Golf/GTI VI :: Uneven Front Brake Pad Wear - What To Do
Sep 24, 2012
I noticed this yesterday when swapping out my wheels. What could be the causes?
Pass side
Drivers side
Sep 24, 2012
Advertisement
Corolla / Matrix 2009-13 :: Uneven Brake Pad Wear About 50% More Than Passenger In Front
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 RepliesFord Ranger / B-Series :: Uneven Front Brake Wear / Caliper Sticking Slightly
2000 Ranger, see my sig.
Just had to swap out the pads on my truck yesterday. The pedal was pretty mushy and I was getting shaking in the steering wheel when the brakes got warm. Shaking wasn't all the time, only after they had been used quite a bit - say after city use and the brakes had to be applied suddenly. So I popped off the tires and swapped out the pads and replaced the brake fluid - flushed it.
On the driver side front, the pads barely had any real wear and the anti-rattle clip was all messed up. It was installed properly, but it looked like the pads had smashed into it. The rotor appeared to be warped, or at least out of round - but just barely. You could see it wobble slightly in one spot if you spun the hub with the caliper removed. The caliper itself was sticking slightly.
I didn't see any evidence of damage, the brakes flushed just fine although the fluid was incredibly dirty (because I haven't done it in a long while). On the passenger side front, the pads were worn down to the level I would have expected given the mileage. The wear was even.
My question ultimately is this - is the out of round hub the culprit here? Might there be something else going on like a caliper problem? Ultimately I plan on having the rotors surfaced - one of them certainly needs it and with new pads I might as well do it anyway.
Ford Aerostar :: Uneven Brake Pad Wear / Increased Brake Dust On Wheel
97 4.0 ext. As the title says the right front pads wear more than the drivers side. Have replaced calipers pads and rotors during recent overhaul. Noticed increased brake dust on wheel on rf front. Could the metering valve under master cyl be the culprit. Abs and brake lights work as normal.
View 4 RepliesCamry :: 2005 SE Gen 5.5 - Getting Squeak / Uneven Brake Pad Wear
2005 I4 SE Camry USA built. Got a squeak from the rears the other day and pulled the tires to check. Inside pads (ones against the caliper cylinder) on both rear wheels were at the metal but the outside pads were still not down to the little stripe down the middle of the pads, let alone the wear indicator clip. I pulled slide pins and there were not stuck. The calipers retracted very easily, so not gunked up or dragging. I ordered a new hardware kit with the new dust boots and rubber slide pin parts. I am using good Permatex disc brake grease. I am going to have to have the rotors turned, but aside from replacing the rubber parts the only other thing I can think of is slide pin replacement.
View 2 RepliesCamry :: Uneven Wear Between Outer And Inner Brake Pads
I just thought I'd mention this observed wear of brake pads...I just replaced all 4 up front after about 128k miles...
@ 114k miles it was observed that 1 of the 2 pads of each front wheel had worn significantly more than the other (the inner more than the outer pad IIRC)....my expert mechanic rotated the two and I got another 14k miles out of them...I could have gotten a LOT more had they been rotated @ 50-80k miles.
I don't know if this is extraordinary, or more typical than I'd have thought...or a function of (failing?) calipers, or just how these (MY) calipers work, or just my driving habits (though I've owned the car for only 30k of the 128k miles on the odometer)....but....
In my case the new pads will get a 50k mile inspection and possible rotation if there is uneven wear between outer and inner pads....
I'd recommend that pads be inspected for (uneven) wear at one of the scheduled tire rotations....rotating the pads isn't much of a job, but it might be something for you to consider to get the most miles from the pads (that and better braking too perhaps).
Lexus GS 2013+ :: Front Right Tire Has Uneven Wear On Outer Thread
Any 1 have their tire that have uneven tire wear? Mines is Dunlop and my front right tire has uneven wear on the outer thread. All other tire don't have uneven wear. I'm getting new tire for all 4 rims and check my alignment. My gs is a f sport rwd.
View 3 RepliesGolf V R32 :: Front Brake Discs Wear Out Differently
My R32 is ~5700 miles and today I realized that Front brake discs wear out differently. Left one is OK but right one is scratched more deep and different than the left one. So they are not equal.
