Golf/GTI VI :: Shudders At Full Throttle Like Car Going To Stall
Apr 1, 2010
So I finally reached what I considered my break in period at 800 miles and now when I give the car full throttle, it shudders like it's going to stall. I can go as fast as I want at any RPMs but when I give it full throttle it nearly goes into a stall til I let off.
I do have APR STG1 and it is in the correct setting (93 OCT) I tried putting it to stock & running it like that on my drive home & still no go, check engine light is still on.
View 21 Replies
Advertisement
My R is vibrating in second gear near full or full throttle around 2,000 Rpm. It feels like a high frequency vibration. It seems to be only happening in that scenario. It's when the turbo spools up and there is a large rush of exhaust gas produced very quickly. My guess is that my apr downpipe paired to the stock cat back is the culprit. It didn't happen when I first put the downpipe on, but after the next track day it started. I don't know if there is anything to burn in inside the apr downpipe but it got louder too. Could it be back pressure from the stock cat back? It's very strange and I wondered if it is stage 2+ but running the stock cat back has felt this? I checked to see if the drive shaft was rubbing on anything and for any other visual indicators of rubbing around the downpipe and I see nothing. Perhaps it's the stock muffler. I'm just not sure.
View 13 Replies
My car started a rough idle last night.... Pull to stop light, in gear, a/c on #1 and car shudders and acts like it's going to stall..... Went away as I drove a round a bit.....back this a.m. (after the warm up program ran) drove it a bit and was sporadic.....and even went away...then came back.....
Its worse when car is at stop and in 'D'.....little better with a/c off and/or in neutral......it finally threw the CEL today....... I had the fuel pump recall done about a month or two ago, car has 36k+ on it...... Anything I should have the service dept look for aside from what the fault codes might read?
[URL] .....
View 7 Replies
My GTI is the first FWD car I've had since 1985, so the issue that I'm having may be just me adapting to a front drive platform. Here's what's happening: when I nail the throttle in 3rd or 4th gear, on or about 4K rpm or above, the car feels as if it's hesitating slightly as the revs climb.
It accelerates fiercely (I have the JB1, and I had the Neuspeed Power Module before it, and it's reacted the same way with each mod), and it's almost as if the front end of the car is lifting and struggling for traction (although the traction control light doesn't come on).
Is what I'm experiencing normal FWD behavior? Is it the beginning of torque steer? I only notice this at full throttle--not noticeable at all at partial throttle. Also, it doesn't happen consistently. My car is a performance package manual.
View 21 Replies
250 2006 Superduty v10. Codes p2106 and p2135 ... Only occasionally when coming to a stop it shudders like it would stall. It happens for just a few seconds then ok again but wrench light comes on. After the next shut off and start the light goes out. I had the throttle control position sensor checked and they said it was ok. Got a software update at Ford. I hate to just start replacing expensive parts. I have about 60000 miles and it is a great truck otherwise.
View 1 Replies
I have a 2012 Camry SE and lately on low throttle the car vibrates or shudders like if in driving thru a rough road and tires are good used a different set and still the same result.
View 14 Replies
After I fill my 6 cyl 2004 Hyundai Sonata (280,000 km), the engines starts, then stalls. I can only get it to work by keeping the accelerator pushed to ensure sufficient rpm's. If I remove my foot from the accelerator, the rpm's drop to zero.With the engine revving, I put the car in drive and 'lurch' away from the pump. After that, everything is fine. It starts up properly … until the next fill. My mechanic is mystified and I am frustrated.
View 6 Replies
My truck will start and idle but when I engage it into a gear, whether it is drive or reverse, it will start to bog down and not respond to throttle. Sometimes the truck will stall other times it will just bog down then the rpms shoot up and the truck will run normal after. If the truck does die it will fire right up and have no issues and run great. Now whenever I stop and shutoff the truck the next time I start it up it will go through the exact same process. It doesn't matter how long the truck has been shut off. Could be a minute could be a day. Truck has 177k miles, in the last year it has given a code for camshaft sensor going bad and has been replaced twice. Have also had the catalytic converter and the O2 sensors replaced within the last 6 months. Not sure if this matters but was told my truck is California Emissions by the garage that replaced the cat.
View 3 Replies
I did some searching and cant seem to find this in a 6.0 (massive results in IDI)
If I rev my truck over about 3200 rpm and release the throttle, as it comes back down to idles it will stall.
Ficm voltage is fine and I am running a stock tune, ICP doesn't seem to drop until the stall...
What should I be looking for?
View 8 Replies
A buddy of mine has a stock 1.8t auto with some miles on it. THe car sputters after you come off full throttle and then the check engine light comes on. we have replaced the blue coolant temp sensor and the 4 coils and plugs. car is still doing this.
View 3 Replies
Just talked to a good friend with a 2008 limited, V6. While his wife was driving the throttle went full, then back to idle, then full while her foot was off the pedal. She put it in neutral got to the side of the road and turned it off. She just had towed to the nearest dealer. She said the dealer suspects the Throttle Position Sensor....seems to be a common problem for Hyundai, based on other issues seen on this forum with some losing power, etc. Surprised there isn't more information from Hyundai as the TPS seems to be a weak point.
View 15 Replies
I've noticed on a few occasions that when asking for full throttle to merge on a highway, my car bucks while in 3rd gear (automatic) as the rpms climb above 5k or so. It's almost as if the car is choking on too much air (I do have the SRI) because backing off the throttle slightly immediately stops the bucking. The car does not buck in 2nd gear at the redline. What would cause it?
I'm thinking maybe the spark plug wires are arching or there is a slight crack in one of the coil packs that only manifests under full throttle. Or perhaps the engine really is getting more air than it can handle. I'm at 46k, no mechanical problems, never a check engine light, and the car operates smoothly under all other circumstances. The spark plugs were replaced with NGK platinums at 30k.
