Golf/GTI VI :: How To Remove Front Emblem
Mar 8, 2010
Looking for a write up, is it just stuck on there like the back GTI or is it screwed in?
View 6 RepliesLooking for a write up, is it just stuck on there like the back GTI or is it screwed in?
View 6 RepliesI have the grill out, how do i get to the three tabs the emblem is attached with...
View 9 RepliesI want to plasti dip the emblem and the chrome piece on my hood and around my grill. what is the best way to do it? How can i remove it so i can easily paint it?
View 4 RepliesI tried searching and I was not able to find how to remove the rear emblem.
View 9 RepliesWant to paint color of car black stealth look! Painting everything black door & rear bumper trim black.
View 2 RepliesI've searched high and low, but cannot find a product/way to replace my Front and back emblem on my 2014 RX450H - it's not like the Rx350 where you can paint it black or spray it (because the 450H emblem is under a thick clear plastic). Plus the 450h emblems are a little bigger than the 350 counterpart so you can't just switch it out either.
Again- the 450H has a plastic cover over the actual emblem- it comes in one piece. I would love to change it (smoke/black it out) I can't stand the blue-hue the hybrid cars FORCES you to have.
How to remove the front emblem on a golf? I removed the four screws and tried pulling out the grill but nothing. I dont want to break any snaps so looking for pics. Also is there a need to remove the grill to get the badge out?
View 1 RepliesI have took off the screws in below pictures. But the bumper seems still stick on the car body. Any screws are missing? Or other issue?
View 4 RepliesI am looking to black out my front and rear Toyota emblem/badges. I would like to get matte black. I've seen a few 2012 Camry's with it, but am not having any luck finding them online.
View 14 RepliesI am having trouble finding the correct part number for the Ford emblem that goes on the front grill on an 09 F150 lariat crew cab. My father in law asked me to order one since his is faded badly. What is the correct part number?
View 1 RepliesI am talking about the aluminum part....
View 4 RepliesMy R doesn't have a hatch emblem. I have the emblem, and I want to put it on. But how do I know where to put it?
View 8 RepliesCan't find out how to remove the driver side front bumper grille. I could not see any screws or tabs holding it in. I'm hoping it can be removed without taking off the entire front bumper.
View 5 RepliesJust like our fleet of 06' F-150's, my emblem on my 2011 F250 is starting to peel and bubble up on the front grill. Every 06' had their rear and front emblems replaced close to 3 times until we just gave up and lived with it. I thought Ford fixed this problem? Going to the dealer tomorrow to get a warranty repair.
View 14 RepliesI need to replace the center mesh grill on the front bumper. Is there anything I need to be careful with or watch out for. when I pull on the old grill or when I push the new one back into place? Does it come out easily or is it tricky?
View 4 RepliesI need to remove the front headlight in order to repair it. Must I remove the bumper? How?
View 16 RepliesAs owner of the Phaeton diesel v6, 3.0D... I need to remove the bumper in order to have full access to the headlight unit.
View 4 RepliesIs it possible to remove the front passenger seat? Is it just a few bolts? I have to transport my bicycle and it has an extremely long wheelbase (its a recumbent). I basically need the full length of the interior compartment to accommodate it.
View 12 RepliesI was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 Replieshow can i take off the front plastic plate on the front of my touareg
View 4 RepliesPutting in my amp/sub this Friday. I was told to run wires under sills, not through the center console.
So I don't goof up and bust/damage any clips or pins , what is the correct way to remove the sills, both f & r, drivers side?