Golf/GTI VI :: How To Remove The Front Badge
Mar 13, 2010
How to remove the front emblem on a golf? I removed the four screws and tried pulling out the grill but nothing. I dont want to break any snaps so looking for pics. Also is there a need to remove the grill to get the badge out?
View 1 Replies
Advertisement
I am halfway through the badge backup camera install and I just had a thought. Will replacing the badge with the backup camera badge affect my kessy functioning? I did not check to see if there was a kessy and non kessy golf backup camera. I have read at least 10 DIYs on this mod and not one mentioned kessy at all.
View 24 Replies
I have took off the screws in below pictures. But the bumper seems still stick on the car body. Any screws are missing? Or other issue?
View 4 Replies
Looking for a write up, is it just stuck on there like the back GTI or is it screwed in?
View 6 Replies
I have the grill out, how do i get to the three tabs the emblem is attached with...
View 9 Replies
I am talking about the aluminum part....
View 4 Replies
Can't find out how to remove the driver side front bumper grille. I could not see any screws or tabs holding it in. I'm hoping it can be removed without taking off the entire front bumper.
View 5 Replies
I need to replace the center mesh grill on the front bumper. Is there anything I need to be careful with or watch out for. when I pull on the old grill or when I push the new one back into place? Does it come out easily or is it tricky?
View 4 Replies
Picked up F sports black on black in Dallas Getting some work done like darker tint, front clear bra (Already has rock chip)thinking abt the Fog lamps but looking at the forum seems like it's a pain to do and coming from Bmw 535 want to stay away from pain from sometime. Also it's missing the F badge on the trunk have ordered oem and wanna know what is the exact location on the trunk.
View 7 Replies
I have just managed to remove my scratched steering wheel badge on my phaeton. It comprises two parts, the metal holder and a thin metal badge which is glued on. (if you look closely you should be able to see the edge of the badge)
I used a small screwdriver to deeply score the badge many times, then once through, the badge can be prised off with a pair of plyers!! I the cleaned the glue from the surface using nail polish remover and am now awaiting a 50mm stick on VW badge from eBay. Hope it looks good..
View 8 Replies
i know the 05-07 grille badge is 9 inch the 08-11 is also 9 inch and the 11 up is 12 inch
wondered if there was a ford oval that was between the 9 and the 12 inch
View 1 Replies
I need to remove the front headlight in order to repair it. Must I remove the bumper? How?
View 16 Replies
As owner of the Phaeton diesel v6, 3.0D... I need to remove the bumper in order to have full access to the headlight unit.
View 4 Replies
Is it possible to remove the front passenger seat? Is it just a few bolts? I have to transport my bicycle and it has an extremely long wheelbase (its a recumbent). I basically need the full length of the interior compartment to accommodate it.
View 12 Replies
I was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 Replies
how can i take off the front plastic plate on the front of my touareg
View 4 Replies
Putting in my amp/sub this Friday. I was told to run wires under sills, not through the center console.
So I don't goof up and bust/damage any clips or pins , what is the correct way to remove the sills, both f & r, drivers side?
View 2 Replies
Exactly how do you remove the cover (facia) below the front of the front seat so the battery can be removed. To my knowledge no one has spelled this out on this board.
View 7 Replies
I do not know how to remove the front right headlight on my 1991 Honda Accord.
View 4 Replies
I am in middle of "trying to" change the wheel bearing and I have the hub out but I can't figure out how this bearing needs to come out.
I have done it on MKIV Golf and like most other cars there is a C clip, but i can't see a clip in this knuckle.
Is this thing press fit in there without a clip? I have seen a guide for MKIV Jetta and people say Passat is almost the same, but not until I find this C clip.
View 2 Replies
I am trying to remove the front seat warmer switch. Been trying but no luck.
View 3 Replies