View 5 RepliesCamry :: Uneven Tire Wear With 2011 SE
I have a 2011 Camry SE which I leased brand new from a dealership in Ottawa. It has about 35,000 KMs on it. After my last regular maintenance at the dealership (32K oil/filter change with tire rotation etc.), I started noticing a sound coming from the tires. The sound is like low pitch boom boom boom boom. I tool it to the dealdership and they told me there is uneven wear on the tire which is normal for Camry SEs because they have wider tires that easily scallop during hard cornering.
Firstly, I do not buy that explanation because it's not the first car I have driven with a little wider tires. Secondly, I do not drive rough as most of the times I have my kids in the car with me. Lastly, I would think that if you are selling sports tuned cars, you would choose appropriate tires for it so buyers can drive it like a sports car.
I wonder why the situation became noticeable after the tire rotation. According to the rep at the dealership, all 4 tires have uneven wear so should I not have noticed it before the rotation?
Lexus SC430 :: 2006 Wheel Alignment For Uneven Wear?
I have a 2006 SC 430 with 20,000 miles on it The (run flat) tires are wearing on the inside and the dealer says that they need replacing The local tire shop agrees, and will sell the tires to me for less, and also throw in an alignment He says that alignment is the reason for the uneven wear But the dealer says that the wheel on my 2006 SC 430 cannot be aligned, and that the new ones will probably wear the same way
View 12 RepliesPrius (Gen 3) :: Rear Brakes Gone With Severe Uneven Wear At 55,000 Miles
While in for an oil change, the tech pointed out that my rear brakes were almost metal to metal, and that one pad on each side of the car had severe uneven wear. He noted he had never seen rear brakes go this quickly in a Prius and he had never seen the uneven wear. He said part of the mechanism that allows the pad to slide in and out as the brakes are used had frozen, creating a pivot point, and creating the uneven wear. The front brakes are fine with plenty of meat left.
Parts were ordered, including new shims and other hardware to try to insure this does not happen again, and the brakes were replaced. I contacted Toyota Customer Care and basically got the old line that brakes are a wear and tear item but the issue would be sent onto engineers.
I am the sole driver of the car and use the regen brakes at every opportunity, which is most stops. Since long brake life is one of the benefits of regen brakes, this is disappointing to say the least.
Elantra GD (2013+) :: 2014 GT Rear Tires Wear Uneven
My 2014 Elantra Gt bought in May 2014 and 18000km on it now, the rear tires on both side are worn out pretty bad on the outter side of the tire. I took it to one of the dealer. The mechanic said that's not about the alignment, it's because I drove too hard in the corner..... So, I made an appointment with the other dealership which I bought the GT. I was told that it need the alignment and it's not covered by the warranty. I don't mind to pay for it but just want to make sure they will fix it.
I have the KYB on it right now. should I swap it back to the oem before I go to the dealer??
Ford Ranger / B-Series :: Uneven Tire Wear / Over Inflation
I have a 1999 Ford Ranger XLT using the Futura GLS 225/70/R15 tires. The vehicle decal in the driver side door listed the recommended tire pressure to be 30 PSI. I have tried to maintain religiously along with proper balance and alignment. However, I've always had the experience of the tires wearing out more along the middle which seemed to indicate over inflation. The sections on either side of the center line seemed to wear out normally. For this reason I've had to turn in the tire prematurely as they become unsafe. These tires were made by Coopers Tire and distributed by Pep Boys. Have i been using poor quality tires all along? Do I need to lower my tire pressure below the 30 PSI recommended? If I do that wouldn't I be risking overheating and/or affecting my gas mileage?
View 13 RepliesLexus GX 2004-09 :: Clunk When Stopping And Starting - Uneven Tire Wear
Why are My Tires Wearing Unevenly?
View 2 RepliesLexus IS 2014+ :: Bridgestone Turanza EL400 - Uneven Inner Wear Due To Factory Alignment?
My front driver's side Bridgestone Turanza EL400 (225/40R18) has premature wear such that the steel belt is beginning to show through the center of the tread. The front passenger side tire has no such wear and the alignment is good.
