I've had my 2003 GTI VR6 for the last 12 years and was accustomed to the exhaust sound. I just picked up my 2016 GTI DSG w/ PP and I"m surprised with the exhaust sound. The new car is stock still, but it already sounds like it's been supped-up with a new exhaust system, kinda "throaty" and sporty. MUCH different than the 2003. Is this normal?
View 12 RepliesI've wondered why our cars make those burping sounds when you let off the throttle.
Example the new Ferrari P4/5 in this video does it a lot : [URL] .....
What the technical reason this happens?
I just purchased a 2003 V10 with 270 000kms. The truck had had regular maintenance. It has an exhaust leak and runs a little bit rough. Could the exhaust leak cause the truck to run a little rough or am I dealing with another issue?
View 2 RepliesMy 2003 Impala has been running fine for months now, after about 6 months or more it got exhaust work and 2 months ago it had to get exhaust work again.
The muffler actually fell off on a long drive and a garage nearby said the previous garage totally screwed it up because the said the exhaust pipe was cut too short and they had to weld together a "fixer piece".
Then we took it to our local Firestone simply to get the hubcap covers taken off as it was a free service and after we had to them put back on, about 1 day later, we started getting a strange noise.
Everything sounds fine when you are idling yet the minute you start moving and especially with all the windows up it sounds like somebody is running a lawn mover or an airplane is flying above.
There is no vibration or anything just that strange noise.
I've noticed that potentially my heat shield or whatever guard that is 1 step toward the front of the car from where the inlet pipe connects to the exhaust system may be the reason for my rattle at 2k and 3k rpms. i think its a heat shield but I am not sure. the thing is it seems properly mounted, nothing is cracked/broken/or loose. But when I do try and wiggle it it does make a slight creaking noise that sounds similar to the rattle I get. So I could foresee this as being my issue.
But, is there anyway to fix this rattle w/out just taking off the part? i figure its there for a reason and it looks like its held on in 2 places. But they're not nuts they almost look like spot welds or something. 1 on each side. What to do?
Something to get you all in here:
Golf R, 3000 miles. Seems like the engine sounds coarse or rough between 2-3k rpm for the first 5 minutes or so of operation. Smooths out after it is up to temp. Does not run rough, it's just an audible thing. Relatively insensitive to outside ambient temperature (winter/summer). One oil change with Motul Specific, Soundaktor still in place. Is this typical or am I the only one?
View 8 RepliesI owe a GTI autobahn 2015! I have problems with the front suspension (left side) sounds like is all loose, took the car to the dealer all they did is tight a bolt that is part of it! Problem still remain!!
When going over speed bumps and pot holes the front suspensions hit very hard like the shocks are not doing their job property!! This is causing the body of the car to start coming loose! I can hear some noises like an old car!!
Is normal or they need to be replaced,, i always drive in sport mode!!
I recently purchased this truck and have towed a couple of times with it. It has 98,000 miles and I do not know if the automatic transmission fluid has been changed. Should I have it flushed or drop the pan and change it? I have a lift so doing the change is no problem, although it might be worth it to pay a transmission shop to do it.
Also, I hear what appears to be like a heat shield rattle or something that sounds kinda like an exhaust leak during loaded acceleration. What to look for to locate the noise? One last question, the air bag light is on sometimes then off sometimes. Any known air bag light issues? I love the truck, hate the gas mileage!
I started my car this morning and drove to work. It's not that cold. I heard knocking sounds coming from the engine at a stop light. I lightly tapped on the accelerator to hear it better. My commute is short (3 miles), so I gingerly cruised there. I didn't try to accelerate and it didn't seem like I was suffering from loss of power either. I opened the hood and let it idol at work and couldn't really hear the knocking sound.
I downloaded the code when I got to work. After that I started the engine again and it sounded pretty normal. I'm due for my oil/filter change (~5500 miles).
Here are the codes. Any reasons to worry, or is this an one-time thing?
2 Faults Found:
001322 - Camshaft Adj. Bank 1 Intake
P052A - 001 - Cold-Start Timing not Reached
Freeze Frame:
Fault Status: 01100001
Fault Priority: 2
Fault Frequency: 1
[Code] ....
I just installed glow plugs, ucvh, stage 2 rosewood injectors, t500, ipr and gear head tunes. I have out 97 miles on the truck since all this was installed and the truck seems to run okay but has a rough idle and sounds like there is a mis? What should I look into first?
View 12 RepliesI have a 98 with the 4.2.The troubles started with popping a little through the exhaust ,bogging down and bucking,rough idle and had the two codes together that deal with having bad intake gaskets don't remember the codes offhand.
I also noticed every plug in the truck was wet and black however it didn't appear oil wet.I have changed the fuel filter,spark plugs,lower intake gaskets,plenum gasket ,injector o rings,checked injector ohms all were 16.5,new EGR gaskets,all bolts are torqued to specs
Now I have a no run condition, it will crank but not run. I heard a pop in the engine one time. I cranked till the battery went dead.I also noticed as I was calling it a day last night the radiator reservoir was empty. I don't know if somehow I got a hydro lock even though I put new intake gaskets in it or i have some other issue like timing or something. I don't know where to look next....
My 2003 F150, 5.4L has been having some rough idle/misfires issues both at idle and under load.
I have fixed one big vacuum leak, replaced the PCV valve, new sparkplugs, seafoam and heet in the gas, replaced fuel filter, tested the fuel injector resistance. Coolant levels have not changed. The truck burns about a quart of oil every 1000 miles or so. The white exhaust is heavier than condensation, but it comes and goes. The rough idling comes and goes as well, and it usually happens under load and the CEL flashes.
