I am trying to figure out the best way to wire something from the ash tray area to the fuse box. Removing the trim is simple enough by the steering wheel, but I can't find how to remove the trim that surrounds the center console on the driver's side. Any pointers?
View 3 RepliesOne of the brackets that connects the tray inside the center console is broken. I wanted to order the part but I only see the inside tray available to buy, not the brackets. I was wondering if I ordered the tray, will the brackets come with it? I don't want to order the tray and then it turns out no brackets, then I'll be stuck with an extra tray. The closest part number I see on Sewell is Part # 58801E.
View 2 RepliesHow do you remove the shifter box from the center console for the 5 speed mk6? how do you drop it out of the car?
View 1 RepliesThe radio trim/bezels around the center console and down to the shifter tend to be noisy when its hot outside and the car driven over rough roads. How to insulate these radio bezels with felt or some kind of insulation so the noise is dampened? I think any rough road tends to make them creak and the hooks tend to rub against the plastic..
View 5 Repliesi just picked up a Black 2010 camry le yesterday, 20K Miles for 15$.Tints are getting done today, spoiler ordered, window rain guards ordered, next is fog lights.. are our cars pre-wired for fog lights or no? can i just get a fog lights from ebay and install them?URL....also does the inserts in the bumper just pop-out? no screws right?
View 1 RepliesHow to remove the overhead center console? I have two false buttons - one on each side of the homelink buttons. Someone pushed on one of them and it popped up inside the console. I've pulled pretty strongly on the console and it comes down about a half inch, and I can see some clips inside holding it, but can't seem to pull it far enough down to get access. I don't want to break the console in half...
View 1 RepliesI am trying to remove the center console in my 1996 explorer limited 4x4 4.0 liter v-6 . Is there some type of trick or hidden fasteners? I am trying to replace the heater core.
View 2 RepliesI have an 09 SE, In the center area under the radio I had a access card slide over the open bottom door into the abyss where I lost a tire gauge and who knows what else lurks in there. It was supposed to go in the top open area but the person just put it on the open door and it slid back and fell.
How to remove the side panels that run from the console in the center to under the dash? I need to access the area under the dash below the 2 storage areas.
I am assuming you take the screws out on the side and possibly pop the shift indicator panel out and lift the console off? Seems a little overkill unless there is an easier way. I really don't want to experiment and break anything.
How to remove the console center right under the radio head unit. I could not find any screws. But it did not pop out if I pull it.
View 2 RepliesJust picked up my 2012 GTI this morning and noticed the little door on the console storage tray (under the a/c controls) wont stay closed. Any tricks I should know about to close it? Or should I just not worry about it and leave it open....
View 4 RepliesI have a camry se and I am currently adding accent lighting to my car. I am trying to take the area around the shifter and the cupholders out so I can hide some wires and mount the led lights controller. How to get this out?
View 4 RepliesI need to do various jobs concerning my center console (I need to change ashtray bulb!!). How to remove it, I've been told to start from the back (removing rear ashtray and cupholder).
View 2 RepliesI'm working on replacing my center console with a wooden one. I'm having trouble getting the center box (under the arm rest) removed; I found the 4 screws in it but I'm having trouble getting the cigarette lighter / power adapter out. The outlet doesn't seem to push forward like, say, the one next to the shifter lever. Nor does it seem to unscrew. Am I missing something obvious?
View 3 RepliesI am wanting to take off the center console lid to recover it. The only way I see to remove just the lid from the truck is to hit the rod out that is in the hinge. I was hitting pretty hard with a punch and it wasn't moving. I don't really want to break it so I'm asking if there is a different way or if I just need to use more force?!
View 4 RepliesHow to remove the center/floor console on my 2002 ford escape?
View 2 RepliesOn a trip I managed to pop both the fuse in the rear of my 07 B6 Variant and also the one in the rear of the center console. Checking the manual indicates a 20A fuse in both position 33 and 35 in the right hand fuse panel. Following the numbering scheme in the manual there were no fuses of that value there.
What are the correct position numbers. Also following the other threads my power outlets were switched with the ignition.
My 2010 II has two power sockets, one under the radio, and another inside the center console. The center console one does not work, whereas the other one does. I checked both the fuses, and even swapped the two fuses. I also checked several other fuses just to be sure. No fuses are blown and nothing changes by swapping the 2 power port fuses.
View 8 RepliesI'm looking to remove my stock seats and ad bucketts to my 2001 Ranger XLT. I want to use the center connsole from an explorer. Any installation tips?
View 14 RepliesI'm trying to remove the center console from my 2016 f350 lariat cc. I have both drivers and passengers seats out and all the obvious bolts removed. I'm still not able to remove the console. I know I'm likely missing just a few bolts as its really loose.
View 8 RepliesI am getting tint done soon, I had thought I read this a long time ago but I couldn't remember, does tinting our windows require interior trim removal or not?
View 11 RepliesTrying to remove all the lower trim on the dashboard. Have everything but the lower right portion on the drivers side. The carbon trim on there seems to be tucked under the upper part of the dashboard itself and I can't remove it. I assume there is one final screw under there?
I can pop it loose a bit on the left corner but feel if I force that trim something is going to break.