At low speeds - Like when I go over the soft-curb at the end of my driveway, I get a rubber seals making a squeaky (from friction?) sound when ever tire goes up or down the curb.
Or in a parking lot with uneven surface - I get it then too.
Just very annoying - but luckily no noise while driving the speed limit...
I never had a car that did this. Been driving VW's since 1986.
My FSB is making some clunking noises. Literally sounds like metal on metal banging. Im thinking its the FSB bushings. I just put the bar in about 4-5 months ago, not sure how the bushings could be shot already. The car only makes these noises at low speeds. On the highway i dont hear a thing. I installed the bar myself, so i know there is very little room for play.
View 5 RepliesNoticed my 5 week old MK7 GTI is making squeaky noises on the driver's side when turning left at slow speeds. What this could be? Occurs intermittently, not all the time. This is a leased vehicle, would this be covered by warranty?
View 7 RepliesLong story short I've had these coils on my car for a little of 2000 miles and about a month, at low speeds I hear squeaky from the rear of the car. I know its coming from the shocks I've checked all of the bushings and lubricated them. Its getting very annoying.
View 9 RepliesThe door seal between the driver's side front and rear doors on my car is coming loose -- the rubber piece that seals out wind/water/noise?/etc. between where the driver's side front door closes and meets the rear door by the B-pillar. I looked at the way it's designed and meant to be applied and was curious if using gorilla glue or some variant of high strength adhesive would do the trick? It seems to be drying up where the rubber meets the sheet metal.
View 3 RepliesJust noticed today that the rubber seal around the window, a small part of the rubber seal, has peeled.
Talked to the dealer and initially they said that it could have been the tint shop's fault because they may have been their fault.
Called the tint shop and they explained their process and after doing little research of my own and watching youtube videos, it is unlikely that the tint shop could have done this.
Called dealer again and explained to them that i talked to the tint shop and after hearing their process and after researching their process, it may not have been the tint shop but just a small mistake on hyundai/dealer part. they said the best they could do is take a look at the car, but not guaranteed they will fix it.
I unstuck my front axles yesterday and while under the car spinning the front axles freely and enjoying my easy fix, I noticed a rubber seal (a thick squared edge round rubber seal) sitting loose and spinning freely. Its next to the axle joint, right before it disappears into the housing.
I'm guessing this is a dust seal of some kind. There is no fluid leaking out...
I'm wondering if I can just press fit this thing back into place or do I have to take the whole front wheel assembly (hub, bearing, axle, etc) to get the seal back into place.
I'm wondering if it broke off from a larger seal or if this is the whole thing? You can see how the seal isn't sitting quite straight. It actually just spins around.
About a month ago my Touareg started making loud rumbling noises at highway speeds. It sounds and feels (it makes the whole truck vibrate) like you're driving on the "wake me up bumps" that are on the shoulder. Some times it last for 30 seconds and other times it goes on for the whole trip. It's driving me crazy; however the dealer can't reproduce the problem so they think I'm crazy. It doesn't do it all the time, however, the only common symptom is it happens at speeds above 65 mph. It has happened when it the car was cold and hot, cruise on and off and variable highway speeds. The transmission was replaced right after I received the car due to a malfunction, so the dealer doesn't think this could be a second faulty transmission.
View 13 RepliesI have noticed a rubber squeak from my driver's door on my 2010 ES 350. It disappears when the rubber is wet so I am thinking perhaps there is a silicon product that I could apply or another fix for this? Any solutions out there?
View 4 RepliesHard to describe since I'm away from the Tiguan and can't take a picture.. but I noticed that the left side wasn't tucked under, but the right side was. I'm referring to where the two glass roofs meet in the middle. The rubber seals are completely visible from the front but then are tucked under the plastic part at the middle of the sunroof.
View 3 RepliesWe have 3 company work trucks. They are F150's 2WD V6 - one is a 2008 and two are 2007s. They have all had thrust bearing problems. We just had the #9 thrust bearing replaced in the 2008 for the third time. The trans hasn't failed but starts making a whining sound at all speeds which varies in pitch relative to speed. The 2008 has had it replaced at: 40K, 60K, and now 70K. One 2007 had it replaced at 60K and 90K. The other 2007 had it replaced at 50K.
Our dealership says they've never seen anything like it & that our trucks are the only ones they've seen this on. They are suggesting it's happening due to driving behaviors. All 3 trucks have a single driver and aren't switched or shared. The 2008 doesn't carry or tow. The 2007s both carry hundreds of pounds of tools daily. This just seems like too much of a coincidence to be driver induced and that we're the only ones with these issues.
