Golf/GTI VI :: Starter Engage And Turn On Engine For About 1/2 Second And Then Stop
Jul 6, 2014
Developed a problem that I'm trying to research a bit to see if there is a common problem. Haven't really seen too much info yet, other than a potential clutch switch that will continue to display "depress clutch!" That's not my problem.
I don't drive this thing more than once a month or so. But occasionally I'll drive it to work for week or less.
Basically, every once in a while I'll try to start the engine and the starter will engage and turn the engine for about 1/2 second and then stop. All lights on the dash stay on. I'll reset the key, and it will usually then start normally on the next try. Sometimes it does the same thing on the second attempt.
Battery is 100% topped up, as it stays on a battery tender. Battery load test shows great. Connections are tight and clean.
The other day I cleaned the main B+ terminal on the starter, made sure the terminal jamb nut was tight and cleaned; then assembled the terminal and torqued. Removed, cleaned and re-torqued the top bolt on the starter. Cleaned and re-tightened the main grounds. Also cleaned the solenoid connection and made sure it fit back on securely.
Was fine for about 6 starts then it did the same thing again.
The last work I did on the car was a clutch upgrade (myself)...literally almost a year ago. I've driven it about...500 or less miles since. So I'd have assumed bad starter connections, but I think I've ruled those out. I didn't drop the subframe, just the transmission. the problem did start pretty much immediately after that job and hadn't done it at all before that job.
So what other interconnects are in the system to control the starter? Relays, control modules, switches, sensors...I'm sure all of the above. Something is allowing the starter to turn for 1/2 second and then drops it.
Perhaps the battery is dropping below voltage while cranking and something is aborting the start?
I haven't really done much diagnosing other than a simple load test on the battery. I haven't taken voltage readings under cranking, voltage drops across wires or voltage readings at terminals yet. Ugh..I really just don't feel like it. Maybe I'll just dump the car into the Pasquotank River.
Not that it really matters, but I've also installed an APR K04, full exhaust, Carbino intake...I don't know what else. But it was all done quite a while ago, by me. This second clutch I've done seems to have been the thing that triggered this particular problem.
View 2 Replies
Advertisement
Replaced starter after which when i turn key to on position starter will engage and actually start engine; turn to accessory and starter will engage but wont start engine. Checked double checked and so on installation. And then exchanged for another rebuilt starter with same results. the reason for replacing the starter in the first place was during the winter went out to start to let motor run fur a while which it did. Went to move before completely warmed up and killed engine starter never made another sound. 1978 gmc 6000....
View 9 Replies
I have a 1998 Accord EX 4-cylinder that will not start. When I turn the key the starter does not engage. The green key indicator on the instrument panel looks like it recognizes the key security chip.
When I checked for voltage at the starter solenoid coil wire I found about 9.0 volts without turning the key. When I turned the key I got a little over 11 volts. I disconnected the wire to the solenoid coil and measured 0 volts from the coil wire to the battery BUT 9.0 volts from the tab on the solenoid valve to the battery. It makes me think something is shorted to the frame of the starter.
View 2 Replies
My Nissan sentra will start on the coldest day, but now that it's getting warmer it sometimes won't start! Turn the key and I have power to everything, but engage the starter and nothing! Not even a click! Try and try and eventually it starts. What could cause this??
View 7 Replies
My neighbor has a 2008 Grand prix V8 that won't turn over. When the ignition is turn on the starter does not turn and then the horn honks once, you hear clicking sounds in the engine compartment and inside the car and the service display goes through each system indicating that it needs service. We unsuccessfully tried jumping the battery.
View 1 Replies
I have 2007 Santa Fe LTD which will intermittently not start. All electrical devices work fine but when you turn the key the starter will not engage. Keep trying the key and after 5-10-100 try's the car will start. The next time it may start on the first attempt or it might not. Sometimes it will go weeks without a problem then it will not start again. I have checked the starter relay, battery, and cables. It seems like the alarm is faulty and not letting the power get to the starter.
