Golf/GTI VI :: Clunking Sound When Pulling Car Into Driveway Or At Speed Bumps
Jan 30, 2014
I had to raise the car a bit to clear the apr turbo outlet pipe. Raised a little too much and was hearing a clunking sound pulling into my driveway or speedbumps, etc. Contacted HR and they said the coilovers have an operating range and to lower them a bit. So.. i have about 3/8" of thread left on both fronts and my (not so scientific measuring method) fender/ground is 24" vs 26.25 stock as measured on a stock gti on my dealer lot. I still have a ton of thread to drop the car (about 1.5") as seen in the picture below. The issue i have is what the spring looks like. It rides fine in my day to day commute so its not noticeable but looking at it, it looks collapsed??
View 13 Replies
Advertisement
I went to check out a '03 7.3 SD the other day. It didn't seem to have a lot of surge when I accelerated to freeway speeds. Kind of lazy feeling. Didn't smoke out the back though. It did have a front end clunking sound going over the parking lot speed bumps. I opened the oil fill cap while it was idling and it blew a plume of vapor/oil about 9' high like a steam engine puffing. Held my hand over it and got a oil wet palm after just a few seconds. I'm hesitant to drop any $$ on it.
View 6 Replies
So i just had installed a brand new set of bilsetin pss9. Going over bumps or pot holes at a slow speed, i get loud clunking out the back. Did not have this prior to the coilovers. Its dropped almost 3/4 of the thread. What this is? Also the shop that installed them, had put them in with out the rear upper spring plate, is that a standard install on these?
View 1 Replies
I have a clunking noise from the right front suspension when going over bumps. I've replaced the Strut bushings that were collapsed, the control arm bushings that had play and the noise is still there. There is no play in the links. There is a slight noise in the sway bar bushings when struck with a rubber mallet. I hate to keep replacing parts chasing down this noise.
View 9 Replies
I have an APR stage 1+, HPPF, Carbonio intake. First thing EVERY morning my car will give a noticeable hesitation when pulling out of my driveway. After this 1 time event, the car rides perfectly. It happened every day. I was told this is gas pooling or some such issue.
View 11 Replies
Clunk in the front end when going over speed bumps? That is the only time I ever get it, never on bumpy roads or anything like that just at speed bumps. It seems to be louder on the drivers side but I am pretty sure its on both sides. I never noticed it until a couple speed bumps were installed along my normal route, but that could be because maybe I never drove over them previously?
View 3 Replies
After doing reading I think my issue might be suspension related. Whenever I engage the clutch at a normal rate I get a rubbing/clunking noise coming from the driver side. I can feel it thru the gas pedal and it sounds like a card in a bicycles spokes. If I engage the clutch extremely lightly I don't get the noise at all. This only happened AFTER I had my H&R Sport Springs installed. Could it be a strut mount? Engine Mount? The car only has 4500 miles on it. I'm extremely confused.
View 4 Replies
What this clunk could be?? in my truck in signature, 2003 F350 CCLB 4x4, 4" lift. its only low speed, on very light bumps. really does it when the truck flexes, like turning into an elevated driveway or something. driving me absolutely insane the last few months. it sounds like its coming from right under my feet
-removed front shocks and drove
-removed front sway bar and drove
-front wheel bearings are new and tight
-front leaf spring, rear upper shackle bushings are new (thought that was problem..no)
-front leaf springs and bushings are new, although i suppose its possible to have a bad bushing already
-removed traction bars and drove
-removed front track bar and drove, but going to try this again.
-all cab mounts look ok
-took out cab mount under drivers foot, and cut down the metal piece a little...read about it on another thread on here. no change
-made sure my gooseneck ball couldn't rattle
-steering box is new...thought that was it
-steering shaft is solid
-transmission mount bushing and crossmember feel tight
-lubed front driveshaft slip joint and it doesn't have any u joint play
-rear shocks seem ok but haven't removed them yet
-fuel tank is solid
-rear driveshaft has new carrier bearing and u joints, all is tight
-exhaust is not hitting anything
-u bolts all tight, spring bolts are tight
As you can see, I've been through damn near everything. my only thoughts right now is a possible bad cab bushing, or bad leaf spring bushing...as it sounds like its right under my feet. and when you flex the truck, it makes all sort of popping and clunking noises. i had the truck on my buddies lift and we went under it for an hour yesterday looking around with no luck. only thing i found was a bad traction bar bushing but we removed them and it still does it..
Most noticeable at the end of the video...it sounds exactly like a bad sway bar bushing but that's not it...
Front end clunk - YouTube ....
View 14 Replies
I have a 2001 Escape XLT, when driving thru a parking lot or otherwise at slow speed and hitting bumps, I can hear a clunking sound from the right front tire. Its especially bad if I drive over cobblestone or on a dirt road. Could this be the CV joint? Ball Joint? How can I tell what it is?
