Is there any way to completely disable traction and stability control. I know pushing the button is supposed to disable stability control but I was told that you can't actually completely disable it.
View 5 RepliesIt is winter. The ice on the lake is almost thick enough to drive onto it. So, I wanna play.
Those of you out there who have gone out on a frozen lake?
I want to get the truck sliding so that I can see what it will take to get it back under control.
As long as there is no pressure cracks, how likely am I to roll it? I do not plan to get it higher than 40km/hr. Is that too fast?
How do I completely disable the traction control? Is there a way to disable the ABS?
I will be playing in 2x4, 4high and 4 low.
Yes, I do have insurance that if I go through the lake, they pull me out.
Evertime I turn left the brake light, traction control and stability control lights come on and the car starts dinging. Mechanic says it could be front wheel bearings because they are tied to the ABS system??? But I have been seeing alot about wheel speed sensors?
Second, everytime I brake suddenly, a cloud of smoke comes from the front end and there is a burning oil smell. The oil is fine and no leaks. Again mechanic says it could be a cracked CV boot throwing grease?
Lastly everytime I put in reverse or when I lightly put pressure on the brakes when driving I get this noise like a humming (errrrrrr) noise. Its not the grinding/squealing noise you would get when brake pads needs replaced. I only have 60k miles on this.
I cant find any info on this for the B6..
Is it just a standard LSD?
Ok well I am not much for roasting the tires anymore but like to wheel a little, but how in the heck do I turn off the traction and/or stability control? Never done it before.
View 4 RepliesAssociated symptoms include no power steering, complete lack/absence of stability and traction control. This has happened to me a few times in the past, but has never stayed in after multiple start ups (and other remedial action). 2-3 times it's happened on startup, and cleared after a restart, one time while driving, and cleared on its own. This is going on the list of issues with less than 7k on the car.... 2012 3.6 sel
View 17 RepliesI own a 2008 Suzuki XL7, purchased new from the dealership in 2008. Recently, the vehicle sounds a dinging alarm inside the cab of the vehicle & the dash lights up w/ "Service Traction Control" & "Service Stability Control" warnings. These warnings appear sporadically - not at startup - but sporadically while I am driving, and in no specific time pattern. We have had the brakes checked, diagnostics run at a mechanic shop, purchased new tires, and changed the fuses. We have googled Suzuki websites & found that other people are having this problem, but no one seems to have a solution.
View 1 RepliesI have a 2009 Pontiac Vibe with 43,000 miles. Recently the check engine light, the vehicle stability control light and the traction control system light all came on simultaneously. Since then they have all come on or all gone off several times. Usually once they come on, they stay on for the remainder of the trip. Sometimes they will still be on when I next start the car, sometimes they will be off. What might be causing this?
View 17 RepliesAfter going through the Prius v manual, I just realized that there is no way to turn off traction control. Now, 99.9 % of the time, traction control is a good thing. But sometimes, it is useful to be able to turn it off.
View 15 RepliesI'm looking into being able to turn off my traction control off as need be is their a fuse I can pull or a simply diy to turn it off by a switch in the cab...
View 5 RepliesI have just purchased a 2013 Passat, SEL Premium. In my GTI, I could disable traction control with the "ESR off" button. I do not see anything like that on the display. Is this a menu function somewhere? While I do not need it all the time, when we do get deep snow, the traction control needs to be disabled.
View 2 RepliesDoes traction control can be disabled on the C? I will be driving this car through the New England winter/ and just wanted to prepare myself for the worst possible scenario (ie not being able to make it up a slippery inclined road). I will be getting a set of winter tires which should work with the tire slip but doubt that will save me in all situations. I also was wondering how aggressive the traction control is compared to a GEN II or GEN III Prius. I was reading that the GEN III allowed more wheel slip compared to the GEN II which made it more drivable in the winter.
How to disable the stability/traction control.
These steps must be completed within 60 seconds.
Step 1: Set the ignition switch to ON, not READY. To do this press the power button two times, without pressing the brake pedal.
Step 2: While the transmission is still in park (P), fully press the gas pedal two times.
Step 3: Apply the parking brake to ensure that the vehicle will not move during this step. Put the transmission in neutral (N) and fully press the gas pedal two times.
Step 4: Put the transmission back in park (P) and fully press the gas pedal two times. The car will display "!Car!" in the upper left corner of the LCD screen.
How to disable traction control system on Prius 2002 ?
View 1 Replies2013 Prius is there any way to disable the traction control. Trying the push start button 2 times and push gas pedal 2 times etc. method wont work on this year.
View 6 RepliesHere is the deal I have an autocross event coming up this weekend, and a 2010 corolla with traction control. How can I disable the traction control for more than just a few seconds? It is strange that when I hit the button after about 15 seconds the traction control comes back on.
View 12 RepliesJust put new wheels, tires on my car...19's with tires 235/35/19, soon as i put them on and took it out to see any issues, the driver side rear wheel/tire making some horrible squeaking noise that just kept getting worse as i just drove the car around the block..ABS light and traction control both came on and stayed on as well (doesn't sound good, expensive) my H20 is ruined it seems.
View 1 RepliesRan the vag com on her and it says "AWD control module J492 no signal/no communication" I'm pretty sure I'm just driving around in fwd only right now.
View 24 RepliesTraction control light can't seem to find out why its on no fault codes ran vag com nothing after I swapped transmissions it came on and ever since its been on.
View 16 RepliesMy traction control light came on today, and it's just...on. I am not sure what that could be. I checked to make sure the maf was on snug, Other than that I'm at a loss. Scanned it and found no codes relating. Just the dumb convenience center module.
View 19 RepliesYesterday, my vehicle stability control light came on along with the ABS symbol. I stopped the car and turned it back on and the car would not come out of Park.
I restarted the car and was able to shift into drive but, both symbols remained and the MFD showed no regenerative braking and the brakes were clearly mechanical only by sound and feel.
I think I took a rather short trip with the parking brake partially engaged, I was talking to my son who was home for the weekend.
I set and released it several times with no results. I finally parked the car, set the brake and checked for codes in my Scangauge-none. But, I did a "clear codes" anyhow.
I've only driven home yesterday and this morning to work. So far, nothing unusual, I have my fingers and stubby little toes crossed.
I got in the car (2010 Prius IV, 170k miles) this a.m and the brake, ABS, & stability/traction control lights all just lit-up. Can run & drives just fine.
View 19 Replies