Golf/GTI VI :: ESP / ABS Error From Lowering A Car?
Feb 10, 2011
Car is at the dealership now and they said that the sensor is being stretched out from being too low. I'm only dropped on a h&r sport cup kit, nothing drastic.
View 24 Replies
Feb 10, 2011
Advertisement
Golf/GTI VI :: Wheel Rubbing While Lowering?
I want to buy some 18' OZ Ultraleggeras but they have a ET45 instead of the recomended 50. Will I have any rubbing issues, especially if I lower it?
View 21 RepliesGolf V R32 :: Headlight Adjustments After Lowering?
I was thinking of replacing my existing springs with a set of OEM European springs from oempl.us. Once it's lowered, do the headlights aiming need to be adjusted? If so, how do I do that?
View 5 RepliesGolf IV / Jetta IV :: 2004 GLS 1.8t - Lowering Spring
My wife has a 2004 jetta gls 1.8t we just got some stock 18" bbs gli wheels . she wants to lower it some. Not really wanting to spend the money for coil overs... she will never adjust them and shes not racing it... just want it to look better. How much to lower it...
View 9 RepliesGolf/GTI VI :: Correct Control Arm Angles After Lowering?
I haven't lowered my GTI yet but would like to at some point in the semi near future (house comes first), but I want to keep my suspension geometry right when I do it. I like the mostly flush look, but I like to drive my car and don't want to compromise any handling of the car. Unfortunately with lowering the car, the front control arm angles get a bit out of whack and will adversely affect the handling of the car. Is there anything that can be done or any products out there on the market that will bring the front control arms back to a flat or slightly angled down position once lowered?
I know that on the MKIV platform a lot of people would go with a drop spindle, but I haven't found any good aftermarket or reasonable OEM solutions from other cars without having to replace a lot of parts. I seem to remember something about the TTRS knuckle/spindle fitting on the GTI, but it requires quite a bit of part swap and adds up in complexity and cost pretty quickly.
Golf/GTI VI :: Headlight Dimmed Downward After Lowering The Car?
Yesterday, I installed H&R Sport Springs and then Last night, I notice my HID headlight is dimmed downward to the ground. Do I have to use VAGCOM to make the adjustment?
View 24 RepliesGolf IV R32 :: Front Swaybar Hitting Axle After Lowering
I just installed some Neuspeed sport springs with Koni sport shocks on my .:R and it appears like my swaybar is knocking against my front axle on the driver side.
Now, I read somewhere that is not supposed to be possible, but I can see the marks on the axle. Also, the swaybar link looks like it is twisted quite a bit with the new struts. And, when I look at them with the car on the ground, the distance between the swaybar and the axle looks to be at least 2 inches.
Do I need to center the swaybar? Maybe my control arm bushings are worn out really bad? The camber on the front of my car is -1.4 on both sides.
Golf VI R :: Lowering Springs Installation Without Removing Axles?
Looking to get a set of VWracing springs but wondering if there is a way to pull the front struts without having to pull the axles out?
View 24 RepliesGolf/GTI VI :: Clunking Noise After Installing Lowering Springs
So I installed the DG springs today, and it should've been a simple install. Well once all was said and done I took it for a test drive. Every time I go over a bump I hear a loud clunking noise, like somethings loose. What it could be? I'm pretty sure I tightened everything.
View 10 RepliesGolf VI R :: Sway Bar Rubbing The Axle Under Heavy Compression After Lowering?
I lowered the car on H&R sport Springs with Koni Yellows. On the front right, the sway bar is rubbing the axle under heavy compression (pot hole, sharp dip, bridge joints, etc) and is rubbing the lower control arm (opposite direction) on the driver's side... I got an alignment when I lowered it and it was "within specs"...
I put on adjustable sway bar end links and lengthened the passenger side 1/4" and shortened the drivers side 3/8". left side is slightly better but right side seems almost worse... all rubbing was minimal (barely through the paint on the cast iron parts and nearly no marks on the axle... both strut bearings are new. is it possible that it could be the alignment? Just seems odd to me that the sway bar end links need to be varied lengths to clear....
Golf/GTI VI :: 2012 - Suspension Clunk At All Speeds In A Straight Line After Lowering
Alright cliff notes are lowered my 2012 GTI on Eibach Pro Kit springs and Koni Yellows (adjustable) as a DIY driveway job and at first were OK, but 2 weeks later are clunking to the point where it sounds like its going to fall on the ground. Any road imperfection makes it clunk (from the front only).
-Clunks all the time, slow, fast, turns, straight, large or small bumps. Doesn't clunk with dips...