New to the R, and recently the transmission seems to be making some noise throughout lower gears at low speeds, when the clutch is engaged the noise goes away, I figured it was the throwout bearing, but now my transmission now refuses to let me into 2nd gear and also reverse.
I changed the transmission fluid hoping it would eliminate the noise a bit, and saw very small metal shavings in the old fluid. I'm now worried I have a serious transmission issue... Are these signs of major transmission issues or should I be checking linkage? Any common transmission problems with the R I might be experiencing?
2003 vr6
Belt squeal but when I have clutch pushed in no noticeable noise.Abs kicks in at low speed stops. I sprayed the belts with dressing noise went away momentarily actually sounded like it could have killed it almost. Right now I have the and fuse pulled to just get me by.
This is about a 2000 gmc sierrra 2500 truck I purchased with 194k a few years ago. It now has 232k. Whenever I go from a complete stop, the noise sounds as if it comes from the rear area. It sort of has a sliding umph noise, as if a slide hammer is going from front to back with a resounding stop as I move forward. I have checked the driveline, the rearend, the bed attaching bolts, and most everything in the rear section for tightness.
I had the bed loaded heavily once and it seemed to not make the noise. When I tow a boat or tow nothing it makes this noise with a sort of bang or stopping sensation at the end like the slide of something that then stops. Who wants to ride under my truck for a diagnosis? Could it be in the transmission? ha, it could be anything we all know that !
I have a 2005 Chrysler Town & Country base model with just over 70,000 miles.
My steering wheel/column "squeaks" when making left or right turns. The noise sounds like it is coming from inside the cabin, just behind the airbag/horn. It does not sound like a typical power steering problem. The sound is more noticeable when I make left turns and when I am driving slowly, like when I am turning the wheel of the car to get out of a parking space. The noise is definitely worse in colder weather.
I had the inner tie rods replaced three months ago, but I think the creaking sound pre-dates that work. Are there bearings or joints that might need lubrication. Something else?
So I already changed the Driver Side upper Control arm. But there is still squeaky noises coming from the trunk area, esp at low speeds going over small hills and small pot holes. I saw this is common on our cars and wanted to know which parts were to be replaced. At 110k, is it worth repairing piece by piece or should I do the shocks, ball joints and such at once.
View 1 RepliesI have a 2003 Camry 'SE Automatic with almost 18,000 miles - that's right, low mileage. This week the steering wheel started making squeaky noises when I turn it. It doesn't matter which way I turn, it will squeak and it doesn't happen all the time. Should I be worried and what can I do about it?
NOTE: This started happening the day after we had got an 1 or 2 of snow. That morning when I opened the door to get the brush/scraper and little snow fell in the driver's side of the car. Perhaps a little fell on the steering wheel.
My belt was making a screaming squeaky noise to wake up the dead. I used dish soap on it and it got quiet as long as I remember to bring the dish soap. My mechanic looked at my AC and told me I need a new compressor (he is a friend I trust) Now the AC comp turns but the belt seems to go on and off. And, the weird thing is-the AC feels great! Am I to expect any moment for it to just stop working? So, what to expect from my dead or dying compressor?
View 18 RepliesAbout 3 months ago i lowered my car on FK his sports. There is a popping sound it never happened before. just started now.
When i drive straight and i let go of the gas the car kinda jerks always then the pop sound comes from passenger side.. or when i turn, then drive straight i pops. I'm thinking it might be a bad cv joint or bearings..? or i heard that the FK coils it self-make weird noises.
Last night on the way home from running some errands I noticed some sloshing sounds coming from the rear of the car at low speeds. I thought maybe I had some container back there (spare oil, distilled water, etc) that just happened to be making the noise. I noticed it again this morning and it seems to me like the only thing it could be is the gas tank. I don't seem to hear it at anything but low speeds and even then it is not constant. Is this normal? I just filled up the tank for the first time two days ago and I currently have probably 3/4 to 7/8 of a tank at the moment. Is this normal? I'm not used to hearing sloshing in the gas tank.
View 4 RepliesMy shifter when moved into fifth or six makes a squeeking sound. It only does it when you put pressure on the shifter to the full right of travel. I'm pretty sure that it the shifter is rubbing against some trim underneath the boot. I'm taking it in on Friday to have it checked under warranty but wanted to get member's opinion before I went in.
View 2 Replies