2200 Miles... It will not shift into 2nd gear in automatic and the rpms race up to 4000 when going about 20 mph. The only way to get it to work again is turning car off and on again. It has only happened twice.
View 7 RepliesI have a 36 foot motor home on a 2000 Ford F53 chassis. (similar to single axle freight trucks and school busses) After getting one set of the rear wheels partially stuck, which resulted in some spinning of that side, the overdrive off light on the shift lever began to blink and the service engine soon light came on. The fault code said, "speed sensor showing more than one mile per hour". Now the automatic transmission sometimes will not shift into first gear after stopping and has to be manually downshifted, after which, it works fine.
View 1 RepliesI started experiencing a delay in my shift points going from 2nd to 3rd gear. Then today I was driving and my automatic transmission wouldn't shift into third gear...the speedometer stuck at 20 mph...and it would rev all the way to red line, but wouldn't shift.
There is no "abnormal" noise coming from the transmission, or from the drive train. I suspect that this has something to do with the shift points and the computer rather than a mechanical problem with the transmission.
I would like to know what it could be before I take it into the dealer to get it diagnosed.
Recently I had a stuttering and squealing from a belt. I was able to shift into all gears with no problems. Before I could get it looked at, the squealing stopped and I was unable to go faster than 30 mph. The belt and pulley were replaced, but the car now will not shift out of 2nd gear. Transmission fluid is good, and has not been leaking. Does this indicate that I will need a new transmission? Or is there possibly a less expensive possibility? I've heard that some vehicles have what's called "limp mode". Also, is it safe to drive at 30-35 mph., and what damage might I do by driving it?
View 4 RepliesWell I've been towing for almost 150,000 miles with a 2012 6.7 Lariat 4 wheel drive. Things have been going pretty well with the truck. I noticed some sluggish and indecisive type shifts early on but now I'm worried. I depend on this truck for pulling a horse trailer all over the country and Canada. Just recently I've been getting a hard shift or a thump or a clunk when shifting up or down in to second gear. I'm at about 152,000 miles and did a hot flush with LV ATF at about 148,000 miles. Should I worry or keep running?
I have a 97' PSD I'm thinking of giving a nice paint job and a flat bed but am reluctant to do so due to financial concerns and the fact that some folks may not want to see me pull up in an old truck no matter how nice it looks. My tranny temps have been stating under 200F and I really keep an eye on the temps when running up and down the hills while towing. The trailer is a 35' Gooseneck with a max GVRW or 14,000 pounds. Should I wait for the tranny to grenade and then drop in a built tranny and if so who's building these tranny's stronger than stock? Long time no see but this site has always been my go to for all my Ford truck questions, upgrades, etc.
I have a problem with automatic tiptronic transmission my golf MK4 TDI 1.9 2001, it dosent engage on 4th gear when i am driving, the codes that I received for this foults:
01316 - ABS CONTROL MODULE
49-10 No communication- Intermittent
00652 - Gear monitoring
27-10 - Implausible Signal - Intermittent
I have the mods listed below in my signature. When I shift gear and have almost completely released the clutch to move up into the next gear I get a clicking noise and feel from my transmission I think or maybe differential. This is with traction control off and is only noticeable at lower rpms like a low rpm shift from 1st into second.
View 7 RepliesHave a question when I shift slow from 2nd to 3rd my o2j tranny doesn't grind but when I shift fast from 2nd to 3rd it grinds it happens starting at 3000 Rpms thru 6000 Rpms. It also doesn't happen when I shift from 4th to 3rd. Have performed a tranny fluid change. Along with replacing the clutch at 1500 miles ago. The engine is AWP.
View 4 RepliesGot a 2001 Jetta 2L automatic 200k miles with gremlins. possibly multiple unrelated problems. First problem that presented is that the transmission will occasionally not shift into 4th gear. I discovered that if I stop the engine, then restart it, it will again return to normal operation, hence the thought that it is electrical. After a year or so of this, second problem pops up: the engine will die while the car is driving, or some times idling at a light. I've also noticed that the interior lights flicker somewhat in intensity when on and the engine is operating, so there could definitely be a grounding issue somewhere. I have heard that the ECU/ECM connectors could become corroded, but haven't yet dug into it to look. Any guesses as to where to begin?
View 2 RepliesI have a 1993 corolla auto trans and when I first try to take it out of park it will not shift. I noticed that when I push the brake pedal to the floor it finally shifts. I recently replaced the brake switch, could the adjustment be a problem?
View 1 RepliesWhere I can find information on how to swap out the shift know on an automatic transmission in my 2003 Passat GLX? I bought a new knob but don't know how to get the old one off.
View 1 RepliesI have a BMW 523i SE AUTO (1997) 2494 Petrol. In auto transmission the gears will shift from 1st to 2nd and 2nd to 3rd but won't shift any higher. In steptronic/manual transmission the gears will shift from 1st to 5th without any problems therefore suggesting that the problem isn't the gearbox itself. Only very occasionally does the shift electronics telltale light appear on the dash, yet the problem with the auto transmission is continuous. A local garage specializing in automatics suggested that it was the gearbox inhibitor. I've today had this changed but the problem still exists.