View 14 RepliesSaturn - Sl :: 2002 - Front Brake Rotor Has Unusual Wear
recently I replaced the front rotors and pads on my 02 Saturn SL2. I did this because there was a grinding sound coming from the front left wheel well and I had noticed a band around the rotor that looked gouged. All in all, about 30 minutes of work, following the Hanes manual. In the course of disassembling the front left caliper, I realized that the cause of the gouge in the rotor was from one of the tensioning clips on the caliper bracket. One of the flaps on the clip had bent back and was causing both the grinding sound and the gouge in the rotor. So naturally, I replaced all the tensioning clips as well. After putting everything back together, I took the car on a quick test drive around the block. The noise, while lessened, was still present. Furthermore, after I got to work this morning, I noticed that that there is the start of the same wear pattern on my brand new rotor.
What could be causing this problem to reassert itself?
Ford F-150 (2009-2014) :: Front Brake Rotors Premature Wear
I have a 2014 Supercab Ecoboost F150, which has 37k KM on it (23k miles). I work at sea for 4 weeks on / 4 weeks off so the truck sits a fair bit. I had it in the dealer for scheduled servicing and they noticed the inside pads on both front brakes were wearing significantly more than the outside (4mm vs 7mm). The lube guy at the time had suggested sticking calipers and that they'd be warranty.
A few days later I brought the truck back in to have the brakes looked at and an unrelated warranty item done. They looked and said the calipers aren't sticking and the rotors are grooved and rusted, particularly the inside surface. They wanted to put new pads on and turn the rotors for 400 bucks.
I had a hard time believing it wasn't the calipers, and I was having a hard time getting a good explanation from the service writer of what was going on. So I took the truck back and pulled the pass side tire off in the driveway to take a good look.
As far as I can tell, the calipers are free. The slide pins are nicely lubed and are free, and the pads are free to move in the anti-rattle clips. I squeezed the piston back with a set of C clamps and it seemed to be good. Also, the pads are wearing more or less evenly (not tapered or anything), just the inside is worn significantly more than the outside.
So, rotors wearing out in 23k miles? They aren't really warped, just heavily grooved. My theory at this point is that the weeks the truck spends sitting allows too much corrosion to build up on the rotor, which is getting caught up and wearing down the pads and rotor. Maybe the outside of the rotor isn't nearly as bad because it gets hosed down and washed more frequently?
Inside rotor surface
Outside rotor surface
Inside pad surface.
I still have 7 months of bumper to bumper warranty. Ford says the only cover brakes if the damage is caused by a caliper, so I think I'm out of luck on that front.
Ford Super Duty (1999-2016) :: 2001 F350 - Extreme Uneven Wear On Rear Pads
Have a 2001 F350 7.3 4X4 with single wheels in rear. Started hearing brakes noise and decided to change both front and rear pads. Front had almost half the pads left. Rear on drivers side had about half the pads left. The passenger side metal to metal on the inboard pad and about half the pad on the outboard side. The slides on the caliper were a little sluggish but moved freely. Don't think there is enough to have them turned so will have to replace the rotors. Why this would happen. Could the caliper get stuck? It was easy enough to compress with a C clamp.
View 3 RepliesFord Ranger / B-Series :: 1998 - Front Brake Lines Kink In Sharp Turns And Wear Out
98 Ranger Front brake lines Too short! they kink in sharp turns and wear out then start to seep then eventually leak and need replacement. Checked parts references and the lines have been considered stock. Not sure if I have a 1/2 year model.
View 1 RepliesGolf/GTI VII :: 2012 - Brake Pad Wear Sensor Not Connected To Calipers?
I was cleaning my brake calipers and noticed that neither of my calipers have pad wear sensor connected to pads.
My 2012 GTi had sensor on the inner pad, but I cannot find one installed on my MKVii GTI. Looking for a photo of the caliper and the location of the sensor?
Golf V R32 :: Excessive Tire Wear On The Front
Having issues with excessive front tire wear? I have had the alignment checked by two VW garages and a third party garage and all of them confirm that the alignment is good.
The VW garage also confirmed that as far as they can see there is no suspension issues, but the excessive wear on the front tires indicates that something is wrong.
I have owned the car since new in 2008 so know it has a clean history no accidents.
Both front tires look like this.....