Golf/GTI VI :: CEL Started Flashing When Accelerating Onto Freeway
Jan 22, 2015
On my way to work this morning I was accelerating onto the freeway when my CEL started flashing then eventually went off, and my EPC light was left on. Definitely idling rough, feels like a misfire. When I got to work turned the car off and back on, still rough and the cell flashed again then stayed solid, EPC light also on.
Based on what little research I've done so far it looks and sounds like a misfire. I have my scanner to double check, but it is at home. Can I baby it home 10-15 miles on the freeway? It seems to drive "ok" above about 2.5k, rougher below that. 2012 GTI APR stage 1 about 43k on the clock.
View 2 Replies
Advertisement
Today after driving my roadtrip to work my car started surging! It happened leaving the light after i had gotten of the exit! Around 5500-6000 rpms and the engine light came on and started flashing. This went on for about 10 sec then the engine light went off and no more surging. Car had a half tank of gas also. Just a note i also have EVOMS intake.
View 8 Replies
So I get in the car to drive back home, and after i start it wont engage gear, PRNDS flashing, cant get the key out, total drama. Called the dealer. I will tow it back to the origin where it came from. What it is. Shift solenoid failure... But f..ck knows with these things. It only took me 4589785115 times to get the key out...
View 18 Replies
2000 VW GOLF 2.0L, manual, ~190k miles
Driving down the highway my CEL started flashing and the engine power dropped at the same time. I drove two miles to my destination and the idle was very rough and the power was still very low. The codes were P0300, 0301 and 0304.
The coil was replaced about 2 years ago. The plugs have never been replaced. About 2 weeks ago I had a solid CEL with the codes P1255 and P0422... I purchased a new ECT Sensor but did not yet make time to install it.
Could everything be related to the ECT? Or do you think there are multiple issues?
View 5 Replies
So I put in an MFA cluster a couple months ago and now all of a sudden the other day it started flashing STOP motor oil pressure low turn off car. It happened twice right in a row. I took the car to my local firestone changed the oil and pulled out. Five mins later it did it again. It only seams to go off when my rpms are really low in second or third gear. I'm guessing it's a bad sensor cause my oil level is fine.
View 10 Replies
I just bought a 2007 Prius a couple of days ago and noticed on my drive home the first day after purchase that the A/C got hot when I was accelerating onto the freeway and remained hot for a couple of minutes after that. I turned it off then turned it back on, and it blew cold air for a couple of minutes, then settled on a "cool-but-not-cold" middle ground. When I test drove the vehicle, I ran the A/C, but since it wasn't overly warm, I didn't notice that the car struggles to reach "cold" and mostly blows only "cool" air.
View 2 Replies
Recently I noticed my car vibrates to left and right when I hit the pedal and the speed is around 40mph and above. The car runs smooth if I maintain the speed.The car has 176K and running quite good and I am about to have the timing belt service.I am just curious what could cause this: timing belt? fuel filter? The car is 2001 acura TL so it has front wheel drive.
View 15 Replies
So, lately I've noticed a slight fluttering sound in my '08 GS460 when accelerating on the freeway or up a slight incline. It'll kick in around 2,000-4,000 RPM, and it almost sounds like it's coming from right underneath the center console. I did have an exhaust system installed, then uninstalled, so maybe it's something the shop did, but can't be positive whether or not it was there before (always drive with my music on pretty loud).
View 4 Replies
I purchased a ES300h in March 2013. Starting end of September I noticed a rattle (pebbles in a tin can tumbling sound) when I went up a slight grade, accelerating from a stop, or accelerating after a brief coasting on the freeway. The first time at the dealer they said stop using Costco gas and use Top Tier. I used Shell and Chevron and there was a 80% improvement but the nuisance still continued, some days more and some days less, meaning when it rained it poured.
On the third visit to the dealer, with two specialists on a ride along of course it does not make that noise, but left it there for them to find the continued problem and they conceded it is engine knock to which there is nothing out of specs with the engine AND say that this is normal. I have never had a car do this, maybe specific to hybrids? The service advisor goes on to tell me that they filled my tank with 91 octane to stop the knock, BUT, the manual says use 87!!!
Some say this can lead to engine damage, some say only blown gasket, the dealer says no problem! A friend of mine has the same car and has no issues.
View 14 Replies
I have a 2011 Toyota tacoma with 35k miles. Yesterday while driving at about 70-75mph on the freeway with no warning the vehicle shut down and the engine light came on. It made a clunk about the the time it shut off, it wasn't very loud but I could feel it. I'n not sure if that noise was just the vehicle powering down or transmission kicking from the change in torque? I pulled off the freeway, there were no fluids leaking, serpentine belt was in place. The truck will turn over but not start. The check engine light flashes rapidly.
