and 2 did not work, only 3 and 4 worked, so whenever I would turn on the heat or A/C, it was on full blast all the time. After replacing the resistor, the issue was resolved and all of the speeds worked well. I guess I just never realized the issue with the vents, or maybe the problem happened because I replaced the resistor?
Since I'm not too knowledgeable with the climate control circuit, I'm not too sure where to begin, perhaps the switch or blower motor?
So the heater on my 2001 f150 will only blow through cold air. I thought that I may have a heater core clog so I back flushed it with water until it was coming through clean and unrestricted but that didn't solve the problem.
Now, some things to note are a potential coolant leak. I can't seem to find one but I filled up the antifreeze about two months ago and when I checked it the other day it was more or less empty. I've filled it up again and I will monitor it for the next couple of days.
Another thing to mention is that no matter what setting I have the heater on (ie 'panel' or 'defrost') I get cold air blowing at the passenger side's feet. Is this indicative of a hose leak or something?
Also worth noting is that the intake hose to the heater core gets hot after driving but the outtake stays cool. This is why I originally thought I had a core clog.
Should I be checking my blend door? If so how to I access it?
I took my 200000 mile Prius to a garage that is highly recommended and the mechanic stated that I need a new evaporator and expansion valve. He tested the car for a day. There was no time to do the fix so I arranged for a dealership that I trust to do the job. When they were ready to do the work, they detected no leak in the evaporator, but said that the compressor, expansion valve, and AC line needed replacement. (They showed me the leak in the compressor with special glasses.) After I called the first mechanic with the new info, he said that he could detect a leak nowhere, but, in the evaporator, and, at the expansion valve area. I am now stymied as to what I should do.
View 7 Replies