Golf/GTI VI :: Setting ST Coilover On Highest Settings?
Jul 16, 2015
Installing STs on my mk6 tomorrow. Doing it in a steep driveway. want to be on the highest setting when I leave. regular v1 st coil over.
View 1 Replies
Jul 16, 2015
Advertisement
Elantra MD (2010-15) :: Fan Only Works On Highest Setting
I drive a 2012 E, and this is not about mine. It's a buddy whom has a 2013 or 2014 (I think all of the fan hardware is identical). His fan stopped working on the three lowest settings, but still blows fine on the highest setting.
Perhaps resistors knock the current down for the lower settings and they have failed? Just a wild guess....
Passat (B6) :: Slow Wipers At Highest Setting?
So compared to my old Jetta, these wipers are "fairly" slow at the highest seeting, and in a down poor at 70 mph they do not clear the windshield fast enough.
View 5 RepliesGMC - Sierra :: 2005 - Blower Fan Would Not Run On Highest Setting
So I have a 2005 GMC Sierra 1500 pickup that is in great condition. Recently, I have noticed that in the mornings on my way to work the blower fan would not run on the highest setting. After a while of driving, the highest setting would then work. This happened for about two weeks. Now, the blower will not turn on at all on any setting. Thought it might a simple fuse, but that looks fine. Should I take it to the shop? Could it be the blower motor that needs to be replaced?
View 3 RepliesNissan - Versa :: 2007 - AC Will Only Run On Highest Setting
I have a 2007 Nissan Versa and my AC will only run on the highest setting. The dealership suggested that the whole panel with AC dials needed to be replaced, they did say they were not sure this was the problem. In doing some research on the web I did see discussion regarding a Nissan Altima that had what sound like a similar problem and the fix was a part called the "blower resistor" which was much cheaper and could be fixed at home.
View 2 RepliesCorolla / Matrix 2009-13 :: Fan Only Blow On Highest Settings
The fan in my 2011 Matrix is only blowing on the highest setting (4), heat and air is ok. Is this a fuse issue?
View 6 RepliesGTI 337/20th Anniversary :: Heater Only Works On Highest Settings?
I'm having an issue with my heater/fan. When I started her up this morning, I noticed my heater (and fan for that matter) only work on the highest setting (4). It still blows hot, and runs at normal temp, but none of the vents are functional unless its blasting!
View 13 RepliesPrius C :: Windows Fogged Up / Fan Moved To Highest Setting When Defrost On
I thought I wouldn't have need of the defrost for several months yet, but today we had unusually cold rain and my windows soon fogged up. The fan (not a/c) was already running at a very low setting (one or two clicks only) when I depressed the defrost button. Roughly 15 seconds later, it was like a hurricane in the cabin! The fan moved to the highest setting all by itself. This did clear the windshield in seconds, but it was a bit disconcerting. This phenomenon repeated itself all three times that I engaged the defrost button. Is the defrost supposed to do that? I swear, the sudden change startled me so much, I hit my head on the ceiling of the cabin...
View 3 RepliesSubaru - Legacy :: 2011 - AC Does Not Get Above A Cool Breeze In Car Even At Highest Settings
I got a new 2011 Subaru Legacy a few months ago and now that the weather is starting to get warm again I am finding that the AC really sucks!! Even on the highest settings it doesn't get above a cool breeze in the car. I grew up with an older legacy and the AC was awesome so is this just with the new Subarus or have I gotten another lemon?
View 5 RepliesSonata NF (2006-10) :: Blower Motor Making Noise On Highest A/C Setting
My A/C has been making a loud noise for a couple months now ,only when I put the A/C on the highest setting. I was LONG overdue for a cabin air filter change so I bought a new one and while I was down there I looked inside the blower motor and here's what I saw... It is now blowing fine and not making a noise . Sprayed some Ozium New Car spray on the new cabin air filter and my car is smelling great now !
View 4 RepliesDodge - Ram :: Blower Operate Only At Highest Speed Setting - Resistor Failed
2002 Dodge Ram 3500 van (engine unknown, but I think it doesn't matter). Blower operate only at highest speed setting. OK, that's the classic symptom of a failed resistor. Replacements are readily available at chain parts stores.
Where is the resistor located? This video shows me for a 2002 Ram 1500 van. Will it be the same on the 3500?
I've learned here that sometimes resistor failure results from bearings going bad in the blower, causing excessive current draw. Is there a way to test that other than with an ammeter? What's the correct current?
2a. If the blower motor is going bad, is that something we'll be able to replace ourselves? (Yes, I should tell them to get a Haynes or Chilton.) I don't like the idea of taking off dashboard panels.