View 16 Replies
Neighbor bought a 91 tracker. We put a new battery and alternator in it. We have to jump the vehicle to get it to start. While running with the light on, the lights are extremely dim. Sometimes the vehicle will start again, but most times it won't. What I mean by it won't start is nothing happens when you turn the key. No clicking starter does not engage. Sometime the car will not stay running with out charger attached. Then again sometimes everything is fine.
View 7 Replies
When I insert the key, there is current to the dashboard and the steering wheel moves into position. When I try to start the car, the dashboard is illuminated- the radio comes on etc- but the starter does not engage all. It's totally quiet. I remove the key, insert the key and try again. Sometimes the starter engages, sometimes not. When it cranks, it starts right up. The battery is good. We had the ignition switch changed out a while back, but it didn't really improve the situation.
View 2 Replies
After getting the oil changed in my 1997 Ford F-150 4.6L with 150K miles at a local quick lube, I made one stop and my truck wouldn't start. I could hear the starter engage the flywheel, but couldn't turn it over at all. Oil was clean and full. I bench tested the starter and it tests good. I put a breaker bar on the crankcase nut and I could barely move it. Oil level was about 2 quarts low before oil change.
View 10 Replies
I have a 2001 supercab 4x4 with a 4.6 in it, it has 186k on it and the only issues I've had was a misfire not to long ago. I replaced the plugs and coil packs and fixed that issue. 2 days ago she ran fine with no issues and this morning I went out to go to the store and she wouldn't start. All the dash lights come on and all of that normal stuff when you turn the key. When I turn the key I hear what sounds kind of like a clunking noise towards the bottom of the windshield and the middle of the dash. The starter does not engage, no nothing, really confused here. I thought maybe the battery was bad so I put my jumper on it and tried but again nothing happened.
View 14 Replies
160K miles. Sometimes starter doesn't seem to engage with the engine and the engine won't start unless i put it in neutral and floor the gas pedal. Then it shakes, rattles, sputters and smokes comes out but it starts like the car in Chitty Chitty Bang Bang (for the oldsters here). Happens about every third start. Once i had a 67 Plymouth where every once in a while i would have to hold the butterfly open (with a stick) on the carburetor. I have to take it and get it fixed. So odd that it is not every start. Happening with more frequency.
View 7 Replies
I hoped in my 2006 GS300 car Monday morning to head to work and pressed the start button while holding the break pedal and the starter didn't engage/turnover the engine. Everything looks normal (Green light on starter button, dash lights come on, etc...) except no starter action. I mean not even a tick or a click.... Nada....
The car battery was replaced in the past 6months or so and the key FOB battery seems good as well since it detects when I approach the vehicle. My wife was also in the car with me and had her key FOB as well. I can also hear the fuel pump priming when I press the start button as expected.
I'm thinking its a starter problem and will start by verifying the voltage at the solenoid when attempting to crank.
View 14 Replies
My starter motor in my 2004 Golf 2.0 doesn't engage or spin when it is very cold. By very cold, I mean below 5F.
The battery has plenty of juice, and jumping the battery doesn't work. I turn the key to "start" and nothing happens. When key is in the on position, fans, wipers, etc all work fine. When the car warms up to 20F or so, everything is fine and the car starts.
Here's the funny thing. If I put a little space heater on the driver side floor to warm up the fuse and relay panel, it starts with no issue.
I don't know enough about the interlocks between load reduction, starter motor, ignition switch etc to make a good guess as to which relay (if any) may stick in extreme cold. It's a tough problem to diagnose, because I can only experiment when it gets REALLY cold, when it isn't very fun to experiment anyway. I don't think it's the piggy back harness, because the wipers, horn and fan all work.