View 1 Replies
I have a 97 escort that was running great after a lot of maintenance work and then on the freeway it started to loose power. I pulled it over and it died. It would not restart for about 15 mins then it did. Ran really rough, mad some noises, I got it home and now it won't restart at all. It is not the battery or starter. Is it possible a bad EGR valve could cause it to do this? About a month before this happened I replaced all plugs and wires, coil, fuel filter, battery, oil change and O2 sensor.
View 2 Replies
Why I am smelling coolant? I have a 2004 6.0 SD.It generally happens when accelerating up to freeway speeds or passing cars, Medium to hard acceleration and the smell is strong and will go away after a few min. The obvious thing is to check for a leak but I haven’t seen any.
View 14 Replies
2000 Ford Excursion, 7.3 PS with 210,000 miles. I am on I40 at a truckstop. I was rolling down the freeway last night when the truck started bucking. I pulled of the freeway and here came a thunderstorm. I waited til this morning to check for codes cheap scanner. I pulled a code P1211. I waited for NAPA to open so I could take it in the shorts. I bought a fuel filter and an ICP sensor. After changing them out, the truck runs then starts missing. My battery is about to die so I will finish post shortly.
View 14 Replies
So today i was pulling into traffic from a driveway. As i merged in I noticed my Traction Control light flashing for like 3 seconds then it went off.
View 9 Replies
So, a couple days ago, my car started to shudder a little bit and the check engine came on and started flashing. I pulled over and restarted it and it came back but then it went away. I tried to take it to Auto Zone the other day but for some reason my car wont communicate with their diagnostic computer. I read that its probably the coil packs but I want to be sure before I spend the money. I changed the spark plugs which were in desperate need of being replaced and it went away for a day and the CEL went off but it just came back today. I'm gonna try a different auto parts stores diagnostic computer before I give up on checking that.
View 4 Replies
Yesterday while driving my wifes check engine light came on and started flashing so she limped the car home so that i could take a look at it. I know from previous issues it was a sever cylinder misfire. I hooked up a computer to it and got codes for cylinder 1 &2 having misfires. So today i went and bought new plugs and 2 new ignition coil packs. when i took out the coil pack on cylinder 1 it was broken off and the top of the plug was broken. (nothing entered the cylinder and there wasn't any noticeable oil. But when i changed cylinder2's plug it was covered in oil... i changed the plug and coil pack and cleared the codes from the computer and started it. there was some blue smoke coming out the back (lots actually) for a min or 2 then went to regular exhaust. what would cause the oil in cylinder 2 and possibly 1?
View 4 Replies
Yesterday in MN when it was -17 while on the highway around 5 pm my 96 Audi A6 started accelerating by itself. I was able to get of the highway and to a parking lot where it idled in park at about 4000 rpm's before I turned it off and let it sit for several minutes. I started it twice the second time it did not rev up to 4000, it was just normal. My question is this a sign of something terrible or just the cold messing with my old car? Should I have something specifically checked out?
View 2 Replies
My 97 Explorer 4.0 SOHC has started to bog down when I press the accelerator. It feels like their is interference with the exhaust. I has a new muffler and there are no holes in the exhaust system. When I stop at a light or in traffic, it will stall. I have to keep the RPMs at 1000 while holding the brake. There is no check engine light on. Where I should begin to look?
View 6 Replies
A couple of days ago the TPMS light started flashing on my 2004 GX. This morning I took it to a trusted tire shop. They checked each sensor, including the spare, and found they were all sending a signal. At 11 years old, and they are original as far as I know (I've owned it about 7 years), the tech said the signal may be too weak for the ECU to pick up. He didn't want to start changing sensors in the event it is an ECU issue. Not sure what to do for now, other than leave it alone. Is there a way to confirm the ECU is good? Do the scanners tell how strong the signal is?
View 14 Replies
So driving home today cel came on and vsc started flashing.
The codes I got were pretty out there
P0420 - cat converter (this one I did expect)
B0cc0 ???
C3a32 ???
U0a8e ???
B3e1f ???
I'm wondering if this was poor communications between the unichip and ecu? As for the vsc flashing, people complained about this during rain. It is currently raining. But not certain this is the issue.
View 4 Replies
Ii had drove my car about 20 miles and after i had got inside and turned it on to drive it again CEL started flashing and car was sputtering lost power and felt like it didn't want to move so I had taken it to a VW specialist and he diagnosed it and told me its my coil pack and its got a bit water inside it and I would need to replace it and he said he would charge me $300 to replace ...
So I figured if its just the coil pack I could most likely do it myself and could this be from the coil pack? and why would there be water in my spark plug? Should I replace all coil or just the one that's bad.
View 5 Replies
