Golf/GTI VI :: Airbag Light Went On After Removing Headlight Switch
May 2, 2014
I suppose it could be unrelated but yesterday i was showing my coworker how easy it was to remove the headlight switch on my 2010 golf tdi (he has an a3). I took it out of the slot, unplugged it, plugged it back in, and slid it back into place. im sure i didnt yank on the wiring harness but who knows. I went to turn on my car and now i have an airbag fault showing up for the driver seat position sensor. I looked under the seat and everything is still plugged in, along with in the little access panel where the wiring goes.
Address 15: Airbags (J234) Labels: 5K0-959-655.clb
Part No SW: 5K0 959 655 B HW: 5K0 959 655 B
Component: AirbagVW10G 021 0706
Serial number: 003C4R009H0T
Coding: 00003031
[Code] .....
I tried to reset it but it comes right back on.
View 4 Replies
Advertisement
I noticed that there is no parking light position on the headlight switch, so how does the headlight switch work? Either all OFF or all on? Or is the on position really "auto"
View 10 Replies
I have the lights all taken apart but I can't really see how they would come out.. Are they pressed in? Screwed in?
View 4 Replies
So my headlight switch is literally On/Off. I disabled the DRL by folding down the pin inside. But I am replacing my headlights with a custom projector housing with HID lows, halogen highs, LED Fogs, and CCFL halos, so I'd like the ability to turn on just parking lights or just the fog lights to show off the Halos etc. If I pick up a Bora Switch that has these features, will I have to re-wire/run through fuse box, etc.
View 7 Replies
A squirrel chewed through some wires in my 2009 Toyota Corolla. My left headlight went dim and my airbag light came on, all within a matter of days. I had the wires repaired and the airbag light never went off. I waited for months until I found out that my airbags won't deploy if I am in an accident. I did some research and from what I gathered until the problem is fixed the light will remain on, (Problem cannot be reset).
I took it to the same guy who fixed the wires .The code that came up was a faulty module. He said since my bags did not deploy the module most likely tripped and he could try to reset it. He tried to do it manually and by the SRS reader with no luck and told me I should go to a shop with a more advanced reader so they could try to reset the module and if that doesn't work go to Toyota.
Can this problem be reset? If it is reset how do I know there still is not a problem that needed to be fixed?
View 1 Replies
...while I didn't get the light sensor installed (since I actually use my cuppyhole to store my grarage door opener & EZ-Pass transponder0...
kept the Auto switch in...
with the DRL's activated (they are in the fog light position):
Off: DRLs
Auto: full lighting on
Parking: DRLs (plus I can use rear fog)
Low beam: full lighting (plus front & rear fogs)
and since activating the coming home and leaving home... the coming home works on "auto" position.
View 8 Replies
I went test drove a R32 today and I noticed when the headlight switch is in the off position, the HID came on when I release the hand brake, is this normal? I thought the DRL suppose to be the inner two halogen lights not the HID. This way, having a switch is kinda pointless except to turn on/off the the instrumental lights because you have the HID on whenever you release the parking brake, doesn't matter if the switch is in the off position or the on/lowbeam position.
View 12 Replies
I need Vag-Com to reset a failed lamp warning light . . . I'm assuming because I ended up pulling the switch out too far, which commands the rear fog light to come on, which doesn't exist, I caused the "lamp failure" warning light and chime to come on and NOT GO OFF (I installed my new Euro headlight switch last night).
I checked and have no dead lamps. I put the old switch back in for a bit but it's still reporting a failed lamp. I searched for this problem before posting but the search engine on this site is extremely poor ... .Couldn't find anything in the manual either. It assumes we're idiots because it says a certified mechanic should change the lamps but oh, carry extras with you !!??
View 3 Replies
I recently purchased an '01 Prius that needed work. I was driving it last night, and noticed that the dash does not light around the heater controls or radio. The whole center dash area does not light with the headlight switch.
I took a look through the owners manual for any fuse that might control this, but did not find any. I would not think that all of the bulbs would be burned out.
View 7 Replies
I have a 98 Ranger 2wd reg cab 2.3L 5sp. Recently the airbag warning light was blinking 2-7 which indicates bad lamp in passenger airbag deactivation switch. Since the lamp has no numbers or markings on it, and my repair manual has no schematic on that part, where I can find the ma, wattage or ohm rating of the lamp? Or a part number / source for a replacement lamp?
View 13 Replies
Any tips on safely removing the obnoxious airbag stickers on the back of the visors?
View 4 Replies
I just got a new switch from the dealer, only rear fog control (don't have OEM LED's yet), and I want to turn to the right one position, but the HID's come on, and no city lights. What am I missing?
I have a VCDS... [URL] .....
View 13 Replies
I am in the midst of wiring up the Bold Sport kit that comes with the OEM mirror with build Rain/light sensor. It comes with a nicely made wiring harness with OEM terminals already installed. The kit can be found here for reference. [URL]
Right now I am following the directions from myturbodiesel.com [URL]
It instructs to add the power source to the fuse box. No problem. Says to add the RLS to fuse pin 17 and the Mirror power to pin 7.
Here is the diagram they show.
The problem is on my '13 Golf R, 17 is already taken. I can certainly add to a different pin on the same bus. So not really an issue there.
The other issue is that there is no power bus for pins 7-11 on my R. What gives? There is a power bus on pins 1-6 but they are all taken already.
View 1 Replies
I have a 2010 Santa Fe Limited. When I first bought it, I'm pretty sure the headlights would delay turning off for a few seconds after removing the ignition key. Now they turn off as soon as the ignition key is turned off. Is that normal? I can find nothing in the User Manual and the dealer does not seem to know how it works.
View 2 Replies
I plan to replace my Halogen low beams with xenons in a 2003 b5 (v6 auto 4motion). Can't figure out how to remove the shroud over the power steering reservoir to provide access to the driver's side lamp - the passenger side looks pretty straightforward.
View 4 Replies
I am installing Sparco Evo Seats, a custom Harness Bar and racing harnesses in my MK4 R32 and have questions about wiring of the airbag and seatbelt sensor. What do I need to do so the airbag light and seatbelt warning light do not come on.
View 2 Replies
So after years of making fun of my Audi friends for always having their air bag lights pop on, on the way to the grocery store my airbag light decided to come on and stay on
View 11 Replies
I purchased a 2002 2.0 jetta a couple of months ago and not long after I had it I noticed that the airbag light had come on. I brought it to a garage and had them check it out and they came back with a code that read 01218 side airbag igniter passenger side. When. I asked about getting this fixed they really couldn't say much about what exactly the problem was other then to say that it could be a problem with the whole system...which I don't get as the code only came back for the side airbag igniter. I also went and spoke to the dealer here in town and they wouldn't even speak to me about it unless I let them have the car be seen by one of their mechanics and putting the computer on it to read the code which I had already told them about.
View 6 Replies
1st: 00532 Supply Voltage Too Low - Intermittent
2nd: 00592 Seat Belt Switch on Passenger Side -E25
Resistance Too High - Intermittent
3rd: 00592 Seat Belt Switch on Passenger Side -E25
Resistance Too Low -Intermittent
the piece where the passenger side seat belt clicks into has a chunk broken off of it, now im assuming that this is causing most (maybe all?) of the problem here?
View 10 Replies
Any hacks for that yet?
View 6 Replies
I need o pull the headlight switch on my T-Reg. Pushed in and turned to the left and pulled but it won't come out. Is this the correct method?
View 1 Replies