View 3 Replies
My accent 2006 has the check engine code p0171. AT mornings I have to start the car like 5 times until it revs up and do not stall. Also when the car is running, If I press the gas too much it starts misfiring and have really slow acceleration. I have already change the 02 Sensor, spark plugs, TPS and maf sensor, and PSV valve, cleaner the throttle. I really don't know what else to look for.
View 5 Replies
My car is: Passat 1.9 PDTDI, 2003,AVB(101HP)(200.000km). This is my first diesel car, I bought it two months ago. The car has poor power under 1800-2000rpm. I push the throttle full down and my car accelerate slowly. At 1800-2000rpm kick out and accelerate very fast, but over 3000rpm the car goes limp mode.
2 months ago i had the following error msg: 17965 charge pressure control positive deviation p1557 - 35-10 intermittent.
My turbo was cleaned. No limp mode,but poor power under 1800 rpm.
Now, I have this error msg again. I logged the block 11 with vag-com. The duty cycle is 94,4(2500rpm).
The EGR is disabled. What is the problem? MAP? MAF? Actuator? Turbo?
View 4 Replies
2002 Ranger XLT 4WD 4.0.. I was passing another car at about 55 when they also started speeding up (go figure) so I floored it and got on around them but before I lifted I felt it miss, the CEL began flashing so I slowed to the speed limit and went on to work. The light flashed for about a mile then went out. So on the way home I floored it again close to home and the CEL came on again. Got home and put the code reader on it and all it had was a random misfire so I have cleared it. The truck has new plugs, wires, etc for a complete tune-up. I don't usually run at full throttle so don't know if that would be normal for the Ranger, the Ranger was my wife's truck for 12 years and now is my DD. Need to clear this up? Thought of changing the fuel filter in that is still the original one.
View 8 Replies
Any turbulence in the exhaust note, ie. slapping noise at full throttle. I have run 3 different mufflers in one year on my true dual and also gutted the cats. I currently have 2 1/2inch true dual with gutted cats and cherry bomb extreme mufflers. I Also am running an H-pipe, but I feel it isn't doing its job so well to balance the two sides. My trucks exhaust is almost perfect, it starts mean and loud, and has limited drone at highway speeds and great flow and power, but when I am smashing down the throttle the exhaust goes everywhere and makes all sorts of weird noise.
I almost feel that I should of went 3 inch to allow for me air to get out of the motor, I think the 2.5inch is restrictive possibly hence the air is having a tough time squeezing out of the system. But anyway do you think if i ran an X pipe it would work? Its my last option because otherwise i may convert back to the a single 3 inch dual 2.5inch outlet again, i miss my old set ups mean consistent tone at full throttle.
View 12 Replies
I recently purchased a '13 FX4, i love the truck, the Ecoboost power is incrediable. Recently while passing someone it made a horrible grinding sound, the dealer advised that it was known turbo issue that should have been corrected before we took delivery of the truck. When we took it in the dealer called and said they have Ford corporate involed because when the truck reaches WFO the four wheel drive tries to engage. Said it might be soem sort of vacuum issue.
Specs : 2013 Ecoboost Screw FX4 short bed. No mods, 6500 miles.
View 10 Replies
96 F150 carbed 300 with a C6/208 SAS44/9" with 3.55 on 35s.
I put a transgo shift kit in the transmission before putting it in the truck, it also has a small stall. At half throttle you can manually shift 1-2-3 with no issue at all. Under full throttle when you shift to second it won't go into second until you push the shifter into third. Then it'll go to second and spin the tires when it grabs second in dirt. This is all in 4lo, I was gonna switch to 2hi and try it but it's raining and I don't feel like crawling under it to change it. The truck is a mud toy so will spend 90% of its time in 4lo.
I don't have a vacuum line currently hooked to the transmission because I have the same shiftkit (transgo) in my 77 and no vacuum line on it either and it works fine.
View 4 Replies
So I started to NM from fort worth texas with my 33" camper blew my CAC pipe four times. Finally got there. In the morning it took longer than expected to start. When it did white smoke. That was replaced with black smoke under full throttle.
I went from elevation of 700 to 8000 Ft. Should I care about black smoke? Meaning should I take it to Ford and get a rental car to get it looked at for our trip home.
96 degrees towing at 70mph with lots of climbing mountains.
View 14 Replies
It's time to do some oil change and is using 10w30 synthetic but the truck is eating fuel like crazy and I can hear some kind of knocking when full throttle .
Sparks , boots and fuel filter is new . The mechanic said I should put some lighter velocity oil . truck odo 130k v10 hot hot weather .
View 14 Replies
I just have a 1999 ES300 that is having a strange issue. I realize this is a toyota forum, but the engines should all be the same.
When you accelerate from a stop at full throttle, the car feels very sluggish moving up the RPM range, and acts as though it is missing and stumbling the entire way up. If you do the same acceleration at lets say 70-80% throttle its much faster and much smoother (like the car is supposed to be). Works just fine until the car hits like 55mph, then power just cuts out.
If I'm revving the car in park or neutral its the same story. Works well at part throttle, but full throttle it misses as its revving up. To me this seems like 100% some kind of weird electrical issue. I'm having a tough time tracking it down though.
Things I have done:
1. At one point i had an VVTi OCV code for the rear bank, so I've replaced both OCV filters, and removed tested and replaced the RH OCV valve (they were both working to spec, but the rear one had a little more play in it).
2. No codes by OBDii scanning.
3. Cleaned MAF
4. Checked intake hoses for rips (there are none)
5. TPS seems to be working well based on OBDii diagnostics.
View 14 Replies