View 4 Replies
I have a 2010 F150 with 39,000 miles. This morning the truck started fine. I ran in to get something came back out and the truck had died. I tried to restart it and nothing. When you turn the key forward the starter spins and wont stop until u turn the key off. The truck never tried to fire. The motor tuned over and over but nothing. is there a starter relay? A solenoid?
View 2 Replies
I was driving to work and lost all power (during rush hour) I was able to coast to a exit. Had it towed home, when I turn the key the starter engages but nothing after that, the engine will not turn over. I checked the battery and has a full 12 volts.
I removed the belt and front plugs to see if I could manually turn the engine over but it will not budge. How can I tell if this engine is really locked up or if maybe something else is happening?
3.1 V6 engine .....
View 7 Replies
I have a 2000 Chevy S10 (4-cylinder, rear wheel drive, the most basic model). A few months ago, the truck wouldn't start. The starter clicked a single time when I turned the key, and the lights on the radio came on, but nothing else happened. Several hours later, I attempted to start the truck again, and it started just fine. I disconnected the battery and found some corrosion on the positive connection (not that bad), and I assumed it was because of a bad connection.
I cleaned it and haven't had any problems since....until last night. The truck once again wouldn't start at a gas station. One click from the starter but nothing else happened. I cleaned out the battery connection again, and the positive terminal was again slightly corroded, but it wasn't that bad. The truck started after I cleaned out the connection and it got me home, but wouldn't start again after I shut it off. Can a bad battery cause repeated corrosion or possibly be the problem? I'm hoping it's just the battery, but I don't want to get a new one until I'm sure...
View 6 Replies
Had an odd situation earlier tonight. The starter cranked normally but the engine wouldn't actually start. I let it go for 10 seconds and hit the button again to make it stop in order to protect the battery. A few seconds later, I tried and it fired right up without a hitch. The MIL never came on so no codes most likely.
Car has 17k on it. 2013 2.0
View 6 Replies
My parents have an 07 f150 with remote start and for some reason it will not work, it locks the doors and turns the key on but it doesnt turn the engine over, we brought it to a local dealership and they just unplugged it and plugged it back in and it started working... but later down the road, like 150 kilometers my mom got out to go shopping and it wouldn't work again, does this mean the whole module has to be replaced or is there a quick fix to this, it looks like the stock ford remote start but it has a separate keychain for the button, if it has to be fixed, any instructions on how to do it?
View 3 Replies
I went to leave today and found the 2012 Accent (auto trans) won't start. The starter doesn't even try to engage.
Battery voltage was 11.5 both when turning the key to start, and when just in the accessory position.
I put jumper cables on it from my truck and left it for 5 minutes. Voltage was now 13.5 but it still wouldn't try to crank.
What to easily check? I plan to call the dealer in the morning and have them come get it since I only have 17,xxx miles on it.
View 21 Replies
So yesterday I drove to my friends house b4 work. My car started up just fine no problem. I was at his house for maybe an hour and as I was going to leave I tried to start my car and it was dead? All my lights work got a jump. Still nothing so today I took my starter off and had it tested( fail). Paid for a new one and put it back on. Hooked everything up. Went really smooth. But went to start it and it won't engage the flywheel? Am I missing something?
View 1 Replies
I have a 2010 Accent with 106 000 km on it (Canada). A couple months ago (just as warranty expired) the car would not start. Nothing. Engine would not even turn over. Just a click of the starter solenoid. battery had a load test and is fine. Removed negative battery cable and cleaned the cable where it bolts to the body under the battery tray. Battery terminals were both cleaned at the same time.
Things worked fine for a couple weeks and the problem is back but worse. Everything in the car works fine when it won't start. If I continually turn the key to the start position it will eventually start to turn over and start fine. Sometimes it takes 20-30 turns of the key till it turns over and starts. When it does turn over and start, the engine turns over fine at the normal speed. Not slow like a weak battery.
Dealer is useless. Had a coil go a couple months back just before the warranty expired and they told us that the reason the coil went was that the car had been rust proofed by someone other than Hyundai.
View 12 Replies