-Gets better when its hot outside (>70 degrees),
Golf IV / Jetta IV :: Lowering Rear Axle To Install OEM Suitcase Muffler
I am replacing the mid and rear (suitcase) mufflers on my daughter's 2001 2.0L Jetta wagon. She is not interested in anything that would be louder than stock. What I am seeing is that the rear axle needs to be dropped to remove / install the rear muffler. Can this be correct? I know I can continue to cut off parts of the old muffler but that does me no good when it comes to install the new unit.
View 2 RepliesGolf/GTI VII :: After Installation Of Lowering Spring Hearing Popping / Banging Over Large Bumps?
I installed H&R lowering springs this weekend and now the suspension is making quite a bit of noise. I've double and triple checked the installation, and this isn't my first rodeo, so I don't think anything is improperly installed.
I'm hearing popping/banging over large bumps. I do believe that the noise is most noticeable when my tires drop off into a pothole and the suspension is unloaded. I think the noise is caused by the suspension being uncompressed and then the coils of the springs either hitting themselves or hitting the top hat.
Experienced excessive noise with the H&R springs? I think my next course of action is to get some spring isolators and see if that stops the noise.
Passat (B6) :: HID Range After Lowering
I just lowered by B6 4-motion variant using H&R Sport springs (only springs, not coilovers). I was on some back roads tonight where there was no lighting besides moonlight and my HID's. I noticed that the range is severely reduced since I lowered it.
View 3 RepliesPrius C :: Alignment After Lowering?
Have lowered C, an difficulty getting it into decent alignment? Do I need to purchase a camber kit? I'm on Tanabe DF210s, which are no lower than 1.8", I believe! I'm making an appt. for this Thursday to get the alignment done. I had springs installed this past Friday but wanted to wait a few for them to settle. (I put about 800 miles a week on the car.)
Basically, I'm just looking to know whether the shop should be able to get the car within spec. without the addition of a camber kit or anything else that might be required for the alignment.
Golf/GTI VI :: MFD Says Airbag Error
So tonight I took apart my glove box and center console in hopes of relocating the TPMS button...Once I put everything back together the MFD says airbag error and when i sit in the passenger seat the airbag icon in the center console is flashing and a 2 and a X. Also the airbag icon is on the dash.
View 13 RepliesGolf/GTI VI :: Error About Low Oil Pressure
So I bought my first VW as a used car. It's a 2011 GTI and already running into some problems. During the test drive at the dealership, the problem didn't occur. The car was sold as "as-is".
So on the way home from the dealership, the car threw an error about low oil pressure (I'm not sure what the wording was exactly at this time). I drove normally. I did not hit red-line or do any hard cornering on the way home. I got freaked out so I stopped, turned engine off and checked oil level. It's at the proper level.
I looked around the engine bay but nothing was obvious. I started the car up again and the code was gone so I made it all the way home. I drove around some more and now it's showing up about every 15-20 mins. Goes away and then comes back on later. The error now is "Low oil pressure. Turn engine off immediately".
Golf VI R :: Cannot Start Due To ESP Error
I have experienced ESP error when trying to start the car. When I turn the key, the engine does not crank, instead, the ESP error shows up on MFD. I have to wait for several minutes until the EPC light is on. Then I can start the car with the ESP and EPC light off.
Here is the video: [URL] ....
From the forums, I have already had my battery replaced and still the problem persists. I take my car to local garage which cannot troubleshoot the cause. They just say it might be the relay or even the ECU. So, wonder if there is any clue?
Golf/GTI VI :: Car Won't Start - ESP Error
I was trying to install my MDI in a parking lot where I could get some space. I thought the radio fuse was inside the panel by my drivers side door. I pulled those fuses out one by one, the I realized it was under the hood. I'm not done swapping pins, but I need to drive the car and it won't start. I didn't put the radio back in. My MFI says ESP error when I turn the car on. I have a micro can with me, but it's having a hard time finding the interface.
View 4 RepliesGolf/GTI VI :: 2012 - CEL For EGR Error?
I have a 2012 Golf tdi. Got a cel after a 300 mile highway trip.
Got it scanned by dealer, came out to be p2413. Some EGR malfunction. According to service ticket, all vw did was reset my ECM. Does that sound accurate? Car has 16k miles.
Service rep mentioned that it could have something to do with my carbonio intake. True? Or BS?
So far, 100 miles later, no cel and car seems to be running fine.
Just curious if it actually could have something to do with the carbonio, or if he was just busting my balls.
Golf/GTI VI :: Getting Bulb Out Error?
I had HID's installed in my fogs (before haters jump in, it doesn't look remotely bad, and they're aimed down, so no glare), and I'm getting a bulb out error. I have a VAG, but I'm not seeing any long coding to disable error checking for the fogs. I have the error cancelling add on, but we forgot to install. Just curious if there's a VAG trick to disable that error before I rip the fogs out again.
View 1 Replies