View 4 Replies
'01 Taurus with an occasional rattle/clunking sound coming from the front end when going over bumps. Took it to the local shopping center auto. service dept. (probably 1st mistake I know) They say the only thing they could find was the RH CV boot was bad and was probably the source of the noise. Doesn't sound right to me since the boot is rubber and what I hear is more of a metal sound..what I was thinking possibly a suspension link or tie rod end. I know what a bad cv JOINT sounds like and it's nothing like this. Now if the CV boot is bad I don't mind to replace it, but I don't want to spend the money if it is not going to solve the problem. I've never heard of a boot making noise before.
View 2 Replies
Aside from the clutch and gear changing noise, recently I've been noticing something that sounds almost like a rattle when going over bumps, say a series of filled potholes on a highway where they just slightly bump to move your wheel around, it's not that deep thumping you would expect to hear but it sounds like something is loose in terms of the suspension.
Happens on the front and seems like its coming from both sides. To me it sort of sounds like they forgot to tighten something up when they removed the shipping "blocks"/spacers, but I am not exactly sure what to check. I really do not want to visit the dealership at only 600 miles on the clock ...
View 5 Replies
There is a clunking noise coming from the rear of the car. Not a metal on metal sound. Sounds like its more on the passengers side. I replaced the swaybar linkage ends since they were a little loose and thought it was that. Nope...I have H&R coilovers, they are about 5 years old. Can't imagine they be shot this soon. Had someone drive my car while i was behind the R and the rear wheels aren't dancing at all, a common sign of a blown shock. Push down on the car, shocks still respond like they did from day one. I've put the car up on a lift, both sitting and wheels dangling. With the wheels dangling, I grabbed onto the shocks to see if there was any play in the upper shock mounts, solid. Looked under the whole car for loose plastic covers. Can not see anything loose. I made sure everything inside the hatch, including the battery is sitting snug.
The clunk happens over bumps, with or without the brakes on and is loud enough that if the radio is on, it can still be heard.
View 3 Replies
Yesterday, i bumped into the curb as I got home, and today when I went to work the car is pulling very hard to the right, and makes a squeeling sound when I get up to speed. The ball joint looks bad, but can that cause this problem?
View 4 Replies
Went to leave the grocery store and as im pulling out I can't get out of 4th gear. After I got home I was able to work it into neutral and I can obtain 2nd, 4th and reverse but the throws aren't straight and it won't go into another gear unless you would force it. There is virtually no side to side travel in the shifter. What could this be? I drive my car hard but I've never missed a shift or grinded the clutch and I wasn't beating on it before it happened.
View 13 Replies
I am experiencing a bad clunking noise when going over bumps. Its comming from the passenger rear and I am assuming the springs collapsed. How can i tell for sure? The car is sitting a little lower on the corner. Is it bad to drive the car with the spring in this condition?
View 8 Replies
Just did a brake job on my IS-F. Everything went smoothly for 50 miles, then as I'm pulling into the driveway I hear a horrible grinding from the front.
Disassembled everything this morning and it looks like the pads are in constant contact with the rotor. Is there a set screw I missed? When I did the brake job, I retracted the pistons slightly with a C-clamp, and did not bleed the brakes. What am I missing?
View 6 Replies
I've got a 2009 Azera with 58k. When I'm backing out of the driveway, I start to hear a low squeaking noise right as I'm turning the wheel. It happens right before I get a squeak I recognize as the breaks, so I know it is not that. It only happens when the engine is cold and typically the first or second time I try to turn at low speeds when I'm driving the car. I've had it also happen when I'm pulling out of a parking space at the garage at work.
View 2 Replies
I have an early production 2008 2.0T 6MT. The car has just over 2000 miles on the clock. I noticed that early in the morning, when it's cold, pulling out of my driveway, I hear a clunk from the front end. It doesn't always happen. Also, on the highway, the car feels like it wanders left and right, certainly more than my old B5.5 did, and in general it pulls to the left and the steering wheel sits slightly to the right. I found the following TSB on this site: [URL] .... My question is, this TSB doesn't mention anywhere that an alignment should be performed as part of the service. Should that be done? I'm going to take it to the dealer tomorrow.
View 4 Replies
Do we suffer from this clunking noise as well? I know I have rattles and things that make noise over bumps and humps in the road. But is this what I hear?
[URL] .....
View 5 Replies
My '05 Elantra GT has done some weird stuff in the last few days: Losing complete power for a second when pulling out of the driveway two days ago, flickering headlights constantly, complete loss of power while trying to start last night, then suddenly everything started right up. Today, it lost power 2 times in about 10 seconds while I was sitting at a light on the way to work, but the motor never shut all the way off so it just restarted. Today at lunch, I turned the key and everything went dark. I pressed the brake pedal, the dash clock came on and then I was able to start the car. Bad Diode in alternator?
View 2 Replies
My Phaeton has recently developed a single clunking sound that occurs at low speed, either when braking, or when turning the steering wheel towards the right about 90. The clunk can be felt at the drivers footwell area too.
All four upper control arm bushings were replaced a few months ago and the antiroll bar links are pretty new too.
I have not identified exactly where the noise is coming from, but by placing my hand on all suspension components it seems that the clunk is most felt at the front left rear lower arm. Hence I am wondering if the bushing or the whole arm may need replacement.
View 9 Replies
