Golf/GTI VI :: Chirp / Squeak Under Hood - Bad Serpentine Belt Tensioner?
May 1, 2016
So my mk6 developed what initially sounded initially like a bad serpentine belt tensioner. Only under anything more than load, and sounded like a bird chattering under the hood. Got outside today, fired car up, watched tensioner and it sat there steady as a rail. The noise is coming from the opposite side of the engine. Not really mechanical/metallic at all and tracks under load with the RPMs. Why i initially thought what i did. Not I'm sort of baffled.
View 3 Replies
Advertisement
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
View 4 Replies
How to replace the belt tensioner. It's not putting out enough tension when the engine is cold. So, the belt makes chirping noise for couple of minutes idling when cold with AC on.
I had the AC inspected and everything checks out according to my mechanic.
He believes that the issue is with the tensioner since I had recently had replaced the serpentine belt.
View 6 Replies
I had my timing chain tensioner replaced. When they do this do they touch the serpentine belt tensioner? 1000 miles after the timing replaced, my serpentine belt shredded and they say I need a new serpentine belt tensioner. Does this sound correct?
View 3 Replies
After finally identifying a bad serpentine belt tensioner for being the the culprit for my engine noises, my mechanic said that the 'thru-bolt' is siezed. Since the replacement job was at my budget limit he said he doesnt want to get into it in fear that he has to brake the bolt and drill it out (requiring 2-3x more labor cost according to him).
If this is the case, and the 'thru-bolt' is seized, is this in any way something I can make a an effort to tackle? I have a jack and jack stands, and plenty of time.
View 3 Replies
I installed a new serpentine belt tensioner into my 1994 Chevy Suburban C1500. It vibrated as much as the old one did, so I assumed that a bit of vibration is normal and forgot about it. Well, after recently looking at some instructional videos, I am now under the impression that any vibration in the tensioner is bad. Here is what is going on -- [UrL] .... Is it OK or should I get another new tensioner?
View 4 Replies
2002 Camry 4 cyl. Can the idler pulley alone be replaced on the serpentine belt tensioner? I noticed a very slight side to side play when I had the belt off. No noise from it. When I looked at rock auto, they sell the whole bracket with the pulley.
View 2 Replies
My tensioner pulley is making noise.I replaced the rear idler pulley (can't get to the front one), but still have the noise. Mention a DIY for replacing the tensioner pulley bearing. A part number for the bearing?
View 2 Replies
I have a problem with my 1997 aerostar. There is a squeaking noise that gets more significant when I turn. I am pretty sure this is the drive belt as the power steering fluid is fine. Should I attempt to replace the belt tensioner and if so is it just the pulley that needs replacing or the whole tensioner. I am by no means a mechanic but can figure most things out.
View 5 Replies
Well, started to get belt squeak during cold starts. The idler pulley was changed many miles ago for same issue, but it seems to be starting up again. There are NO tutorials for serpentine belt replacement on this gen of RX.
View 14 Replies
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
View 9 Replies
The serpentine belt starting squeaking on cold and damp mornings about 18 months ago at about 60K. I replaced it with a Dayco belt, and the noise went away for about 6 months. When the weather turned cold last winter, the noise came back. So I changed the tensioner with both idler pulleys right about when the weather warmed up, and it was fine all summer. Now that it has gotten cold again, the squeak is back yet again and as before it goes away when the car warms up. I know it is the serpentine belt because when I spray it with water the noise immediately stops. I checked all the pulleys with the belt off and when I spin them I hear no noise. Is there something else it could be?
View 1 Replies
Been trying to isolate my noisy serpentine belt. Had the belt off and spun everything, only thing I found that made any noise was the alternator. It had a nice churp like a bearing was on its way out in it. So I replaced that figuring my squeak was going to go away. No such luck. Listening to it again while it was idling, I crawled underneath. Almost seems like the churping noise is coming from the Crank Pulley. Is there a bearing on this pulley that goes bad?
View 13 Replies
So last night I washed the R, pulled it out of the garage to squeegee the floor, and brought it back in. Then I heard this weird squeak chirp sound... tracked it to of all places, the engine compartment of my R! Thought I had a mouse in there.. didn't find anything.
So tonight I took the wife out for supper. Got home, parked the R, same sound, but only faster! Here's a video of the sound, sounds like it's coming from the engine bay for sure. Weird, right? I did some googling and didn't find anything else. Seems like it must slow down when it's colder. Because last night it was once every 30 seconds or so.
View 17 Replies
Ever since i bought my .:R (3weeks ago) there has been this 'squeak' or 'chirp' sound whenever i hit a bump or rough road. Car only has 22k miles on it so this is way too early for any noises to be coming up. I've spoken to a few friends and they think it might be the bushings or my suspension was installed incorrectly. What it may be?
View 20 Replies
So I was trying to track down this squeak noise and I removed the drivers side seat belt but now the belt will not retract? It's stuck like this, is there a manual release? Buying another one is not a option right now. And I have to drive the car tomorrow morning.
View 1 Replies
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 Replies
So the PO of my Jetta had the alternator replaced...awesome! One less job for me to do. My serpentine belt went out yesterday so I chalked it up to being old. When I got the new belt on it kept slipping off, I pulled the tensioner pulley off and saw that the wheel was all chewed up, I look down and saw that whoever put in the alternator didn't bother to screw in the bolt all the way and it chewed up the belt and everything else.
View 1 Replies
My ball bearing on the tensioner seized and broke the belt. Does that happen all the time?? My car is a CP and right now it's only 36k miles..
View 24 Replies
So this car has only 50k miles. It was really cold in the sierra (around 20F) and the car started making a squeaking sound. I assumed it was just belt warming up, but when I opened the hood later, I saw shredded plastic. No CEL's! Seems to run smooth.
Where this came from? Is it part of the serpentine belt system?
View 20 Replies
I have an 03 vr and my serpentine belt squeals when I first start the car up and after it warms up it will go away at idle but starts to squeal again when i accelerate. I can not seem to find what is causing this. After I start it and sprites a little water on it near the power steering pulley the squeal will disappear then come right back. I've tried new belt new tensioner and new power steering pulley. What else I could try or look for...
View 1 Replies
