Golf/GTI VII :: Right Front Turn Signal Is Inoperative
Oct 4, 2015
So I was doing the DRL - Dimming on indication mod with the VAGCOM. I used the following steps:
Go to [09] Central Electronics
Go to Security Access and enter 31347
Go to adaptation channels and set the following (they're quite far down the list):
"Leuchte2SL VLB10-Lichtfunktion G 2" to Blinken links active (besides Phasen)
"Leuchte2SL VLB10-Dimmwert GH 2" to 35
"Leuchte2SL VLB10-Dimming Direction GH 2" to minimize
"Leuchte3SL VRB21-Lichtfunktion G 3" to Blinken rechts aktiv (beide Phasen)
"Leuchte3SL VRB21-Dimmwert GH 3" to 35
"Leuchte3SL VRB21-Dimming Direction GH 3" to minimize
Now my right front turn signal is inop. Checked voltage and swapped bulbs left to right. the bulb is good. No sure what I did. Could I have disabled the blinker somehow? Where is the channel for the right front blinker?
View 1 Replies
Advertisement
Last night I was heading home from a two day race and found that my turn signals wasn't working. the running lights are working and obviously i could feel the brakes working.
well i hooked up some jumpers to a 12v battery and the 7 pin and the lights work. to make 100% sure it works i hooked it up to my neighbors Tacoma. it all worked. well..........
On my last f150 when it was new this happened to me too. it ended up being the turn signal fuse on my truck.
I hooked right back to my truck again and just made sure my plug was all the way in and still nothing so i know its my truck side.
Now my last f150 owners manual had a section to where it told you what fuse is what and where. well i don't even see the f250 fuse box is and don't know which one it is to see if its blown.
View 7 Replies
My 03 Golf ac is not working and i am looking for a wiring diagram/ troubleshooting chart. the cooling fans turn on low and I hear the engine surging like the compressor is trying to cycle but it is not.. When I jump the low pressure switch the fans go to high and no power to the compressor. I get a flash of power to the compressor but just a blip every ten seconds. I am trying to check continuity of the ac clutch but having a difficult time getting in there hot. I just bought the car and fixed light body damage on the right front but it was not even bad enough to hurt the washer bottle. Hard to believe the hit caused damage to the ac? AC seems to be charged with about 100 psi static pressure. Why are diagrams so hard to find?
View 2 Replies
So I just picked up an R32 and it has a euro switch and euro projector headlights but I've noticed that my parking lights, city lights, and front fogs are all inoperative. Though the turn signals do work. I tried doing a quick search but wasn't really able to come up with anything as to a reason why.
View 7 Replies
I would like to start off by saying I am new to this forum. I bought a 2005 Jetta GLI a couple of months ago and from the first day I noticed that occasionally when I would lock it with the alarm, the right turn signal would stay on. It was not much of a problem as I would just press the lock on the remote again a couple of times to turn it off. Lately it has become more frequent and annoying. I have to wait up to an hour so I can finally turn it off through the remote. I was thinking the relay probably.
View 15 Replies
Can make the front turn signal witch is also the parking light into a hid?? And how to change the bulbs in the mirror turn signal?
View 5 Replies
I have a 1997 GMC Sierra. I had a turn signal out in the front driver side. the old bulb was rusted out so i had to remove it with needle nose pliers. replaced bulb, and now i have absolutely no turn signals at all. not even the clicking noise or the turn signal illuminator in dash. I have since replaced the turn signal relay, but that was no luck.
View 2 Replies
I recently purchased a 2001.5 Passat V6. The front left turning signal is not operating, I swapped the right with the left (with housing) and still the left portion is not working. Obviously the problem is not the bulb or bulb housing. Can it be fuse?
View 4 Replies
What is the procedure to replace the front DS turn signal? Is there an easy way to replace it or is it just a matter of reaching carefully. This is for the turn signal in the front headlight assembly.
View 3 Replies
My front left turn signal won't work, the signal on my dash board doesn't work, and the signal in the rear blinks rapidly. but the whole right side is fine. this is aggravating, I have changed the lightbulb in the front and nothing happened. It still doesn't work.
View 5 Replies
For a little over a month now, the front left turn signal has gone out at least once a week. I have been continuing to buy new bulbs for it, and it would run for a few days, then quit on me again. Just today, it happened again, I replaced the bulb, but this time it still isn't working. Ive tried clearing some of the crud off of the inside of the socket, but nothing seems to be working, and now im down a turn signal.
View 1 Replies
I don't know where the wiring harness is for the front turn signal.
Im able to get to the bulb (from under the front fender) I took the bulb out and I notice the harness is not on the back cap of the bulb....
Where's the harness???? I need to install the load resistors.
This is for the 1157 flashback bulb
View 10 Replies
My left front turn signal stopped working. Rear turn and mirror light both work normally. Checked the socket and it is clean. Switched bulbs with right side to confirm. This one is driving me crazy and I don't want to spend a fortune at the stealer to fix it.
View 5 Replies
Put a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 Replies
My issue is i recently have put two different sets of front LED turn signals in my car and only after a day or so they blow out. When i pull out the bulbs they smell burnt. i do have LED turn signals in the rear as well they are plug and play with decoders no resistor required. For the front ones i did add 50W 6Ohm resistors on each side.
View 7 Replies
On my Gen II Prius, I want to swap the Front Side Marker with the Turn Signal. Thus, the Front Side Marker becomes my blinker and the Turn Signal bulb as my Front Marker light. Since I do not have the money or patience to clear out the front orange reflectors, i decided to swap the light functionality. I plan to get some SMD 992 bulbs to replace the current halogen and make them my side markers.
View 5 Replies
My drivers front signal does not work. its not the bulb. took headlight assembly out and then the passanger side did not work and the drivers side did. check passenger side. now it switched again. now drivers side is out and passenger side works. both parking lights work fine. no clue what's going on
View 2 Replies
1998 Olds Intrigue 3.8L ... When I turn on the right signal on my Olds Intrigue the back light flashes faster than normal. The front light does not flash. I purchased a new light bulb for the front. I replaced the bulb. The back flashes at a faster rate but the front does not flash. I replaced the front and rear bulbs. The front does not flash and the rear flashes at a faster rate. Do you think there is a broken wire or broken signal flasher?
View 3 Replies
My front left turn signal was hyper flashing. I replaced all four bulbs to no avail. Just to satisfy my curiosity I switched the bulb holder from left to right sides. The hyper flash followed to the right side. Turns out that the bulb holder shorted out. I had it replaced under warranty yesterday.
View 2 Replies
I have a 2003 W8 wagon and my front turn signal bulb went out. I need to replace it, but am having some problems. I removed the high beam cover to get to the turn signal socket, but I am having problem removing the socket. I was able to turn the socket slightly and was hoping I could just pull it back, unfortunately it doesn't seem to want to move. Is there a trick to remove the turn signal socket so I can remove the bulb? I don't want to force anything in fear of breaking something. there has to be a way.
View 1 Replies
I've got a 2008 GX470 with 38K miles. My problem is that the driver's side front turn signal has quit now for the fifth time! The first 3 times, the dealer's shop said that it was a loose bulb, the was some grit in the socket (which there should not be), etc. The fourth time they replaced the wiring harness. Yesterday, the bulb went out for the fifth time. This is occurring every 4-6K miles. I use my vehicle exclusively on city/highway driving. No off/rough road at all.
View 5 Replies