View 5 RepliesGirlfriend has a '92 automatic. Transmission's been acting up for several months, periodically not wanting to shift into higher gears. Now, it will not shift at all after the first one, about 20 mph. Engine whines, but has power up to about 50 mph. Odometer states 64,xxx miles but don't know if accurate.
Need info on possible causes, other than total rebuild. Been reading about speed sensors, shift solenoids, control modules, as well as replacing fluid/filter and adding a treatment.
My 2002 Explorer LTD with 155K miles on it is in terrific shape except for a worsening rough shift into overdrive (automatic transmission) and a clunk which occurs with increasing frequency when I shift into reverse. I would love to keep the car but don't want to spend the money for a new or rebuilt transmission. There is no access for owner approach to transmission fluid - I have already looked in the manual. I would need to take the truck to a garage as I cannot do repairs myself.
View 2 RepliesEarlier this year, I worked with my dealer to get a new automatic transmission for my 2007 Accent. I had only had the car for a couple months (purchased used, from my Grandmother who I knew, if anything, had probably been TOO gentle with it.) Only about 40,000km. I found the car extremely hesitant to shift on cool mornings, and allowing the engine to warm up first didn't make much difference. The 2-3 shift was especially late.
The last straw was when, on a frosty morning, the transmission failed to engage 3rd, bucked back out to find 2nd again, and then got 3rd on the next try. It did this a couple of mornings before I was done negotiating with the dealer, who ultimately agreed to supply a new transmission if I paid labour. This despite the car being just outside the 5-year powertrain warranty. I was quite satisfied.
So I enjoy the Summer with no problems -- only the barest hint of transmission "morning sickness", but only if I'm rushing it. I figure "that's an economy car for you". Now that cooler Fall weather has begun, I'm convinced that the new transmission behaves the same way as the first one. I haven't had the "bucking out of gear" problem yet, but the 2-3 shift is already a real dog on cool mornings.
My 95 ford Aerostar 3.0 automatic trans wont shift into overdrive, here's what happened. a small hose on the side of the transmission came off, this must have popped off when I was stepping on the gas with the brake on in drive and reverse. It took 2 months to find the hose off, during those 2 months I had to shift the van manually, you had to get high RPMS before it would shift.
About 2 weeks before I found the problem I notice the van would not kick into overdrive. When I finally found the issue and reconnected the hose the trans shifted fine but still would not kick into overdrive though. Is there another vacuum hose that goes to the main vacuum housing? or an adjustment on the linkage area? This has been like this for about 6 months now and I can go on a highway..
My check engine light has recently turned on in my 2004 hyundai elantra, and since it has come on my car will kick and sound like its going to stall, works but the automatic transmission refuses to shift. This inconsistent because it sometimes works fine with the light on and sometimes the light won't even turn on and everything is ok. What's wrong?
View 3 RepliesI have had a 2000 Chevy Cavalier 2.2 liter 4 cyl Automatic for about 5 or 6 years now. I have noticed the whole time I have owned it that when I start the car and shift from Park to Drive I hear a clunk and the with the hood open the engine pivots back and forth one time more than it is supposed to. This only happens from park to drive, it does not do this from park to any other gears, and once the car is in drive everything is normal. The car has no shifting problems at all, no slips or clunking while driving or hitting the gas real fast on take off.
I changed the all three mounts on the car yesterday. Upper engine mount (still in decent shape), lower dogbone (tore to hell), and Transmission mount (decent). I really haven't noticed it get any worse over the years I just know its not right. I have never changed the fluid or the filter since I owned the car, and most likely it has never been changed in the cars life. Could a dirty filter, and dirty fluid cause this problem? Or could the linkage need adjusted or replaced?
So couple of days ago, I went shopping. no issues. after shopping i fired it up, no issues, put it reverse, car was shaking, put the car in neutral. No issues, put the car in drive car is shaking again. i started to drive no shaking, however the car felt like it had no power, I only felt shaking during switching from R TO N TO D. So I change to manual mode and see the gear was 3rd. i was not able to change gears manually, neither did the tranny switched them for me. I drove home about a 3 miles. shut the car off, restart it...gears and car drives normal. Took to dealership, they checked it...and of course no issues. Ihave 44k miles and 50k warranty expires next week, nice, huh? got another year of powetrain warranty left.
View 3 RepliesI just noticed last night that my transmission was slipping in 3rd gear, it's an automatic. I added just about a quart of transmission fluid today....took a little drive and it still seems to be having the same problem? What might be causing this besides needing to get a new/rebuilt transmission?
View 6 RepliesSo I have a 2006 Hyundai accent with 75000KM on it. I notice when it shifts from 1st to 2nd gear sometimes it will jerk. It feels almost as if it goes to neutral and then sifts, causing the whole car to jerk. It use to only do it when the car was cold (first 15 min of the day) but now it seems to be doing it all the time and getting worse. I have had the transmission fluid replaced, but it doesn't seem to work.
View 30 Replies