The codes I get are random cylinders, po303, po308, po171, po174 were the most recent but there have been other cylinders as well. I clear the codes after each attempt to fix it and they come back different.
I notice that there is a small exhaust leak that drips water just behind the engine, and when I shut down the truck a lot of water will pour out of an area just behind the cab on the passenger side as well as out of the bottom of the muffler (small hole, looks drilled).
Usually the rough idle occurs after filling up the tank, but from different stations so I do not think it would be watery gas. I use Heet every fill up as well. Also, there is a sulfur smell after the rough idling occurs (catalytic converter?).
I'm losing coolant have, excessive white smoke coming from the exhaust, and rough idle. Doesn't over heat or even try to overheat. The oil fill cap looks brownish white. It drives fine other than extremely rough idle. I know how to check a blown head gasket with the combustion gas test.
From what I've read blown head gaskets on 4.6 fords are fairly uncommon but a blown intake gasket is fairly common. How can I tell the difference?
I recently had my muffler and resonater taken off and put a magnaflow in place of the resonater. in place of the muffler is a Y pipe with 2 tips. the exhaust now sounds like a jet or like air is just blowing through the pipe really fast. also my check engine light came on as soon as the work was done and cranked the car. when i get hard on the gas the car hesitates on and off continuously. I don't know if the jet sound is from the Y pipe and tips or if it is something else.
View 6 RepliesIt's been a long time since I have posted here mainly because my truck was wearing a bow tie for awhile. But my wife was nice enough to tell me the Bow Tie wearing truck was making a funny noise on New Years Day (seems a small drum corps took up residence in the oil pan). So anyhow now I am back in a real truck . My new to me 1998 F150 5.4 Liter ran fine until yesterday. It started idling rough and almost stalling at red lights. about halfway home the CEL light came on and is throwing a P0171 code.
So far I have checked for vacuum leaks including all the elbows on the PCV system' tried the spray test with a can of flammable break fluid and a can of starting fluid (man I love the smell of that stuff) could not find a leak. Cleaned the MAF sensor and the K&N air filter (not a fan of these) IAC seems to be working. Only thing I know that is leaking for sure is the driver side exhaust after the cat. But that is the wrong bank if I am correct on which bank is which.
So why only one bank running lean and why does it act like it is only firing on 4 cylinders?
2002 f150 4.6l v8... Truck is misfiring and the exhaust is smelling very rich, I have new coils and plugs, it also idles rough and stalls if i let it idle for more than a couple minutes. Could it be something with fuel delivery system?
View 1 RepliesI've been chasing a problem all summer. Began with crappy batteries dying intermittently. I replaced the batteries, FICM, finally cleaned EGR valve and replaced ICP with pigtail. The problem is still persistent. Basically a rough idle, puff of whit smoke on cold startup, rough running at around 1500 rpms( driving at 50 mph). The ICP was soaked in oil so i was confident replacing it would finally cure my issues. It actually got worse with the rough idle turning to a surging idle and quite rumbly at 50 mph speed. I guess its time to look to injector issues but i thought id check if after replacing icp/ cleaning egr. I also have a slight exhaust leak at turbo out that i can see. The clamp is not seated properly. This after turbo connection to exhaust.
View 1 RepliesSo I just picked up an 07 camry se.
Is the car is a bit loud? It almost sounds like it has a sporty exhaust on it. From what I can tell it's all OEM. Its not super loud, I have an 06 evo, thats loud lol. This just sounds like its got a gutted cat or something. Just a throaty tone from the exhaust.
I am kinda thinking maybe the flex pipe is maybe leaking a bit. Cause it seems like its coming from under the car near the flex pipe, but its cold here, so I figured I might see an exhaust leak under the car.
I just didn't know if the se were a little louder or what? Its definitely not coming from the engine bay.
I have an exhaust leak that has gotten worse and is quite loud now. I have been under the car and a mechanic just checked what he could without a lift and didn't find any leaks. Yesterday, I had it up on ramps and looked under and think the sound is coming from where a heat shield is. When I'm in the car the noise sounds like it's slightly in front of me.
View 3 RepliesSo I started my truck this morning and it sounds like air rushing out from the driver side of the engine. I currently have my ICP unplugged due to a bad sensor, will be replacing it on Sat. Also I have been having an issue with my turbo but I don't think that it's related as I here the air rushing sound when at idle as well at when driving. It seems to be a bit louder when the engine is cold but I could also be crazy about that.
View 3 RepliesI have a 2000 pontiac grand am with a 2.4 L engine it is automatic transmission. Th issue is i just bought the car from a lot thinking it was an easy fix. What happens is when i start the car it goes from a 1k idle to a 500 or lower and sounds like it might die or if i am at a stop light and decelerate too fast it also feels like its going to die and has a few times unless i keep the gas pedal pressed down. I read the codes at my local store they said it was a engine misfire, o2 sensor the front one, and the map sensor.
My farther works at a pull and save which is a lot to pull used parts from cars hes brought a used ignition coil, used boots , i bought new spark plugs and nothing was fixed there. we have replaced the maf sensor and the map sensor both with used parts neither fixed the problem. I am at my wits end here i cannot afford to take it to the shops around here and am trying to get this fixed to get back and forth to work. I may have left out parts that have been replaced, also as far as lights are concerned the check engine soon light is on .