2b. Is there any other "prime cause" I should look for if the blower motor seems OK?
Are there any other parts (other than the switch) whose failure would also give that symptom?
Nissan - Frontier :: 2000 - Heater Doesn't Blow Air Unless On Highest Settings
I own a 2000 Nissan Frontier. Just recently while I was driving (in 15 degree icy conditions!) my heater, which was blowing on setting 2, stopping blowing air. I tried messing around with it, and found out that it won't blow any air on settings 1,2,or 3. It does, however, blow air on setting 4, but that is accompanied by a slight strange noise/vibrating of the dash. The coolant level looks fine and I haven't spotted any leaks anywhere that might indicate that it's the heating core. I thought it might be the resistor.
View 4 RepliesChevrolet - Tahoe :: 2003 - HVAC Blower Switch Only Works When Put It On Highest Setting
My HVAC blower switch only works when I put it on 5 (the highest setting). What needs to be replaced (besides the whole truck)?
View 4 RepliesPrizm - Chevrolet :: 1998 - Heat And Cooling System Only Works On The Highest Settings
I have a Chevrolet Prizm 1998 and the heat and cooling system only works on the highest setting which is actually the fan setting. When I have it on any of the other settings such as low or med nothing comes out, it doesn't work. I can hear it click on but nothing comes out. So when I'm driving depending on the weather I have the heat or cold air blasting out of the fan until it gets annoying and I turn it off. I've checked the fuses and they're good. I have not checked the relays because I'm not sure how to do that. I haven't taken it to a shop because I'm poor and don't have a trustworthy mechanic and it works just not on low or med. Should I have this looked at? I don't want to be causing any damage but it seems like it could be something simple.
View 2 RepliesSanta Fe (CM - 2007-12) :: 2010 - Warm Air From Vent / Temp Control On Highest Settings
I find that my 2010 V6 is always cold in the winter. I always need to turn the temperature control to the highest, but there is still not enough heat. This morning, it was -11c outside. After I drove 10 KM (about 20 minutes) , inside the car is still very cold. My feet were frozen. The air from the vent is only warm, not hot. I also find that this car takes longer to warm up. The temperature gauge won't start to move until I drive about 2.5KM.
View 5 RepliesFord 6.0L Power Stroke Diesel :: Blower Motor Only Blows On Highest Settings
Thought for sure that would fix my fan speed, but nope. Replaced blower control module, Still only blows on the highest setting. Didn't try running it on auto, but that's what it did on manually turning the speed up. What else could it be?
View 9 RepliesFord A/C :: 2010 Expedition - Blower Motor Not Turning Off / Stuck In Highest Fan Speed Setting
My 2010 Expedition Limited AC seems to be stuck in the highest fan speed setting. Changing the setting on the panel control do nothing to change the speed. But you can adjust the temp and it will respond. It is a dual control unit. When I try to turn the system to off completely it will go to what I believe is the vents and stay on full blast. If I turn the truck off and on again the whole system remains off until I turn it on again. The only way to turn it completely off is to turn it to off mode and turn the truck off.
View 1 RepliesGolf VI R :: ABS Warning Light After Coilover Install
I had KW V2s installed on my R and the shop said they cause the ABS warning to come on so how to code out the alert using VCDS?
View 15 RepliesGolf IV R32 :: Passenger Strut Won't Come Out When Installing Coilover
The strut is lose, I can spin it hardly but I can't get the rotor to go down far enough, already disassembled the control arm but it didn't do much considering I couldn't move it forward or backward so the rotor still sits on a corner or the arm. I did the drivers side already.
View 3 RepliesGolf VI R :: Headlights Not Adjusting After Coilover Install
Installed coilovers and took it for a drive today/tonight..I turned the headlights on and they adjusted side to side like normal..when they went to adjust up they moved like an inch..making it almost impossible to drive at night..I reset the battery and still the same scenario..is this a setting I have to change or can change thru vag com? Everything worked fine prior to install, and no I did not break anything.
View 7 RepliesGolf VI R :: Creaking Under Extreme Turns After Coilover Install
I just installed a new pair of PSS10 coilovers on the R today and everything is running great, except a creaking noise I am hearing under extreme turns. If I am going slow, I can whip the wheel all the way to one direction and hear the creaking noise, or if I am going around a longer corner at higher speeds, I hear it as well. I've taken the wheels off and checked, everything is tightened.
Based on the searching, most are complaints of similar sounds but in straight lines. This is only when turning. There are only 20k miles on the car, but that includes 7 weekends of HPD events. So worn/dry bushings or joints was my first thought.